Buscar en el registro

Shaker screen sliced thru right hand.

Employee thawing out frozen belt. A piece of ice and rock slid off belt smashing fingers on left hand. Fracture to little finger.

Slipped on bottom step of truck. Foot rolled under him popping ankle. Bad sprain to right ankle.

Laceration to thumb - needed tetanus shot only.

Smashed finger between pry bar & frame of jaw.

Fell over axle-cracked rib.

Grease gun fell off ladder and hit employee in the head; cut to head.

Pulled head off truck and exhaust gasket cut left hand.

MOVING CRUSHER, TRUCK PULLED UP ONTO A PIPE, PIPE CAME UP & HIT EE ON RT. LEG, KNOCKING EE INTO FENCE & HITTING HEAD & HIP ON IRON POST. ABRASION TO HEAD & KNEE. NO FRACTURES.

LIFTING TO INSTALL FEEDER CHAIN, HURT BACK 1-4-01 POSSIBLE HERNIATED DISC

HYDRAULIC FLUID IN R EYE.

FELL OFF LADDER AND TWISTED KNEE TORE ACL AND REQUIRED SURGERY.

EE WAS PICKING UP ROCK TO KILL A SNAKE WHEN ANOTHER SNAKE BIT HIM

EMPLOYEE WAS DRIVING PIT TRUCK WHEN LOADER DROPPED A LARGE ROCK IN TRUCK, IT JARRED BACK OF EMPLOYEE.

WHILE EE WAS GETTING OFF CONVEYOR BELT. HE SLIPPED AND CUT LEG.

SHOVLING BEARING ON SHAFT AND CUT FINGER THRU NAIL.

EE WAS GETTING ROCKS OUT OF JAW AND HIT FOOT WITH HAMMER.

EE SLIPPED ON MUDDY PLATFORM AND FELL OFF CRUSHER. HE BRUISED HIS RIBS, SHOULDER AND PULLED MUSCLES.

EMPLOYEE WAS PULLING A CHAIN WITH LOADER, WHEN CHAIN BROKE AND WRAPPED AROUND LOWER LEGS, CAUSING BRUISES AND CUTS TO LOWER LEGS.

EE STEPPED UP ONTO UTILITY TRAILER, SLIPPED ON WET SURFACE AND FELL INTO TRAILER-FALLING OVER RAIL-HURTING BACK. EE WAS UNABLE TO MOVE UNTIL OTHER PERSONNEL ARRIVED APPROX. 1 1/2 HOURS LATER. THEY TRANSPERTED HIM TO E.A. DR SAYS HE HAS A POSSIBLE PINCHED NERVE-IN A LOT OF PAIN.

EE GOT OUT OF TRUCK, TURNED FUNNY & TWISTED BACK

A PIECE OF SHEET METAL FELL FROM CATWALK ON CRANE ABOUT 31/2 FT HIGH. THE CORNER OF THE PIECE OFMETAL STRUCK THROUGH BOOT ON RIGHT FOOT CUTTINGTHE FOOT

EE WAS HELPING REPLACE A SCREEN & FELL OFF CONVEYOR BELT, HITTING RIBS ON EDGE OF LOADER.

EE WORKING ON TRUCK WHEN HOT SAND AND GREASE FELL INTO EYE.

EE WAS LOOKING UNDER PIT TRUCK AND DIRT FELL INTO HIS EYE.

EMPLOYEE WAS MEASURING JAW AND DIRT FELL INTO EYE.

EE WAS REPAIRING CONE WHILE SITTING ON CONVEYOR BELT.

EMPLOYEE WAS REPAIRING JAW CRUSHER AND FELL FROM LADDER HE HAD POSITIONED WRONG.

FOREIGN MATERIAL CAME UP UNDER WELDING HOOD WHILE EE WAS WELDING ON CRUSHER CONE.

EE HAD BEEN GRINDING ON A PIECE OF METAL. HE REMOVED HIS SAFETY GLASSES, WHEN HE FINISHED AND GOT A FOREIGN OBJECT OFF HIS GLOVE IN HIS EYE.

WELDING ON EQUIPMENT AT PLANT.

EMPLOYEE WAS LOOSENING A BOLT ON A JAW CRUSHER WITH A CRESCENT WRENCH AND THE WRENCH SLIPPED HITTING HIM IN THE HEAD.

EMPLOYEE WAS REPLACING ENDS ON BELTING USING A HAMMER AN DMISSED THE BELTING AND HIT HIS WRIST.

EMPLOYEE WAS UNLOADING A DUMP TRUCK LOAD OF SAND - A ROCK BOUNCED OVER THE SIDE OF THE VIBRATOR AND HIT THE COUNTERWEIGHT AND BOUNCED AT THE TRUCK.

EMPLOYEE WAS GRINDING BITS & NOT WEARING HIS SAFETY GLASSES (WHICH WE PROVIDE) AND GOT METAL IN HIS EYE.

EMPLOYEE WAS TRYING TO PRY LOOSE ROCKS & GOT HIS HAND BETWEEN THE BAR & ROCKS

EMPLOYEE'S TRUCK ACCELERATOR STUCK AS HYE WAS COMING UP RAMP TO THE CRUSHER AND HE PUSHED IN THE CLUTCH AND TRIED TO GET IT OUT OF GEAR AND PULLED A MUSCLE IN HIS SHOULDER.

FELL OVER BIT RACK BRUISED HIP

EMPLOYEE WAS PLUGGING IN ELECTRIC HEATER TO A LOADER-THE END TO THE PLUG WAS DIRTY & THIS CAUSED IT TO SHORT & SPIT METAL IN LEFT EYE.

EMPLOYEE WAS WORKING ON A CHUTE ON BACK OF THE SHAKER WHEN HIS FOOT SLIPPED & HE FELL ON HIS HAND TURNING HIS THUMB BACK.

EMPLOYEE WAS POSITIONING HINGED FUEL TANK ON LOOSER & WHEN IT WAS SET DOWN IT LANDED ON HS FOOT

DESCENDING CATWALK, FOOT SLIPPED FELL HITTING ELBOW

CHANGING WHEEL ON LOADER 2 JACKS ONE LET DOWN LOADER FELL ON CRIBBING HAND BETW. LOADER AND JACK

EMPL DID NOT CLEAN CRUSHER CHUTE BEFORE STEPPING ON IT & FOOT SLIPPED ON GRAVEL CAUSING HIM TO LOSE FOOTING & FALL.

EMPLOYEE WAS REPAIRING BROKEN LOADER. PIECE WHEN WIND BLEW METAL SHAVINGS IN HIS EYE.

EMPLOYEE WAS HOLDING A BAR WHILE ANOTHER EMPLOYEE USED A SLEDGE HAMMER TO KNOCK A PIN OUT-EMPLOYEE USING HAMMER MISSED & HIT I,NAME'S ELBOW.

EMPLOYEE WAS DRILLING WITH ROCK DRILL AND BLOWING DUST CAME IN AROUND HIS SAFETY GOGGLES AND INTO HIS EYE.

SHARPENING DRILL BITS GRINDING ROCK BROKE PC OF IT UNDER GLASSES IN R EYE

EMPLOYEE WAS CHECKING ON SHAKER SCREEN CHANGE PROGRESS AND SOMEONE HAD LEFT A CLAMP BAR ON WORK PLATFORMA ND EMPLOYEE USED THIS FOR A HAND RAIL AND FELL.

EMPLOYEE WAS PUTTING HYDRAULIC OIL IN THE LOADER AND DROPPED THE HOOD ON HIS LEG. THE HOOD CUT HIS LEG.