Buscar en el registro

Smoke was reported in the developed underground space at 3:21am. The fire department responded but was unable to locate the source, although it was thought to be in the developed underground area. No miners were working underground. Mine management and Buckley Powder discovered the burned truck at approximately 8:30am and MSHA was notified at 8:36am.

Was working at the surface plant on rollers and conveyers with a wrench and pulled right shoulder causing tingling in index, thumb and middle finger.

Employee pulled away from crusher with his 35 ton truck bed in the air. The bed of the truck hit the ceiling of the mine and although the employee states that he was wearing his lap belt, he was thrown into the steering wheel and suffered lacerations and a broken nose.

Plant Operator was moving base stacker conveyor out of way for the Loader Operator. During this maneuver hydraulic hose broke. While searching for leak, either in hose or connections, he asked that it be raised up and pump turned on. In doing so pressure was reinstated in hose. Hand was positioned right over hole causing penetration to middle finger on right hand.

Changeling a punch plate on the second deck of scalping screen. EE stated he felt a pull in his lower back. Declined med attention at this time. Called supervisor at 5:30pm on 10/31/11 and stated his back was stiff and sore, but he would wait until morning and see how it felt. Called supervisor at 5:30 am on 11/1/11 and requested to see a doctor because his back still hurt.

Prying rock out of motor and guard on scalping screen. Pry bar slipped and mashed finger between bar and motor. Went to doctor, gave anti-inflamatory and finger splint.

EE was in a lift basket scaling the roof of the mine. He stated that he twisted while trying to pull down a piece of rock with a pry bar, and pulled a muscle in his neck/back area. EE has been prescribed muscle relaxers, anti-inflammatories and pain aid. He will not work until the Dr. has released him. Dr. will reevaluate in one week.

EE was in a lift basket with another EE when the lift basket was raised too high & the employee bumped his hard hat on the ceiling. Employee did not report discomfort until 5 days later & was sent to a physician. Minor diagnostic & medical attention was given & a follow up visit was scheduled. A 3rd visit was scheduled 3/31/09, thus making the injury reportable(a "Series")

The employee was cutting conveyer belt with a retractable knife. As he pulled the knife, toward his body, it slipped and lacerated his right leg. The laceration is about an inch long, but it did require stitches. He was treated and released back to work without restrictions.

Employee was scaling the roof of the mine when the mechanical scaler that he was operating came off of its' turntable and toppled over. He suffered bruises and contusions. He has been fully released as of today.

Employee was lifting on a pulley guard that was stuck in semi-frozen mud. About 45 min. later he began to have pain in the lower right abdomen/groin area. He said he did not initially injure himself at work; that he had severe pain the previous week and he had to stop doing physical activity. We sent him to the doctor as a precaution and he was prescribed Naprosyn 800mg.

Employee was filing something in a metal file cabinet and as she turned to walk away, she accidentally closed the cabinet drawer on her right little finger.

EE WAS ATTEMPTING TO REPOSITION A CRUSHER HAMMER ON A PALLET WHEN THE HAMMER MOVE UNEXPECTEDLY, CATCHING HIS LITTLE FINGER BETWEEN TWO HAMMERS. BOTH HAMMERS HAD JUST BEEN RELOCATED TO THE SHOP , BUT ONE WAS NOT DOWN COMPLETELY ON THE PALLET.

EE WAS USING A FACTORY WEDGE FOR TAKING THE CONE CRUSHER APART WHEN HE HIT THE WEDGE WITH A SLEDGEHAMMER, A PIECE CHIPPED OFF OF WEDGE AND HIT HIS LEFT ARM.

EE WAS PULLING A 3" DISCHARGE HOSE WHEN HE STEPPED ON A ROCK & TWISTED HIS RIGHT ANKLE. HE TRIEDTO KEEP FROM FALLING DOWN BUT COULDNT GET HIS RIGHT LEG UNDER HIM ALL THE WAY

EE WAS TAKING IT UPON HIMSELF TO LOOK AT THE MOTOR ON THE CONVEYOR TO GET A SERIAL NUMBER. WHEN HE CLIMBED UP ON THE CONVEYOR(NOT RUNNING). HE SLIPPED AND FELL ONTO THE CONVEYOR, HITTING A ROL LER(?) INJURING HIS BACK.

EMPLOYEE WAS LOOKING OUT THE WINDOW OF THE CAT HAUL TRUCK WHILE BACKING UNDER THE LOADER BUCKET TO GET LOADED WHEN HE FELT SOMETHING HIT HIS RIGHT EYE.

EE REPORTED HIS PROBLEM IN 3/2000 ON 3/15/00 WE SENT HIM TO THE CO DR & IT WAS DETERMINED HE HAD AN UMBILICAL HERNIA & THE EE ALLEGES IT WAS CAUSED FROM DRIVING HIS CAT DUMP TRK. HE IS SCHE DULED FOR SURGERY BUT THAT IS PENDING INVESTIGATION BY OUR WORK COMP INS CO. HE HAS BEEN WORKINGLIGHT DUTY SINCEY 3/15/00

EE STARTED OPERATING THE HITACHI EXCAVATOR WITH RAMER HYDRAULIC HAMMER IN 3/1999. EE COMPLAINED OF PAIN & BURNING & EVENTUALLY HAD BLEEDING IN HIS STOOL. ON 3/7/00 EE WAS DIAGNOSED BY THE CO DR AS HAVING A TEAR OR FISSURE INSIDE THE RECTUMSURGERY IS SCHEDULED AT WHICH TIME THE SURGEON HAS STATED HE WILL DETERMINE WHETHER THE INJURY IS WORK RELATED OR NOT

EE ALLEGES CARPAL TUNNEL SYNDROME IN BOTH HANDS, AGGRAVATED BY WORK. EE ADMITS THE CONDITION STARTED WHILE WITH HIS PREVIOUS EE, WORKING AS A DRILLER. EE HAD SURGERY ON THE FIRST HAND ON 2/8/0 0 AND THE SECOND HAND ON 3/21/00.

EE WAS REPAIRING A EUCLID R-22 DUMP BODY. THE DUMP BODY WAS RAISED AND SECURED. HE HAD FINISHED WELDING AND FLIPPED UP HIS WELDING MASK TO CHIP SLAG OFF OF HIS WELD WHEN HE FELT SOMETHING HIT HIS EYE. HE WAS WEARING SAFETY GLASSES. AT ABOUT 9:20 HE WENT TO THE RESTROOM AND COULD SEE SOMETHING IN HIS EYE, SO HE TOLD HIS PLANT MANAGER.

EE GHAD FUELED HIS LOADER AND WAS HANGING UP THE HOSE WHEN HE TWISTED HS BACK.

EE WAS HAMMERING A BOLT THROUGH A HOLE WHEN THE HAMMER HEAD CAME OFF AND HE HIT HIS HAND ON THE SCREEN, HE WAS GOING TO REPLACE, BREAKING HIS THUMB.

EE GOT OUT OF HIS TRUCK TO CHECK ON A PLUGGED CHUTE. WHILE ON THE TRUCK CATWALK, HE WAS HIT ONTHE HARDHAT BY A ROCK THAT SPILLED FROM THE CHUTE (4"-6"). THIS CAUSED HIM TO FALL APPROX 7' TO THE GROUND, LANDING ON HIS RIGHT HIP & LOWER BACK AREA. WE SENT IMTO THE DR FOR EVALUATION. ON 6/17/98 DR MEHAFFEY SENT HIM FOR A CAT SCAN. ON 6/18/98 EE WAS GIVEN A NOTE.

EMPLOYEE WAS WALKING DOWN THE STAIRS ON THE DOCK BARGE WHEN HE LOST HIS BALANCE AND LANDED ON HIS FOOT, HARD, BREAKING A BONE HIS FOOT.

EMPLOYEE WAS CLEANING UP WORK AREA ON THE DOCK, HOLDING A PIECE OF FLAT STEEL THAT SLIPPED FROM HIS GRASP AND HIT A PRY BAR ON THE GROUND THAT FLIPPED UP & HIT HIM ON THE LEFT CHEEK.

EE WAS DRIVING A CAT D25D HAUL TRUCK, THE TRAILER PART OF THE TRUCK TURNED OVER AND THE EE GOT OUT OF THE CAB AND WAS RUNNING IN THE MINE TO GET THE LOADER OPERATOR TO UPRIGHT THE TRAILER, WHE N HE RAN INTO A ROCK PILLAR IN THE MINE AND HIT HIS FACE. THE EE HAD NO LIGHT TO ILLUMINATE HIS PATH.

WHILE EMPLOYEE WAS CHANGING SCREEN DECK ON SCREENING PLANT HE WAS DRIVING A WEDGE TO SECURE THE SCREEN DECK. HE HIT THE STEEL WEDGE AND IT CAME OUT AND HIT HIM IN THE FACE, JUST BELOW THE RIGH T EYE.

EMPLOYEE WAS PUSHING CAP-SHOT ROCK WITH THE DOZER. AS HE BACKE DUP, THE REAR OF THE DOZER DROPPED, CAUSING HIM TO BE JARRED. EH SAID THIS HAD HAPPENED SEVERAL TIMES, FINALLY CAUSING HIM TO S TOP BECAUSE OF THE BACK PAIN.

OPERATOR WAS DRIVING AN EMPTY HAUL TRUCK FROM THE PLANT TO THE MINE. HE WENT AROUND A CORNER TOOFAST AND LOST CONTROL. HE WENT INTO A DITCH AND HIT A TREE. HE BOUNCED AROUND IN THE SEAT, WAS NOT WEARING A SEAT BELT AND INJURED IS BACK AND NECK.

EMPLOYEE WAS HELPING TO SPLICE A CONVEYOR BELT WHEN HE LOST HIS BALANCE AND FELL OFF THE CONVEYOR TO THE GROUND BELOW, WHICH WAS ABOUT 10 FEET. EMPLOYEE LANDED ON HIS FEET ON LOOSE ROCK. INJUR ED HIS RIGHT FOOT AND ANKLE.

EE WAS STRAIGHTENING A COTTER PIN ON THE TAMROCK TRACK DRILL. HE WAS HOLDING THE PIN AGAISNT HE DRILL WITH HIS RIGHT HAND AND USING A HAMEMR WITH HIS LEFT. AS HE WA POUNDING ON THE PIN HIS F LASHLIGHT FELL TO THE GROUND CAUSING TO STRIKE HIS THUMB ON HIS RIGHT HAND WITH THE HAMMER.

EMPLOYEE WAS ATTEMTPING TO REMOVE ROCK FROM THE CRUSHER WHEN HE SPRAINED HIS LOWER BACK.

EMPLOYEE WAS UP ON A LADDER FILLING HOLES WITH EXPLOSIVES WHEN THE TOP OF THE LADDER SLID SIDEWAYS AND HE FELL TO THE GROUND.

EE STRUCK BY FULL BARREL OF HYDRAULIC OIL, WHICH FELL FROM BUCKET OF LOADER. BARREL WEIGHED ABOUT 350 POUNDS, AND BUCKET OF LOADER WAS 7-8' HIGH FROM GROUND.

EE WAS LIFTING A RAILROAD TIE INTO THE BACK OF A PICKUP TRUCK AND HIS KNEE GAVE OUT.

MAN WAS SUPERVISING CLEARING OFLARGE BOULDERS FROM PRIMARY CRUSHER USING A STEEL CABLE TO PULL THEM OUT OF THE CRUSHER HE WAS SIGNALLING THE TRUCK DRIVER TO PULL FORWARD WHEN THE CABLE PULLED THE STEEL SPILL PROTECTOR OFF OF THE ROCK BOX DUMP HOPPER & PINNED HIS RT ANKLE AGAINST THE GROUND

EMPLOYEE WAS STEPPING DOWN OFF A HAUL TRUCK (769B) AND HE HIT HIS KNEE ON THE BUMPERCAUSING HIM TO MISS THE LAST STEP. AS HE STEPPED ON THE GROUND, HE STEPPED ON A ROCK AND TWISTED HIS KNEE( T HE SAME KNEE HE HIT ON THE BUMPER). HE SAID SOMETHING POPPED IN HIS KNEE.

SWINGING A HAMMER AND SMASHED LITTLE FINGER BETWEEN HANDLE AND BIN DOOR, CAUSING AN OBLIQUE NONDISPLACED FRACTURE OF THE FIFTH DISTAL PHALANX.

EMPLOYEE WAS CLIMBING OUT OF THE CAB OF HIS TRUCK TO WIPE OFF THE HEADLIGHTS. DUE TO MUDDY STEPS ON HIS TRUCK, HE LOST HIS BALANCE AND TWISTED HIS KNEE ON THE STEP.

EMPLOYEE WAS WELDING J HOOKS ON A CONVEYOR (4"-6") TO HANG CONTROL CABLES FROM,WHEN A 4" ROCK ROLLED DOWN BELTS AND HIT HIM ON THE TOP OF THE HEAD. THE BELT WAS RUNNING ON THE CONVEYOR.

EMPLOYEE STEPPED OFF OF DRILL TRUCK & PLACING WEIGHT ON LEFT LEG THE WEIGHT CAUSED THE EMPLOYEE TO COLLAPSE EMPLOYEE HAD A PREVIOUS INJURY TO THIS KNEE EMPLOYEE STATED HE WAS ON SOLID GROUND

EMPLOYEE WAS ABSENT FROM WORK MARCH 30, 31,AND APRIL 1, 1994. EMPLOYEE RETURNED TO WORK APRIL 41994 WITH NOTE FROM DR. SAYING, HE HAS AN INJURYTO HIS LEFT ARM AND WILL BE ABLE TO RETURN TO WORK ON MONDAY APRIL 4, 1994.

TRUCK DRIVER HAD PARKED WATER TRUCK UNDERGOUND, CLIMBED DOWN OUT OF IT TO MAKE SURE IT WAS PARKED IN CORRECT SPOT, THE DRIVER THEN CLIMBED BACK INTO TRUCK, TURNED THE TRUCK S HEADLIGHTS OFF, A ND WHEN CLIMBED OUT OF THE TRUCK THE DRIVER MISSED THE BOTTOM STEP AND FELL ON HIS BACK.

AN EQUIPMENT OPERATOR WAS SCALING WIATH THE GRADALL SCALER IN THE SOUTHWEST CORNER AREA OF THE MINE WHEN A ROCK THAT HE SCALED LOOSE ROLLED TO THE GRADALL & BECAME LODGED BETWEEN THE ACCESS LA DDER & FRONT WHEEL. THE OPERATOR ASKED A NEARBY EQUIPMENT OPERATOR TO HELP HIM DISLODGE THE ROCK & WHILE DOING SO THE MAN HELPING THE GRADALL OPERATOR STRAINED HIS BACK.

CONVEYOR HAD BEEN SHUT DOWN TO REMOVE ROCK FROM TAIL PULLEY ON BELT TO SIMP. SCREEN . GUARD WAS REMOVED TO FACILITATE REMOVAL OR ROCK. ROCK WAS REMOVED, THEN GUARD WAS REPLACED. JUST AS SIGNAL WAS GIVEN TO RESTART, GUARD SLIPPED BRACKET, SWINGING FROM REAR BRACKET, STRIKING EMPLOYEE IN GROIN AREA.

EMPLOYEE SLIPPED WHILE REPAIRING CONVEYOR, BUMPED HIS KNEE AND SPRAINED HIS WRIST. NO ONE WITNESSED ACCIDENT. EMPLOYEE BEGAN TEMPORARY DISABILITY 8-9-93.

CLEANING OUT FROM UNDER BELT (CONVEYOR) AND SCRAPED HAND ON METAL BURR ON PULLEY GUAR. GLOVES HAD BEEN PROVIDED TO EMPLOYEE BUT HE DID NOT HAVE THEM ON AT THE TIME OF THE ACCIDENT RESULTING IN A 2 CM. LACERATION TO RT. HAND.

73512E REFER TO ATTACHED, DETAILED, ACCIDENT REPORT.

EMPL WAS CHANGING OIL ON HAUL TRUCK,FOOT MISSED BOTTOM STEP ON TRUCK AND EMPL FELL CAUSING FRACTURE TO RIGHT PELVIS.