Millersburg Quarry Metal/Non-Metal

Stepped on nail while putting scrap in bin.

Employee was backing truck on stock pile to dump, positioned truck at an angle, upon lifting bed the truck tipped and landed on driver side.

Employee was trying to pry a rock loose from tail pulley. Pry bar slipped or dislodged and struck employee in left side of face and head. Hard hat and safety glasses being worn.

Employee was operating a hand drill, drill bit caught and caused drill to twist and spin. Finger was "jerked" and caused strain. Employee did not notify appropriate management official and report accident until 4/27/2016

Miner was pushing detachable trailer locking pin back in place. Pin resisted, when pin gave way, finger was pinched.

Employee tightening hammers on crusher. Ratchet slip and pinched finger between ratchet and crusher

Employee was power washing equipment (prepping for repair), reached to retrieve something with left hand and accidentally pulled trigger with right hand. Right arm was cut with power washer spray.

Heat Exhaustion

Lock lodged on machine, when dislodging the rock rolled and struck left hand.

While loading screen cloth from rocks to screen plant, EE pinched finger on loader bucket.

Accidental impact of pry bar during maintenance on crushing plant

While connecting a charger to battery of a dump truck, battery sparked and ruptured, sending acid at employee.

Employee replacing bearing on plant. While using hammer, small piece of steel lodged in eye.

Employee slipped on chain ladder and bruised ribs.

Swing gate/chute on plant impacted shins when hinge broke.

Employee accidently sprayed foot w/power washer, hot water resulted in burn.

Employee claims back injury related to loading scrap crusher hammers.

EMPLOYEE WAS CLEANING HOPPER. LARGE STONE ROLLED AND STRUCK EMPLOYEE'S PRY BAR. PRY BAR STRUCK LEFT LEG FOLLOWED BY STONE STRIKING PRY BAR AND BREAKING LEFT LEG.

EMPLOYEE WAS GETTING INTO DUMP TRUCK, SLIPPED ON RUNNING BOARD & TWISTED RIGHT KNEE. WEATHER WAS RAINY; RUNNING BOARD WAS WET.

EMPLOYEE PLACED 4" GRINDER ON WORK TABLE PRIOR TO WHEEL STOPPING. GRINDER SPUN AROUND & STRUCK HIS FINGER.

EE WAS INSPECTING AREA AROUND PLANT FOR BUILD UP UNDER CONVEYOR. ROCK FELL OR CAME FROM PLAT AND STRUCK IN HEAD.

THE STEERING WHEEL OF A EUCLID HAUL TRUCK JERKEDAND IMPACTED EMPLOYEE'S HAND ON THE DASH BOARD.

EE WAS CUTTING FLASHING WITH A UTILITY KNIFE. THE KNIFE CUT OPEN HIS THUMB ON HIS LEFT HAND.

DRIVER WAS GETTING INTO HIS DUMP TRUCK WHEN DOOR SLAMMED ON HIS FINGERS AND SMASHED THEM.

EE WAS WORKING ON PLANT--USING WELDER AND GRINDEER--HE DID USE HIS WELDING HELMET AND SAFETY GOGGLES, BUT AS THE WAS BLOWING DEBRIS WAS BLOWN INTO THE EE'S EYES, CAUSING DISCOMFORT.

EE WAS UNDER DUMP TRUCK PUTTING IN A PTO SHAFT. HE WAS LAYING ON HIS SIDE USING A LARGE HAMMER TO BEAT THE SHAFT INTO PLACE. WHEN THE VIBRATIONLOOSENED THE DIRT UNDERNEATH, FALLING INTO HIS EYE. HIS SAFETY GLASSES WERE IN PLACE,BUT THE CLUMP FELL AROUND THE SIDE.

EE WAS DRILLING. HE PUT HIS HAND ON THE DRILL AND AS THE HAMMER CAME DOWN SMASHED HIS FINGER. HE HAD ABSENTMINDEDLY PUT HIS HAND IN THE WRONG PLACE.

EE WAS DRIVING AN EUCLID ROCK TRUCK. SAID HE HIT A POTHOLE WITH THE FRONT TIRE CAUSING HIM TO LOSE THE GRIP ONT HE STEERING WHEEL. THE STEERING WHEEL SPUN AND THE KNOB ON THE WHEEL CAME AROUND AND HIT HIS ELBOW.

EE PINCHED THE SKIN ON HIS LEFT HAND WITH THE LEVER FROM THE SURGE BIN.

EE WAS USING A HAND HELD GRINDER ON A PIECE OF STEEL TO GO ONTO THE CRUSHER. HE WAS WEARING SAFETY GLASSES AND DID NOT REPORT THE INCIDENT FOR 7 DAYS. HE ALSO DID NOT GO TO A DR. UNTIL 7 DAYS AFTER THE ACCIDENT OCCURRED.

EMPLOYEE LOST HIS BALANCE GETTING OUT OF LOADER. HE HELD ON WITH ONE HAND AND SWUNG AROUND AND HIT HTE LOADER, THEN DROPPED TO THE GROUND.

WORKING NEXT TO WELDING , DEVELOPED FLASH BURNS TO EYE

THE EE WAS REMO5ING A CUTTING EDGE FROM A DOZER WITH A SLEDGE HAMMER & A PIECE OF METAL BROKE OFF & WENT INTO HIS LEG.

A POWER GRINDER3WAS BEING USED WHEN IT BECAME LODGED IT KICKED BACK & STRUCK OPERATOR IN KNEE.

WHILE HE WAS IN3THE PROCESS OF CUTTING A PIECE OF ANGLE IRON ANOTHER PIECE FELL ON HIS HEAD. HE WAS WEARING A HARD HAT, BUT IT WAS KNOCKED OFF CAUSING A SMALL CUT BEHIND HIS RIGHT EAR.