Buscar en el registro

EE was operating a 980 FEL when pain was felt in the lower back.

Employee states they were hand scaling and went to swing the hand bar at a rock when the bar slipped out of their hand and caught the right pinky finger between the hand bar and the top rail of the manlift basket. The pinky finger suffered a fracture.

Employee was seated power washing, stood up and felt pain in their right knee.

Employee stated that while changing liners, a rock fell from a ledge, bounced off something, and struck EE in the mouth, breaking a tooth.

Employee stated that EE was dismounting the machine, missed the step and fell.

Technician was removing a transmission plate from under a 980G loader when the plate fell on EE's left arm causing a fracture. The plate was held by one bolt which bent/broke causing the plate to fall.

Employee stated was dismounting the haul truck, as EE approached the ladder on the front bumper EE fell to the ground EE lost balance and fell.

Employee stated was lifting bags of ANFO and felt a strain in the left shoulder. Went to the doctor on 6/14/2019 and was referred to physical therapy. Was first aid until then.

Employee stated was standing along a conveyor while it was being started when a rock came off the conveyor and struck them on the hardhat.

Technician was installing a suspension cylinder on a 773 Off Road truck. While attempting to push the rigged cylinder in to place technician felt a pinch and pain in lower back.

Employee stated ee was helping splicing a belt and pinched finger in the belt clamp

The employee stated that when stacking bolts on the roof bolter the employee cut arm on a band.

The employee stepped off the back of a truck and rolled EE's left ankle.

Employee stated that while loading a shot at the face, a hole above the employee ignited causing sand to fall on employee's back.

Employee stated that while loading a shot at the face, a shot tube hooked on the lift basket, stretched, broke, and initiated the hole.

Employee stated was scaling the highwall, pulled down a piece of rock, the rock struck the bottom of the man-lift basket, but the bar was still stuck in behind the rock which caused EE to strike ribs on the man-lift railing.

Employee stated was lifting steel plate into place with chain hoist, tied the plate off to re-hook, released the chain hoist, and the chain slipped causing the chain hook to strike the employee on the cheek.

The employee cut the bolts that were holding the shaft in place, when trying to loosen it, the shaft broke free and smashed his finger.

The employee was working in the hopper when a welding lead and stinger fell from above, striking him on the head, neck and shoulders.

Employee walked onto catwalk and hit his knee on mid rail.

The employee was adjusting the seat forward and struck her left knee on the dash.

Employee was tightening a bolt on a hose clamp and felt something pop in his shoulder

Employee was using a hand held hammer to drive a 3/4" bolt, missed the mark and struck his left thumb with the hammer. He refused medical treatment until 3/4/11 at which time x-rays revealed a fracture of the IA joint.

Employee was lying on his stomach checking the oil on a 8x20 shaker and when completed he went to sit up and felt a "charlie horse" in his low back.

Employee was using a power washer to clean the scale, when debris went underneath the safety glasses and into his left eye.

Cumulative effect of climbing up and down ladder.

Employee was working on a Pantera 900 drill and he was removing a cover off of the side of the boom, when he bent to set it down he felt a sharp pain in his low back.

Employee was driving the water truck using the steering wheel knob and felt a pop in his left ring finger. Became reportable 5/25/10 when physician injected his finger.

Employee was walking back to the tower to start the plant up when he caught the toe of his boot on a frozed dirt clod, he tripped, stumbled and twisted his right knee.

Driving a scraper from the landfill , the back of the scraper started to swing around, the employee hit a dry spot and it turned over on its side. Laceration on right hand requiring 6 stitches, possible metacarpal fracture.

EE was working in the crusher tower repairing the hammer mill. He handed another employee some tools and turned around and struck his upper front tooth on the lid of the mill. His front tooth was chipped toward the midline.

While driving an end dump truck, truck hit rough area in road, reports seat, bottomed out, causing neck pain with radiculopathy to right arm.

EE was aligning holes for bolts in a slide bed on a seperator bypass conveyor. While fitting steel plate EE struck left thumb with sledge hammer.

While climbing ladder, EE slipped and fell to ground from about 7', hurting his left hand.

While changing screens in bin house, stepped back to put screen in place and stepped in hole, left leg hit against grate and cut leg.

EE alleges hitting his elbow on the support post in the loader he was operating

EE was climbing back onto 980-G loader, when he slipped and strained his back.

EE reported he slipped and fell on ice while carrying a metal bar. Bar hit EE in the mouth

EE states dust blew in eye when he went outside to give driver paperwork.

EE reported he slipped and fell on ice, under Bin House #1, injuring his right shoulder.

EE states he was working on a truck removing a flywheel. He does not know how he got some metal in his eye.

EE reported to have injury at work after working all weekend at his 2nd job. EE admitted to working at his shop 8-10 hrs barbequing on concrete at pumpkin patch. Minor lifting of pumpkins from bed of truck resulted in strain. Questionable as being work related.

EE reported he lost grip to ladder while descending down to bottom of bin area. After losing grip from ladder he slid down the ladder falling against bottom of bin and hitting his right ankle.

EE reported while using an impact gun to tighten nuts he felt a pain in his left arm below the elbow

EE states he was kneeling all day working on equipment when he noticed his left knee was bothering him.

EE alleges left arm & shoulder was hurting when he is operating the Mechanical Scaler.

EE alleges to have injured left ankle & right knee while performing maintenance on slide chute.

EE ALLEGES TO HAVE CUT HIS LEFT LONG FINGER, WHILE USING A PRY BAR.

EE alleges cervical strain from operating scaling machine.