Buscar en el registro

EMPLOYEE WAS REMOVING BOLDER FROM ROADWAY IN MINE, THE BOLDER ROLLED BAK ON TO HIS LEFT FOOT CAUSING CRACKING BONE.

EMPL REMOVING CABLES FROM OVERHEAD CRANE BUCKET CABLE STRUK LITTLE FINGER ON LEFT HAND CAUSING SIMPLE DISLOCATION.

AS EMPLOYEE WAS ATTEMPTING TO STRAIGHTEN A SEPARATOR SLIDE THAT WAS IN PLACE THE WELD BROKE CAUSING THE SLIDE TO STRIKE HIM IN THE FACE HE SUSTAINED A LACERATION TO THE LOWER LIP REQUIRING 3 SUTURES

EMPLOYEE WAS CL3MBING A LADDER,TURNED AND STRUCK LEFT KNEE.

EMPLOYEE WAS HE5PING TO CHANGE SCREENS IN THE 8 FT X 16 FT VIBRATOR ON PLANT 12 HE AND A COWORKER WERE PUTTING A 4 FT X 4 FT SECTION IN PLACE AND HE CAUGHT HIS FINGER BETWEEN THE SCREEN AND CENTER RAIL HE3WAS WEARING WORK GLOVES

EMPLOYEE WAS TU9NING LARGE NUT ONTO BOLT (30-35LBS)THAT SECURES GYRATORY SHELL.ANOTHER EMPLOYEE WAS PUSHING UP ON BOLT TO ALLOW ROOM TO TURN NUT.THE BOLT DROPPED DOWN AND CAUGHT INJURED EMPLOY EE'S FINGER BET4EEN BOTTOM OF NUT AND SHELL.

EMPLOYEE WAS GE7TING INTO THE CAB OF DOZER & AS HE REACHED FOR THE DOOR LATCH HE SPRAINED HIS BACK

EE WAS LIFTING 2' SECTION OF 8" PIPE TO PUT BACK ON SLURRY PUMP & STRAINED HIS BACK.

EMP STATED THAT3HE WAS THROWING A PIECE OF OLD CONDUIT INTO A PILE WHEN IT BOUNCED BACK AND STRUCK HIS FINGER MASHING IT AGAINST A RAIL

EE WAS GREASING3TRACK ROLLER ON 4600 CRANE. AS HE WAS STRETHCING TO REACH GREASE FITTING UNDER TRACK PADS HE STOOD UP & STRUCK HIS HEAD WEARING HARD HAT ON TRACK SPRAINING HIS NECK.

EMPLOYEE STATED3THAT HE WAS REPLACING THE METAL LID 5 INCH DIA X 1/2 INCH THICK ON THE AIR SLIDE WHEN HIS FINGER BECAME PINCHED BETWEEN THE LID AND THE HOUSING.

EE STATED THT H9 WAS SLIDING A SECTION FO USED CONVEYOR BELTING OVER A HADNRAIL WHEN HIS FINGER WAS PINCHED BETWEEN THE BELTING & THE EHANDRAIL.

AS TWO EMPLOYEE8 WERE MANUALLY LIFTING A FEEDER TO PLACE IT ON TWO STANDS, IT FELL LANDING ON THE TOP OF THE INJURED EMPLOYEE S FOOT.

EMP WAS ADJUSTI3G THE FORK ON A FORKLIFT TRUCK WHEN IT SLIPPED OFF AND STRUCK HIM ON THE RIGHT FOOT

EMP WAS ASSISTI3G TWO OTHER EMPLOYEES IN MOVING A SECTION OF METAL RAMP WHEN THE CORNER SLID OVER HIS FINGERS

EMPLOYEE STATED3THAT HE WAS REMOVING A COUPLING FROM A SHAFT INSIDE #2 CEMENT COOLER WHEN HIS HAND BRUSHED AGAINST A SHARP EDGE OF THE KEY WAY

WHILE EMPLOYEE 4AS DRAGGING AND LIFTING A 4" FEXIBLE HOSE, HE FELT A PAIN IN THE RIGHT SIDE OF HIS LOWER BACK

EMPL LIFTING SECTION OF METAL SCAFFOLD END FRAME.HE TWISTED AND FELT PAIN IN HIS BACK.

EMPLOYEE WHEN HE BEND OVER TO PICK UP A HAND PUMP GREASING CAN HE FELT PAIN IN HIS NECK AND SHOULDERS.

EMP STATED HE WAS HELPING ANOTHER EMPLOYEE TO POSITION A 16X8 SECTION OF PIPE ONTO A CART WHEN HE FELT PAIN IN HIS LOWER BACK

EMPL MOVING MOTOR.WHILE MOVING MOTOR HE HURT BACK CAUSING LOWER BACK STRAIN.

EMPL HOLDING UP OVERHEAD GARAGE DOOR WHILE ADJUSTING ROLLERS.HAND PUSHED THROUGH GLASS WINDOW IN DOOR.

EMPL SHOVELING WASTE MATERIAL INTO BAGS ON TOP OF FINISH SILOS.HE PICKED UP FULL BAG AND TWISTED INJURING HIS BACK.

STANDING IN THE CONTROL CAB OF #2 STORAGE CRANE WITH ANOTHER EMPLOYEE THE OTHER EMPLOYEE CLOSED THE METAL DOOR OF THE CAB ON TEH MANS LEFT THUMB

HELPING REPAIRMAN REPLACE WORN INION SHAFT ON #2 STORAGE CRANE,HAND BRUSHED AGAINST WORN METAL EDGE CAUSING LACERATION TO LEFT MIDDLE FINGER REQ 5 STITCHES.

ASSISTING WITH INSTALLATION OF LARGE BEARING INTO BEARING HOUSING WHILE HOLDING BEARING ON WOODEN SHAFT MOVED FORWARD TO INSERT BEARING RT FOOT BECAME CAUGHT ONE EDGE OF WOODEN PALLET, CAUSING RT LEG TO ROLL INWARD. FURTHER AGGRAVATED LEG IN DEC. CAUSING KNEE PAIN

THE INJURED EE & 3 C/-WORKERS WERE REPLACING THE BUCKET TEETH ON A DRAGLINE CRANE & ALSO TURNING THE DRAG CABLE LINKS TO PROLONG THE USE OF THE CHAIN. WHILE THE EE WAS HELPING LIFT THE CHA IN HE PULLED A MUSCLE IN HIS LOWER BACK.

EMPLOYEE WAS HELPING TO STEAMCLEAN A DRAGLINE CRANE. HE AND THE FIELD FOREMAN WERE GOING TO MOVE THE STEAM JENNY SEVERAL FEET BY HAND TO ALLOW THE WATER AND SOAP CONTROL TO BE MORE EARILY VISI BLE. WHEN THEY PULLED ON THE JENNY THE FRONT WHEEL FELL FROM THE TRAILER TONGUE AND AS IT DROPPED DOWN A BURR ON THE TONGUE LACERATED HIS F INGER. EMPLOYEE WAS NOT WEARING GLOVES.

IN ATTEMPTING TO HELP ANOTHER EMPOYEE MOVE A STEEL DISK (1 1/4 IN. X 20 IN DIA., WT. APPROX. 100 LBS.) TO LOAD INTO A TRUCK, THE MAN STUCK HIS FINGER INTO A LINE-UP HOLE IN THE DISK. WHEN THE DISK WAS MOVED HIS FINGER WAS STUCK AND CUT. (FINGERTIP WAS REATTACHED AT HOSPITAL EMERGENCY ROOM)

EE WAS HELPING PUT SPACERS ON THE REAR DRIVE TUMBLER SHAFT ON UNIT 223. THE CRANE WAS NOT BLOCKED AT THE T IME & AS THE EE REACHED TO PUT A NIT'**' NUT ON THE SHAFT BOLT, THE HOIST BRAKE SLIP PED & THE CRANE BODY DROPPED DOWN CAUSING THE SHAFT TO ROLL AGAINST THE NUT CATCHING HIS FINGER.

WHILE ATTEMPTING TO MOVE A COMEA LONG THE CHAIN BECAME ENTANGLED IN HIS FEET HE FELL BACKWARD STRIKING HIS HEAD ON A PALLET JACK HAND TRUCK

WHILE ASSISTING ANOTHER EMP IN OPENING A SWIVEL MOUNTED DOOR ON A RAW MILL HIS LEFT INDEX FINGER BECAME PINCHED AS THE DOOR SWUNG OPEN AND STRUCK A CROSS LATCH BAR

EMPLOYEE WAS REMOVING BRAKE DRUM STUDS WHEN HIS RIGHT HAND CAME IN CONTACT WITH THE SHARP EDGE OF THE OIL SEAL AND LACERATED THE BACK OF HIS HAND SIX SUTURES REQUIRED

EMPLOYEE WAS WORKING ON JAW CRUSHER. HE WENT TO GET A CHISEL FROM THE TOOL BOX (HANDMADE IN SHOP WITH 1/4" STEEL). AS HE WAS LOOKING INTO THE BOX, THE LID FELL CATCHING HIS HEAD BETWEEN THE LI D AND THE EDGE OF BOX. A LID SUPPORT HAS BEEN INSTALLED SINCE ACCIDENT.

ADJUSTING UNDERGRATE TIPPING VALVE ON 5 COOLER,GLOVED HAND BECAME PINCHED AS AIR CYLINDER MOVED.LACERATION AND BROKEN BONE IN END JOINT,MIDDLE FINGER LEFT HAND-25 STITCHES.