Buscar en el registro

EMPLOYEE WAS PO5ING IN #23 HOUSING & HOT DUST FLEW OUT & HIT HIM ON THE FACE & NECK

EMPLOYEE STATES3THAT THE SHAFT HAD COME OFF THE PURGE AIR DAMPER AND HE WAS TRYING TO ALIGN SHAFT INTO THE BLOCK BY HAND WHEN THE CYLINDER ACTIVATED,CAUSING HIS FINGER TO BE PINCHED.

EE WAS FITTING 6AGS ON THE THIMBLES IN #51 DUST COLLECTOR. A BAG SLIPPED CAUSING HIS THUMB TO STRIKE THE SHARP EDGE OF T HE NEXT THIMBLE.

EMP WAS REPLACI3G ROTOR ON BOTTOM OF CYLINDER FOR BRICKING RING, ROTOR WAS INSIDE THE TWO RING FLANGES WHICH ARE ONLY ABOUT 4-1/2" APART. HE WAS USING SPRING DEPRESSOR TOOL ABOUT 4-3/4" LONG A ND WE D 3 GED IT BETWEEN THE TWO FLANGES AND WAS TRYING TO ALIGN THE HOLE IN THE PIN WITH THE SLOT IN THE ROTOR. THE TOOL SLIPPED AND THE FLANGE SPRANG

ATTEMPTING TO R9MOVE PIECE OF TRAMP IRON FROM COAL BELT ELECTRONIC ACTIVATION CAUSED THE GO SWITCH TO TURN ON & CAUGHT FINGER BETWEEN SWITCH & ACTIVATOR PEG (IMPROPER PROCEDURE TO REMOVE FOREI GN OBJECT ) 3

EMPLOYEE STATES3HE WAS PULLING BUCKET BACK INTO PLACE ON POER WHEELBARROW & STRUCK FINGER ON GAS TANK OR BAC

WHILE PUTTING D9IVE CHAIN ON COOLER HE FELT SHARP PAIN IN SIDE AND CHEST.

EMP WAS INSTALL3NG A HYDRAULIC CYLINDER IN LITTLE CAT LOADER. THE CYLINDER SLIPPPED CAUSING CUT OF FINGER

EMPL POKING CHU3KS THROUGH BACK OF #12 HOPPER.PIRIED UP ON BAR AND GOT HAND CAUGHT BETWEEN BAR AND OVERHEAD PIPE JOINT.

EMPLOYEE WAS BO9ING A BUSHING FOR A PUMP SCREW AND A TRAIL OF SHAVINGS TWISTED AROUND AND CUT HIS FINGER

EE WAS USING 6'3BAR TO REMOVE COATING FROM KILN. CHUNK OF COATING BROKE FREE & EE JUMPED FROM PLANK SCAFFOLD 2' AS COATING STRUCK BAR CASUING HIM TO TWIST AS HE LANDED.

EMPL USING BAR 7O CLOSE SLIDE ON FEEDER.PUT FINGER IN PINCH POINT CUTTING FINGER AND TEARING FINGERNAIL.

EMP WAS LOWERIN1 HOIST CABLE CLAMP CAUGHT IN SAFETY BAR AND HUNG UP CABLE CABLE CAME FREE THE HOOK FELL AND PINCHED FINGER BETWEEN HOOK AND ELEVATOR BUCKET

EMP WAS PUTTING3A PIECE OF PLYWOOD ON DISCHARGE SLIDE. THE PLYWOOD FELL OFF THE SLIDE STRIKING HIS LEFT FOOT

EMPLOYEE CLAIMS3WELDING FLASH CAUSED INJURY WHILE WORKING IN #21 ID FAN.

WHILE SAWING BR3CK BLADE OF SAW BECAME BOUND THROWING BRICK AND CARRIAGE TO REAR OF SAW TABLE EMP HAND WAS ON BACK OF BRICK AND WAS CAUGHT BETWEEN BRICK AND DUST COLLECTOR PICK UP

EMPLOYEE WAS RE5CHING IN TO REMOVE STOCK FROM SMALL MAGAZINE STORAGE BOX. COVER LID CAME FORWARD AND STRUCK HIS HAND. WIND MAY HAVE BEEN A FACTOR.

EE WAS STRIPPIN1 COATING INSIDE KILN USING A PRY BAR. A CHUNK OF COATING CAME DOWN & HIT THE PRY BAR WHILE HE STILL HELD IT. THE ACTION CAUSED HIM TO TWIST HIS BACK.

EE WAS ASSISTNG3RE BRICKING A KILN. HE STEPPED ON AN UNEVEN SURFACE & TWISTED HIS ANKLE.

EMPLOYEE WAS AS8ISTING ADJUSTMENT OF CLUTCH ON 10 RAW MILL. ANOTHER EMPLOYEE TURNED THE ADJUSTMENT BLOCK AND UNIT TURNED FREELY CATCHING INJURED S FINGER BETWEEN THE BLOCK AND THE ADJUSTING NU T ADJUSTMENT BL2CKS ARE NORMALLY TURNED USING CHAINFALL DUE TO SIZE AND TIGHTNESS. THIS OCCASION, UNIT TURNED FREE AND WAS A SURPRISE.

EMPL ASSISTING REMOVAL OF OLD CONVEYOR BELTING FROM ROOF AREA.HE GOT HIS HAND BETWEEN BELTING AND ROOF RAILING AS CRANE LIFTED BELTING CLEAR.

OPERATING PAYLOADER DOING GROUND CLEANUP AROUND KILN DEPT.THE BUCKET ON THE PAYLOADER STRUCK A CONCRETE SLAB AND EMPL WAS THROWN SLIGHTLY FORWARD.STRUCK HEAD AGAINST THE IN-CAB RADIO BRACKET.

EMPL ASSISTING REPAIR OF COUPLER ON BRADLEY MILL.WHEN JOB OB REMOVAL WAS OVER,HYDRAULIC JACK WAS PLACED NEARBY ON UNUSED MILL FOUNDATION ON ITS SIDE.THE JACK ROLLED OFF AND STRUCK EMPL ON FOOT BEHIND THE STEEL TOE OF HIS SAFETY WORK BOOT.

EMP WAS GRINDING WELDMENT OFF CUSHER CONCAVES HE SHIFTED HIS POSITION KAND HIS PORTABLE HAND GRINDER STRUCK HIS KNEE

EMP WAS ASSISTING THE INSTALLATION OF SCAFFOLDING INSIDE #23 KILN COAL TANK HE WALKED ONTO THE AAS WORKING FROM AN ALUMINUM PLATFORM BOARD 4\ X 20\ BEFORE RETAINING CLIPS HAD BEEN INSTALLED H E INDECATES HE WAS PS POSITIONING A WOOD STRINGER WHICH WOULD FORM PART OF MAIN WORKING SCAFFOLD. ALUMINUM PLATFORM TITLTED SIDEWAYS AND HE FELL DOWN WITH IT FALL EST

EMPLOYEE WAS CLEANING OUT #19 KILN BOILER HOPPER. HOT DUST FLUSHED AND GOT ON HIS ARMS AND NECK.

EMP WAS TIGHTENING A PIPE CONNECTION ON A TURBINE OVERHAUL HIS WRENCH SLIPPED ACCAUSING FINGER TO BE PINCHED BETWEEN THE WRENCH AND A STEAM HEADER

EMPL PUTTING BOLT IN HOUSING AND BACK OF HAND NICKED EDGE OF HOUSING.

PACKING BAGS OF CEMENT.CATCHING BAG OF CEMENT AS IT FELL OFF DELIVERY CHUTE.

EMPLOYEE WAS REMOVING A EUCLID DRIVELINE WHEN THE WEIGHT OF THE DRIVELINE CAUSED IT TO PIVOT UPWARD AND CRUSH HIS FINGER AGAINST THE FRAME OF THE TRUCK. (HE WAS ATTEMPTING TO CONTROL A HEAVY O BJECT WITH MUSCLE POWER ALONE.)

PUTTING A DUST COLLECTOR BAG IN PLACE. THE CLAMP SPRING CAME OUT OF THE CLAMP HANDLE, FLEW BACK, CAUGHT RIGHT INDEX FINGERNAIL.

INJ CLIMBED TO TOP OF ELEVATOR TO ATTACH CHAIN,SLIPPED & FELL ABOUT 5\ AND STRUCK A BEAM.

EMPLOYEE WAS CRAWLING UNDER THE DAMPER OF #19 KILN COOLER AND STRUCK HIS KNEE AGAINST THE DAMPER. LAST DAY WORKED WAS 4-19-85 AND SAW DOCTOR ON 4-22-85.

PACKING CEMENT ON PACKING MACHINE. BAG BROKE CEMENT DUST ENTERED LEFT EYE

TIGHTENING A CAP ON #2 KILN HOOD DRAFT LINE. PHYSICAL FORCE USED WHEN PUSHING ON CAP ROD LATER CAUSED PAIN IN LEFT HAND AND SWELLING OF LEFT WRIST.

EMPLOYEE WAS INSIDE THE RUBBER-TIRE DOZER AND ATTEMPTED TO CLOSE THE DOOR. DOOR CLOSED AND CAUGHT HIS THUMB BETWEEN THE DOOR AND THE FRAME.

WALKING THRU MACHINE SHOP GOING TO GRINDER STEPED ON SMALL PC OF ANGLE IRON STANDING UPRIGHT WHICH FLEW UP MAN JUMPED AND LANDED ON RT FOOT FIRST TWISTING LEFT ANKLE TRYING TO RETAIN BALANCE

UNLOADING COAL RAILROAD CARS USING A SLEDGE HAMMER TO OPEN DOOR HIT RIGHT HAND AGAINST SIDE OF CAR WITH SLEDGE HAMMER

PULLING CHAIN BLOCK ON OVERHEAD TROLLEY THROUGH STORE ROOM. CHAIN CAUGHT A PIECE OF 1/4"X4"X10\ LONG PIECE OF STAINLESS STEEL WHICH WAS IMPROPERLY PLACED ON TOP OF STORAGE BIN, CAUSING TI TO F ALL AND TO STRIKE INJURED\S NOSE.

BAG OF CEMENT BURST IN INJURED\XS FACE.

HELPING TO INSTALL NEW LINERS ON INSPECTION DOOR. INJURED WAS HOLDING LINERS IN PLACE, WITH BOTH ELBOWS RESTING FOR SUPPORT ON A STEEL BENCH. A CO-WORKER BOLTED THE LINERS IN PLACE. THE SAM E EVENING, IMJURED EMPLOYEE FELT PAIN AND SWELLING IN LEFT ELBOW.

EMPLOYEE WAS REMOVING A USED GASKET FROM AN ENFINE HEAD WHEN HIS HAND SLIPPED AND WAS CUT ON A SHARP EDGE

EMPLOYEE WAS ASSISTING REMOVAL FF AN ELECTRIC MOTOR AT #62 FAN HOUSE HE SIGNALED CRANE OPERATOR TO RAISE LOAD AND THE BLOCK OF THE CRANE BUMPED A SHEET METAL DUST COVER OVERHEAD DUST COVER FE LL AND HIT EMPLOYEE ON HIS HARD HAT JARRING HIS HEAD AND NECK

PACKING ON 1 PALLETIZING BELT. INJURED REACHED ACROSS POWER CURVE BELT TO RETRIEVE HIS GLOVES, LOST HIS BALANCE, THEN FELL ACROSS THE BELT AND INJURED LEFT SIDE OF CHEST.

EMPLOYEE WAS WALKING UNDER FINISH GRIND MILL OPERATING DECK AND STRUCK FOREHEAD ON UNDER-SUPPORT BEAM.

WORKING IN KILN NO.2 COOLER - INSPECTING GRATES. INJURED BEGAN CLIMBING ON INCLINE, SLIPPED, AND BRUISED LEFT KNEE.

EMPLOYEE WAS ASSISTING PLACING AN ACETYLENE CYLINDER INTO A CART RACK.OTHER EMPLOYEE LET HIS END GO.INJURED CAUGHT HIS FINGER BETWEEN THE CYLINDER AND THE CART RACK.

WORKING ON 3 SCREW AT BAGHOUSE. WALKED TOWARD TOOL BOX, SLIPPED ON BAG DUST MUD.

OPERATING A CRUSHER, ATTEMPTING TO LOOSEN STUCK STONE. USING A SLEDGE HAMMER TO RELEASE A STONE WHICH WAS STUCK IN THE CRUSHER. A PIECE OF STONE MOVED, CAUGHT INJURED\S LEFT RING FINGER BETWEE N IT AND SIDE OF CRUSHER.

PULLING DOWN A ROW OF OLD BRICK IN KILN #2. INJURED STATED A BRICK STRUCK HIS RIGHT WRIST.