Buscar en el registro

In repairing screener, EE released the open/close lever and in doing so did not anticipate the weight of the equipment. The equipment began to close rapidly and caught EE's finger between the screener and channel iron.

Frozen material jammed auger. Pellet mill operator attempted to free jam by using a metal bar. Bar slipped off of leverage point, pulley recoiled back and pulled hands into belt. Incident resulted in pellet operator losing two fingers on left hand.

Another EE was driving the forklift. IE and other EE were unloading a container filled with 20 2000lb sacks with no skids under. Other EE had lifted the straps for 1 of the sacks about 1/4 of the way in the truck. IE pinched IE's finger between the sack and the tip of the fork lift. was sent to the er.

The employee was removing steel roof beams and materials. While attempting to remove a beam, the injured was struck on the back and neck areas by a piece of falling steel.

Walking down steps and caught thumb on an upright and bent EE's thumb backwards

Was filling fuel truck and was walking on a narrow walkway and slipped ee grabbed the railing and fell against fuel truck bruising ribs

while checking the dust collector operator lifted the lid up and removed the clogged dust popped lid up and slid down and cut the operators finger.

entrance gate got wedged between truck and trailer while it was stuck as the truck pulled away the gate was freed and sling shot backwards and hit the employee in the head ( was wearing a hardhat ) as he fell down he broke his right leg.

While shrink wrapping bags with heat gun bag caught on fire he attempted out of impulse to swat the small flame with left hand was wearing latex gloves instead of work gloves. (forgot them at home)

Shoveling material into pay loader bucket, while swinging the shovel over to dump it, he hit the edge on bucket slicing his finger

while working on an airline, airline came undone resulting in a burst of compressed air hitting left hand near thumb.

Working on street sweeper and slipped on oil that was on the motor

Employee was lifting and stacking 60 pound bags. Claimed he hurt shoulder/back.

Employee complained of numbness in left hand and arm while driving forklift. Employee claims this has been ongoing for two weeks. Employee was sent for treatment for left 1st extensor compartment tendonitis and placed on restricted duty.

Employee was ducking under the dryer to look at gear when a bolt sticking out of the dryer knocked off his hard hat. When he reacted to catch it, another bolt struck him on the top of his head.

Employee went to pick up gloves and lacerated right thumb on a razorblade dispenser.

Employee stepped down off of the yard lift and onto a piece of rock and rolled his right ankle.

Employee was reaching over pellet mixer and bumped bottom rib on left side.

Employee was lifting 60 pound bags of Carb-O-Cite material. He felt sharp pains in his right elbow and couldn't lift any longer.

Employee was greasing equipment when tarp line caught his boot and he fell injuring his right arm.

Employee attempted to lift latch on tanker truck. Latch was rusted and partially frozen shut. Employee felt a pull in groin and left arm near elbow joint.

While loading tanker, pulley on chute broke causing chute to fall on employee's left foot.

Stacking bagged material into a box bottom. The box bottom shifted on the pallet. He picked up the end of the box bottom to move it back on to the pallet. Did not notice any pain until he got home. Reported incident to supervisor on 07/23/13.

Employee was going through the plant doing the morning preventative maintenance checklist. He slipped and fell on the catwalk cutting his left knee and shin.

Employee was bending over and shrink wrapping a pallet of material. After he finished wrapping the pallet, his back began to tighten.

driving loader, was turned so he could see backing up

Employee was bagging material when he felt his right arm start to hurt.

Employee was opening bagged material and material got in his right eye.

Employee was dumping barrels, he bent over to pick up empty barrel and started having muscle spasms.

Outside Pellet mill, payloader was coming towards him, operator of payloader was brining the bucket downward toward level position, foot was pinched by bucket

Loading tanker truck with material. Lifted arm to reach for the load chute. Employee heard a "pop".

Working on street sweeper changing the hydraulic valve. Employee was wearing safety glasses. Debris in his left eye.

EE was on top of a railcar. Lifted the mat so they can move the car.

Step off forklift to check if sack of product was secure.

On top of railcar lifted the mat to move the car.

Employee was cleaning rollers, inside the die. Glove got caught. Injured fingers on his left hand

Right hand was caught between dryer and chute. Steel ripped EE's skin.

Leaves blew under the dryer and ignited the wall. Fire damage is limited to the wall.

Holding a sack that was filling with product.

EE was cutting a tarp. Cut palm - left hand.

EE was removing a chute, slipped and fell and fractured his left foot.

CAUSE UNKNOWN. EE STARTED UP THE STREET SWEEPER.APPEARED LOW ON GAS. WENT TO LOOK FOR A GAS CAN.COULD NOT FIND A CLEAN ONE. PUT KEY TO SWEEPER IN THE FOREMAN'S LOCKER. EE WENT HOME.