Buscar en el registro

Employee was using a bobcat to lift an old pipe guard a foot off the ground and move it. Employee noticed that pipe guard started to slip so they went into reverse and the pipe fell out of the bucket and the bottom left leg of the pipe guard went into the cab of the bobcat and struck them in the left ring finger causing a laceration.

Employee was using a shuttle car to move two rail cars, due to wet slippery conditions shuttle car unable to stop. Shuttle car and two rail cars went to derail and ran off track. Employee worked for several days and did not request medical until 4/19/22 no restrictions given released full duty. Second Medical 4/22/2022 is when restrictions issued.

Employee was backing a WA600 Front-end loader when EE struck a pot hole causing a sudden jerk.

While driving a golf cart in the direction of the sun, he was blinded by the sun. He drove into a concrete column on the roadway.

Employee was walking out of silo #12 due south next to a parked truck getting loaded. The truck pulled out of the loading area, striking him on the left thigh.

Was using a Bobcat, cleaning the drainage area near the elbow dump area. When mud fall from his load hit the ground, some hot dust/steam came-up to his face and ears.

Dust blew into left eye, when he turned on the AC on the loader.

Injured was helping remove feeder wobble bars. He got his ring finger on his left hand caught in a pinch point. The pinch point crushed his distal phalange. It had to be amputated.

IP was attempting to reach behind a guard and hit a troughing idler with a hammer. IP does not remember exact details but sustained an injury when his LT hand passed between a troughing idler "can" and the running conveyor belt. IP's LT hand was bruised and he was placed on modified duty.

On 4/17 QC samples were being collected from a conveyor belt. Lockout requirements were not followed. The belt was accidentally activated by another employee for a few seconds. IP's knee contacted a conveyor x-member. No reportable injury was communicated. On 4/28, IP reported that while walking at a lake his knee gave out on 4/26. IP came to work on 4/28 on crutches & light duty.

Employee slammed shifter into reverse and jammed wrist.

Employee was operating a loader bucket. The loader bucket dropped to the gound by itself and it jerked the entire piece of equipment.

Employee did not know proper usage of air seat. Caused some soreness on tailbone,

Lost control of haul unit vehicle while driving to the pit.

EMPLOYEE WAS DRIVING HAUL TRUCK. WHEELS WENT ONTO BERM AND TRUCK TURNED OVER.

EE HIT A POTHOLE IN THE ROAD, THE EUCLID DOWNSHIFTED UNEXPECTEDLY & HE HIT HIS SHIN ON THE SHIFTER TOWER.

THE SHIFTER ON THE FRONT END LOADER BECAME STUCKEE BEGAN TO PUSH AND PULL THE SHIFTER PULLING A MUSCLE IN HIS LT. ARM.

PULLED NECK MUSCLE DRIVING ON ROUGHT PIT ROAD.

EE WAS ADJUSTING THE CLAY CHUTE ON PLANT WHEN HE SLIPPED AND TRYING TO CATCH HIMSELF PUT HIS LEFT HAND INTO HEAD PULLEY OF CONVEYOR.

EE WAS DRIVING A EUCLID AND SAND BLEW IN HIS EYE.

EE WAS UNLOADING MATERIAL WITH DUMP TRUCK. AS HE WAS MOVING OUT OF UNLOADING AREA HE RAN INTO A FRONT END LOADER, CAUSING DUMP TRUCK DRIVER TO STRAIN BACK.

EMPLOYEE WAS OPERATING A MANLIFT AND CAUGHT FINGER BETWEEN MAN LIFT AND BUILDING.

EMPLOYEE WAS ATTEMPTING TO ENGAGE THE POWER TAKE-OFF FROM UNDER A DUMP TRUCK.EMPLOYEE BY MISTAKE PULLED THE WRONG LEVER AND BED CAME DOWN ON HIS HAND.

EMPLOYEE WAS WORKING WITH A FRONT END LOADER MOVING CLINKER INT HE CLINKER BUILDING. WIND WAS LBLOWING AND OPERATOR HAD DOORS OPEN ON LOADER BECUSE AIR CONDITION WAS NOT WORKING. SOME CLINKE R DUST BLEW AROUND HIS SAFTEY GLASSES AND INTO HIS EYE.

EMPLOYEE FINISHED DOING SOME CLEAN-UP AROUND CONVEYOR. HE RETURNED HIS TOOLS AND REMEMBERED LEAVING HIS FLASHLIGHT. WHILE REACHING FOR HIS FLASHLIGHT, EMPLOYEE'S FEET SLIPPED ON SOME CLINKER A ND WHILE TRYING TO CATCH HIS BALANCE HIS RIGHT HAND GOT INTO THE CONVEYOR/SKIRT AND HIS HAND AND ARM WERE PULLED IN.

EMPL WAS OPERATING ONE OF HAUL UNITS HAULING RAW MATERIAL FROM PIT TO PLANT. ROAD FROM PIT TO PLANT HAD SOME VERY UNEVEN & ROUGH AREAS & EMPL FAILED TO SLOW DOWN FOR UNEVEN & ROUGH AREAS & E MPL DID NOT HAVE SEAT BELT TIGHTENED SUFFICIENTLY TO PREVENT HIM FROM BOUNCING UP & DOWN IN SEAT.

EMPLOYEE WAS DRIVING A BELLY DUMP TRUCK, DUMPING STRIPPED MATERIAL ON A FILL PILE. EMPLOYEE DROVE TO THE EDGE OF THE FILL PILE AND TRUCK SLID OFF OF EDGE AND TURNED OVER. EMPLOYEE HAD HIS SEAT BELT ON AND THE BOLT HOLDING THE SEAT BELT TO THE TRUCK WAS BOLTED UPSIDE DOWN. HE HIT HIS LEFT THIGH ON THE BOLT, CAUSING ABRASIONS AND BRUISING.

EMPLOYEE HAD JUST DUMPED A LOAD AT THE PLANT, HE WAS RETURNING TO THE PIT, HE HAD PUT THE BED DOWN, BUT THE PTO WAS NOT FULLY DISENGAGED, CAUSING THE BED TO LIFT. HE HIT A OVER HANGINH TREE L IMB WITH THE DUMP. HE LOST CONTROL OF THE HAUL TRUCK RAN DOWN AN EMBANKMENT AND CAME TO REST AT THE BOTTOM.

EMPLOYEE WAS HA6LING A CABLE TO THE BULL PEN STORAGE AREA, ON A FORKLIFT. HE WAS SITTING SLUMPED IN THE SEAT, BECAUSE THE HEADRACK ON THE FORKLIFT IS TO SHORT FOR HIS HEIGHT, WHEN HE HIT SOME CHUCKHOLES IN 7HE ROAD, HIS BODY FLEW UPWARD.

EMPLOYEE WAS DR3VING A DUMP TRUCK UP AN INCLINE. HE FAILED TO SHIFT TO A LOWER GEAR & TRUCK STARTED TO ROLL BACK AND DROVE OFF OF ROAD HITTING A LOG WHICH IN TURN BEC AUSE OF THE INCLINE BESID E OF ROAD TURNE8 TRUCK OVER ON ITS SIDE THROWING HIM ACROSS SEAT AGAINST OPPOSITE SIDE DOOR

EMPLOYEE WAS SHOVELING UNDER A CONVEYOR WHEN A LARGE ROCK FELL FROM FEEDER STRIKING A GUARD BRACKET, AND THEN HITTING THE EMPLOYEE ON THE LOWER BACK.

EMPLOYEE WAS RETURNING BACK TO DRAGLINE FOR ANOTHER LOAD OF PIT RUNWHEN HE LOST CONTROL OF UNIT ON RAMP AND RAN THROUGH LEFT ISDE OF BERN EMPLOYEE WAS THROWN OUT OF UNIT WHEN IT CAME TO A STOP OP

EMP WAS CLEANING CONVEYOR WITH A HOE. THE BLADE OF THE HOE CAUGHT IN THE TAIL PULLEY OF THE CONVEYOR WHICH SNAPPED THE HOE BACK AND BROKE IT IN TWO, HITTING THE EMPLOYEES HAND THE CAUSING THE INJURY

EMP WAS CLEANING OUT THE SPILLAGE IN THE INCLINED RAMP, USING A 930 LOADER. AS EMPLOYEE STATES BRAKES FAILED & THIS CAUSED A SUDDEN STOP, JOLTING THE EMPLOYEE FORWARD CAUSING HIM TO STRIKE HI S LEGS AND SHINS ON THE ENTERIOR OF THE CAB

CHECKING OPERATION OF C/301 CONVEYOR WHEN BELT CAUGHT LEFT HAND AND THREW FOREARM AGAINST TROUGHING ROLLER BREAKING ARM.

EMPLOYEE WAS RIDING THE PERSONNEL BASKET WITH HIS HANDS OUTSIDE OF THE BASKET THE BASKET HIT A BEAM AND MASHED THE END OF HIS THUMB OFF

TWO EMPLOYEES WERE PLACING KILN BRICKS ON TO A ROLLER CONVEYOR AND ONE EMPLOYEE WAS REMOVING BRICKS AT THE BOTTOM OF CONVEYOR. EMPLOYEE MISSED ONE OF THE BRICKS AND IT WENT OFF OF THE END OF T HE CONVEYOR AND STRUCK EMPLOYEE ON ANKLE.