Cada lesión y muerte que la MSHA tiene registrada. Filtra por estado, año, sector, clasificación, experiencia o cualquier palabra clave de la narrativa del investigador.
Envíame un correo cuando un nuevo incidente coincida con estos filtros. Un correo de confirmación; cancela la suscripción cuando quieras.
Operator was attempting to push the Breaker Switch into the "ON" position after a bad electrical storm, when the breaker blew up and burnt his right hand.
THIS ACCIDENT OCCURRED AS THE LABORER WAS ASSISTING OTHER PERSONS TO TIGHTEN AND ADJUST THE CONVEYOR BELT IN THE AREA OF THE HEAD PULLEY. AS HE WAS PUTTING PRESSURE ON THE BELT FOR SOME UNDETERMINED REASON HE SPRAINED HIS LEFT WRIST.
EMPLOYEE WAS WALKING AROUND THE CONVEYER AND SLIPPED 0N THE ICE. HE THEN FELL AGAINST THE TIRE OF THE CONVEYER AND BROKE HIS UPPER LEFT ARM.
Employee was attempting to get into the wheel loader with muddy boots. When he got onto the step or ladder of the loader, he slipped and hit his right knee on the step and fell to the ground. He did not seek medical attention until 11/20/07. He was treated & released.
Employee was lifting an electric motor with a come-along from the screen deck. When the motor got loose it swung and pinched his hand between the motor and a safety railing.
Employee was getting out of the jaw crusher after doing repairs. He bumped his left leg (shin) on a piece of steel. He thought he was OK, but after a few days his leg swelled, so on 9/27/2007 he went to the hospital to have it checked. He was treated and released.
EE was attempting to remove the back door of the jaw crusher & when he pulled out the bolts, the door fell onto his right hand & pinched it between door & angle iron. Went to hospital and was treated & released for bruised right hand.
Employee was attempting to loosen a nut on the jaw crusher. When the nut broke loose, the 17/8 inch wrench fell out of his hand and struck his head above his left eye, which caused a small cut above his eye which required a few stitches.
EE was attempting to get down from the generator trailed by using a ladder. When he put his foot on the top rung, the ladder kicked out from under him. He fell approx 5' to the ground and landed on his right side.
The loader operator was backing off the crusher ramp when the engine stalled and the brakes failed. The loader continued in reverse until it struck the stone berm. At that time the loader rolled over onto its side. The operator then crawled out of the cab onto the ground.
Employee was assisting the mechanic in repairing the loader. He was attempting to tighten a nut and when the wrench slipped off the nut he lost his footing and fell from the front fender to the ground and landed on top of a come-along tool.
Employee was checking the continuity on the 1-B conveyer switch and for an undetermined reason caused a flash back which caused burns to both hands and face, the employee did not get an electrical shaock.
EE IS A LOADER OPERATOR AND OVER A PERIOD OF 25 YEARS HE HAS BEEN DIAGNOSED WITH SPLIT EXTENSOR TENDONITIS OF THE RIGHT THUMB AND IS ALSO HAVING PROBLEMS WITH HIS LEFT THUMB DUE TO REPETIVE MOTION WHEN OPERATING THE BUCKET ON THE LOADER. EMPLOYEE WILL BE OPERATIED ON 2/22/05. THE REASON FOR THE DELAY OF THIS REPORT IS DUE TO THE UNKNOWN EXACT DATE OF INJURY.
EE was using a hammer to repair a roller pin and was putting the bearing back onto the pin. When he went to strike the pin with the hammer he missed the pin and hit his left left hand that was holding the pin.
Employee was operating a water truck on the quarry ramp and stated he lost his brakes and could not stop the truck. To stop the truck he ran into a large rock near the bottom of the ramp. Due to extensive damage, it was difficult to determine if the brakes were faulty.
EMPLOYEE WAS ASSISTING ANOTHER EMPLOYTEE WELDING ON A PIECE OF EQUIPMENT (LOADER). AS HE WAS TRYYING TO KNOCK OFF THE WELDING SLAG, A PIECE OF SLAG OR METAL WENT INTO HIS LEFT EYE. HE WAS WEAR ING EYE PROTECTION WHEN THIS INCIDENT OCCURRED. HE WENT TO AN OPHTHAMOLOGIST FOR TREATMENT. HE WAS TREATED AND RELEASED.
EE WAS SITTING IN BED OF PICKUP TRUCK HOLDING DOWN A DRUM OF OIL. THE OPERATOR OF THE PICKUP RAN OVER A POTHOLE IT CAUSED THE EE TO COME UP AOFF THE FLOOR OF THE REAR BED AND LAND BACK DOWN ONTO HIS BUTTOCKS(COCCYX BONE) WHICH GAVE HIM SOME PAIN THROUGHOUT THE DAY. THE NEXT DAY EE TOOKHIMSELF TO HOSPITAL FOR TREATMENT. HE WAS RELEASED WITH NO RESTRICIONS.
EE WAS SHOVELING MATERIAL UNDER THE #3 SCREEN DECK WHEN A ONE FOOT DIAMETER ROCK FELL OFF AND STRUCK THE EE ON HIS LEFT SHOULDER AND BACK.
A LOADER OPERATOR, AFTER LOADING A 10-WHEELER DUMP TRUCK, ASSISTED THE DUMP TRUCK DRIVER IN FREEING A STONE WHICH WAS JAMMED BETWEEN THE BED OF THE TRUCK & THE TAIL GATE. AFTER FREEING THE STO NE, THE TAIL GATE PINCHED THE LOADER OPERATOR'S RIGHT MIDDLE FINGER. NO SUTURES WERE REQUIRED. THE HOSPITAL GAVE HIM SOME LIGHT PAIN MEDICATION.
WHILE LIFTING A 150 LB STEEL IMPACTOR HAMMER TO REPLACE BACK INTO THE STONE CRUSHER EE PULLED HIS RIGHT KNEE CAP. IT IS UNDETERMINED IF THIS IS A REPORTABLE INCIDENT DUE TO THE FACT HE LOST NO DUTY TIME AND DID NOT TAKE MEDICATION. HE DID NOT GO FOR MEDICAL TREATMENT UNTIL FRIDAY AFTER WORKING TWO FULL SHIFTS.
EMPLOYEE WAS PULLING A HOSE WHEN THE HOSE GOT STUCK ON A ROCK AND HE PULLED AND STRAINED HIS SHOULDER. THE EE CONTINUED TO WORK AND DID NOT REPORT THE INJURY OR SEEK MEDICAL ATTENTION UNTIL 7-22-02. IT IS UNDETERMINED IF THIS INCIDENT IS A REPORTABLE INCIDENT DUE TO THE FACT THE EE DID NOT LOSE ANY TIME OFF, AND HE TOOK NO MEDICATION.
WHILE CLEANING OFF THE SCREEN DECK THE LABORER PLACED HIS LEFT HAND ON THE CATWALK STEP TO BRACE HIMSELF, WHEN A ROCK ROLLED OFF THE BELT AND STRUCK HIS LEFT HAND. EE WAS TERMINATED DUE TO FACT HE NEVER CALLED INTO WORK OR CAME BACK TO LIGHT DUTY WORK.
EE WAS REPAIRING A 20 FT VIBRATING FEEDER (WHICH WAS TAGGED OUT & LOCKED OUT FOR SERVICE) & WHILE PULLING ON THE DRIVE BELT WITH HIS RIGHT HAND HIS LEFT HAND POINTING FINGER GOT PINCHED BETWEE N THE DRIVE PULLEY & THE BELT.
EE WAS BACKING THE LOADER OUT FROM THE MODIFIED STONE PILE WHEN THE STEERING WHEEL SPUN AROUND AND JAMMED HIS LT. ARM BACK CAUSING INJURY AND PAIN TO HIS LT. SHOULDER.
EMPLOYEE WAS LIFTING A SEAT TO INSTALL IT ONTO THE 175C MICHIGAN LOADER AND STRAINED HIS LEFT SHOULDER.
WAS WORKING ON TOP OF CRUSHER AND WAS BENDING OVER RAIL TO PULL A BUCKET OF TOOL UP WITH A ROPE AS HE WAS PULLING THE ROPE HE STRAINED HIS BACK WHICH HE HAD ALBREADY INJURED FROM A PREVIOUS IN JURY AT ANOTHER PREIVOUS EE . EE CAME BACK TO WORK ON 2-28-02 BUT WENT TO HOSPTIAL ON 3-5-02 FOR TREATMENT. WAS OFF SIDE 3- & 5-02.
EE WAS STEPPING DOWN OFF OF THE EUCLID DUMP TRUCK AFTER CHECKING THE ANTI FREEZE LEVEL IN THE ENGINE. HE STEPPED ONTO THE BUMPER AND THEN ONTO THE STEP AND LOST HIS FOOTING AND FELL ONTO THE G ROUND. HE STATED THAT HE WAS HAVING PROBLEMS WITH HIS KNEE AND IT WAS POSSIBLE HIS KNEE GAVE OUT.
EE WAS GRINDING A JAW DYE WITH A GRINDER AND THE GRINDER SLIPPED AND CUT HIS RIGHT KNEE. THERE WAS NO DAMAGE TO ANY EQUIPMENT, ONLY A KNEE INJURY.
WHILE SHOVELING STONE THE EE SUSTAINED A STRAIN TO HIS GROIN AREA.
EE WAS INSTALLING A NEW ELECTRIC MOTOR ON A CRUSHING PLANT WHEN THE OTHER PERSON EE. WHO WAS HELPING HIM HOLD THE HEAVY MOTOR LOST HIS GRIP AND THE MOTOR FELL ONTO EE S LEFT RING FINGER AND CU T SAME REQUIIRNG STITCHES.