Buscar en el registro

THIS ACCIDENT OCCURRED AS THE LABORER WAS ASSISTING OTHER PERSONS TO TIGHTEN AND ADJUST THE CONVEYOR BELT IN THE AREA OF THE HEAD PULLEY. AS HE WAS PUTTING PRESSURE ON THE BELT FOR SOME UNDETERMINED REASON HE SPRAINED HIS LEFT WRIST.

EMPLOYEE WAS WALKING AROUND THE CONVEYER AND SLIPPED 0N THE ICE. HE THEN FELL AGAINST THE TIRE OF THE CONVEYER AND BROKE HIS UPPER LEFT ARM.

Employee was lifting an electric motor with a come-along from the screen deck. When the motor got loose it swung and pinched his hand between the motor and a safety railing.

Employee was getting out of the jaw crusher after doing repairs. He bumped his left leg (shin) on a piece of steel. He thought he was OK, but after a few days his leg swelled, so on 9/27/2007 he went to the hospital to have it checked. He was treated and released.

EE was attempting to remove the back door of the jaw crusher & when he pulled out the bolts, the door fell onto his right hand & pinched it between door & angle iron. Went to hospital and was treated & released for bruised right hand.

Employee was attempting to loosen a nut on the jaw crusher. When the nut broke loose, the 17/8 inch wrench fell out of his hand and struck his head above his left eye, which caused a small cut above his eye which required a few stitches.

EE was attempting to get down from the generator trailed by using a ladder. When he put his foot on the top rung, the ladder kicked out from under him. He fell approx 5' to the ground and landed on his right side.

The loader operator was backing off the crusher ramp when the engine stalled and the brakes failed. The loader continued in reverse until it struck the stone berm. At that time the loader rolled over onto its side. The operator then crawled out of the cab onto the ground.

Employee was assisting the mechanic in repairing the loader. He was attempting to tighten a nut and when the wrench slipped off the nut he lost his footing and fell from the front fender to the ground and landed on top of a come-along tool.

Employee was checking the continuity on the 1-B conveyer switch and for an undetermined reason caused a flash back which caused burns to both hands and face, the employee did not get an electrical shaock.

EE IS A LOADER OPERATOR AND OVER A PERIOD OF 25 YEARS HE HAS BEEN DIAGNOSED WITH SPLIT EXTENSOR TENDONITIS OF THE RIGHT THUMB AND IS ALSO HAVING PROBLEMS WITH HIS LEFT THUMB DUE TO REPETIVE MOTION WHEN OPERATING THE BUCKET ON THE LOADER. EMPLOYEE WILL BE OPERATIED ON 2/22/05. THE REASON FOR THE DELAY OF THIS REPORT IS DUE TO THE UNKNOWN EXACT DATE OF INJURY.

Employee was operating a water truck on the quarry ramp and stated he lost his brakes and could not stop the truck. To stop the truck he ran into a large rock near the bottom of the ramp. Due to extensive damage, it was difficult to determine if the brakes were faulty.

EE WAS CHECKING THE WATER LEVEL ON A MICHIGAN 175C WHEEL LOADER DUE TO THE FACT THE RADIATOR WAS OVERHEATING. WHEN THE EE LOOSENED THE RADIATOR CAP HE GOT SPRAYED WITH STEAM AND BOILING WATER ON HIS RIGHT ARM & HAND AND RIGHT TRUNK BODY AREA WHICH CAUSED 1ST & 2ND DEGREE BURNS.

EMPLOYEE WAS ASSISTING ANOTHER EMPLOYTEE WELDING ON A PIECE OF EQUIPMENT (LOADER). AS HE WAS TRYYING TO KNOCK OFF THE WELDING SLAG, A PIECE OF SLAG OR METAL WENT INTO HIS LEFT EYE. HE WAS WEAR ING EYE PROTECTION WHEN THIS INCIDENT OCCURRED. HE WENT TO AN OPHTHAMOLOGIST FOR TREATMENT. HE WAS TREATED AND RELEASED.

EE WAS SITTING IN BED OF PICKUP TRUCK HOLDING DOWN A DRUM OF OIL. THE OPERATOR OF THE PICKUP RAN OVER A POTHOLE IT CAUSED THE EE TO COME UP AOFF THE FLOOR OF THE REAR BED AND LAND BACK DOWN ONTO HIS BUTTOCKS(COCCYX BONE) WHICH GAVE HIM SOME PAIN THROUGHOUT THE DAY. THE NEXT DAY EE TOOKHIMSELF TO HOSPITAL FOR TREATMENT. HE WAS RELEASED WITH NO RESTRICIONS.

A LOADER OPERATOR, AFTER LOADING A 10-WHEELER DUMP TRUCK, ASSISTED THE DUMP TRUCK DRIVER IN FREEING A STONE WHICH WAS JAMMED BETWEEN THE BED OF THE TRUCK & THE TAIL GATE. AFTER FREEING THE STO NE, THE TAIL GATE PINCHED THE LOADER OPERATOR'S RIGHT MIDDLE FINGER. NO SUTURES WERE REQUIRED. THE HOSPITAL GAVE HIM SOME LIGHT PAIN MEDICATION.

EE WAS REPAIRING A 20 FT VIBRATING FEEDER (WHICH WAS TAGGED OUT & LOCKED OUT FOR SERVICE) & WHILE PULLING ON THE DRIVE BELT WITH HIS RIGHT HAND HIS LEFT HAND POINTING FINGER GOT PINCHED BETWEE N THE DRIVE PULLEY & THE BELT.

EMPLOYEE WAS LIFTING A SEAT TO INSTALL IT ONTO THE 175C MICHIGAN LOADER AND STRAINED HIS LEFT SHOULDER.

EE WAS BACKING THE LOADER OUT FROM THE MODIFIED STONE PILE WHEN THE STEERING WHEEL SPUN AROUND AND JAMMED HIS LT. ARM BACK CAUSING INJURY AND PAIN TO HIS LT. SHOULDER.

WAS WORKING ON TOP OF CRUSHER AND WAS BENDING OVER RAIL TO PULL A BUCKET OF TOOL UP WITH A ROPE AS HE WAS PULLING THE ROPE HE STRAINED HIS BACK WHICH HE HAD ALBREADY INJURED FROM A PREVIOUS IN JURY AT ANOTHER PREIVOUS EE . EE CAME BACK TO WORK ON 2-28-02 BUT WENT TO HOSPTIAL ON 3-5-02 FOR TREATMENT. WAS OFF SIDE 3- & 5-02.

EE WAS STEPPING DOWN OFF OF THE EUCLID DUMP TRUCK AFTER CHECKING THE ANTI FREEZE LEVEL IN THE ENGINE. HE STEPPED ONTO THE BUMPER AND THEN ONTO THE STEP AND LOST HIS FOOTING AND FELL ONTO THE G ROUND. HE STATED THAT HE WAS HAVING PROBLEMS WITH HIS KNEE AND IT WAS POSSIBLE HIS KNEE GAVE OUT.

WHILE SHOVELING STONE THE EE SUSTAINED A STRAIN TO HIS GROIN AREA.

EE WAS INSTALLING A NEW ELECTRIC MOTOR ON A CRUSHING PLANT WHEN THE OTHER PERSON EE. WHO WAS HELPING HIM HOLD THE HEAVY MOTOR LOST HIS GRIP AND THE MOTOR FELL ONTO EE S LEFT RING FINGER AND CU T SAME REQUIIRNG STITCHES.

HE WAS COMING OUT OF THE HOLE AND THE CENTRALIZER GOT STUCK ON THE DIRLL STEEL AND RAISED WITH IT. THE OPERATOR SAW THE CENTRALIZER GOING UP WITH THE STEEL BUT FORGOT ABOUT IT AND PLACED HIS HAND ON THE BIT. THE DRILL STEEL BROKE LOOSE AND FELL DOWN HITTING HIS TWO FINGERS ON THE BIT AND CUT THE TIPS OFF THEM OFF.

STARTING HAMMER AT JAW CRUSHER GETTING READY TO RUN ROCK A PIECE OF STONE FLEW OUT HITTING HIM IN THE RIGHT EYE.

HELPING MECHANICS WITH SETTING A PINION GEAR IN REAR OF A PIECE OF EQUIPMENT WHEN A PIECE OF SHEET METAL (STEEL PLATE) THEY WERE USING FOR MEASURING PURPOSES SLIPPED AND FELL ON HIS FOOT.

HE WAS GREASING BROOM TRUCK SMALL STREET SWEEPER WHEN HE FELL BACKWARD.

WHEN GETTING INTO TRUCK HE LOST HIS FOOTING, SLIPPED AND FELL TRYING TO STOP HIMSELF WITH RIGHT ARM.

LOW BACK STRAIN FROM DRIVING QUARRY TRUCK DUE TO SEAT.

ROCKS BECAME JAMMED IN CRUSHER. CRUSHER SHUT DOWN. FOUR MEN WERE WORKING TO LOOSEN THE ROCKS, SEVERAL PIECES FLEW OUT AFTER BECOMING DISLODGED, ONE STRIKING EMPLOYEE ON END OF HIS FINGER. WAS WEARING GLOVES.

WORKING WITH OTHERR MEN TRYING TO UNJAM CRUSHER. WHEN ROCKS WERE LOOSENED, SOME PIECES FLEW OUT ONE OF WHICH LANDED ON HIS HAND.

WORKING AT CRUSHER, TRYING TO UNJAM THE JAW, USING A STEEL PRY BAR TOLOOSEN A PIECE OF ROCK, BAR CAME BACK HITTING HIS CHIN.

PERFORMING MAINTENANCE ON CONVEYOR BELT, SHUT FELL HITTING LOWER LEG (CALF AREA).

EMPLOYEE WAS AT OUR HARLEYSVILLE PLANT, USING THE BROOM SWEEPER (ROAD SWEEPER) AND WAS RETURNING TO TELFORD TO CLOCK OUT, WHEN HE WAS REAR ENDED IN A TRAFFIC ACCIDENT, IN HIS OWN VEHICLE.

WORKING WITH HAND GRINDER ON PIECE OF STEEL FOR NEW CRUSHER,PULLED GRINDER BACK,CAUSING LACERATION TO LEG.

WORKING FROM A PLATFORM ON A H-REACH CRANE,CHANGING BELTS ON CONVEYOR,EMPLOYEE STRAINED HIS ABCK.NO OTHER INJURY.NO UNSAFE CONDITIONS.EMPLOYEE BACK TO WORK MON FEB 15,1988.

WHILE SHOVELING STONE, A PIECE OF DIRT FLEW UP UNDER SAFETY GLASSES, WENT INTO HIS RIGHT EYE.

CARRYING A STEEL BEAM, WHICH WAS BEING PUT AT BASE OF PLANT. HE LOST HIS BALANCE AND THE BEAM HE WAS HOLDIGN HIS ANOTHER BEAM WHICH WAS STANDING UPRIGHT, JAMMING HIS FINGER.

WORKING ON JAW OF CRUSHER, SHUT DOWN FOR MAINTENANCE, USING A SLEDGE HAMMER TO BREAK GEARS FREE. MAN ABOVE NEEDED SLEDGE, WHICH WAS PASSED TO HIM. IT SLIPPED FROM HIS GLOVED HANDS, FELL HITTIN G HIM ON SIDE OF HIS HEAD. HE WS WEARING A HARD HAT. HE RECEIVED A LACERATION TO HEAD FROM HAT PUSHING DOWN- NO OTHER INJURY.

NON INJURY EMPL2YEE WAS HIRED AS A LABORER LATER BECAME A MECHANIC HE USES HIS HANDS CONTINUALLY USING A WIDE RANGE OF TOOLS ETC HE HAS BEEN DIAGNOSED AS HAVING BILAT (BOTH HANDS) CARPAL TUNNE L SYNDROME A CO1Y OF DOC.LETTER IS ATTACHED

DRIVING UKE IN 0UARRY, LOADED WITH STONE, COMING UP INCLINE ROAD OUT OF QUARRY, FRONT WHEELS SHIFTED SLIGHTLY CAUSING TEMPORARY LOSS OF STEERING, MAN JUMPED FROM TRUCK, LANDING HARD ON LEFT LE G (HE PANICKED)1 FRACTURE OF FIBULA (SMALL BONE OF LOWER LEG) NEAR CALF AREA.

UTILITY MAN PUT7ING OIL IN TRUCK, SLIPPED OFF THE STEERING BAR HE WAS STANDING ON, GRABBED FOR GROOVED STEPS, CAUGHT RING (LEFT RING FINGER) ON STEP, PARTIALLY AMPUTATED FINGER WHICH WAS SURGI CALLY RE-ATTACH9D.

THE MAN SLIPPED ON THE ICE IN THE YARD AREA AND BROKE HIS RIGHT LEG NEAR THE ANKLE

THE TOGGLE PLATE WAS BEING LIFTED OUT OF CRUSHER WHEN IT CAUGHT ON SIDE OF CRUSHER. IT CAME FREE CAUSING CHAIN IT WAS BEING LIFTED BY TO GO SLACK COMING UNHOOKED AND THE PLATE FELL TO THE CATW ALK STRIKING THE MAN ON HIS LEFT ARM CAUSING BRUISES.

HE WAS HIT IN THE HEAD BY FALLING OBJECT, RECEIVING A LACERATION ON THE HEAD