Buscar en el registro

Miner was positioning a bearing housing in the hydraulic press. The bearing housing slipped on the frame, causing the housing to fall partially off the frame, pinning EE's fingers between the housing and the frame. EE went to urgent care clinic, was referred to the ER where EE received sutures. Returned to work the same day on light duty, and released to full duty on 5/6/16

Not an accident. An employee has had an audiogram when compared to baseline audiogram falls under the category of Reportable Hearing Loss. This is the purpose for this report.

Miner was hooking a lifting strap to lift a drill steel out of the drill. Steel stuck in the bit, causing the eye bolt in the drill head to fail. Miner was struck by falling shackle. Miner refused treatment, wanted to see how it felt the next morning. On 3/8, miner sought treatment, diagnosed with a fracture of the right radius. Miner returned 3/8 on light duty.

Employee (Ee) was greasing the loader at the start of shift. Ee reported he ducked under the boom arms and felt a pop in his lower back. Ee said he'd like to see how it felt in a few days before he went to clinic. Ee went to clinic 11/05/15, diagnosed with lower back strain. Physical therapy ordered w/ no restrictions. Released from care 11/17/15

Employee (EE) was discarding a conveyor idler when finger got caught in idler, pulling right arm/shoulder. EE reported injury but did not seek treatment. EE sought treatment on 10/2/2015 as shoulder soreness did not improve. Diagnosed with unspecified shoulder strain, and ordered physical therapy. Returned to duty w/no restrictions on 10/2/2015.

Employee (EE) visited clinic on this 8/13 with complaint of stiff/sore neck resulting from work performed on 8/10. On 8/10 EE was working on Primary Crusher removing, cleaning, and replacing wear plates. EE was working in an awkward, stooped position. On 8/13 Dr. diagnosed neck sprain/back strain and ordered physical therapy. EE returned to work same day.

Employee (EE) was working inside primary crusher changing impact hammers. When witness struck the impact hammer with a sledge, a shard broke loose from the impact hammer and struck EE in the arm, lodging just below the skin. EE was transported by supervisor to local ER where Dr. cut out shard and applied 3 sutures. EE returned to work with no restrictions same day.

Ee slipped while walking on an elevated walkway checking conveyors. Ee grabbed handrail, straining right shoulder. Ee reported injury to foreman on 7/9/15, but did not request treatment/evaluation. 7/14/15 Ee received evaluation of injury. Dr. diagnosed sprain of right shoulder, returned to full duty same day (7/14/15), & ordered physical therapy.

Fell walking down small grade. Torn rotator cuff. Diagnosed 6/5/14. Root cause of fall dated 5/2/14.

Employee was using sledge hammer to move slabs of rock that had jammed a conveyor. The employee hit himself in the shin with the sledge hammer. It was not a direct hit but slid back from rock being hit into shin. The accident resulted in bruising and a cut that required 6 stitches.

Employee took a sideways step and aggravated a previous soccer injury to knee.

Employee was cleaning frozen mud from the pulley on main belt conveyor using a round bar 5' to 6' long. Right small finger pulled in between bar and conveyor belt which pulled part of the skin off the finger as he pulled out his finger. He received 8 stitches from a specialist and returned to work.

The truck landed on its' right rear corner in the dumped material the truck then fell forward causing the left front corner of the cab to striking the rock wall and sloughed or rolled back to the position. He seem lucid but bloody from cuts on his left arm and right hand and some cut on his head, was no visible bleeding at that time.

WHILE PUSHING AN ELECTRIC WELDER UP A SLIGHT INCLINE, EMPLOYEE FELT A "POP" IN HIS RIGHT KNEE. THE TERRAIN WAS NOT UNEVEN OR OF A DANGEROUS SURFACE. HE HAD ASSISTANCE IN PUSHING WELDER.

EE STATED HE WAS ON TOP OF THE PLATFORM HOSING DOWN OIL ON HIS MACHINE. HE STARTED BACK DOWN THE STAIRS, & SLIPPED. THERE WAS EITHER OIL ON HIS BOOT OR HE SLIPPED FROM THE WATER. HE PUSHED HI MSELF AWAY TO PREVENT HITTING HIS BACK OR HEAD AS HE FELL AND LANDED ON HIS LEG.

EMPLOYEE WAS REMOVING A PIN FROM THE TOOTH ADAPTOR BY DRIVING IT WITH A SLEDGE HAMMER. WHEN HE STRUCK THE PIN A SMALL SLIVER CAME OFF AND IMBEDDED IN HIS KNEE.

EE WAS LOADING CAPSTON AND STRIPPING INTO 100 TON TRUCKS WITH A CAT 992G WHEN HIS BUCKET TEETH HOOKED INTO A SEAM IN THE CAPSTONE. WHILE TRYING TO LIFT THE BUCKET, THE BACK OF THE MACHINE CAM E OFF THE GROUND. WHEN HE BACKED AWAY FROM THE WALL, THE BACK OF THE MACHINE CAME DOWN, JARRING HIM, CAUSING HIM TO BOUNCE IN THE SEAT.

EE HIT HIS OWN HAND WITH AN 8LB HAMMER. FRACTURED FINGER.

CARPAL TUNNEL SYNDROME TO RIGHT HAND.

FAILURE OF INJ EE TO DE-ENERGIZE ELECTRICAL CIRCUIT AND LOCK OUT SAME BEFORE WORKING ON

FAILURE OF INJ EE TO DENERGIZE ELECTRICAL CIRCUIT AND LOCK OUT SAME BEFORE WORKING ON.

EE WAS HELPING THE MECHANIC INSTALL A LIFT CYLINDER ON A 5O TON TRUCK. AS IT WAS BEING LIFTED INTO PLACE. THE EE GOT HIS HAND BETWEEN THE EYELET ON THE CYLINDER AND PIN BOSS ON THE BED. THE CY LINDER PINCHED HIS SMALL FINGER PUT ABOUT A 3/4"CUT IN HIS FINGER.

EE STEPPED ON PIPE WRENCH, WRENCH SKIDDED ON STEEL GRATING.

HAULING WET MATERIAL UP INCLINE. FRONT END RAISED CAUSING TRUCK TO ROLL BACKWARD, STRIKING STONEWALL AND TURN OVER ON LEFT SIDE.

EMPLOYEE WAS CHECKING THE BUCKET LEVELER ON THE HIGHLIFT. AS HE WAS CLIMBING DOWN HE STRUCK HIS HEAD ON THE RIGHT REARVIEW MIRROR BRACKET.

USING PRY BAR IT SLIPED & HE FELL STRIKING HIS CHIN ON A STEEL OBJECT

EE HAD HAD A HISTORY OF BACK PROBLEMS. HE SAYS HIS PRESENT COMPLAINT IS NOT THE RESULT OF AN ACCIDENT BUT AS THE RESULT OF HIS OCCUPATION AS A TRUCK DRIVER. HE CANNOT POINT OUT ANY SPECIFIC RE ASON FOR HIS BACK PROBLEM.

REPAIR WORK BEING DONE TO HUD. JACKHAMMER AT PRIMARY CRUSHER. HAMMER HAD BEEN PUT ON A STEP OF A STAIRWAY WHILE BEING FIXED. IT SLIPPED OFF THE STEP & CAUGHT THE EDGE OF THE FOOT JUST BEHIND T HE STEEL TOE. PINCHED THE SKIN & CAUSED SLIGHT FRACTURE TO LITTLE TOE.

EE HAD SPENT THE PREVIOUS NIGHT MOVING HIS BELONGINGS FROM HOME THAT WAS EXPECTED TO BE COVERED BY THE FLOOD HE WAS OBSERVED BEFORE WORK WALKING WITH CONSIDERABLE DISCOMFORT SHORTLY AFTER STAR TING WORK LOADING SHOT ROCK HE CLAIMS TO HAVE RUN INTO A LEDGE IN FLOOR CAUSING BACK PAIN

CLIMBING DOWN FROM DRILL FOOT SLIPPED ON LADDER AND EMPLOYEE FELL ABOUT 2'.

STUCK HIS FINGER THRU GUARD OF RUNNING HEATER FAN IN TRUCK. ALL HE SAYS WHEN ASKED WHY IT HAPPENED IS THAT IT WAS A STUPID THING TO DO.

INJURED REPORTED HIS BACK WAS HURTING FROM DRIVING HIS TRUCK.HE WENT TO HIS DOCTOR ON 05-15-92.AND HAS NOT COME BACK TO WORK.

EMPLOYEE WAS CHANGING POSITIONS WITH A LIT TORCH IN HIS HAND AS HE TURNED HIS BODY HIS FOOT SLIPPED CAUSING HIM TO PASS THE LIT TORCH CROSS HIS LEFT CHEEK (FACE) AS A RESULT HE RECEIVED SMALL 1ST DEGREE BURN ON HIS LEFT CHEEK

HE WAS ON HIS BACK UNDER A TRUCK CUTTING THE DRIVESHAFT OFF WHEN A SMALL PIECE OF SLAG FELL INTO HIS EAR.

EMPL REPORTS THAT HE WAS STANDING IN BACKYARD WHEN PAIN SHOT UP FROM FOOT TO BACK. THIS WAS ON SUNDAY. HE HAD REPORTED TWISTED ANKLE 10 DAYS EARLIER.

TRUCK WAS GOING DOWN HILL DRIVER MOVED TO EDGE OF ROAD TO AVOID A ROCK AND WHEEL DROPPED IN AN AREA THAT HAD WASHED OUT BECAUSE OF RAIN.HE LOST CONTROL AND DROVE UP ON A BANK AND TRUCK TURNED ON ITS SIDE.STRAINED HIS RIGHT WRIST.DRIVER WAS WEARING SEATBELT.

EMPLOYEE WAS USING A ROCK AS A STEP. ROCK WAS WET AND FOOT SLIPPED TWISTING ANKLE.

HYDROLIC HOSE ON A LIFT CYLINGER BROKE WITH BED OF TRUCK RAISED BED FELL & JARRED THE TRUCK

DRIVER WAS REPREMANDED FOR UNSAFE DRIVING ON 1-10-90ON 1-11-90 REPORTED HE HAD HURT HIS BACK WHILE DRIVING A TRUCK HE SAID HIS SEAT HAD BROKED DURING THE DAY & THIS HAD CAUSED INJURY INSURANCE CO IS INVESTIGATING

EMPL WAS USING A CHISEL AND HAMMER PICE OF CHISEL BROKE OFF AND PUNCHED SKIN IN STOMACH AREA WOUND CLEANED FOUND FIT FOR FULL DUTY AND TOLD TO REPORT BACK TO WORK

CUTTING FIREWOOD, LOG FELL TO GROUND AND BOUNCED UP AGAINST THIGH.

TIGHTENING BOLTS WITH WRENCH FELT MUSCLE IN NECK PULL.

CLIMBING STAIRS CARRYING 5 GAL CAN FELT PAIN IN BACK

EMPLYEE WAS WALKING & HIT HIS HAND ON A PIECE OF IRON CUT HIS HAND REFUSED MEDICAL CARE BUT WAS SENT TO HOSP.BY SUPERVISOR

OPERATOR CLAIMS MACHINE GIVES HIM WIPLASH NO PARTICULAR OCCURANCE OR ACCIDENT CAUSED HIS BACK CLAIM.

PINCHED LEFT IN8EX FINGER BETWEEN THE BIT AND HAMMER OF A DOWN THE HOLE DRILL. HAD REMOVED HAMMER FROM DRILL AND PUT IN PICKUIP TRUCK TO GO TO MACHINE SHOP WAS TAKING HAMMER FROM TRUCK AND LO LOWERED IF OFF 7AILGATE FORGETTING TO REMOVE FINGER FROM BETWEEN BIT AND HAMMER. PINCHED SKIN FROM SIDE OF FINGER SLIGHT DAMAGE TO FINGER BUT REQUIRED SKIN GRAFT

A CUSTOMER TRUC5 DRIVER STALLED HIS ENGINE ON HIS TRUCK ON A HILL & ROLLED BACK INTO THE BUCKET OF A COMPANY.TRUCK DRIVER SAID HE HAD BEEN JUST RELEASED FROM HOSP.FOR A HERNIA & FELT THE IMPAC T MAY HAVE BROK9N LOOSE SOME OF THE STICHES AMBULANCE WAS CALLED & HE WAS TAKEN TO HOSP.TO SEE

CHANGING OIL ON TRUCK, SLIPPED WHILE GETTING OFF FENDER HIT EAR ON FENDER DID NOT WANT TO GO TO SEE A DOCTOR.