Buscar en el registro

Cleaning out plugged impactor his finger wedged between rock, frame and tailpulley.

(MSHA Report of Investigation: Loading a steel plate (5' wide x 10' long x 3/4" thick; approx. 1,500 lbs.) onto flatbed truck using chain attached to front-end loader. The victim was on bed of the truck steadying & guiding plate onto the truck when the hook (no safety latch) became detached from the plate, and the victim & plate fell to the ground. Plate crushed victim.)

EE WAS LIFTING HOOD ON LOADER TO CHANGE OIL AND STRAINED BACK.

THE EMPLOYEE WAS LIFTING CURTAIN LINERS ON K440 AND STRAINED GROIN.

EMPLOYEES WERE UNLOADING A WATER TANK USING A FRONT END LOADER TO LIFT THE TANK, THE EQUIPMENT OPERATOR SET THE TANK ON THE EMPLOYEE'S FOOT.

EMPLOYEE WAS SCRAPING WITH THE SHOVEL BY THE CONVEYOR WHEN HE TURNED ABRUPTLY AND FELT A SHARP PAIN IN HIS LOWER BACK.

TURNING OFF STOCK PILE HIT THE END OF BERM JARRING EE SIDE TO SIDE SORE AND TIGHT BODY HIS HEAL WOULD NOT TOUCH FLOOR.

EE'S FOOTING SLIPPED ON WET SURFACE, SLIPPED AND FALL.

FOREARM STRAIN FROM CHIPPING STONE.

LIFTING SCREENS INSIDE OF PLANT.

EMPLOYEE WAS CHANGING FLASHING ON CONVEYER IN A CRAMPED AREA AND STRAINED LOWER BACK.

EE STRUCK HAND WITH HAMMER WITH BREAKING STONE.

WHILE CLOSING HOOD ON THE IMPACTOR, EE S THUMB WAS IN A PINCH POINT WHEN THE HOOD CLOSED.

NOT AVAILABLE.

PINCHING IN LOWER BACK AFTER USING HYDRAULIC SPLITTER.

WHILE CHISELING ON BLOCK, FELT PAIN IN L. ARM.

HAMMERING W/MALL & DRIVING IN PIT.

SUNBURN FROM WORKING OUTSIDE.

LIFTING STONE AT WORK STATION AND STACKING.

GAS BUILDUP IN SCALE PIT- EXPLOSION- THAWING OUT SCALE.

EE WALKED OUT OF TOOL TRAILER. HE GOT HIS SLEEVE CAUGHT ON RAILINGS. THIS CAUSED HIM TO LOOSE HIS BALANCE AND SLIP DOWN THE STEPS. HIS SLEEVE WAS STILL CAUGHT ON THE RAIL TEARING HIS ROTATOR C UFF.

EE REMOVED GUARDS TO CLEAN OUT AROUND PULLEY. EE DID NOT LOCK OUT PIECE OF EQUIPMENT AND GOT ARM CAUGHT BY PULLEY. EE BROKE LEFT ARM.

ROCK FLEW OUT OF CRUSHER STRUCK EE IN FACE. REQUIRED STITCHES & A CROWN ON TOOTH

EMPLOYEE WAS CRAWLING FROM UNDER BREAKER & THOUGHT HE HAD CLEARED THE EQUIPMENT WHEN HE STOOD UP HE SHARPLY STRUCK HIS BACK ON STEEL CROSS MEMBER EMPLOYEE HAS A CONTUSION TO HIS LOWER BACK POS SIBLE CHIP OF VERTEBRAE

CREW WAS SETTING UP CRUSHING PLANT MAGNET WAS HANGING FROM A LOADER BUCKET & THE CHAIN TIGHTENED CAUSING THE MAGNET TO SWING & HIT EMPLOYEE IN CHEST

EE CLIMBED UPON CONVEYOR TO HOOK ON A CHAIN SO THAT IT COULD BE MOVED SLIGHTLY FROM ITS POSTION IN RELATION TO THE CRUSHING PLANT. MOVEMENT JARRED ON/OFF ARM ON CONVEYOR AND STARTED CONVEYOR. EE FELL FROM CONVEYOR.

EMPLOYEE CLIMBED ONTO 8-10 FT. ELEVATED HORIZONTAL CONVEYOR TO MAKE A CONNECTION. EMPLOYEE LOST BALANCE AND FELL TO GROUND.

EMPLOYEE WAS IN A TOOL TRAILER AT SITE AND STUMBLED ON AN OBJECT CAUSING EMPLOYEE TO FALL FORWARD AND HIT SHOULDER ON A STEEL DRUM.