Lockbourne Plant Metal/Non-Metal

EE was stepping off conveyor on 6/27/07 and felt a pull in his right shoulder. EE has been trying rehab and waiting on doctor to have his shoulder repaired.

Employee was leaving property, when he discovered a body of white female that had been murdered & dumped on mine property. Murder is still under investigation with city of Columbus Police.

Employee was hosing off deck of radal stacker in pit. There was a light load on conveyor approx. 100 tons. A rock rolled or bounced off conveyor striking employee high in middle of back.

REMOVING A TAT 5 GEAR REDUCER FROM CONVEYOR. HE WAS USING A 16" PRY BAR TO HELP REMOVE REDUCER. REDUCER BROKE LOOSE, LETTING PRY BAR TO SLIP. EE FELT A POP IN AND BURNING IN LEFT SHOULDER.

EE WAS PRYING ON AN IDLER WITH A SPUD BAR. SPUD BAR SLIPPED, CAUSING EE TO HIT HIS LEFT INDEX FINGER ON THE IDLER.

EMPLOYEE WAS CHANGING OUT A TEMPORARY IDLER TRAY & CUT LEFT THUMB ON METAL.

EE WAS PULLING A CONVEYOR BELT ON WHEN THE BELT SLIPPED, PULLING HIS THUMB BETWEEN A RETURN ROLLER & THE BELT.

EE WAS HOSING OUT FROM UNDER CONVEYOR, FELT A BURNING IN LEFT EYE. EE RUBBED EYE & CAUSED IRRITATION. EE WAS NOT WEARING SAFETY GLASSES.

EE PULLED A LEVER IN CAB, FELT A PINCH IN RIGHT MIDDLE FINGER. FINGER SWELLED & ALSO HAD SOME NUMBNESS. EE ALSO COMPLAINED OF NUMBNESS IN RIGHT LEG & FOOT.

EE WAS FUELING VOLVO ARTICULATED TRUCK STEPPED DOWN RIGHT FENDER TO FUEL TANK EE SLIPPED AND FELL BETWEEN TRUCK AND TANK HITTING HIS ELBOW & HIP.

EE WAS DRIVING TRUCK HAULING MATERIAL BEING LOADED WITH TRACK EXCAVATOR WHEN STONE CANE OUT OF BUCKET. BROKE REAR CAB GLASS OF TRUCK. EE GOT PCS OF GLASS IN EYE.

HE WAS STEPPING INTO A ROWBOAT TO INSTALL AN OUTBOARD MOTOR. BOAT SLIPPED OUT INTO WATER CAUSING HIM TO LOSE HIS BALANCE 7 HE FELL ONTO BANK. HE HIT SOMETHING CAUISNG HIS LEFT SHOUDLER TO DISL OCATE.

EE WAS CUTTING W/ TORCH. RAISED GOGGLES UP. SLAG POPPED, AND GOT A PIECE OF SLAG & RUST IN HIS RIGHT EYE.

EMPLOYEE WAS CLIMBING ON DOZER. DOZER BLADE ARM HAD FROST ON IT. EMPLOYEE SLIPPED AND FELL ON ELBOW.

TAIL PULLEY BEARING STARTED TO GO BAD ON F-5 CONVEYOR. EMP BENT OVER TO GET A BETTER LOOK AT IT.A PIECE OF IT FLEW INTO HIS RIGHT EYE.

EMPLOYEE WAS WELDING ON CRUSHER DURING COLD WEATHER AND RECEIVED FROST BITE BEHIND EAR. THIS WAS REPORTED TO US ON 2-21-06 - HE HAD NOT SEEN A DR. AND I REPORTED FOR HIM TO DO SO.

PICKED UP SPUD BAR & TURNED TO THE RIGHT & SOMETHING IN BACK SNAPPED--HE FINISHED SHIFT & ALSO WORKED THE NEXT SHIFT. ON THAT SHIFT HE WAS HELPING TO UNPLUG JAW CRUSHER--THE NEXT MORNING HIS L OWER BACK WAS SORE & SWOLLEN.

REPAIRING CONVEYOR BELT - TEMP WAS AROUND 100 DEGREES. HE WAS OVERCOME WITH HEAT. HE LAID DOWN IN SHADE AREA THEN PASSED OUT. HE HAD VOMITED EARLIER BUT WENT BACK TO WORK.

INJURED WAS HELPING CHANGE DUMP CABLE ON DRAGLINE BUCKET- HE WAS SHOVELING CABLE INTO SOCKET- ITJAMED CAUSING HIM TO HURT HIS BACK.

WAS PAINTING A WATER PUMP FLOAT HE WAS WALKING BACK WARDS & FELL INTO PUMP HOLE IN DECK HE INJURED HIS LOWER BACK

CHIPPING WELD AND A PIECE OF SLAGE WENT BEHIND HIS FACE SHIELD AND INTO HIS EYE.

WAITING FOR THE WORK BOAT TO PUSH FLATS OVER TO THE BANK TO HOOK A CHAIN ON IT TO PULL OUT OF THE WATER EE LOST HIS FOOTING AND FELL INTO THE WATER TWISTING HIS KNEE.

CREW WAS REMOVING CUTTER HEAD FROM DREDGE I.NAME WAS PINCHED BETWEEN LADDER BEAMS & SHAFT MOUNTED BEARINGS WHILE PULLING OFF WITH FRONT END LOADER