BALLGROUND MINE SITE: 132 citaciones de la MSHA Metal/Non-Metal

While removing accumulator on HP500, the accumulator fell unexpectedly. While attempting to catch the accumulator, ee's index finger became caught between the accumulator and side of the crusher mainframe. EE's finger was cut through gloves and required 7 stitches.

EE was removing zip ties from hydraulic hose with a pocket knife and cut their hand. EE was taken to the emergency room where they were treated with one suture and tetanus shot.

Hydraulic cylinder swung out, struck employee on left hand. It broke the knuckle of ring finger on left hand.

While installing a 2400R35 on Cat 775. EE was prying back the Rim flange with a 90 degree tire bar. The flange was rusted to the hub and EE was having a difficult time prying the flange loose. EE pushed with all of EE's might and strained EE's left shoulder.

Notified 04/03/2015 by Audiologist that employee was diagnosed with Sensorinueral Hearing loss attributing to STS.

Employee was cutting a card board drilling tube with a utility knife. The utility knife slipped and he cut his left leg right above the top of his boot. He was taken to the doctor and received tetanus shot and five sutures.

EE was mounting tire back on unit. EE used a push bar to set flange and lock ring. While putting the lock ring in place the push bar slipped and the tire flexed which struck the index finger on the left hand and the middle finger on the right hand.

It had been raining all day. At the time of the accident the rain was very heavy and oxygen bottle was slippery. The injury that resulted was a lacerated/smashed finger tip on right hand ring finger when attempting to load new oxygen bottle in mechanic's truck.

An employee with 35 years of experience, seven years at this company, was found to have a hearing loss through the annual audiometric testing. The employee was sent to the doctor whom confirmed that the employee was suffering from sensorineural hearing loss caused by a combination of noise exposure and Presbycusis (aging process).

The maintenance employee burned his eyes due to welding / cutting. The employee states that he was wearing PPE.

When turning off the high pressure water hose the employee lost his grip on the hose and it struck him in the face chipping his upper front tooth.

The employee was helping to pull a cable around a crusher and felt a pull in his back. The employee has a minor back strain and is on modified duty with a lifting restriction.

Employee was attempting to pick up a "pipe smoker" and felt a pull in his back. Employee has a mild back strain, and is on modified duty.

The gentleman was steading a ring on a barmack crusher and strained his back. The injury was not reported to us until June 7th at approximately 7:00 AM following the employee's scheduled vacation.

THE EE WAS REACHING UNDER HIS LOADER TO GREASE THE CENTER PIN WHEN HE FELT A POP IN HIS BACK.

EMPLOYEE ALLEGES HE SUFFERED BACK STRAIN WHILE LIFTING A PIECE OF BELT TO REPAIR WATER FLUME. EMPLOYEE WENT TO DOCTOR ON 8/8/03.

EE WAS PULLING THE FUEL HOSE TO PUT FUEL IN A SMALL TANK. WHILE PULLING THE HOSE OUT FROM THE TANK IT TWISTED FROM HIS HANDS & STRUCK HIM IN THE FACE, SHATTERING A TOOTH AND CAUSING A SMALL AB RASION ON THE FACE.

EE WAS LOADING A CUSTOMER TRUCK. THE EE TURNED AROUND IN HIS SEAT & TWISTED HIS BACK.

EMPLOYEE WAS MOVING AROUND A STONE STOCKPILE WHEN HIS SEAT IN HIS LOADER BROKE. THIS CAUSED THE EMPLOYEE TO STRAIN HIS BACK.

EE WAS PULLING A STEEL CABLE UP TO A PLATFORM WHEN HE SUDDENLY STRAINED HIS LOWER BACK.

EE WAS ATTEMPTING TO CLEAR OFF A BELT. THE EE GRABBED A LARGE STONE ATTEMPTING TO REMOVE IT FROM THE CONVEYOR, THE ROCK SHIFTED FALLING ON THE EE LEG.

EE WAS ATTEMPTING TO REPAIR A SET OF JUMPER CABLES WITH A RAZOR KNIFE, WHILE DOING SO THE KNIF SLIPPED CAUSING A LACERATION TO THE EE'S LEFT PALM. (STITCHES WERE REQUIRED)

MANAGER WAS ENTERING THE SCALE HOUSE OFFICE WHEN HE SLIPPED ON A WET AREA OF CERAMIC TILE. HE THEN FELL TO THE FLOOR ON HIS RIGHT KNEE AND RIGHT HAND. THIS CAUSED HIM TO INJURE HIS HIP AND LOW ER BACK.

BENDING OVER TO PICK UP CRUSHER BLOW BAR. STRAINED LOW BACK AREA.

EE WAS PULLING BLOW BARS OUT OF IMPACT CRUSHER AND STRAINED GROIN.

EMPLOYEE BURNED HIS EYS WHILE HELPING WELD A LINER IN A TRUCK BED.

EMPLOYEE CUT A PICE OF PIPE WITH AS PIPE CUTTER AND THE PIPE FELL AND CUT THE EMPLOYEES ARM.

EMPLOYEE SLIPPED WHILE CLIMBING OFFA SCREEN BOX AND SUFFERED A PUNCTURE WOUND ON HIS LEFT HAND ON STITCH WAS APPLIED.

EMPLOYEE WAS LI0ITNG A SHAFT OUT OF A CONE CRUSHER AND FELT A SHARP PAIN IN HIS LOWER BACK.

EMPLOYEE WAS WA5KING DOWN STEPS AT THE PRIMARY CRUSHER AT PLANT 2 HE SLIPPED ON SOME MUD AND STARTED TO FALL. HE REACHED OUT AND GRABBED THE HANDRAIL AND DISLOCATED HIS LEFT SHOULDER.

EMPLOYEE WAS INSIDE A SHAKER BOX PULLING OUT A SCREEN. HE PULLED A MUSCLE IN HIS LOWER BACK. MEDICATION WAS PRESCRIBED.

EMPLOYEE WAS HELPING LIFT A MOTOR ONTO A CONVEYOR BELT. HE LEANED OVER WITHOUT BENDING KNEES AND PUT TOO MUCH STRAIN ON HIS GROIN CAUSING A TEAR IN HIS GROIN. DOCTOR IS TO PERFORM SURGERY TO R EPAIR LEFT HYDROCELE.

EMPLOYEE WAS AT A JUNK YARD IN GAINESVILLE, GA. WALKING OVER JUNK MATERIAL LAYING ON THE GROUND LOOKING FOR PARTS TO USE AT THE QUARRY. EMPLOYEE WALKED OVER SOME MATERIAL THAT HAD A ROLLER CON VEYOR UNDERNEATH, CAUSING EMPLOYEE TO SLIP AND FALL INJURING WRIST.

JAW CRUSHER HOUSE EMP WAS TEMPORARY REPLACEMENT AT CRUSHING PLANT RECENTLY REPLACED WINDOWN FAN WITH ANOTHER FAN TO KEEP JAW HOUSE COOLER REPLACEMENT FAN DIDNT HAVE A GUARD ON BACK OF FAN TO P REVENT ACCIDENTAL INJURY EMP GOT TO CLOSE TO FAN WHILE HANGING UP SECURING LINE AND BELT ON THE WALL HOOK ON WALL WHERE BELT IS STORED IS APPROX 2\ AWAY FORM FAN HAND TOUCHED FAN BLADE CUTTIN