Buscar en el registro

While an employee was using a torch to thaw a water line, a Rock came off the plant and struck the employees right hand.

Employee reached up through a guard to check belts shortly after the machine turned off. The machine was still in motion and the belts took the employee's fingers through the pulley.

Employee was testing the operation of a crank on a winch. While testing the handle came out and struck the employee.

Performing engine repair on 992C Wheel Loader. Cleaning air filter with sanding pad attachment. Piece of metal flew into Left eye. Eye became irritated next day. Given Rx and referred to ophthalmologist 7/13.

Employee was using a cutting wheel to cut a bearing out of a crusher. While cutting the bearing the wheel kicked back and cut the employees right arm.

Employee was working with other Employees to cut up a low-boy trailer using an oxygen-acetylene torch. Immediately upon finishing his cut, the piece of steel fell on his right foot.

EE WAS WORKING WITH OTHER CREW MEMEBERS REMOVINGTHE GRIZZLY FROM THE PUGMILL TRANSFER BOX. THE 6000 LB GRIZZLY WAS LIFTED STRAIGHT UP BY THE CRANE OPERATOR. AS IT WAS LIFTED IT SWUNG TOWARDS THE CONTROL HOUSE. EE ATTEMPTED TO GUIDE THE GRIZZLY AWAY FROM THE CONTROL HOUSE TO PREVENT DAMAGE TO IT. IN DOING SO, HIS RIGHT INDEX FINGER WAS CRUSHED BY GRIZZLY AGAINST A HANDRAIL

REPAIRING FLAT TIRE - DIE GRINDER CAME APART WHILE BUFFING THE INSIDE A TIRE TO PATCH. BUFFING WHEEL HIT RIGHT HAND & BRUISED HAND BETWEEN MIDDLE & INDEX FINGER.

EE WAS CUTTING STRAPS THAT HELD DUCTWORK. WHEN HE CUT ONE OF THE REMAINING STRAPS, THE WEIGHT OF THE DUCTWORK FORCED THE EE TO HOLD THE WORK, CAUSING THE LADDER TO SLIP AND FALL. THE EE FELL 5 -6 FT INTO AN OPEN BARREL WITH ONE LEG IN AND THE OTHER LEFT OUT.

REPAIRING DUMPTRUCK GOT SLAG IN RIGHT EYE.

THE EE WAS HOLDING A CABLE IN HIS HANDS WHICH WAS USED TO UNSCREW THE TELESMITH 44FC CRUSHER. THE LOADER OPERATOR TIGHTENED THE CABLE WITHOUT THE EE S KNOWLEDGE.

WELDING HAND RAIL ON CATWALK-PIECE OF 2 X 2 ANGLE FELL ON RIGHT LEG AT THE KNEE.

WHILE USING CUTTING TORCH, DEBRIS CAUGHT IN RIGHT EYE.

WAS GRINDING & PIECE OF STEEL WENT BY GOGGLES HE WAS WEARING.

EMPLOYEE WAS USING OXYACETYLENE TORCH TO CUT A BOLT HOT SLAG FELL INTO SHOE EMPLOYEE WAS WORKING SYNTHETIC FIBRE SOCKS MATERIAL MELTED CAUSING A BURN TO HIS ANKLE

EMPL IN PRONE POSITION INTERMITTENTLY USING AIR WRENCH HELPING TO CHANGE GRIZZLEY BARS.OVEREXTENDED HIS LEG BRACING HIMSELF.HAD SUFFERED TORN LIGAMENTS IN SAME KNEE 5 MOS EARLIER.TORN LIGAMENT S WERE SURGICALLY REPAIRED BEFORE HE CAME TO WORK FOR THIS COMPANY.

EMPLOYEE WAS CO5LECTING INTO FROM DATA PLATE ON ELECTRIC MOTOR. HE PLACED HAND ON PULLEY GAURD. AS HE SHIFTED HIS WEIGHT, HE GRASPED GAURD FOR SUPPORTS BACK SIDE OFF, PULLEY WASNOT GUARDED. BE LT CAUGHT FINGE9 AND PULLED IT INTO THE PULLEY.

EMPLOYEE WAS US3NG 1/2 IN PORTABLE ELECTRIC DRILL TO DRILL HOLE IN A PIECE OF 1/8IN STEEL BIT CAUGHT ON THE METAL CAUSING DRILL TO SPIN HANDLE OF DRILL STRUCK RT WRIST

EMPLOYEE WAS HO5DING LIGHT TO ILLUMINATE WORK AREA WHERE ANOTHER EMPLOYEE WAS WELDING.INJURED EMPLOYEE WAS NOT WEARING EYE PROTECTION.

EMPLOYEE WAS US3NG CUTTING TORCH WHEN HOT SLAG GOT INTO PARTLY LACED BOOT. BURN WAS NOT REPORTED TO SUPERVISOR UNTIL INFECTION SET IN 8-19-87. PROMPT MECHAINE ATTENTION WOULD HAVE PREVENTED LO ST WORK TIME. 3

GARDNER-DENVER 5IR GRINDER SHAFT AND HOUSING BROKE WHEN GRINDING WHEEL CAME A PART.INVESTIGATION REVEALED THAT INTERNAL SAFETY DEVICE (GARTER SPRING) HAD BEEN REMOVED AND REPLACED WITH A NON-F LEXIBLE WIRE.MA3IMUM RATED RPM WAS PROBABLY EXEEDED.

EMP WAS MOVING 5 GARDNER-DENVER DRILL FROM ONE HOLE TO ANOTHER WHEN ONE TRACK RODE UP ON A 12-INCH ROCK. IT SLIPPED OFF ROCK CAUSING TONGUE TO DXX ON DRAW BAR TO HIT VICTIM ON TOE OF SAFETY BO OT. TONGUE SLIP1ED OFF STEEL TOE AND HIT INTSTEP. STEEL TOE SAVED VICTIMS FOOT FROM BEING CRUSHED

GREASING A EUCL3D AND GOT STRUCK ON THE BRIDGE OF THE NOSE WITH A PAINT SPRAYER REQURRING STITCHES.

HE WAS A CUTTER3ASSISTING A WELDER AND INADVERTEDTLY LOOKED AT THE WELDING ARC.

I.NAME CHECKING GENERATOR BELT ON SHOVEL WITH MOTOR OFF.HIS HELPER INADVERTENTLY ACTIVATED STARTER CATCHING I.NAME FINGER BETWEEN BELT AND PULLEY.HE WAS TAKEN TO ACCESS WITH TIP OF MIDDLE FING ER CUT OFF AND BROKEN.TREATED AND TOLD TO SEE ANOWN DR.RIGHT HAND.

MAKING ADJUSTMENT ON A SHOVEL WHILE IT WAS RUNNING HOIST DRUM RAKED ACROSS BACK OF RT HAND CUTTING IT HAD TO HAVVE STITCHES

USING GRINDER & CUT BETWEEN KNUCKLES ON LEFT HAND.

INJURED WAS STANDING WITHIN THE SWING RADIUS OF THE HOPPER CRAME WHEN THE CRANE WAS SWUNG AROUND AND STRUCK HIM IN THE BACK.

CUT ON RT FOREARM BY FLYING ROCK AT THE PRIMARY. HAD 3 STITCHES.

PUTTING UP SHED, DRILLING HOLES, CAUSED PRESSURE ON VERTABRA, PINCHING NERVE IN BACK.

WHILE PULLING LEVER ON CRANE TO CHANGE FROM WALK TO SWING PULLED LIGAMENTS IN LOWER BACK

INJ WAS OPERATING A SHOVEL LOADING A TRUCK WHEN BOLT BROKE THAT WAS HOLDING A HOIST SHAFT BEARING ALLOWING SHAFT TO RISE PUTTING PRESSURE ON HOIST BRAKE CAUSING HOIST BRAKE PEDAL TO SNAP BACK BREAKING RT ANKLE

USING WEEDEATER AND OBJECT FLEW UP AND HIT HIM IN HEAD NEEDED XRAYS AND 2 STITCHES

INJURED WAS WORKING ON A SHOVEL AND CHAIN SLIPPED TEARING SKIN OFF LEFT HAND AND IT BECAME INFECTED