Avísenme cuando se presente un nuevo incidente de la MSHA en Arizona #1.
| Trimestre | Horas trabajadas | Citaciones | S&S | Por 1M hrs |
|---|---|---|---|---|
| 2015 Q2 | 472 | 0 | 0 | 0.0 |
| 2015 Q1 | 1,928 | 3 | 0 | 1556.0 |
| 2014 Q3 | 912 | 1 | 0 | 1096.5 |
| 2014 Q1 | 3,871 | 2 | 0 | 516.7 |
| 2013 Q4 | 11,172 | 3 | 2 | 268.5 |
| 2013 Q2 | 12,463 | 1 | 0 | 80.2 |
| 2013 Q1 | 13,762 | 1 | 0 | 72.7 |
| 2012 Q4 | 6,928 | 4 | 1 | 577.4 |
2 Miners were lowering a jackleg drill down from a raise, the drill slipped from their grasp and 1 miners hand was caught between the drill and a piece of wooden lagging.
While bolting the back a 6 inch rock came loose from the back and struck the miner on the hand on top of the drill causing a cut that needed 4 sutures.
A miner was kneeling on the ground repairing an airline, when he went to stand up, his leg made a pop and gave out. He went to the hospital for examination.
Electrician was wiring in a starter box when he stepped on a 4 inch rock rolling over his ankle. causing a small bone to break.
Working in the # 2 manway compartments at approximately the 770 foot steel set, he was removing an old piece of lagging. While attempting to remove the wood cribbing from the bottom the top started to tip towards him. He put his hand up to stop it from falling.
Miner was attempting to install splitset rock bolt. Miner inserted bolt into drilled hole. While positioning driver into splitset, miner bumped splitset causing it to dislodge and fall from back striking him on bridge of nose. This caused a laceration requiring 6 stitches.
While riding the conveyance down the shaft at a slow pace, employee tried knocking off a piece of timber from the shaft steel set getting his right index finger caught between conveyance and guide resulting in a laceration requiring 8 sutures.
Crew was using a cutting torch to remove inaccessable guide bolts; a piece of molten metal inadvertantly fell down the shaft. It is unknown what was smoldering as the shaft is under rehabilitation at this time and it is unsafe to travel down the shaft to extinguish the fire.