Lambertville Quarry Metal/Non-Metal

An employee using a sledge hammer to tigten a wedge plate bolt struck fellow employee who was holding slugging wrench on left bicep when the hammer glanced off the wrench.

Employee was climbing a ladder of a 988 loader for Am Start-up. His hand slipped off the hand rail causing him to fall backwards, landing on his back. he received a lower back strain,

Employee was cutting nuts with a torch to release bolts on a 980 loader cutting edge. As the nut was split, pressure on the nut caused it to release and it struck the worker in left knee.

EMPLOYEE WAS PERFORMING ADJUSTMENT ON STONE CRUSHER WITH A WRENCH WHICH WAS BEING STRUCK BY A CO-WORKER USING A HAMMER. EMPLOYEE'S FINGER GOT PINCHED BETWEEN WRENCH HANDLE AND CRUSHER FRAME.

EE WAS CLEANING UNDER THE PRIMARY CRUSHER. WHEN HE THREW A SHOVEL FULL OF DIRT, HE FELT PAIN IN HIS LOWER BACK.

WHILE STRIKING A PIN INTO A HAUL TRUCK LIFT CYLINDER, A PIECE OF THE METAL PAIN BROKE OFF AND STRUCK THE EE BELOW LOWER LIP.

EE WAS CHANGING A SHAKER SCREEN AND FELT BACK PAIN WHEN LIFTING.

EE WAS CLIMBING INTO HIS TRUCK WHEN HE STRUCK THE BACK OF HIS NECK ON THE UPPER DOOR FRAME

EE WAS CLEANING OUT A CHUTE WHEN HIS FOOT SLIPPED CAUSING HIM TO FALL FORWARD STRIKING HIS RIGHT FOREARM & WRIST.

EMPLOYEE WAS WELDING WHEN STOCK SLIPPED AND HIS THUMB PASSED THRU FLAME AND CAUSED BURN TO LEFT THUMB.

EMPLOYEE WAS WORKING WITH SANOTHER EMPLOYEE REMOVING BOWL ASSEMBLY FROM 4 FT SHORT HEAD CRUSHER WHEN PORTA-POWER JACK SLIPPED FROM ITS POSITION AND STRUCK EMPLOYEE ABOVE THE LEFT EYE.

EMPLOYEE INDICATED ON 9-9-93 THAT ON 9-7-93 HE EXPERIENCED BACK PAIN FROM BOUNCING AROUND WHILE OPERATING A DOZER.

EMPLOYEE WAS STRIPPING SHINGLES FROM MACHINE SHOP ROOF AFTER HE WAS DONE HE COMPLAINED OF LOWER BACK PAIN

EMPLOYEE WAS WORKING ALONG A HAUL ROAD IN HIS FRONT END LOADER A HAUL TRUCK DROVE BY & KICKED UP A ROCK THE ROCK FLEW IN THE LOADERS SIDE WINDOW STRIKING THE OPERATOR ON HIS LEFT CHEEK

EMPLOYEE WAS CARRYING STEEL I-BEAM UP AND DOWN STAIRS AT SHAKER TOWER AND DEVELOPED A SORE BACK.

EMPL WAS ATTEMPTING TO CLIMB APPROX 3' STEP WHILE CARRYING PIECE OF ANGLE. HAND SLIPPED & HE LOST BALANCE. EMPL FELL & LANDED ON ARM.

HE WAS USING AN AIR HAMMER TO CHISEL STEEL AT THE PRIMARY. HE WENT HOME AND CAME BACK THE NEXT DAY COMPLAINING ABOUT EYE IRRITATION. HE WAS WEARING SAFETY GLASSES.

EE WAS CUTTING UP SCRAP ON JUNK PIKE WITH AN ACETYLENE TORCH. A PIECE OF SHAFTING FROM THE PILE FELL ONTO THE TORCH HOSES AND PULLED THE TORCH FROM HIS GRASP. THE BURNING END OF THE TORCH WEN T BETWEEN HIS GLOVES AND HIS LEATHER JACKET NAD BURNED HIM ON HIS RIGHT INNER FOREARM NEAR HIS ELBOW. '

HE WAS WORKING ON TAKING DOWN AN OLD CHAIN LINK/BOARD FENCE AND CLEARING - WHEN PULLING THE CHAIN LINK FENCE TO LOAD THE TRUCK, THE ROLLED PART OF FENCE TURNED CATCHING HIS THUMB BETWEEN THE L INKS. HE WAS WEARING GLOVES.

EMPLOYEE WAS DIGGING OUT 3/4 BLEND BIN WHEN A PIECE OF DIRT CAME FROM ABOVE (ASSUMED FROM SHAKER FRAME) AND STRUCK HIM IN THE BACK OF HIS NECK. HE WAS WEARING A HARD HAT.

EMPL BACKED UP TO DUMP LOAD IN PRIMARY FEEDER. PRIMARY CRUSHER OPERATOR NEEDED HELP WITH STIFF LEG CRANEHOOK OPERATION ON LARGE ROCK IN PRIMARY. INJURED EMPL GOT OUT OF TRUCK TO HELP AFTE ING CALLED BY OPERATOR. ON STEPPING DOWN FROM TRUCK, EMPL TWISTED LEFT ANKLE. LADDER ON TRUCK WILL BE LENGTHENED TO ELIMINATE SUCH A HIGH STEP.

INJURED WAS GET7ING OFF TRUCK ZAT THE END OF T HE SHIFT & THE LADDER STEP BROKE & HE FELL TO THE GROUND TWISTING HIS RT KNEE.

ANOTHER EMPLOYE9 AND INJURED WERE RAISING A NEW 40" TOGGLE WITH THE BUCKET OF THE JOHN DEERE LOADER. I,NAME WAS PUTTING A BAR UNDER THE TOGGLE WHEN THE BAR FELL ON HIS LEFT FOOT.