Buscar en el registro

Employee was loading out shot rock and was making berms to contain the boulders as they would fall while EE was digging the shot. Operator was digging on a 45-degree angle to get around a high spot in the floor and a massive boulder fell with a rockslide. The boulder jumped over the berm and hit the right front tire of the loader causing damage to the front wheel and the operator.

Miner was driving haul truck, when miner started feeling discomfort on their lower back

Driver was dumping material when the cab rocked back and forth causing Miner to hurt EE's back.

Employee notified management of discomfort in their back on 9/12 alleging that on 9/8 EE's back started bothering EE but was common due to previous injuries at past job. EE went to the ER and was signed out of work starting on 9/15 due to lower back pain.

While operating a 70 ton Terex haul truck the operator hit a divot bump at 10mph causing pain in lower back.

While operating the JLG man-lift the employee used the safety gate to pull self upright. The gate swung open and hit the employee in the face causing a broken nose and laceration needing stitches.

Employee was moving a boulder in the pit when they experienced back discomfort. Was not reported until 3 days later.

While moving material in a haul truck employee drove over a bump in the haul road and experienced pain in tail bone/lower back.

Employee was attempting to push in a skirt rubber that had popped out. EE used a pry bar to push the rubber back in place and inadvertently made contact with the moving conveyor belt causing the bar to spin and pinch their finger between the bar and the chute. A few stitches received to tip of right middle finger.

Haul truck driver felt discomfort in neck and lower back after being loaded. It is believed a large stone was in bucket and when loaded into bed it made bed shift side to side.

Employee was using heat to warm slow moving feeder belt and left jacket cuff caught in pinch point of troughing roller and belt and resulted in a left wrist fracture

Employee operating walk behind skid steer to clean stone spillage bottom level of screen tower and while backing, left elbow struck cross member causing a jam of wrist at controls resulting in a left wrist fracture.

strained back while operating loader

Employee states while operating water truck he struck a rut/pot hole in roadway causing him to be jarred in the seat. Employee was returned to work and placed out of work by his personal physician on 12/8/09.

Employee alleges while driving haul truck, he had pain in his neck and shoulder.

Employee was operating walk behind under a conveyor. While grabbing a bucket of material, the control end lifted and pinched EE's finger against return idler guard.

While operating walk behind skid-steer, the machine was backed into a support beam, causing the operator's finger to be pinched in the controls.

Carrying a shovel near a conveyor, employee turned and belt grabbed shovel causing employee's arm to be dragged onto conveyor.

A loader and haul truck struck each other, causing the employee to hit head against the radio system attached to the roof of the cab.

EMPLOYEE CAUGHT GLOVED HAND IN CONVEYOR HEAD PULLEY WHILE APPLYING BELT DRESSING.

WHILE TRYING TO REPOSITION BELT, HAND SLIPPED CAUSING IT TO GO THROUGH DRIVE SHEAVE.

EE WAS WALKING UNDER A CONVEYOR BELT. DUST/DIRT COMING OFF BELT ENTERED HIS RIGHT EYE.

EMPLOYEE WAS CHECKING BELT TENSION ON SCREEN. SCREEN WAS JUST SHUT OFF BUT WAS STILL ROLLING ON HIGH SIDE OF ECENTRIC. EMPLOYEE REACHED AROUND GUARD TO CHECK BELT AS THE ECENTRIC ROLLED CATCH ING HIS HAND BETWEEN BELTS AND SHEAVES.

A 58.5 POUND ROCK MEASURING 10 1/2"X9 1/2" ROLLED OFF OF #1 CONVEYOR APPROX. 9 FT FROM GROUND STRIKING EE IN THE BACK OF HIS HARD HAT. EE SUSTAINED A MILD CONCUSION.

EE WAS ADJUSTING TAIL PULLEY UNDER #1 BELT WHEN A SINGLE ROCK BEING CONVEYED TO SCHRREN #1 ROLLED BACKWARD AND FELL OFF OF CONVEYOR HITTING EE IN HARD HAT. ROCK WEIGHED 15 LBS.

WHILE DOING PRIMARY REPAIR WITH IDLERS BANGED LEFT MIDDLE FINGER.

HAUL TRUCK DRIVER BEING LOADED IN QUARRY BY LOADER. OPERATOR DROPPED LOAD IN BED OF TRUCK AND SHOOK THE VEHICLE. DRIVER HIT MOUTH IN HAND HOLDING THE STEERING WHEEL AND KNOCKED TOOTH OUT.

EMPLOYEE WAS CLEANING UNDER A MOVING CONVEYOR WITH A HOE. HOE CAUGHT THE MOVING CONVEYOR AND THRUST THE EMPLOYEE'S HAND INTO AN IDLER. EMPLOYEE FAILED TO TURN OFF CONVEYOR AND LOCK OUT THE SYS TEM, WHICH IS STANDARD PROCEDURE. ALL SAFETY FEATURES WERE IN PLACE AND WAS CORDONED OFF.

EMPLOYEE STATES THAT HE WAS TOSSED FROM SIDE TO SIDE DUE TO ROCK HITTIN GSIDE OF HAUL TRUCK WHILE BEING LOADED IN QUARRY.

EMPLOYEE PLACED TWO CONCLAVES ONTO A PALLET WITH A CRANE. EMPLOYEE NOTICED LATER THAT ONE OF THE CONCLAVES WAS SLIGHTLY OFF THE PALLET. EMPLOYEE ATTEMPTED TO JOSTLE CONCLAVES ITNO POSITION WI TH HIS HAND. HE SLIPPED AND PINCHED HIS RIGHT MDDLE FINGER BETWEEN THE TWO CONCAVES. EMPLOYEE SHOULD HAVE UTILIZED THE CRANE TO MOVE THE CONCAVE.

HIT BY ROCKS WHILE WELDING ON SCREEN.