Buscar en el registro

Employee was changing bags in the dust collectors and the repetitive motion of using a screwdriver and ratchet may have caused the swelling. Note: Lost time began 8/26/05.

EMPLOYEE STATES THAT BELT 001 WAS FROZEN TO TAIL PULLEY AND ROLLS AND THAT HE WAS PRYING BELT LOOSE WHEN HE STRAINED HIS BACK.

WHILE EE WAS OPENING A PALLET OF BAGS WITH A UTILITY KNIFE, THE KNIFE SLIPPED AND CUT THE INSIDEOF HIS LEFT FOREARM.

WHILE EE WAS CUTTING UP CARDBOARD BOXES WITH A STANLEY KNIFE HIS HAND SLIPPED AND THE KNIFE WENT INTO HIS LEFT THIGH.

EMPLOYEE WAS SWINGING A SLEDGE HAMMER TRYING TO BREAK A LARGE ROCK IN THE JAW CRUSHER HOPPER AND MISSED HITTING HIS ELBOW ON THE SIDE OF THE HOPPER.

EMPLOYEE HURT HIS LEFT WRIST CLEANING FROZEN MATERIAL OFF OF THE PAN FEEDER. HE WORKED UNTIL 1-17-91 THEN WENT TO THE DOCTORS AND THE DOCTOR TOLD HIM TO TAKE A FEW DAYS OFF.

EMPLOYEE WAS SLAGGING A PIECE OF STEEL AND A PIECE OF SLAG GOT IN HIS RIGHT EYE.

EMPLOYEE WAS USING A BEARING PULLER TO PULL A BEARING & WHEN HE BENT OVER HE PULLED A MUSCLE IN HIS BACK

EMPLOYEE WAS PUTTING A SHAFT IN A TAIL PULLEY, WHILE HE WAS KNEELING DOWN TIGHTENING A NUT ON A BEARING HE FELT A PAIN IN HIS LOWER BACK.

EMPL WAS USING A HAMMER AND A PUNCH TO DRIVE CONNECTING SHAFT INTO SCREW CONVEYOR SCROLL SECTION STEEL SLIVER FROM PUNCH PIERCED EMPLS L WRIST TOP SIDE CUT AN ARTERY AND IMBEDDED IN MUSCLE NEX T TO WRIST BONE

THE TRACK SLIPPED OFF THE DRILL AND WAS ATTEMTPING TO REPLACE IT ABCK ON THE DRILL.TRACK WAS PINCHED SO I HIT IT WITH A SLEDGE AHAMMER TO LOOSEN IT.WHEN I HIT IT A PICE OF STEEL EMBEDDED ITSEL F INTO MY UPPER LEFT THIGH.

EMPL WAS MAKING BAG OPENER. WHILE SHARPENING ONE EDGE OF PIECE OF ANGLE HE DROPPED HIS FILE. WHEN HE BENT DOWN TO PICK IT UP HE HIT BACK OF HIS FINGER ON EDGE OF ANGLE.

WAS LOOSENING A NUT ON A LANGER. WRENCH SLIPPED AND THE BACK OF HIS RIGHT HAND STRUCK THE NUT AND CUT IT.

EMPL WAS TIGHTENING NUTS ON FLANGE & WRENCH SLIPPED HITTING HIM IN MOUTH.

EMPLOYEE WAS SCRAPING THE SIDE OF 13 ELEVATOR WITH A PIECE OF ANGLE IRON. THE ANGLE WENT THROUGH A HOLE IN THE ELEVATOR CAUGHT ON A BUCKET AND THE BUCKET THREW THE PIECE OF ANGLE BACK STRIKING HIM ABOVE THE RIGHT EYE.

EMPLOYEE WAS CUTTING DAMAGED SALT CANS OPEN WITH A BOX CUTTER KNIFE TO RECLAIM THE SALT.AS HE WAS CUTTING THE TOP OF THE CAN,HE PULLED ON THE KNIFE HARD ENOUGH TO CUT NOT ONLY THROUGH THE CAN, BUT ALSO HIS THUMB.CUT REQUIRED STITCHES.

EMPL BANGING ON3 PIPE WITH HAMMER AND TURNED HIS WRIST.

OPENING RAIL CA9 DOOR WITH PRY BAR AND BAR SLIPPED STRIKING EMPL ON MIDDLE FINGER OF RIGHT HAND.

EMPLOYEE WAS RE1AIRING PALLETS AND ONE OF THE 1" X 4" FACING BOARDS HAD A PIECE OF A STRINGER STILL ON ONE END. EMPLOYEE WAS HOLDING THE FACING BOARD WITH HIS LEFT HAND, HITTING AT THE PIECE O F STRINGER WITH3A HAMMER. EMPLOYEE HIT HIS LEFT THUMB WITH THE FACE OF THE HAMMER, PINCHING HIS THUMB BETWEEN THE HAMMER AND THE EDGE OF THE BOEARD. EMPLOYEE WAS PRESCRIBED 250 MG. KEFLEX.

EMPLOYEE WAS TI1HTENING A 2 IN X 1 IN REDUCING BUSHING INTO A 2 IN TEE WHICH WAS PLACED IN A VISE IN MACHINE SHOP WITH A 24 IN PIPE WRENCH THE PIPE WRENCH SLIPPED CAUSING EMPLOYEE TO FALL BAC KWARDS PUTTING 5 STRAIN ON HER LEFT LEG

TIGHTENING A NU7 ON A CRUSHER HURT HIS KNUCKLE.

PULLED STRAINED3MUSCLE IN BACK WHILE CRANKING UP THE LEGS IN A TRAILER.

EMPLOYEE WAS AT7ACHING HOSE CLAMPS TO A 3/4 HOSE HOLDING THE HOSE IN HIS HAND AND TIGHTENING THE HOSE CLAMP WITH A SCREWDRIVER AS HE WAS ATTACHING THE LAST HOSE CLAMP THE SCREWDRIVER SLIPPED O UT OF THE SLOT 3N THE CLAMP AND PUNCTURED EMPLOYEES LEFT HAND THIS PUNCTURE BECAME INFECTED REQUIRING PRESCRIPTION MEDICATION

EMPLOYEE WAS USING A 5\ STEEL BAR TO LOOSEN FINESALT IN A FINE SALT BIN. A SMALL WALL OF SALT FELL, CATCHING LOWER END OF STEEL BAR, FORCING IT TO SWING. UPPER END OF BAR SWUNG OPPOSITE DIRECT ION, HITTING EMPLOYEE IN THE MOUTH AND SPLITTING HIS LOWER LIP AND LOOSENING AND CHIPPING A TOOTH. CUT TO LIP REQUIRED STITCHES.

EMPLOYEE WAS USING A WRENCH AND THE WRENCH SLIPPED OFF OF THE NUT CAUSING THUMB TO BE STRUCK BETWEEN SCOOP FRAME AND WRENCH. FRACTURED TIP OF BONE ON RIGHT THUMB.

EMPLOYEE HAD BEEN REPAIRING WINDOW PANES. THIS INVOLVED CHIPPING OLD GLAZING COMPOUND FROM THE FRAMES. THE FRAMES WERE RUSTY AND IT IS POSSIBLE THAT THE RUST CAME FROM THIS JOB. EMPLOYEE NOT ICED AN EYE IRRITATION THAT EVENING AND WAS SENT TO DOCTOR THE FOLLOWING DAY. DOCTOR REMOVED FOREIGN PARTICLE BY DISSECTION.

PRY BAR SLIPPED AND HIT EMPL ON SIDE OF HEAD.SMALL CUT ON SIDE OF HEAD.2 STITCHES USED TO CLOSE CUT.

EMPLOYEE WAS CUTTING P-IECE OF BELT FOR CONVEYOR HIS KNIFE SLIPPED CUTTING LEFT INDEX FINGER CUT REQUIRED 5 STITCHES

EMP WAS CLEANING UP IN MILL SCOOPING SALT FROM UNDER THE AROUND BELTS WHEN HE PULLED BACK WITH SHOVEL HE BUMPED HIS LEFT ELBOW ON FRAMEWORK IN MILL EMP BRUISED ELBOW ON 3-8-83 EMP WENT BACK TO DR AND WAS PLACED ON 1 DAY LI-GHT DUTY

WRENCH SLIPPED OFF NUT HEAND HIT PROTRUDING BOLT

EE WAS TRYING TO DISLODGE PIECE OF ORE IN CRUSHER USING A PRY BAR, BAR SLIPPED & STRUCK HIM IN THUMB. EE\S WERE NOTIFIED PRIOR TO INCIDENT NOT TO USE THIS METHOPD TO DISLODGE ORE IN CRUSHER.