Buscar en el registro

EMPLOYEE WAS TIGHTENING A BOLT AT THE CRUSHER, HE WAS WEARING LEATHER GLOVES (PPE) WRENCH SLIPPED, HIS HAND SLIPPED HITTING A PIECE OF METAL, WENT THROUGH THE GLOVE CUTTING 4TH FINGER ON RIGHT HAND.

EMPLOYEE WAS USING A WRENCH TO TIGHTEN A BOLT, WRENCH SLIPPED CUTTING INSIDE OF THE HAND.

EMPLOYEE WAS PLACING A JACKING PLATE FOR THE CRUSHER SCREEN BOX UNDER THE JACK. HE BENT OVER AND TURNED TO THE LEFT, THEN PICKED UP THE PLATE TO SCOOT IT UNDER THE JACK. HE FELT A SHARP PAIN IN HIS LOWER BACK AND DECIDED TO GO SEE A DOCTOR THE NEXT DAY.

OPERATOR WAS ROLLING COUNTER WEIGHTS ON WASHPLANT FINGERS WERE PINCHED IN BETWEEN WEIGHTS CAUSING A CUT ON LEFT LITTLE FINGER REQURING STITCHES (5 STITCHES)

EE WAS ASSISTING ANOTHER EE IN REMOVING THE SECTION SIDE LINE FROM A LARGE PUMP, USING A CHISEL TO SEPARATE TWO PIECES OF METAL, MOMENTARILY RELEASED HIS GRIP ON THE CHISEL AS OTHER EE STRUCK CHISEL, PINCHING LT. HAND LITTLE FINGER.

EE WAS DUMPING HIS END DUMP TRUCK AT THE PIT. WHILE THE BOX WAS IN THE AIR HE BEGAN TO MOVE FORWARD TO DUMP. HIS LEFT SIDE REAR WHEELS SLIPPED INTO A HOLE OR SOFT SPOT. THE BOX SWAYED TO THE L EFT AND THE WHOLE TRUCK TIPPED OVER ONTO IT'S LEFT SIDE. EE'S HEAD HIT THE TOP OF THE DOOR JAM. THIS CUT HIS LEFT EAR AND HE HAS SORENESS IN HIS NECK AND BETWEEN HIS SHOULDERS.

WORKER WAS OPERATING AN ACETYLENE TORCH, AND WAS CUTTING OFF RUSTY BOLTS, WHEN A PIECE OF HOT SLAG SPLASHED OFF THE BOLT AND LANDED IN HIS RIGHT EAR AND INTO THE EAR CANA, CAUSING A BURN TO TH E EAR CANAL.

PRIMING THE WATER PUMP FOR THE CRUSHER DUST ABATEMENT APPRATUS. EMPLOYEE LIFTED A FIVE GALLON BUCKE TOF WATER AND POURED IT INTO THE PUMP. HE BENT OVER AND REPLACED THE PLUG AND WHEN HE STOO D UP HE FELT A SHARP PAIN IN HIS LOWER BACK. HE KEPT WORKING, RUNNING LOADER, FOR FOUR HOURS AND THEN SAID HE WANTED TO SEE A DR.

EE WAS MAKING REPAIRS TO THE DREDGE IN THE ENGINE HOUSE. AFTER REMOVING THE BELT PULLY GUARD IT WAS PLACED IN THE ONLY LOCATION AVAILABLE. THIS LOCATION IS ABOUT FOREHEAD HIGH AND EE DID NOT F LAG ITS PROTURDING SECTION. WHILE MAKING REPAIR EE STEPPED INTO THE EDGE OF THE GUARD HITTING HIS FOREHEAD JUST ABOVE THE BRIDGE OF HIS NOSE. THIS CAUSED A SMALL BUT DEEP ENOUGH CUT THAT HE W

WORKER WAS CLIMBING UP A LADDER ON A LOADER, SLIPPED STRIKING RIGHT ELBOW ON LADDER.

EE IS A DREDGE OPERATOR. EE WAS ATTEMPTING TO STEP OFF OF THE SHORE ONTO A METAL DREDGE WORKBOAT. IT HAD BEEN RAINING, SNOWING & SLUSH HAD BUILT UP ON THE DECK OF THE BOAT. AS EE STEPPED ONTO THE DECK HE LOST HIS FOOTING AND FELL ONTO HIS BACK.

THE CRUSHER SHUT DOWN AND HE TURNED OFF THE MAIN SWITCH AND LOCKED OUT THE MAIN POWER. WHILE PERFORMING MAINTENANCE ON THE CONVEYOR PULLEYS, AN ELECTRICAL STORM PASSED THROUGH THE AREA. HE WAS HOLDING UP A GUARD PLATE, READY TO GREASE THE TAIL PULLEY, WHEN LIGHTENING HIT THE UNIT HE WAS WORKING ON. A BOLT OF POWER ARCHED FROM THE PLATE TO THE GROUND, CAUSING HIS MUSCLES TO CONSTRIC

EE WAS INSPECTING THE BLOW BARS FOR WEAR ON THE HSI CRUSHER THAT MORNING. HE WAS REACHING THROUGH THE INSPECTION PLATE HOLE ACCESS AND ROTATING THE ROLLER. WITH HIS RIGHT ARM FULLY EXTENDED AN D PULLING THE ROLLER FROM RIGHT TO LEFT, HE FELTADN HEARD A POPPING NOISE IN HIS RIGHT SHOULDER. THE PAIN WOULD NOT GO AWAY AND DECIDED TO SEE A DR. BY THAT AFTERNOON.

WORKER, WAS USING A SHOVEL TO CLEAN OFF A WALKWAY AROUND A CONE CRUSHER. WORKER TURNED WRONG AND STRAINED HIS LOWER BACK.

EE WAS REMOVING THE PROTECTIVE COVER FROM A BELTPUNCH WITH A UTILITY KNIFE. HE WAS HOLDING THE PUNCH IN HIS LEFT HAND AND CUTTING WITH HIS RIGHTHAND. THE KNIFE BLADE SLIPPED OFF AND CUT INTO HIS LEFT INDEX FINGER.

EMPLOYEE WAS TIGHTENING BOLTS WITH A WRENCH ON THE LOG WASHER (AT THE WASH PLANT). HE PULLED A MUSCLE IN HIS BACK BECAUSE OF HAVING TO TWIST HIS BODY IN AN AWKWARD POSITION TO REACH THE BOLTS. HE DID NOT SEE A DR. UNTIL 10-8-97 AT HIS OWN REQUEST. AT THAT TIME THE DR. PUT EMPLOYEE ON RESTRICTED WORK ACTIVITY FOR 21 DAYS.

EE WAS CLIMBING ONTO A HORIZONTAL SHAFT IMPACTOR AT THE GRAY AND FELL ABOUT 3 1/2-4' BREAKING A PIECE OF HOME OUT OF THE ELBOW OF HIS RIGHT ARM.

ON 3-10-97 T 10:00AM EE COMPLAINED ABOUT A PROBLEM OF TINGLING & NUMBNESS IN HIS RIGHT HAND & WRIST. HE SUSPECTS THAT HE MAY HAVE CARPEL TUNNEL SYNDROME FROM WELDING & GRIPPING.

THIS LABORER WAS ASSISTING ON WORK BEING DONE TO A ROLL CRUSHER WHILE THE ROLLS WERE BEING WELDED ON, A PIECE OF HOT SLAG FROM THE WELDING OPERATION DROPPED OFF AND STRUCK HIM ON THE RIGHT ARM NEAR THE ELBOW BURNING THE FOREARM.

CRUSHER OPERATOR WAS REPAIRING A CONVEYO HE WAS LYING ON HIS BACK IN A TIGHT AREA, WHERE THERE WAS ONLLY ROOM FOR ON EPERSON. HE USED HIS KNEE TO PUSH UP A SHOOT IN ORDER OT INSERT A PLATE AN D BOLT. WHILE PUSHING UP OEPRATOR HEARD A POP IN HIS BACK.

HE WAS WELDING INSIDE THE IMPACT CRUSHER. HE WAS BENT OVER WHILE WELDING. WHEN HE STRAIGHTENED HIS BODY HE FELT A SHARP PAIN IN HIS LEFT LOWER BACK.

JTL GROUP EMPLOYEE EE RECEIVED WIRE-FEED ELECTRIC WELDER FLASH BURNS TO HIS EYES WHILE WORKING NEAR THE MACHINE WELDING SHIELDS WERE IN PLACE & WERE BEING USED EMPLOYEE INADVERDENTLY LOOK AT A RC AFTER LEAVING SHIELD & WELDING HELMET

EMPLOYEE WAS CLEANING TIPPLE HAD FINISHED AND WAS MOVING TOWARD THE WALKWAY, WHEN HIS RIGHT THIGH STRUCK A SHARP PIECE OF STEEL, LACERATING THE THIGH.

WHILE USING ABAR TO CLEAN THE MUD OFF OF THE RETURN ROLLERS OF THE 220' CONVEYOR, THE BAR SLIPPE DOUT OF HIS HAND SAND HIT HIM IN THE CHIN.

EE WAS PULLING ON FLOATING FUEL TANK DURING WINDY CONDITIONS PULLED ELBOW.

INSTALLING NEW BEARING IN LOWER SECTION OF SCREEN BOX. FELLOW EMPLOYEE BELOW WAS TRYING TO FREE THE SCREEEN BOX. HARMONIC BALANCE WHEEL SUDDENLY SHIFTED WHILE WORKING ON AND PINCHED AND CUT LEFT INDEX FINGER. FINGER WAS PINCHED BETWEEN BOLT AND 2" PIPE ELBOW ON SCREEN BOX.

EMPLOYEE WAS TRIMMING A CONVEYOR BELT WITH UTILITY KNIFE, KNIFE SLIPPED & CUT FINGER [LEFT INDEX] FROM FIRST JOINT THROUGH FINGERNAIL. FINGER WAS STITCHED IN EMERGENCY ROOM.

PLEASE SEE ATTACHED.LOADER WAS LIFTING AND PUSH THE TAIL. EE COULD NOT SEE OVER THE CHUTE ON THE TAIL SECTION SO HE STEPPED UP INTO THE LOADER BUCKET TO CHECK ALIGMENT. FRAME OF THE TAIL SECTI ON CAME DOWN ON HIS LEFT FOO AND PINCHED THE FOOT BETWEEN THE FRAME AND THE BOTTOM OF THE LOADER BUCKET. LEFT FOOT RECIVED A CRUSHING INJURY RESULTING AMPUTION OF THE BIG TOE AND TORN MUSCLE

WHILE REPLACING A STEEL RING ON THE VSI CRUSHER. THE EMPLOYEE'S MIDDLE AND RING FINGERS ON HIS RIGHT HAND, BECAME CAUGHT IN A PINCH POINT BETWEEN THE STEEL RING AND THE STEEL BODY OF THE VSI. HE RECEIVED CUTS WHICH REQUIRED STICHES.

INJURED WAS HELPING INSTALL WEAR PART INT EH HORIZONTAL SHAFT IMPACT CRUSHER. WHILE LIFTING THE WEAR PARTS ITNO PLACE, HE STRAINED HIS LOWER BACK.

36605E WERE LIFTING BATTERY OFF CRUSHER HANDLE BROKE AND BATTERY FELL ON EE S RIGHT FOOT BRUISING IT.

SETTING ROLLS ON CRUSHER PIECE OF IRON FLEW OUT AND HIT HIM IN THE HEAD.

RIGHT ARM SEVERED ABOVE ELBOW-DETAILS NOT KNOWN AT THIS TIME-UNABLE TO SPEAK TO EMPLOYEE NO KNOWN WITNESSES.

RIDING ON LOADER FOOT CAUGHT BETWEEN FRONT AND B ACK SECTIONS CRUSHED LITTLE TOE AND BROKE NEXT TOE ON R FOOT

OPERATOR WAS ADJUSTING THE ROLL CRUSHER BY PUTTING A WEDGE IN THE ROLLS AND THE WEDGE FLEW OUT AND HIT HIM IN THE PENIS.