Avísenme cuando se presente un nuevo incidente de la MSHA en Scherr Quarry.
| Trimestre | Horas trabajadas | Citaciones | S&S | Por 1M hrs |
|---|---|---|---|---|
| 2025 Q4 | 11,248 | 1 | 0 | 88.9 |
| 2025 Q3 | 6,056 | 9 | 6 | 1486.1 |
| 2025 Q2 | 4,302 | 3 | 1 | 697.4 |
| 2025 Q1 | 2,944 | 0 | 0 | 0.0 |
| 2024 Q4 | 1,276 | 1 | 0 | 783.7 |
| 2024 Q3 | 11,553 | 0 | 0 | 0.0 |
| 2024 Q2 | 2,903 | 0 | 0 | 0.0 |
| 2024 Q1 | 6,386 | 4 | 0 | 626.4 |
EE went to get out of the service truck to put fuel in, stepped on a rock, and rolled ankle.
EE was in white ford for 2 hrs, clutch went out, pre-shifted another truck, #C-24, and worked for 5.5 more hrs until EE went into turn with excess speed and rolled onto the trucks passenger side while heading to stock pile. Resulting in EE getting thrown into passenger side due to not wearing seatbelt.
EE was washing out a screen deck. As EE was performing this duty EE felt a pop in EE's back, causing pain.
Removing rock blockage from chute. A large rock slipped and thumb was under it and landed on another rock. Left thumb broken.
The employee was washing off the pad under the crushing plant when a rock fell off belt #2 hit the ground and then hit EE's foot. The rock hit just above the steel toe. The employee went to the hospital for an x-ray and was put in a boot while awaiting treatment.
Excavator operator was working to close to the Highwall. The Dozer working on the bench above knocked a bolder free that fell on the cab of the excavator, injuring the operator.
EE our plant Supervisor had a S.T.S. on our annual hearing test performed on 02/01/2016. EE was re-tested with-in 30 days (on 02/29/2016) and a mild loss resulting in a S.T.S. was again reported. EE has been with the company for 10 years.
Employee bent over to pick up his hard hat and when he stood back up to put it on he hit his head on the tail pulley on belt #3. He cut his head and had to have seven staples put in his head.
Hammer slipped out of hand, bounced off machine and struck injured worker in the jaw...cut jaw 3 stiches.
Employee reached into a heater fan that he was working on to retrieve something that had fallen in. The fan came on and cut his 3rd finger on his right hand. The cut required stitches.
Employee was driving a king pin out of a truck axle when a nut flew off the pin and struck him above the left eye, cutting his face and cracking the bone.
Employee was using a grinder while another employee was welding. He felt like something was in his eyes and he went to the hospital emergency room.
EMPLOYEE WAS DUMPING A BAG OF FLOOR DRY INTO THE CONTAINER WHEN HE HAD A SHARP PAIN IN HIS LOWER BACK.
EMPLOYEE WAS HELPING PUT A WEAR PLATE ON BELT #3 AT THE PLANT WHEN 2 OR 3 GOLF BALL SIZED ROCKS FELL FROM ABOVE & HIT HIM ON THE BACK & ARM.
EMPLOYEE STEPPED OUT OF HIS TRUCK AND HURT HIS KNEE.
ONE OPERATOR WHILE WAITING FOR THE CLEAR ALARM SHUT DOWN HIS TRUCK IN THE SAFE ZONE AFTER ALL IS CLEAR, HE TRIED TO START BUT WHOULDN'T CRANK, FELLOW EUCLID DRIVER RAISED BATTERY TOP STOOD ON BATTERY POST TO SEE IF IT WAS LOOSE, THE DRIVER TRIED TO START WHEN IT SPARKED AND THE BATTERY BLEW UP. THE DRIVER DID HAVE HIS EYE PROTECTION AND HARD HAT ON.
DRIVING A HAUL TRUCK, BRUISED DISK IN BACK.
THE EE WAS HELPING THE WELDER AND EVEN THOUGH HE CLAIMED HE HAD A WELDING HELMET ON HE STILL RECEIVED FLASH BURNS TO HIS EYES.