Search the record

Employees A and B were using a forklift to dump bulk bags of waste product to rerun thru plant for reuse, when employee B got on forklift and turned forklift over on its side resulting in fatal injury.

The unit mechanic was traveling across the section. A ram car was traveling inby toward the miner. The car had only traveled a few feet inby when the employee was struck by the ram car.

The conditions contributing to this accident are unknown at this time. The weather, road condition, and equipment failure is not of suspect as of this date. The miner lost his life

An employee on the ground level retrieved the tool and climbed 1 to 2 rungs of the ladder to hand the tool to the employee above. The employee appeared to lose consciousness and fell. The witnesses indicated that it appeared the victim was breathing. At 12:01pm, US Silica was informed that the victim had a heart attack and while at the hospital the employee died.

The victim backed the truck he was driving to the edge of the overburden dumpsite and started to raise the truck's bed to dump a load of material. The bank failed and the truck overturned falling 30 feet below. The victim died in route to the hospital.

A crew of 5 workers were installing an 8'x10' process door when the lifting lug on the door became detached. This resulted in the door free falling approximately 22" to the ground and ultimately falling over onto one of the crew members.

The EE involved arrived 15 minutes before start time and went directly to his haul truck and started the truck. While in the shop the EE reported to another EE that he had slipped and fallen from his truck after it was started. He said he missed the bottom step and fell against the tire. He slid down the tire, striking his head on the concrete. He died on 11/27/2014.

On the 002 Section in the #2 entry face, a rock fell out of the roof striking EE while he was roof bolting and knocked him to the ground. The crew was able to remove the rock and transport him to the surface while performing CPR. He was taken by ambulance to Ruby Memorial Hospital where he was pronounced dead at 1130 pm.

EE shut down crushing plant to remove a drill bit stuck in the jaw crusher. He was using a torch to cut off drill bit when the bit flew up into his chest & face. He was hospitalized and died on 1/17/15.

Details & conditions are currently under investigation.

Fall from Platform at Lehigh Cement Facility. On 10/10/14 a truck driver/loader employed by FT Silfies Inc. was in the process of pre-loading a trailer on miner property. At Aprox. 11:18AM, the driver was standing in side the safety loading rack on top of a trailer when he fell between the lower railing of the rack and the trailer, aprox ten (10) feet to the ground.

Employee apparently entered into highwall miner hole in an attempt to retrieve a cutter chain. While at the chain, the employee was struck by rock from roof.

The accident occurred while performing maintenance on a forklift. Injury occurred when the forklift apparently moved, crushing the miner between forklift and wooden support column. Specific details are currently under investigation.

EE was operating the company #24-43 Wagner ST 2DS Can-setter at x-cut #11 in B Canyon,#2 entry in the 23rd East intake. When the victim was found, he was unconscious & unresponsive, his mid torso was pinned in the articulation area of the machine. His feet were in the cab & he was seated in the seat. CPR was administered. The victim was pronounced dead upon arriving on the surface.

Bulldozer operator was preparing a drill bench on top of an approx. 50' highwall. Operator was pushing consolidated material over the edge of the highwall. The bulldozer traveled over the edge of the highwall and fell to the pit bottom. Operator was found unresponsive. 1st aid and CPR were performed until the coroner arrived and pronounced the victim dead at 1404 hours.

About 3:15 pm., employee went to a storage building to get some planks. He climbed a stack of loaded pallets to get to the planks that were near the rafters and fell approximately 8 feet to the floor below and was found dead the next morning at approximately 6:02 am.

The employee was working on a Fletcher roof bolter. He had the panel board off trouble shooting inside the electrical components of the machine. He apparently came in contact with electricity. The investigation is not complete at this time.

Miner was apparently adding oil to hoist of truck. Box was loaded with rock and not properly blocked. The weight of the loaded box split block and the box came down unexpectedly crushing miner between the truck frame and dump box. Although no damage was done to equipment, miner was killed.

CEMEX loader opr was moving flyash from mat'l storage bldg to hopper. Raw mat'l del driver, ind. o/o contracted w/ Tri-State Carriers(TSC), entered mat'l storage area & exited his tractor, preparing to unload. Loader reversed to get another load & impacted the tractor, striking the driver. MSHA issued Contr ID B0350 to TSC under protest as it is not a contr on CEMEX mine site.

Employee pulled aluminum boat over three electric conductors in dredge pond. A patch on the bottom of the boat cut into one conductor and electrocuted the employee. The employee died as a result of the accident.

An empty haul truck traveled in a forward direction through a dump berm and came to rest at the bottom of the angle of repose dump fatally injuring the operator.

The employee was present while two contract workers were performing a repair on a centrifugal water pump. During the repair, an explosion occurred. Heat may have been applied during the repair. The employee suffered fatal injuries.

Truck driver entered empty bulk trailer tank for unknown reason, and was later discovered unresponsive inside the trailer.

Employee was shrink wrapping a pallet with a weed burner and for some unknown reason he burned himself and was found by a co-worker in a serious burn condition. He is burned over 36% of his body including left arm, which has been amputated, and his right upper arm, chest and face. The cause of death was mucomuyosis (fungal infection).

Miner suffered a fatal injury after being pinned underneath the raised cover of a Metso Lokotrack crusher.

Two shaft repairmen had finished pulling lacing from the pipe compartment, the all clear/tucked in verbal command was given twice with response. The bell signal was transmitted to raise the skip. One miner's fall protection lanyard was accidentally left connected to a shaft anchor. As the skip raised the lanyard remained secured pulling the miner between the skip and shaft timber.

The victim and another miner were tramming the roof bolter outby down the No.3 entry of tailgate No.1 when the accident occurred. The victim was injured when he was struck by the roof bolter as he placed himself between the coal rib and the roof bolter.

During maintenance, a miner was struck by the boom of an excavator that was being used to position crusher parts; causing him to lose balance and fall approximately 11 feet. The fall resulted in several broken bones. MSHA arrived on site the afternoon of the accident and started an investigation. *Employee died on 5/26/2015.

On 5/12/14 an event occurred at this mine which resulted in the entrapment of two (2) miners. Upon subsequent recovery it was determined that both miners had perished. The injured were fatally struck by coal/rock. An investigation is on-going. The causes are unknown.

On 5/12/14 an event occurred at this mine which resulted in the entrapment of two (2) miners. Upon subsequent recovery it was determined that both miners had perished. The injured were fatally struck by coal/rock. An investigation is on-going. The causes are unknown.

The victim was unloading a rail car using a transloading conveyor and was entangled in the feed end of the conveyor.

No eye witness to accident. ATV was traveling up a + or - 15% slope and lost traction. The road has some uneven spots that might of contributed to the loss of traction. The ATV appears to not have been in All Wheel Drive which could have contributed to the loss of traction.

Employee had partially drilled a hole using a jackleg drill. A coworker discovered him unconscious/unresponsive, slumped over the drill. It was later determined the employee's clothes were wound up in the 6' drill steel though the cause & nature of the accident & cause of death remain undetermined and under investigation.

Employee had worked an entire day operating a John Deere 750C Dozer along side another experienced dozer operator. At approximately 5:25pm the employee was last seen crossing over a dirt pile. A few minutes later that same employee saw the 750C dozer blade first in a ditch with the tracks still running and employee lying face up behind the machine.

Security guard fell or slipped from the cab of his personal vehicle into a shallow diversion ditch at the base of a berm along a roadway. He was found with his face submerged in approx 12" of water. The death was drowning & that a contributory condition was marked alcohol intoxication. The case was not determined to be chargeable until December 22, 2014.

Victim was caught between track hoe bucket and haul truck. An excavator was loading material in a haul truck parked in the pit. When the victim exited the truck, he was struck by the bucket of the excavator and pinned against the truck.

The employees were scaling from a man basket on a boom truck when large slabs struck the boom causing it to separate from the truck.

Employee was scaling from a man basket on a boom truck when large slabs of rock struck the boom causing it to separate from the boom.

Excavator was lifting plastic pipe when it fell and hit the victim.

The victim was in the process of cutting through the inner left-side side plate. When the cut was completed, the cat frame pivoted upward, pinning the victim between the cat track and frame of the feeder. The side plates connect the hopper jack assembles to the cat frame. The victim was working on n Auxier Welding Inc belt feeder.

A miner become buried from material sliding down the face of a bank.

Emp a contract worker repairing a Scaler in Mod 12. The emp had fallen to the ground in fetal position, locked arms, clenched fist and bleeding from the ears. The witness did not know if the emp fell from a height or ground level. The injured emp was airlifted. He was lacking oxygen to brain for 10 minutes. He was pronounced dead at 9:45AM on Feb 28.

Employee was tramming continuous miner from #4 heading toward #1 heading when he was caught between the conveyor boom and the rib. There were no eyewitnesses.

Without checking to ensure elevator car was present, contractor stepped into elevator shaft and fell approximately 25 feet landing on top of elevator car.

Miner became entangled in belt return roller and sustained fatal injuries. Equipment involved was Rahco mobile stacker, Model m30x1500.

Employee was caught between the feeder and the coal rib as he was tightening up the chain connecting the feeder to the tailpiece. The crew had just completed moving the belt and was in the process of anchoring and aligning the tailpiece. The tailpiece broke loose and when doing so shifted the tailpiece and feeder towards the off side of the belt, where the employee was positioned.