Buscar en el registro

EMPL CUTTING CONVEYOR BELT AND SLIPPED CUTTING HIS CHEST.REQ STITCHES & BANDAGE.

EMPLOYEE WAS PRYING MATERIAL OUT OF FEEDER WHEN MATERIAL FELL & PINCHED FINGER BETWEEN BAR & BINFX INDEX FINGER & CONTUSED MIDDLE & RING FINGER

EMPL WAS LOOSENIING BOLTS ON A FAN HUB THE WRENCH SLIPPED OFF THE BOLT MIDDLE KNUCKLE ON L HAND STRUCK FAN BLADE BRUISED KNUCKLE AND PINCHED A TENDON

THE EMPLOYEE WAS UNTHREADING LOCK BOLTS OUT OF THE 4800 CRUSHER. THE BOLT CAME LOOSE CAUSING THE PRY BAR TO OVE QUICKLY, PINCHING HIS FINGER BETWEEN THE CRUSHER AND PRY BAR.

EMPLOYEE WAS REMOVING A 1 1/2" X 37" BOLT FROM THE PRIMARY CURSHER WITH A SLEDGE HAMMER WHEN A SLIVER OF STEEL CAME FROM THE BOLT AND LODGED IN HIS LEG.

EMPL DID NOT CHECK WORK AREA TO SEE IF HAD HOLD BOOM TO USE SLEDGE OVERHEAD

EMPLOYEE WAS LOOSENING ADJUSTMENT NUT ON DRAG FRICTION WHEN THE WRENCH SLIPPED OFF THE NUT AND PINCHED THE LITTLE FINGER ON LEFT HAND BETWEEN THE WRENCH AND THE DRAG CABLE.

A PIECE OF CHISEL BROKE OFF & HIT CHEST

EMPLOYEE WAS POUSHING A PC.OF ANGLE WITH A HAMMER THE HAMMER SLIPPED OF FHITTING EMPLOYEE IN LOWER LIP REQUIRING 3 STICHES & A CHIPPED TOOTH

IMPROPER USE OF KNIFE.

EMPLOYEE WAS HOLDING WRENCH TO SLEDGE UP WHEEL LUG NUT, WRENCH CAME OFF OF NUT, AND FELL TO INSIDE OF RIM. HIS HAND WAS BETWEEN, WRENCH AND RIM.

EMPLOYEE WAS CLEANING A CHUTE WHEN HE HIT HIS AHND ON THE CHUTE BRUISING IT.

WHILE WORKING ON GREASE GUN CRESENT WRENCH SLIPPED OFF GREASE GUN CAUSING FINGER TO HIT STEEL BENCH CAUSING LACERATION TO FINGER.

EMP. WAS USING A BAR TO DIG UD OUT INSIDE OF A CHUTE AND CAUGHT HIS FINGER BETWEEN THE BAR AND THE SIDE OF THE CHUTE.

ADJUSTING TAIL PULLEY ON TUNNEL BELT WRENCH SLIPPED HTI TAIL PULLEY CAME BACK OUT AND HIT JAW RESULTING IN CUT JAW BROKEN TOOTH CHIPPED TWO TEETH

EMPLOLYEES WERE ADJUSTING HEIGHT OF 5X12FT.ACSCREEN THEY LOWERED THE FRONT END DOWN & STARTED THE SCREEN BY LOWERING THE FRAME END IT CAUSED THE BACK END TO HIT THE FEED BOX WHICH CAUSED THE P PLANT TO VIBRATE CAUSING PIECES OF RUST TO FALL ONE PIECE 6IN.INX7IN.HIT EMPLOYEE ON THE LIP TOOK TO MERCY HOSPITAL 6 STITCHES REQUIRED & TETANUS SHOT

LACK OF KNOWLEDGE OF JOB EMPLOYEE HAD SEEN BIGGER MEN USE PRY BAR IN SAME MAMMER AND THOUGHT HE COULD ALSO.

EMPL USING BALL PEEN HAMMER AND AN ARCH PUNCH TO PUNCH HOLES IN CONVEYOR BELT WHEN HE MISSED PUNCH AND HIT LEFT THUMB.

EMP WAS ATTEMPT3NG TO ALIGN BOLT HOLES WITH A DRIFT PUNCH AND A HAMMER. WHEN STRIKING THE PUNCH THE HAMMER, THE PUNCH BROKE AND EMBEDDED A SLIVER OF STEEL IN HIS ARM

THE EMPLOYEE WA8 USING A PICK TO DISLODGE COMPACTED DIRT FROM THE WALL OF THE UNDERSIZE CHUTE. THE EMPLOYEE WAS USING SHORT STROKES TO FREE THE DIRT WHEN THE PICK CAME IN CONTACT WITH SOME SOL ID MATERIAL GLA3CING THE PIKC IN A DOWNWARD DIRECTION STRICKING THE EMPLOYEE ON THE INSIDE OF HIS LEFT FOOT.

EMPLOYEE WAS TI1HTENING BOLTS IN AIR HAMMER AND PULLED TOO HARD PULLING MUSCLES IN LOWER ABDOMEN.

EMPLOYEE WAS AT7EMPTING TO DRIVE RUBBER SLEEVE TO A PIPE HE HIT A GLANCING BLOW AND SLEDGE HAMMER BOUNCED BACK AND STRUCK RT SHIN BETWEEN ANKLE AND KNEE CAUSING BRUISE

EMPLOYEE WAS US3NG A PRY BAR TO LOOSEN A HAMMER AT THE PRIMARY CRUSHER WHEN IT SLIPPED AND HIS HAND WAS CAUGHT IN BETWEEN

EMPLOYEE WAS SW3NGING A 16 POUND SLEDGE HAMMER IN A CONFINED WORK SPACE (SUMP AREA) AND AS A RESULT, HE STRAINED HIS BACK.

WAS HOLDING PUN7H IT CUT HIS FINGER.DOES NOT KNOW HOW HE DID IT.

HIT RIGHT ELBOW3ON STEEL BEAM

EMPLOYEE WAS TY3NG REBAR WHEN KLINE PLIERS SLIPPED AND EMPLOYEE JERKED PLIERS BACK AND CAUGHT PLIERS ON TWO FRONT TEETH.

I.NAME WAS REPA3RING FENDER ON TRUCK WHEN SMALL PIECE OF FIBERGLASS GOT INTO HIS EYE CAUSING SMALL CUT ALONG SURFACE OF EYE.

EE WAS USING A 2AMMER & BRASS DRIFT TO INSTALL A BEARING ON A GEAR BOX. A CHIP OF BRASS WENT INTO HIS EYE. IT MAY HACE BEEN RUBBED IN WHEN HE RUBBED HIS EYES. HE WAS WEARING SAFETY GLASSES W ITH SIDESHIELDS1

KELLY ON DRILL3WAS STUCK AND I NAME AND I NAME WERE USING PIPE WRENCH TO LOOSEN IT WHEN WTRECCH SLIPPED OFF HITTING I NAME ON RIGHT ELBOW AND RIB CASGE STITCHES TO RIGHT ELBOW AREA AND BRUI RIBS 3

EMPLOYEE WAS TIGHTENING A BOLT ON 275 B MICHIGAN LOADER WHEN THE WRENCH SLIPPED OFF THE BOLT AND HE HIT HIS ELBOW ON BOTTOM OF SEAT.

EMPLOYEE HIT LEG WITH SLEDGE HAMMER WITH A LIGHT BLOW. INJURY WAS SO SLIGHT THATH IT DID NOT EVEN WARRENT FIRST AID TREATMENT. SEVERAL DAYS LATER CELLULITIS DEVELOPED AND THE EMPLOYEE HAD TO MIS WORK. STARTED MISSING TIME ON 10/18/84.

INJURED WAS POKING PLUGGED FEEDER WITH RID. HIS %*%*% HIT HIS FINGER AGAINST BRACE.

WHEN BARY ALLISON WASATTEMPTING TO BREAK STEEL ON DRILL THE STEEL STARTED TO ROTATE CAUSING PIPE WRENCH TO SMASH HIS HAND BETWEN WRENCH AND BOOM OF DRILL