FALL RIVER QUARRY Metal/Non-Metal

HOT DAY WITH NO AIR MOVEMENT. HUMID WEATHER.

EE WAS USING AVOLTPROBE 440 TO TEST FOR BLOWN FUSE IN A 440 VOLT CONTROL BOX. THE POWER WAS ON IN THE CONTROL BOX IN ORDER TO TEST. EE MUST OF CONTRACTED A LUG OR HIT WIRE WHILE TESTING AND WAS SHOCKED.

EE WAS STEPPING OFF ONE CONVEYOR TO ANOTHER WHEN HIS COVERALLS BECAME CAUGHT ON A BOLT CAUSING HIM TO SLIP AND TWIST HIS ANKLE.

EE WAS CUTTING A RUBBER HOSE WITH A KNIFE, WHEN HE CUT THE PALM OF HIS HAND AND WRIST. HE RECEIVED NINE STITCHES.

EE WAS CLIMBING UP ON THE 6X20 FEED BELT TO LOOKAT THE HEAD OF THE CONE DISCHARGE. HE SLIPPED & FELL ON THE BELT HITTING A BRACE THAT RUNS OVER THE BELT.

HURT LOWER BACK WHILE SHAKING ROCK FROM RIP RAP BUCKET.

PROPER DISMOUNTING TECHNIQUES OR POSSIBLY MODIFYING EQUIPMENT.

LIFTING HITCH ON PRIMARY TO HOOK TO 980 LOADER.HE WAS ONE OF THREE PEOPLE LIFTING THE HITCH.

THEY WERE CLEANING OUT SHAKER BED WITH PICKS AND AXES WHEN HIS LOWER BACK STARTED HURTING. ABOUT 8:00 AM IT WAS HURTING HIM REALLY BAD, ALSO HIS RIGHT LEG HAD NUMBNESS.

EMPLOYEE WAS WORKING ON THE CRUSHER, WHEN HE SLIPPED ON BUILD UP OF LIME DUST. HIS FOOT SLIPPED CAUSING HIM TO FALL INTO CRUSHER FRAME, HITTING RIBS. [LEFT SIDE]

WHILE LIFTING 110 POUND HAMMERS HE STRAINED HIS LEFT SHOULDER WAS NOT NOTIFIED THAT THIS HAPPENED ON THE JOB

WHILE DOING CRUSHER MAINTENAC, INURED'S FOOT SLIPPED OF STEEL CRUSHER FRAME CAUSING HIM TO BUMP HIS RIGHT KNEE ON FRAME. HE TOLD HIS FOREMAN ABOUT THIS AT THE END OF HIS SHIFT.

WHILE HOLDING SHAFT TO DRIVE ON BEARING, HE MISSED SHAFT AND HIT INJURED ON THE LEFT SHOULDER WITH A SLEDGE HAMMER.

WHILE MOVING DRILL HOSE, HE SLIPPED ON LOOSE MATERIAL AND STRAINED LOWER, MIDDLE BACK.

WHILE CLEANING SCREEN HIS FOOT SLIPPED OFF THE LADDER AND HE HIT HIS LEFT ELBOW ON THE METAL LADDER BRUSING THE ELBOW AND PULLING A LIGAMENT.

WHILE WORKING ON THROTTLE LINKAGE ON POWDER TRUCK RADIATOR HOSE BLEW UP IN HIS FACE. BURNED BOTH CORNEAS & BURNS ON FACE.

EMPLOYEE WAS UNHITCHING A PIECE OF EQUIPMENT FORM A PICKUP WHEN HE PULLED OUT THE HITCH PIN. HITCH FELL ON LEFT FOOT BREAKING TWO TOES.

WHILE SETTING THE CONVEYOR MIKE SLIPPED OFF OF A BELT.HE FELL ABOUT 6 FEET AND LANDED ON HIS RIGHT KNEE.HE WENT TO THE EMERGENCY ROOM THE NEXT DAY.X-RAYS SHOWED SWELLING AND FLUID BUILDUP ON T HE KNEE.

I NAME LOST HER BALANCE & FELL ABOUT 6FT TO THE GROUND WHILE REMOVING A ROCK FROM THE TAIL PULLEY

OVERSIZE ROCK ON OVERHEAD BELT FELL OFF BELT AND CRUSHED EMPLOYEE'S HAND. EMPLOYEE WAS CLIMBING ON SCREENING PLANT TO MOVE ROCK.

SET OFF A SHOT AND A ROCK FELL INTO THE LABORATORY TRAILER WE FURNISH FOR KANSAS DEPARTMENT OF TRANSPORTATION EMPLOYEES.

A ROCK WAS CAUGHT IN THE TAIL PULLEY. THEY STUCK A DRILL STEEL ROD INTO THE TAIL PULLEY TO PRY THE ROCK LOOSE. THREE MEN HUNG ON THE ROD AS WEIGHT ON THE PRY ROD, AND THE PRY ROD BROKE. EMP LOYEES FELL DOWN ON ROCK. ONE EMPLOYEE HURT HISKNEE.

EMPL SHOVELED OFF CONVEYOR BELT AND AFTER PULLING DOWN ON BELT,PAIN OCCURRED.

EMPLOYEE WAS ROLLING 10" DRAINPIPE WITH CROWBAR, WAS CROOKED IN MIDDLE, PIPE FLIPPED BACK ON HIM, AND JERKED AGAINST BAR.

CLIMBED ON TOP OF BOOM SLIPPED OFF AND FELL ON GROUND

WORKING ON BIN PUTTING FLASHING IN SCREEN ON TOP OF BELL BIN SLIPPED OUT OF HAND & FELL ON KNEE

LOADING PULLING TRUCK OUT OF MUD.EMPL WAS BETWEEN THEM TO UNHOOK CHAIN.TRUCK ROLLED AND PINNED EMPL BETWEEN IT AND LOADER.

WAS OPENING THE3HAMMERMILL LID AND A KUMALONG HANDLE HIT HIM ON THE NECK AND THROAT.

WAS LIFTING A T9UNION ROLLER AND BEARING OFF OF SECONDARY CRUSHER AND CAUSED LOWER BACK TO GO OUT OF PLACE

WAS CHECKING TH9 TRANSMISSION OIL ON A LOADER. CLOSED THE DECK PLATE ON THE LOADER AND A PIECE OF METAL WENT IN HIS LEFT EYE.