Beck Street Metal/Non-Metal

Employee stepped off of a cone crusher onto a ladder bracket that was welded onto the catwalk with no ladder on it and rolled ankle.

While employee was moving angle iron from truck bed to man lift employee pinched left index finger between iron and toe board of man basket resulting in laceration that required sutures

A Komatsu 605HD rolled over backwards at the lower crushing material dump site, landing upside down. The wall was approximately 25 feet high. Employee was wearing a seatbelt at the time of the roll over.

Employee was driving a haul truck and was being loaded when that caused EE to be jarred in the cab of the truck causing muscle spasms in EE's back. This occurred on 11/22, went to the Dr. on 11/23 and treated conservatively until yesterday. The Dr. hasn't seen any improvement so Dr. ordered Physical Therapy and prescriptions making the recordable date 11/29/22.

Bruised foot

Employee received a laceration on left brow, receiving 6 stitches

Employee Rolled a Skid-steer, was released to full duty. Continued having pain, became recordable from MRI results on October 26, 2018 showed Tear in L. shoulder tendon.

Entering loader, reached for the handrail on the door while stepping to top stair. Missed door handrail & fell backwards. Caught self with hand. This action caused a heavy load on EE's right shoulder. MRI shows a Bicep tear. Delay in reporting as Insurance has been debating if the tears are Chronic or Acute.

Employee was working on wash screen and felt discomfort in eye. EE thought some dirt was in it from sweat and was wearing safety glasses. EE used the wash station at work and went home at 2:30 am. At 8 am that same morning EE still felt discomfort and called EE's supervisor for treatment. EE was treated for foreign debris in eye.

When removing a sheave, he dropped it causing his finger to get caught between sheave and the catwalk

EE woke with severe chest pain at approx. 3:30 a.m. and believed it to be really bad heart burn, he got ready for work and then drove to the office. Upon arrival, he started experiencing more of the pain with some tingling in leg and arm. When another EE arrived he asked her to call 911. EE was coherent and communicating with EMT's at departure from the mine.

After adjusting sand belt feeder, impact wrench fell and hit employee's hard hat then nose.

EE was walking oxygen bottle off rack toward him and exerted more force with his right arm.

Shoveling out belly of screeen, while doing this his back was against metal hopper wall. The EE slid against the hopper wall, scraping his back. Area was in a tight area to work in.

Employee stopped loader next to berm so that he could get out and give a set of keys to a supervisor. Descending the ladder, no 3 point hold, he jumped to the berm landing on the slope side with toes pointing upwards, overextending the calf muscle. a couple hr later declined medical help. a week later 11/8/06 pain still continued, he then decided he should be looked

EE was lifting/moving a crusher screen that is 5'X6', weighing approx 40lbs by himself. After lifting the screen, he began to experience pain and swelling at the left elbow.

EMPLOYEE WAS WORKING WITH A CHROME BEARING WHEN A SLIVER OF CHROME CAME OFF AND ENTERED HIS HAND ON THE PALM SIDE. IT IS NOW BETWEEN THE BONE AND TENDONS.

EMPLOYEE WAS LUBRICATING A BELT ON THE FORKLIFT IN PREPERATION TO REMOVE THE BELT. ANOTHER EMPLOYEE OPERATING A BOBCAT WAS PULLING ON THE FORKLIFT, THE BOBCAT'S WHEELS BEGAN TO SPIN SO THE OPERATOR TURNED IT OFF. THIS CAUSED THE FORK OF THE LIFT TO DROP ONTO THE MECHANIC'S HAND.

EE WAS HOLDING ONE END OF FLAT METAL STRAPS, WHILE ANOTHER EE WAS UNHOOKING THE CHAIN THAT WAS HOLDING THEM TOGETHER. THE CHAIN SLIDE THROUGH THE EYELET CAUSING THE LOAD TO DROP WHILE STILL IN THE EE'S HAND. EE HAD HIS HANDS IN A CRADLE HOLD POSITION,BUT WAS NOT WEARING GLOVES

EMPLOYEE WAS ON THE STACKER BELT DOING MAINTENANCE FOR THE GEAR BOX. AS EMPLOYEE WAS GETTING NTO HIS KNEES FOR CLIMBING OFF THE STACKER BELT, HIS FOOT SLIPPED ON DIRT ON THE FRAME, THE EMPLOYE E THEN JUMPED FORWARD ONTO THE BELT TO AVOID FALLING OFF.

EE WAS PLACING ANVILS INTO A BOBCAT BUCKET FOR MOVING AND WHILE PLACING AN 80 LB ANVIL IT SLIPPED SMASHING FINGER BETWEEN THAT ANVIL AND ANOTHER.

OVER TIME OPERATING THE LOADER AND DOZER EMPLOYEE HAS FELT A TINGLING PAIN, OCCASIONAL CLICKING AND SOME NUMBNESS IN HIS RT HAND.

EE BURNED HAND ON STEEL PLATE THAT HAD BEEN LEFT NEXT TO A HEATER.

SHOVELING UNDER A CRUSHER AND TWISTED WRONG.

EE REACHED UP TO PULL HIMSELF INTO THE WATER TRUCK FELT PAIN IN LOWER BACK.

EMPLOYEE BENT DOWN, HIS HARD HAT FELL OFF, HE PICKED IT UP, WHEN HE STOOD BACK UP HE BUMPED HIS HEAD, CAUSING A LACERATION.

FRONT END LOADER (988FCAT)OPERATOR WAS FEEDING JAW CRUSHER & WAS USING MATERIAL TAKEN FROM AN AREA WHERE THE DOZERS WERE PUSHING OFF FROM THE AREA HAD BEEN PREVIOUSLY BERMED. HOWEVER THEO OPERTOR HAD REMOVED A SECTION OF THE BERM

RE-INJURY OF PREVIOUS HERNIATED DISK IN LOWER BACK.

EMPLOYEE INJURED HIMSELF DUE TO IMPROPER LIFTING

INJURED EE WAS PREPARING RUBBER BELTING FOR SKIRTING WHEN HE DREW UTILITY KNIFE TOWARDS HIM CUTTING THROUGH BELTING AND INTO HIS ARM.

EMPLOYEE WAS ADJUSTING FINGER GATES AND STEPPED ON CONVEYOR - FOOT WAS PULLED INTO WIPER. SOFT TISSUE INJURY ONLY.

EMPLOYEE FEELS PAIN IN BOTH SHOULDERS FROM NORMAL OPERATION OF LOADER.

EE SLIPPED ON WET CONCRETE PAD STRIKING ELOW ON CONCRETE.

INJURED WAS PRYING ON A ROCK WITH A PRYBAR AND FELT PAIN IN HIS SHOULDER.

EE SUFFERS FROM CARPAL TUNNEL SYNDROME.

EE WAS STANDING ON SMALL COMPACTED TAILING PILE WHILE SHOVELING. SLIPPED OFF FROM PILE, STRAINING LEG AS HE FELL.

EE DROPPED A PIECE OF ANGLE IRON ON TOE.

EMPLOYEE SLIPPED ON SOME SMALL PEBBLES AND SLIPPED. HE PUT HIS RIGHT FOOT FORWARD TO CATCH HIMSELF AND HYPEREXTENDED HIS RIGHT KNEE.

ROCK BECAME LODGED BETWEEN TAILPULLEY AND CONCRETE WALL. INJURED EMPLOYEE STEPPED ONTO WALL TO ABSERVE PROBLEM AND FELL TO GROUND - 8 FT.

JTHE INJURED MINER WAS TRAMMING THE MUSTANG TRACK DRILL BACKWARD WHILE LOOKING FORWARD. THERE WAS A GARDNER DENVER DRILL WITH A CAB OPERATING ON THE NEXT ROW. THE INJURED MINER BACKED HIMSELF INTO THE DUST COLLECTOR ON THE GARDNER DENVER UPON IMPACT THE RIGHT HAND TRAMMING LEVER BECAME WEDGED UNDER THE DUST COLLECTOR PINNING THE DRILLER.

EMPLOYEE WAS ASSITING IN INSTALLATION OF CONVEYOR BELT. PUSHED CONVEYRO BETL WITH FOOT TO HELP ALIGN BELT BELT CAUGHT FASTRETURN ROLLER ANDBRACE.

MECHANICE WAS CHECKING SCREEN FROM PLATFORM LEANED AGAINST HAND RAIL HAND RAIL GAVE WAY MECHANIC FELL A SHORT DISTANCE TO CONVEYOR HOPPER TWISTED KNEE

EMPL CHANGING CRUSHER SCREENS.WAS WEARING SAFETY GLASSES BUT DUST FLEW INTO HIS EYE.

EMPLOYEE WAS UNING AIR TOOLS; AIR HOSE BLEW OFF COMPACT WRENCH. THE AIR HOSE BLEW A ROCK INTO THE EMPLOYEE'S EYE.

EMPLOYEE WAS HAMMERING A CHAIN/HOOK (HOOK WAS AT END OF CHAIN) THE THEY HAD LIFTED THE CONVEYOR WITH. THE HOOK/CHAIN WAS CAUGHT ON THE CONVEYOR. THE EMPLOYEE HAMMERED HIS THUMB-NAIL INSTEAD OF THE HOOK/CHAIN.

EMPL USING WATER CANNON TO SETTLE DUST IN WORKING AREA.HOSE BLEW OFF AND PRESSURE KNOCKED EMPL OFF TOP OF TANK.,EMPL FELL ONTO BACK CAUSING BRUISES AND SWELLING IN LOWER BACK AREA.

MAN WAS WORKING ON THE GRIZZLEY REMOVING A ROCK BIND UP. IT WAS RAINING AND THE BARS WERE WET CAUSING HIM TO SLIP AND FALL. CAUSED A BACK STRAIN.

EMPL WAS DRIVING PIN INTO BUCKET TOOTH WHEN HE STRUCK PIN PIECE SPALEDED OFF & STRUCK HIM IN THIGH.

EE WAS SHOVELIN1 & BREAKING ROCKS OUT OF BELT FEEDER APPARENTLY TWISTED WRONG & HURT BACK.

ROCK HUNG UP IN3FEEDER TRAP WAS CUT DOWN AND REMAINDER FED OUT ROCKS CAME OUT OF CONE AND FELL STRIKING LEG OF MAN REMOVING ROCK

EE WAS DESCENDI3G STEPS ON LOADER BOTTOM STEP WAS BENT IN SLIGHTLY. HE SLIPPED ON BOTTOM STEP & FELL AGAINST TIRE TWISTING WRIST & CREATING POSSIBLE BROKEN BONE & DAMAGED TENDON ON HAND SIDE O F RIGHT WRIST. 3

EMPLOYEE WAS FU9LING LOADER AS HE DESCENDED LADDER FROM OPERATOR PLATFORM HE SLIPPED AND FELL LEG BROKE ON IMPACT WITH GROUND

EMPLOYEE WAS TY3NG CABLE TO LARGE ROCKS TO REMOVE FROM FEEDER.CABLE FLIPPED STRIKING LEFT LITTLE FINGER ON NAIL CAUSING BRUISE & LACERATIONS.

EMPLOYEE WAS SH2VELING UNDER CONVEYOR AND TWISTED BACK.