Buscar en el registro

IE was recovering tubes when they dropped the tubes and it rolled down their knee hyperextending it.

IE was washing on the slope and due to being wet and dirty as they worked their skin became irritated.

IE was pulling shields when they got water and fines in their boot causing it to rub their right ankle raw.

IE strained their back while shoveling coal fines from shield toes.

IE was assisting in moving fans when right foot got stuck in the mud. As they pulled it out of the mud they felt a strain in their right knee.

IE was opening a mandoor when they let it slam and catch the tip between the door and the frame causing a small cut.

IE was hanging highline when a piece of rib fell that measured approximately 12"x12"x5' fell and struck the employee's right leg.

IE was struck by a piece of rib that measured approximately 12"x12"x5' long. There was caution that the employee had loss of conscious after investigation which caused MSHA to issue citation 5192035.

IE had went through a mandoor and was taking a rake in behind him. When the employee pulled the rake it hung. Once the rake became unhung it caused them to fall to the ground where they claimed to strain their back and neck.

IE was building a brattice. When they were capping the brattice, they were hitting a wedge with an axe and missed striking their left ring finger causing a cut.

IE was putting EE's drill wrench into the drill pot when a small piece of draw rock fell and struck EE's right hand.

IE was operating the shearer when a small rock fell from between the shields and hit EE's right pinky finger against the pan line causing a cut.

IE was riding on a mantrip when EE hit EE's head on a hanging deluge pipe causing a strain in EE's neck.

IE was repairing a suction line on a roof bolter when the knife EE was using cut the palm of EE's hand. Only reportable due to receiving sutures.

IE was removing belt structure at the LW tail when EE allowed EE's left index finger to get smashed between a top frame and the belt rail causing a cut.

IE reported on 5-4-26 that EE felt a pop in EE's lower back as EE was picking up and stacking cement block on 5-2-26.

IE was throwing dust under the tires of a scoop that was stuck when a piece of rock measuring 10"x4"x3" fell from between bolts and hit EE's hard hat before sliding onto EE's shoulder.

IE was walking around a trash when EE slipped, rolled EE's left ankle, and strained EE's left foot.

IE was carrying bolter glue to a roof bolter when EE slipped on some loose coal on the ground and fell into a ventilation tube with EE's right knee.

IE was moving EE's CM waterline when EE felt a strain in EE's lower back.

IE was moving a rock out of the walkway on the belt slope when EE strained EE's back.

IE was installing a roof bolt. As the employee went to push the bolt that EE had bent into the roof with the drill pot of the roof bolter the bolt sprung back and struck EE's left forearm.

The SP Elevator was taken out of service due to an area of concern found in 2 ropes during the NDT tests. The elevator ropes are being replaced, the elevator will be tested, and placed back into service.

IE had been moving spools with a lotrac when EE noticed a fork coming off of the mast. When EE went to reinstall the fork, EE claimed to drop the fork on EE's right foot.

IE strained their back picking up 2 oil cans. IE finished shift and requested treatment after the end of the shift.

IE was loading the mule for LW recovery when they picked up a bundle of cap wedges. When they picked this up they felt a pull in their lower back.

IE was sweeping a belt when they slipped off a concrete pad in the floor straining their left knee.

IE was walking a belt when they slipped and fell. When they fell, they landed on their arm and bruised their ribs.

The SP Material Hoist was taken out of service after finding broken strands in the rope. The rope was replaced, the hoist tested, and placed back into service.

The SP Elevator was taken out of service due to the elevator ropes crossing after they were shortened and lost the "rope memory". The elevator was ran to get a memory back in the rope, the elevator was tested, and placed back into service.

IE was installing sprag beams on the headgate drive when one of the beams that was leaning against the panline fell over and struck EE's leg.

The SP Material Hoist was taken out of service after finding broken strands in the rope. The broke strands were removed from the rope. The rope was shortened, the hoist tested, and placed back into service.

IE was cleaning with a loader when EE backed under a strap that was low hanging. The strap caught the canopy of the loader and flipped out of the machine causing a laceration to the operator back. This was investigated by MSHA.

IE was running a rock truck when they hit a pothole causing them to bounce and strain their back.

IE was walking when EE tripped over a rock and fell hitting EE's elbow on the ground.

IE was cutting belt when the knife slipped and poked their left leg just above the knee. The employee received staples to close the cut.

IE was helping slide a ram jack back onto the shield toes when they used poor hand placement and grabbed the eye so when the jack moved and smashed fingers between the jack and the shield toe.

IE was assisting in moving a CM cutter head. As they were pulling the head onto the duck bill of the scoop a lifting eye that was being pulled against broke free from the machine, appeared to ricochet, and hit the employee in the face area causing multiple fractures.

The SP Elevator was taken out of service due to a faulty limit switch. The switch was replaced, the elevator was tested, and the elevator was placed back into service. An inspection of the elevator was also performed by MSHA.

IE was operating the shearer when a small rock came from the drum and hit EE's cheek before glancing into EE's eye and causing a laceration.

IE was riding on a mantrip to gather supplies for the shift when EE bumped EE's head on an I-Beam. The employee requested treatment for neck pain an hour later after reaching EE's assigned job for the shift.

IE was assisting in lifting the hood on the compactor when EE felt a sharp pain in EE's back.

IE was pushing a rock off of the handrail on the LW face when a rock came from the tailgate and hit the rock they were attempting to push. This caused a strain of their right shoulder.

IE was opening a toolbox when they felt a pull in their right shoulder.

IE was walking with the shearer. A ram jack that was chained to the shearer had its D-ring break allowing it to fall. The jack hit the employee's leg and caught it between the jack and a shield toe causing a bruise.

IE was adding DEF fluid to the 336 Excavator when DEF jug slipped. When the employee attempted to catch the jug, the lid fell striking right wrist.

IE was installing a fork on a lotrac when the fork hit their finger causing a fracture.

IE was walking at the MN2 header when EE rolled EE's ankle and fell to EE's knees.

There was a rib roll located on the MN1 belt between 14 and 15 crosscut. Due to initial information this was reported out of caution. After investigation this was deemed to be a non-reportable event. The area was also investigated by MSHA and deemed to be a non-reportable event.

IE was changing a hose on a shield. They had a chisel braced with left hand when they hit left thumb with the hammer they were using causing a fracture.