Buscar en el registro

Adjusting and cleaning of a tail pulley on a 110' Masaba Conveyor LOTO was not performed by the EE before entering the tail pulley section of the conveyor. Belt was energized by the operator; EE was in tangled in the pulley from his feet to his mid section of his body. EE was fatally injured.

Employee was helping to lift a screen. Employee injured shoulder.

Employee stepped off loader and twisted ankle.

Employee was moving an impact hammer from a lower level to an upper level. Employee lifted the impact hammer and was unable to hold it and it dropped on his hand.

Employee was getting onto a D-8 dozer when he slipped on the steps that were muddy and injured right knee.

OVER A TWO MONTH TIME PERIOD THE EMPLOYEE'S ARM STARTED TO HURT. HE NOTIFIED US ON 9-8-03 AND THEN WENT TO A DOCTOR. UPPER ARM OR SHOULDER STRAIN.

EMPLOYEE WAS WALKING AROUND EQUIPMENT ON QUARRY LEDGE AND STEPPED ON A ROCK HURTING HIS LEFT KNEE.

TAKING WEDGES OUT OF HAMMER MILL, WAS HOLDING ON TO WEDGE WHILE OTHER EMPLOYEE HIT WEDGE. WEDGE DROPPED ON EMPLOYEE'S HAND.

TWO EMPLOYEES WERE MOVING A SCREEN WHEN IT SLIPPED OUT OF ONE'S HAND CUTTING HIS FINGER. HE NEEDED STITCHES ON HIS MIDDLE FINGER.

EE WAS USING A HAMMER WHEN HE HIT HIS FINGER. HEWAS WEARING TINTED SAFETY GLASSES IN A POORLY LIGHTED AREA. HE SUFFERED A CUT FINGER.

WALKING ON SOME ROCKS AND TWISTED KNEE. X-RAY WAS NORMAL AND EE RETURNED TO WORK MISSING ONE DAY.

EE WAS HELPING INSTALL ROCK BOLTS IN THE ROOF USING A ROCK DRILL AND AIR LEG. WHILE BACKING OUT OF THE HOLE JUST DRILLED THE EE PLACED HIS LEFT HAND BETWEEN THE BASE OF THE DRILL AND THE AIR L EG. THE DRILL SHIFTED PINCHING HIS LEFT RING FINGER.

EE WAS LIFTING A STEEL GRATE AND FELT A PAIN IN LOWER BACK.

EE WAS USING A SHORT HANDEL SPADE TO CLEAR ROCK AND MUD AWAY FROM THE LOADING APRON ON AN AM50 ROAD HEADER AND FELT A SHARP PAIN IN GROIN.

EMPLOYEE APPARENTLY ATTEMPTED TO EXIT MACHINE TO THE RIGHT UNDER THE BOOM. WHILE EXITING, THE EMPLOYEE'S HIP ENGAGED THE BOOM LOWER CONTROL, CAUSING THE BOOM TO LOWER AND CRUSH EMPLOYEE'S TORS O, CAUSING FATAL INTERNAL INJURIES.

AN UNPLANNED ROOF FALL OCCURED IN THE LEFT FACE OF THE TOP HEADING. THE FALL WAS APPROX 25 FT IN LENGTH AND RANGED IN THICKNESS FROM 5 FT TO 3 FT. THE ROOF FALL BRIDGED ACROSS THE OPERATOR CAN OPY ENTRAPPING THE OPERATOR 25 TO 30 MIN. THE EEWAS REMOVED, NO APPARENT INJURY.

EMPLOYEE WAS USING A PRYBAR TO LOOSEN A ROCK. THE BAR GAVE AWAY AND HIT HIM IN THE MOUTH. THE TOP CENTER TOOTH WAS CHIPPED. A RESIN SEAL WAS USED TO REPAIR TOOTH.

EE WAS DRILLING FLOOR WITH A SINKING HAMMER. HE PULLED THE DRILL AND STEEL UP TO MOVE TO ANOTHER HOLE LOCATION AND FELT A SHARP PAIN DOWN HIS RIGHT ARM CHEST AND SIDE.

EE WAS SUPERVISING THE REPOSITIONING OF A CEMENT PUMP WITH AN END LOADER AND CHAIN. HE RESTED HIS ELFT HAND ON THE BUCKET CLOSE TO WHERE THE CHAIN WAS ATTACVHED. THE CHAIN SLIPPED UNDER LOAD A ND SHIFTED ACROSS RING FINGER ON LEFT HAND, FRACTURING 1ST BONE AND INFLICTING A LACERATION WOUND TO THE FINGERTIP.

EE WAS REMOVING 30" FIBERGLASS VENTILATION LINE FROM OVERHEAD. THE SECTION HE WAS REMOVING WAS ATTACHED TO SEVERAL SECTIONS WHICH FELL AFTER HE UNTIED THE WIRE SUSPENDING THE VENTLINE. EE WAS HOLDING THE VENT LINE BY A "D" RING AND WAS UNABLE TO LET GO FAST ENOUGH PULLING MUSCLES IN SHOULDER OF RIGHT ARM. STARTED MISSING WORK 5/9/99.

EMPLOYEE WAS UNLOADING A LATTICE GIRDER SECTION OUT OF A LOADER BUCKET WHEN HE SAT IT DOWN ON TEH INVERT IT SHIFTED AND STRUCK HIS RIGHT SHIN CAUSING AN ABRASION TO HIS LEG. ABRASION BECAME I NFECTED ON 4-18-99, EMPLOYEE WENT TO HOSPITAL.

EE WAS REPLACING WINDOW IN LOADER WINDOW FELL OVER ONTO LEFT INDEX FINGER REQURED 3 STITCHES AND BROKE INDEX FINGER FINGER WAS SPLINGERED BY DR GENE OVERLAND PARLK

THIS EE WAS LYING AN A CONVEYOR BELT/BIN, WATCHING EE CLEAN OUT ANOTHER BIN, THE EES POWERED UP THE BIN THEY HAD BE CLEANING WHEN THE CRUSHER OPERATOR HIT THE WRONG BUTTON CAUSING EE TO FALL O FF OF THE BELT TO THE GROUND. EE SUFFERED A COMPRESSED VERTEBRA IN THE MIDDLE BACK.

EE WAS ADJUSTING A SCREEN ON A SECONARAY SCALPER. HE REACHED ACROSS THE SHAFT WHEN HIS CLOTHING BECAME IN TANKLED. EE SUFFERED A STRAINED RIGHT ELBOW REQUIRED 3 VISITS TO PHYSCIAL THERAPY EE W AS SUSPENDED A 2 WORKING DAYS FOR FAILURE TO ELBOW POPP SAFETY PREVIOUS.

EE WAS WALKING AROUND THE DRILL AND HE SLIPPED ON THE MUDDY SURFACE. AS HE FELL HE TRIED TO BREAK HIS FALL WITH HIS HANDS. THIS CAUSED A FRACTURE TO HIS LEFT HAND.

EE WAS CLEANING A SHOTCRETE WITH A PRESSURE WASHER. HE DISASSEMBLED THE NOZZEL AFTER CLEANING THE EXTERIOR PORTION AND ATTEMPTED TO CLEAN SMALL COMPENTS BY HOLDING THEM IN HIS LEFT HAND AND US ING THE SPRAY WAND IN HIS RIGHT HAND. HE INFLICTED A PUNCTURE WOUND TO LEFT HAND BETWEEN THUMB AND FOREFINGER.

EE WAS DOING MAINTANCE ON BELT WHEN HE SLIPPED AND CAUGHT HIMSELF. EE HAD CONTUSION ON RT HAND. DR INSTRUCTED EE TO NOT USE HAND FOR 2 DAYS. RETURNED TO FULL DUTY THAT DAY.

EE WAS ATTEMPTING TO FILL A PRESSURIZED TANK WITH ACCELERATOR AND DID NOT BLEED THE AIR PRESSURE FROM TANK BEFORE OPENING FILL COCK.

THE FOREMAN WAS STEPPING OFF OF A LOADER THOUGHT HE TURNED HIS ANLE. CONTINUED TO WORK UNTIL HIS ANKLE BECAME PAINFUL.

EMPLOYEE WAS USING A 90 LB AIR HAMMER TO DIG A FOOTING IN ROCK. EMPLOYEE POSITIONED HAMMER TO BREAK ROCK. WHILE OPERATING HAMMER, THE BIT BOUNCED OFF THE ROCK AND LANDED ON LEFT FOOT. THE BIT PUNCTURED THE LEFT FOOT REQUIRING SUTURES.

EE WAS HELPING SET A 3 PEICE LATTICE GIRDER ASSEMBLY WHICH WAS BEING SUPPORTED BY AND END LOADER. WHILE ATTEMPTING TO SECURE THE GIRDER WITH 9 WIRE THE GIRDER SHIFTED AND STRUCK THE EE ON THE RIGHT FOREARM.

EE WAS CUTTING EXCESS CEMENT OFF THE SIDE WALL OF THE SLOPE USING AN AIR OPERATED HAMMER & OVER EXTENDED HIS RIGHT WRIST.

EE WAS CLEANING OFF BELT WHEN IT STARTED CAUSINGHIS THUMB TO BE HIT.

EMPLOYEE WAS CLEANING OUT MUD IN AND AROUND THE TAIL PULLY AND THE GUARD WHEN HIS HAND SLIPPED AND HIS RIGHT FOREARM WAS CUT BY THE CORNER OF THE GAURD. PLANT WAS LOCKED OUT.

EE WAS UNCLOGGING A HOLE WITH A ROD WHEN IT POPPED BACK HITTING HIM IN THE MOUTH.

EE WAS WANTING TO GET DOWN TO A CONVEYOR BELT (5-6' BELOW). INSTEAD OF USING THE WALKWAY AND LADDER THAT WAS IN PLACE, HE DECIDED TO CLIMB DOWN THE FRONT OF THE CRUSHER WHEN HE SLIPPED, FALLIN G 5-6' TO THE CONVEYOR. THE EQUIPMENT WAS LOCKED OUT.

EE WAS TRYING TO PUSH A PICK UP THAT WAS BEING WORKED ON IN THE SHOP WHEN HE FELT COME PAIN IN HIS LEFT FOOT. PULLED TENDON IN LEFT FOOT.

EE WAS CLIMBING DOWN A LADDER OUT OF HEAVY EQUIPMENT AND HE TWISTED HIS KNEE.

EE WAS RODDING SHALE AND THE ROD BROKE IN HALF IN HIS LEFT HAND CAUSING A PUNCTURE WOUND.

EMP WAS USING A METAL BAR TO LIFT UP A PIECE OF METAL AROUND THE HAMMER OF A CRUSHER WHEN THE BAR SLIPPED CAUSING THE WEIGHT OF THE OBJECT BEINGLIFTED TO COME DOWN ON EMP'S THUMB.

EE WAS LOWERING THE LIGHT TOWER ON THE LIGHT GENERATING UNTIL AND DID NOT USE THE SAFETY LOCK. THIS IS A NEW PIECE OF EQUIPMENT AND THE EE WAS NOT FAMILIAR WITH THE SAFETY LOCK.

EMPLOYEE WAS CLOSING A DOOR AT THE TOP OF A BUCKET ELEVATOR. IT SLIPPED, FALLING ON TOP OF HIS LEFT FOOT.

EMPLOYEE SLIPPED, BUT DIDN'T FALL AS HE WALKED AROUND PLANT. HE LATER THAT DAY NOTICED SOME PAIN IN MIDDLE OF BACK.

EMPLOYEE WAS DOING ROUTINE MAINTENANCE, HIT HIS LEG ON A ROCK AND NEEDED A FEW STITCHES ON LOWERLEG.

HE WAS USING A GRINDER ON A BELT GUARD WHEN THE CLAMP HOLDING THE GUARD CAME LOOSE. THIS CAUSED THE GRINDER TO KICK BACK CUTTING HIS ARM ABOVE HIS LEFT WRIST.

PICKED UP A ROCK AND CUT FINGER.

EMPLOYE EWAS PULLING ON WATER HOSE AND FELT PULLING AND PAIN IN BACK.

DRILLING HOLE AND SEPARATING TWO PIECES OF DRILL SHAFT WHILE THE COMPRESSED AIR WAS SLIGHTLY ON. AS HE REMOVED THE COLLAR A TINY PIECE OF METAL BLEW OUT AND ENTERED HIS CHEST.

EMLOYEE WAS WORKIGN ON CRUSHER WHEN A PART FELL ON HIS LEFT HAND. BROKE RING FINGER ON LEFT HAND.

STEPPED OFF CONVEYOR & TURNED RT ANKLE FX OF RT ANKLE