Stamper Quarry Metal/Non-Metal

EMPLOYEE STATES THAT HIS BACK HURT DUE TO SHOT ROCK BEING LOADED IN THE LOAD OF THE TRUCK HE WAS OPERATING, THE COMPANY IS SUSPICIOUS AS TO WHETHER THIS IS A LEGITIMATE CLAIM OR IF THIS INJURY OCCURRED THIS WAY.

EE WAS STEPPING DOWN THE LADDER OF A SCRAPPER. HE PLACED HIS FOOT ON UNEVEN GROUND AND SPRAINED HIS ANKLE.

EMPLOYEE WAS USING THE FIRE HOSE FROM THE WATER TRUCK, TO WASH OUT THE MUD FROM THE TRANSMISSION BELLY PANS OF TWO HAUL TRUCKS. THE NOZZLE END WAS HELD IN PLACE BY A HOSE CLAMP. THE HOSE BECAM E SEPARATED FROM THE NOZZLE. THE HOSE SLIPPED THROUGH HIS HAND AND THE HOSE CLAMP CUT HIS THUMB.

EE WAS CLIMBING INTO THE CAB OF THE EXCAVATOR. THE DOOR WAS LATCHED IN THE OPEN POSITION. EE UNLATCHED THE DOOR TO CLOSE IT BEHIND HIM. AS HE WAS CLOSING THE DOOR THE WIND CAUGHT THE DOOR & IT CLOSED ON HIS FINGER IN THE DOOR JAM.

EMPLOYEE WAS CUTTING A BELT TO PREPARE FOR SPLICING. WHILE CUTTING THE BELT THE KNIFE CAME OUT AND LACERATED HIS FOREARM. EMPLOYEE REQUIRED STITCHES TO HIS LEFT FOREARM.

EE WAS POWERWASHING MUD AND GREASE OFF OF THE TRANSMISSION THROUGH THE INSPECTION PLATE ON THE CATWALK OF LOADER. HIS FOOT WAS IN THE INSPECTION HOLE. THE WAND OF THE SPRAYER HUNG UP ON A HYDR AULIC HOSE. THE POWER WASHER WENT THROUGH HIS BOOT. THE HEATED WATER ENTERED HIS BOOT AND BURNED THE BOTTOM OF HIS FOOT GIVING HIM 2ND DEGREE BURNS.

EE WAS STEPPING OFF OF EQUIPMENT LADDER ONTO UNEVEN GROUND. HIS ANKLE ROLLED OVER. HE WAS TREATED FOR A SPRAINED ANKLE.

THE EE TURNED TO CLIMB STEPS TO THE CRUSHER CONTROL BOOTH WHEN HE TWISTED HIS KNEE.

EE HAD FINISHED FUELING VEHICLE AND WAS ATTEMPTING TO ENTER OPERATOR'S COMPARTMENT. HE PUT HIS FOOT ON THE TOP STEP OF SCRAPER WHEN HIS SLIPPED HE FELL BACKWARDS TO THE GROUND. EE STSATED THA T HIS BOOTS WERE MUDDY AND HIS GLOVES WERE WET. EE SUSTAINED A FRACTURED WRIST.

A DRILL AT STAMPER QUARRY CAUGHT ON FIE. EFFORTS BY EE TO EXTINGUISH THE FIRE WERE UNSUCCESSFUL. THE FIRE DEPT WERE CALLED AND PUT OUT THE FIRE. THE CAUSE OF THE FIRE ARE UNKNOWN AT THIS TIME.

THE EMPLOYEE WAS REMOVING COLD WEATHER CLOTHING ON THE WALKWAY OF THE DRESSLER HAUL-PAK HE IS ASSIGNED. THE FRONT END LOADER OPERATOR SHOOK THE VEHICLE WHEN HE BEGAN TO LOAD CAUSING HIM [INJUR ED] TO FALL APPROXIMATELY 6 FEET.

EE WAS TRAINING TO DRILL WITH OTHER HE NOTICED A CRACK ON THE COUPLER. HE THEN SHUT DOWN TO INFORM HIM HE GEGAN TO REPAIR THE DRILL AS EE WATCHED. EE REMOVED HIS SAFETY GLASSES TO WIPE THE SWE AT FROM HIS FOREHEAD HE STARTED TO BACK UP THE DRILL STEEL CAUSING A ROCK TO BECOME AIRBORNE. AND STRIKING EE IN THE RIGHT EYE.

I NAME WAS DRIVING WABCO STOCKPILE TRUCK BOUNCING IN TRUCK RESULTED IN A SORE BACK

I.NAME WAS REPACKING THE HOIST CYLINDERS ON A WABCO TRUCK. THE CYLINDER SLID DOWN AND PINCHED HIS FINGER AGAINST A WOOD BLOCK.

HE WAS CLIMBING UP TO THE CAB OF A WABCO TRUCK AND PUT HIS FOOT IN THE RUNG OF THE LADDER AND SLIPPED CAUSING STIFFNESS TO HIS NECK.

LOADER WAS BEIN1 SERVICED AND THE OPERATOR SLIPPED AND FELL FROM TIRE. THE RESULT WAS A SMALL HAIR LINE FRACTURE OF THE LOWER LUMBAR AREA TO ONE VERTABRA.

SLIPPED OFF GMC3TRUCK WHILE GETTING OFF SPRAINED BACK TO BE OFF FOR 1 WEEK

UNK HOW BACK IN4URED.SPRAIN COMPLEX OF 4TH LUMBAR.

I.NAME WORKING 2N ELJAY SCREEN REMOVING BEARING FROM SHAFT WITH CHISEL AND SPLINTER MADE IT PAST PROTCTIVE DEVICE ON SAFETY GLASSES AND STRUCK HIM IN LEFT EYE.

UNLOADING PUGMI5L FROM LOWBOY - CHAIN CAUGHT FINGER BETWEEN IT & PUGMILL ARM, CUT FINGER & BONE OF RIGHT HAND