Buscar en el registro

Installing drill steel in rig

TURNING ROTOR WHEN A DUCT TUBE SLID OUT & PINCHED FINGERS BETWEEN TUBE & TOOTH.

INSTALLING ROLLERS ON A CONVEYOR LINE.

CUTTING CONVEYOR BELT TO RELAYS.

DESCENDING LADDER EE FELL. FAILURE TO MAINTAIN 3 POINT CONTACT.

WHILE SETTING CONCRETE BLOCKS FOR THE RAMP TO THE WEST SIDE OF THE JAW, THE HOOK BEING USED TO LIFT THE BLOCKS SLIPPED. THE BLOCK LANDED ON THE BOTTOM ROW OF BLOCKS AND ROLLED OFF, PINNING EE TO THE GROUND AND BREAKING HIS RIGHT LEG BELOW THE KNEE.

INJURED WAS EXITING THE TRACK MOUNTED SCALING MACHINE. HE JUMPED OFF THE TOP OF THE TRACKS TO THE CONCRETE SHOP FLOOR DAMAGING HIS ANKLE.

EMPLOYEE STATED THAT SHOES WERE TIGHT AND DOING LIFTING.

OPERATING ENGINEER WAS PUTTING A 10 FT ROUND STEEL IN RACK OF LM401 HYDRAULIC DRILL AND FELL BACKWARD WITH STEEL STRIKING HIS LEFT FEMUR BONE ON HIS LEG CAUSING A LARGE ABRASION WITH SOME SWEL LING AND ERTHEMA TO THE LEFT UPPER FEMUR AREA. HE WAS ACCOMPANIED TO PROVENA MERCY CENTER IN AURORA, IL WHERE HE WAS X-RAYED AND GIVEN CRUTCHES TO KEEP HIS FULL WEIGHT OFF HIS LEFT LEG.

TWO MEN WERE CHANGING CRUSHER LINERS. A PLATE BEING FASTENED INTO POSITION SLIPPED AND FELL ON INJURED'S RIGHT FOOT, BREAKING THE 4TH TOE.

1994 FORD P/U TRUCK WENT OVER THE EDGE WITH OPERATING ENGINEER IN IT. OPERATING ENGINEER WAS TAKEN BY ANOTHER LUDWIG EE TO PROVENA MERCY CENTER, OCCUPATIONAL HEALTH SERVICE 1325 N. HIGHLAND AV E, AURORA IL 60506. OPERATING ENGINEER HAD A FEWSCRATCHES ON HIS HANDS. HE WAS RELEASED TO RETURN TO WORK.

EMPLOYEE WAS IN THE FEEDER ON THE LOWER HOLE CRUSHING PLANT CLEANING THE GRIZZLY AND SLIPPED AND FELL. HIS KNEE LANDED ON A ROCK INJURING IT.

INJ WAS LOOSENING HYDRAULIC OIL FILLER PIPE CAP NOT REALIZING IT WAS UNDER PRESSURE. CAP BLEW OFF & HIT INJ IN THE FACE

STONE FELL ON WORKER'S L SHOULDER @ 1PM. HE HAD PARAKED EXPLOSIVE TRUCK & WAS IN THE PROCESS OF WALKING TO FELLOW WORKER [DRILLING IN LM401IR HYDRAULIC DRILL]. HE PHONED IN INJURY AT 3PM AFTER SHOULDER BEGAN TO SWELL & HURT. HE DID TELL FELLOW WORKER WHEN HE GOT TO DRILL THAT HE HAD JUST BEEN HIT BY FALLING [1] STONE. MINE PERSONNEL TOOK HIM TO HOSPITAL ER & LUDWIG EXPLOSIVES PERSO

CONDITIONS CONTRIBUTING WERE ONE MAN'S HANDS SLIPPING OFF THE PIPE THEY WERE HOLDING. THE DAMAGE DONE WAS A SEVERE BRUISE TO LEFT TOP FOOT.

EE WAS USING A UTILITY KNIFE TO CUT A PLASTIC BARREL. HE WAS CUTTING TOWARDS HIMSELF WHEN THE KNIFE PULLED OUT OF THE BARREL AND CUT INTO HIS LEG. UPPER LEFT THIGH.

EE SLIPPED WHILE ATTEMPTING TO OPEN CHUTE DOOR.

PERSONAL POSTURE.

WHEN USING A HAMMER AND PUNCH A PIECE OF STEEL FROM HAMMER FACE CHIPPED OFF AND WENT INTO MY KNEE.

INJURED WAS SLIPPING A DRIVE BELT OVER A PULLEY, SUSPENDED WITH A SPUD WRENCH, BY A CO-W0RKER. WHEN INJURED USED HIS FINGERS TO SLIP THE BELT OVER THE SPUD WRENCH, IT SLIPPED CAUSING THE SPRIN G LOADED IDLER PULLEY TO DROP ON THE INJURED'S FINGER, PINCHING IT AGAINST A NEARBY SENSOR HOUSING.

TRACTOR DRIVER WAS TRYING TO OPEN TRAILER SIDE DOOR. IT WAS ICED UP. HE FORCED DOOR OPEN AND FORCE HIT HIM IN THE MOUTH, CRACKING UPPER PARTIAL PLATE OF TEETH, AND BRUISING LOWER LIP.

INJURED WAS IN ROOF BOLTER BASKET INSTALLING A SPLIT SET LOOSE ROCK SPALLED OFF ROOF & HIT INJURED ALLEGED ACCIDENT

WHEN DRILLING AT THE FACE, AFTER EXITING CAB TO CHECK DRILL ALIGNMENT MATERIAL STRUCK EE.

AIRBORNE DIRT FLEW INTO EYE.

UTILITY KNIFE SLIPPED WHILE CUTTING RUBBER BELTING FOR A CONVEYOR RESULTING IN DEEP CUT ON LITTLE FINGER OF LEFT HAND. THE CUT REQUIRED STUTCHES TO STOP THE BLEEDING.

STANDING BY SIDE OF CONVEYOR DOINT MAINTENANCE WORK ON IT WHILE THE CONVEYOR WAS RUNNING. A ROCK FLEW OFF THE BELT HITTING HIM ON THE LOWER BACK.

ROOF BOLTER'S DRILL IS UNDERGOING REPAIR. BOLTHOES & BOLT INSTALLATION WAS DONE WITH A JACKLEG WITH THE OPERATOR CLOSE BY. ROOF WAS SCALED BY; HAMMER & HAND, YET ROCKFALL OCCURED DURING HOLE DRILLING. PIECE FELL ON INJURED'S SHOULDER CAUSING SEPARATION, CONTUSION AND ABRASION.

LIFTING BLOCKS TO CRIB A CONVEYOR.

STEAM CLEANING ENDLOADER AND GRABBED THE LADDER ON THE MACHINE AND A SHARP PIECE OF METAL ON THE LADDER CUT HIS HAND.

AFTER CUTTING A PIECE OF STEEL, I WALKED PAST A MAN WHO WAS GRIDNING, AS I WAS GOING TO HOSE OFF MY STEEL TO COOL IT, I NOTICED THAT I HAD SOMETHIKNG IN MY EYE.

WHEN DRILLING BOLT HOLE IN THE BACK.

HE WAS CUTTING A SUPPORT BRACE AND THE BRACE SLIPPED CAUSING THE HOPPER TO LAND ON HIS FOOT.

MINER WAS BENT DOWN KNOCKING A BIT OFF A PLUGGED DRILL STEEL, WHEN A ROCK ROLLED OUT OF EXISTING SUPPORT WIRE (WWF) STRIKING HIM IN THE HEAD.

WHEN REMOVING CRUSHER WEAR PARTS FROM CRUSHER, EE HURT HIS BACK.

APPLYING PRESSURE ON CRUSHER FLYWHEEL, IT BECAME FREE, CAUSING FINGER TO GET CAUGHT BETWEEN PIPE WRENCH AND QUARD FRAME.

DISCARDING PIECE OF FRAYED CABLE,1 WIRE PUNCTURED RIGHT HAND.

MOVING TRACK DRILL FELT PAIN IN MIDDLE BACK AND NECK AREA

INSPECTING EQUIPMENT. THOUGHT LEFT EYE HAD DUST PARTICLE IN IT, UNTIL THAT EVENING. THEN NOTICED RUSTY OBJECT STUCK TO FRONT OF EYE.

ADDING FLUID TO MACHINE AND SLIPPED OFF LADDER WENT TO DOCTOR ON 04-09-92.

PINCH BAR 4'LONG .5"-2"DIAMETER.WEIGHT 10 LBS.BAR SLID FROM UPRIGHT PROPPED POSITION AND FELL ONTO FINGER WHILE PICKING UP ANOTHER ITEM.

HE WAS GREASING PLANT & HE RUBBED EYE WITH DIRTY GREASY GLOVE. DIRT, RUST, & GREASE GOT INTO RIGHT EYE CAUSING IRRITATION.

EMPLOYEE WAS WELDING PIECE OF STEEL ON BACK OF LOADER BUCKET STEEL BECAME UNHOOKED FROM CHAIN & FELL ABOUT 12IN HITTING HIS LEFT LEG

WENT UP A CONVEYOR TO REMOVE A BROKEN PIECE OF STEEL.ON RETURN I STEPPED OVER A MOTOR MOUNTING STAND AND PROCEEDING DOWN,I STEPPED ON AN ANGLE IRON SUPPORT,SLIPPED AND HIT MY LEG JUST BELOW MY KNEE CAP.

FEED CHAIN BROKE WHILE DRIFTER WAS AT TOP OF BOOM.

STEPPING DOWN OFF A CONVEYOR. THE GLOVE ON HIS RIGHT HAD BECOME CAUGHT ON THE EDGE OF A HANDRAILING CAUSING HIM TO LOSE HIS BALANCE AND TWISTING HIS RIGHT KNEE.

EMPLOYEE TIGHTENING BOLTS IN SCREEN WHEN IRON RAIL FELL AND HIT EMPLOYEE'S BACK. THE CLAMP BARS NOT PROPERLY PLACED WHILE WORKING ON SCREEN PLANT.

RECONNECTING DIFFERENTIAL MAIN BEARING.DRIVE SHAFT SWUNG TO THE LEFT AND CAUGHT LEFT HAND BETWEEN FRAME AND DRIVE SHAFT.HAND SWOLLEN AND BRUISED.X-RAYS SHOW NO BROKEN BONES.

WRENCH SLIPPED ON BOLT AND HIT HIS ELBOW.

RUNNING BULLDOZER PUSHING DIRT.

WHILE CLEANING IN AN AREA APPROXIMATELY 12 FT BY 18 FET AND APPROXIMATELY 6 FT HIGH THERE WAS A SHEET OF STEEL 4 FT ABOVE AND IT FELL ONTO HIS THIGH WITH OUT ANY WARNING.