Buscar en el registro

ADJUSTING PRODUCT CONE ON ROCK CRUSHER USING OPY WEDGES & A 20LB SLEDGE HAMMER

WHILE REMOVING THE RETAINER PLATE ON THE REAR BRAKES OF A 980F LOADER, THE PLATE CAME LOOSE AND FELL. IT PINCHED THE EE'S FINGER OF HIS LEFT HAND WHICH RESULTED IN THE LACERATION.

DRIVING ON PUBLIC ROADWAY THRU CONSTRUCTION WITHFLAGMEN WAS REAR ENDED TWICE BY SAME VEHICLE JAMMED THUMB INTO STEERING WHEEL

WALKING TOWARD BUTTON BOARD STEPPED WRONG OR TRIPPED TWISTING LEFT KNEE. DID NOT FALL CAUGHT HIMSELF ON THE BUTTON BOARD

WHILE IN PROCESS OF REMOVAL OF A WATER PUMP, HOLDING TENSION ON CHAIN. WHEN PRESSURE WAS APPLIED TO CHAIN, RIGHT MIDDLE FINGER WAS CAUGHT BETWEEN CHAIN AND ELBOW ON PUMP.

HAD A MAKESHIFT PLATFORM CONSISTING OF TWO 2X6 PLANKS TO STAND ON WHILE REPAIRING A SCREEN DECK. SLIPPED ON WET FOOTING & STRAINED SHOULDER CATCHING HIMSELF. FINISH JOB BUT THE NEXT MORNING SW ELLING & ACHING OCCURRED IN SHOULDER.

HOOD ON A 980G BUCKET LOADER HAD TO BE LIFTED. ELECTRIC MOTOR WAS BROKEN- A TWO MAN JOB. WHEN HE WENT TO CLOSE HOOD, HE DIDN'T HAVE HELP. THE HOOD SLIPPED OUT OF HANDS AND SLAMMED DOWN ON TOP OF RIGHT FOOT.

STANDING ON DOZER TRACK, WAS KICKING OUT MUD FROM THE HARD BAR. STEPPED ON PUSH RAM WHICH WAS SLICK & FELL, LANDING ON WRIST.

WHILE HE WAS WORKING AT FABRICATION TABLE A ROCK FLEW OUT OF THE FEEDER OR JAW AND STRUCK HIM IN RIGHT SIDE OF FACE. SENT TO CLINIC FOR THE CUT TO BE CLEANED AND STITCHED (3 STITCHES)

AFTER PARKING BOULDER BREAKER (#25-999) HE GOT OUT AND AFTER HE REACHED THE GROUND HE SHUT THE DOOR. AS HE TURNED AROUND AFTER SHUTTING THE DOOR HE WAS STRUCK N THE HEAD BY THE DOOR WINDOW AND FRAME AND SUFFERED WHAT APPEARED TO BE A JAMMEDNECK AND COMPLAINED OF PAIN.

EMPLOYEE WAS WORKING ON A SCREEN PLANT ATTACHINHG A ROCK DIRECTION CHUTE. WHILE EMPLOYEE WAS HANDING A SUPPORT CHAIN TO HIS SUPERVISOR, WHO WAS ALSO WORKING ON SAME PROJECT, EMPLOYEE SLIPPED A ND FELL BACK AGAINST THE EDGE OF THE LOADER BUCKET.

WHILE OEPRATING SCRAOER--GOING BACK TO DUMP A LIGHT LOAD OVER VERY ROUGH GROUND AT WHAT APPEARED TO BE AN EXCESSIVE SPEED FOR CONDITIONS--INJURED LOWER BACK FROM A HARD BOUNCE--RADIOED FOR HEL P.

PULLING A MAN HOLE COVER FROM A CONVEYOR MAGNET ON A RECYCLE CRUSHER.

WHILE THE ENTIRE PLANT REMAINED RUNNING, THE EE ATTEMPTED TO TIGHTEN A LOOSE SCREEN RAIL BOLT ON #1 MAIN PLANT SCREEN. HE LIFTERD RUBBER ON GUARD AND STUCK HIS HAND UNDER GUARD IN AN ATTEMPT TO TIGHTEN BOLT & WHILE DOING THIS HIS HAND WAS STRUCK SCREEN'S COUNTERWEIGHT.

PULLING DOWN ON SPRING LOADED ELECTRICAL SHUT OFF BREAKER HANDLE SLIPPED FROM HAND AND RECOILED INTO BOTTOM OF CHIN.

CUTTIGN SOME CROWN RUBBER WITH UTILITY KNIFE AND SLICED THROUGH INTO TOP OF THUMB.

EE WAS HOSING OFF PAD AND WAS SPLASHED IN EYE WHICH MOMENTARILY DISORIENTED. HE STEPPED OFF PAD AND TWISTED KNEE.

SHOVELING IN A TUNNEL FEEDER

HE WAS LIFTING UP ON A GRAVITY WIPE WHILE INSTALLING IT ON THE CONVEYOR, TWISTED HIS BACK AND FELT SOMETHING PULL.

PROLONGE USE OF LEVERS ON TRACK HOE & OTHER HEAVY EQUIPMENT. CREATED OR WAS PART OF A CARPAL TUNNEL SYNDROME IN RIGHT HAND & FOREARM.

MOVING A MOTOR, TRYING TO MOVE BY PRYING WITH PRY BAR. BAR SLIPPED & ELBOW STRUCK MOTOR.

LIFTING LOAD OF IDLERS ON PALLET, CHAIN SLIPPED WHEN PALLET BROKE AND STRAINED HAND.

EE MOVING BLOCK OF WOOD TO SHORE UP A SCREEN WHEN STRAINED LEFT SHOULDER.

EMPLOYEE'S HARD HAT FELL OFF. HE BENT OVER TO PICK IT UP AND RAISED UP INTO THE CONVEYOR, CAUSING A LACERATION TO THE SCALP.

WHILE STEPPING DOWN OFF OF EQUIPMENT EMPLOYEE STEPPED ON A ROCK.

EE FELT A "POP" IN HIS BACK WHILE HE WAS HOSING OFF THE SCREEN PLANT.

EE HURT SHOULDER AND NECK MUSCLES WHILE THROWING A PIECE OF METAL.

WHILE EMPLOYEE WAS HOSING OFF CONCRETE SLAB, HE SLIPPED IN MUD. HE CAUGHT HIMSELF BEFORE FALLING, TWISTING HIS LOWER BACK.

LIFTED TOOTH WEDGE ONTO CATWALK.

EE SAT IN PASSENGER SEAT OF 777 HAUL TRUCK. HE WAS HOT AND PLACED HIS HAND DOWN TO THE FAN BLOWING COLD AIR FROM A/C. THERE WAS NO SHROUD, AND HE CUT HIS 4TH FINGER ON THE LEFT HAND.

RIGHT SHOULDER GRADUALLY STARTED HURTING WHILE OPERATING A 980 CAT LOADER.

WHILE LIFTING A SAWHORSE, EE STRAINED HIS LOWER BACK.

WHILE USING A SLEDGEHAMMER TO KNOCK OUT PINS ON TOGGLE BOLTS, THE HANDLE HIT THE BOLT, SMASHING MIDDLE FINGER OF THE RT HAND. 4 STITCHES REQUIRED TO CLOSE OPEN WOUND CAUSED BY IMPACT.

WHILE WELDING, A PIECE OF METAL SLAG BOUNCED UP UNDER WELDING LOAD AND LODGED IN RIGHT EYE.

DRILL STEEL SLIPPED OUT OF HANDS, TRAPPING/ SMASHING 2 FINGERS BETWEEN GUIDE AND STEEL

EE'S FINGER WAS CAUGHT BETWEEN A ROCK AND HIS TOOL BOX. EE SUFFERED A CONTUSION AS A RESULT OFTHE PINCH.

EMPLOYEE WAS IN CAT WAGON. EMPLOYEE OPERATING LOADER DID NOT SEE HER AND BACKED INTO HER. CAT WAGON WAS PARKED.

WELDER WAS WELDING IN VICINITY OF EMPLOYEE AND EMPLOYEE LOOKED OVER AND RECEIVED FLASH BURN. EMPLOYEE WAS PAINTING AT THE TIME WHICH IRRITATED THE BURN.

EE WAS REMOVING A PIECE OF METAL THAT HAD LODGED IN THE TAIL PULLEY OF SCREENING PLANT. PLANT WAS SHUT DOWN BEFORE REMOVAL BEGAN. WHEN PULLED, STEEL PUNCTURED SKIN ON LEFT ARM.

EMPLOYEE JUMPED OFF OUTRIGGER OF ;CRANE CAPPROX 4 FEET TO GET DOWN *& REINJURED PRES-EXISTING KNEE INJURY

EE RECEIVED FLASH BURN TO EYES WHILE WORKING ON ELECTRICAL SWITCHGEAR.

HIT HEAD ON CROSSBAR WHILE COMING UP AFTER BENDING DOWN TO CHECK EQUIPMENT.

CO-WORKER SHOVELING NEXT TO EE HIT HIM IN THE NOSE WITH SHOVEL

NOTICED INCREASING PAIN WHILE OPERATING CRANE. USES RT HAND FOR PULLING ON HOIST LEVER.

MAINTENANCE ON THE HORIZONTAL SHAFT IMPACT CRUSHER. HYDRAULIC LINE BLEW AND COVER TO CRUSHER CAME DOWN AND PINCHED THE COVER AT THE WAIST. THE INJURIES RESULTED IN A FATALITY.

I NAME WAS HIT ON THE NOSE WITH A PVC PINE HIS NOSE WAS BROKEN WHEN A SECTION OF PIPE SPRANG LOOSE FROM A CONVEYOR FRAME WHERE IT WAS CAUGHT & BENT IN TRYING TO FORCE THE BENT PIPE IT CAME LO OSE & HIT HIM BREAKING THE NOSE

WHILE USING A CUTTING TORCH SLAG POPED UP IN MY RIGHT EYE PS WHILE WARNING SAFETY GLASSES.

EMPLOYEE WAS WORKING WITH A CABLE TYPE(COME-ALONG) PULLER ON A CONVEYOR 10 FEEL ABOVE THE GROUND - THE TOOL SLIPED AND HE LOST HIS BALANCE, FALLING TO THE ROCK FLOOR.

WHILE USING HI PRESSURE WATER TO WASH OFF SCALE WATER OR DIRT CAME INTO CONTACT WITH EYE.

WHILE REMOVING CUTTING EDGE BOLTS HAND SLIPPED AND WAS CUT ON THE SHARP EDGE OF BOLT.