Buscar en el registro

**** This injury was only a 1st Aid incident initially, but EE was prescribed PT on 6/17/26. While digging out large rock on quarry floor, the loader bounced and EE's shoulder popped. This was not a result from any deficient equipment, simply shifted material while properly operating the loader.

Ee's were adjusting the closed side of the crusher opening by pulling a cable connected to a haul truck. As the haul truck pulled on the cable, the cable caught a nearby oil tank causing the cable to lift off the crusher. The flying cable then struck a platform handrail which broke the weld. The broken handrail then hit the injured coworker in the Right Knee.

EE was operating a 988K PL0105 wheel loader, digging in the muck shot and sending loads to Primary Crusher. As EE was digging in the muck pile, EE hit a tight spot which caused the loader to jar/jolt, and the EE strained EE's lower back.

EE was running a loader, loading a truck, when there was a sudden issue with the steering system, and it began jerking to the left and the right. EE was diagnosed with a neck strain. The loader was taken out of service until it gets fixed.

The driver's dump truck hit a pile of sand that had big rocks in it and caused the driver to fracture a rib.

EE was operating CAT 988K, was driving on a haul road in the south pit. Drove through a wash out that was cause by heavy rain the night before. Felt a sudden pain in lower back which was diagnosed as a lower back muscle strain.

After coming to a stop & looking both ways, EE crossed the road in the water truck. A passenger vehicle traveling at a high rate of speed hit the water truck at the front right tire area. The EE was taken to a health works facility where EE was diagnosed with a contusion and swelling on EE's left wrist.

While performing normal job function of operating a front end loader with joystick controls, the EE felt a slight pain on the top of left hand. About a minute or two later, the top of hand started to swell. The EE was taken to the ER where doctors determined they had a hematoma which was caused by a small broken blood vessel.

Two employees were driving the maintenance truck down the ramp to the bottom level of the primary when the brakes went out. The truck was driven into a berm to come to a sudden stop. Both employees showed no injuries at the time of accident. One employee sought medical attention for lower back on 11/5/2019.

An employee was cleaning material out from under the primary conveyor so that EE could wash down the area that was unable to reach with a shovel. As EE bent to pick up a large rock, a second rock came off the conveyor from above EE and hit EE's hand. Xrays showed it's fractured.

While hauling shot material to the stock area the operator hit a bump in the haul road and the seat bottomed out, causing a sharp pain in lower back. The employee did not seek medical attention until 08/31/2017.

Employee was operating a Volvo A35D Articulated truck when the truck slid in a tire rut. The operator had right hand on the wheel and left hand on the grab rail. The sudden movement jerked employee's body to the right causing pain in left shoulder.

Employee was pulling a conveyor belt with a skid steer when the clamp slipped off the belt and struck EE in the right knee.

Employee states he injured his lower back while washing sand for several days with a water hose preparing the plant for shutdown and then riding in the loader aggravated it. He did not seek medical care until 11/16/2015.

Employee was loading shot rock when the loader hit a tight area causing the loader to bounce back, straining his lumbar area.

After servicing a skid steer, the mechanic shut the engine lid. A cloud of dust was thrown by the fan into his face. He rubbed his eyes, but later his left eye was bothering him. He rinsed it but that didn't help the irritation. He went to the doctor who discovered a piece of metal embedded in his eye which he removed using tweezers and a brush.

Haul truck backing up to dump area. Ground under truck released and truck slid down bank.

The Hoe Operator was loading a large rock onto a Euclid when the rock slipped from the hoe bucket and fell onto the bed of the Euclid, jolting the Euclid driver causing strain to his neck, shoulders and lower back.

emp was operating a haul truck when he felt pinching in his right leg. emp reported the incident on 10/24/2011. emp missed 5 days of work for muscle spasms

Dr. states repetitive motion caused from operating loader. Tendonitis.

GREASING BEARING AND CHECKED LINE UNDER DIRT AND GLOVE GOT CAUGHT IN ROLLER ON CONVEYOR BELT.

DIGGING OUT CONCRETE WITH LOADER MADE SUDDEN MOVEMENT AND JARRED EMPLOYEE'S BACK.

GETTING OFF OF SKID LOADER (PL74), TWISTED ANKLE ON LIP OF BUCKET CAUSING A GRADE 1 SPRAIN.

INJURED WAS WORKING ON FLAT DECK SCREEN. A PIECE OF ANGLE IRON WAS SECURED TO SCREEN STRUCTURE--WHEN BELT WAS STARTED FOR TESTING THE STRAP BROKE ALLOWING ANGLE IRON TO HIT THE BELT AND BOUNCE BACK STRIKING HIM IN THE LEG.

PUT LEG ON CONVEYOR.

INJURED WAS CLEANING BOTTOM ROLLERS ON A STATIONARY BELT WHEN THE 12' METAL BAR HE WAS USING BECAME WEDGED BETWEEN THE BELTING & THE BOTTOM ROLLER. THIS CAUSED THE BAR TO STRIKE UNDER HIS LEFT ARM.

HE WAS ATTEMPTING TO UNCLOG STALLED CONVEYOR AT PORTABLE PLANT, CRAWLED ACROSS HANDRAIL AND GRABBED FOR A HANDHOLD INTO THE CONVEYOR DRIVE BELTS. THERE WAS A GUARD ON BUT STILL ENOUGH ROOM WHE RE GLOVE GOT CAUGHT IN BELT AND PULLED LEFT HAND INTO SHIEVE BELTS.

WHILE STRIPPING STONE HE BACKED UP AGAINST THE RAMP WITH THE BACK WHEELS WHEN THE FRONT WHEELS SLID TO THE LEFT, TIPPING THE EUCLID OVER ON IT'S SIDE.

WAS CLEANING PAN ON CONVEYOR WHEN GLOVE GOT CAUGHT BETWEEN ROLLER AND CONVEYOR BELT CUTTING SKIN OPEN ON 3 MIDDLE FINGERS, RIGHT HAND. TAKING STITCHES.

EE WAS TACKING A LOAD OF BLOCK TOP AND PULLED ONE OF THE TIE DOWN STRAPS WHICH WAS UNDER SOME BLOCK TOP AS HE TRIED TO FREE IT THE ROPE BROKE CAUSING HIM TO FALL BACKWARD OF THE TRUCK ON TO TH E GROUND.

OPERATING MUSTANG (PL68).

OPERATING PAYLOADER LOADING EUC.

EMPL OPERATING EUCLID BEING LOADED WITH WASTE MATERIAL.WHEN LOADER EMPTIED ITS BUCKET,EXTREMELY LARGE ROCK ROLLED INTO SIDE OF BED SEVERELY ROCKING THE EUCLID.EMPL WAS SHOOK UP EVEN THOUGH WEA RING A SAFETY BELT AND EXPERIENCED LOW BACK PAIN

CLEANING UP PLANT #1 SECONDARY END AND BOBCAT HIT HIM.

FRONT END LOADER OPERATOR WAS HOISTING EMPLOYEE TOWARD CONVEYOR COUNTER WEIGHT PULLEY WHEN HE TILTED BUCKET BACK. EMPLOYEE GRABBED TOP BAR OF LOADER BUCKET, THE BUCKET TILTED FURTHER BACK AND PINCHED FINGERS BETWEEN TOP BAR AND LIFTING PIVOT ARM.

FRONT END LOADER OPER HOISTING EMP TO CONVEY COUNTER WT PULLEY TILTED BUCKET BACK GRABBED TOP BAR OF LOADER BUCKET THE BUCKET TILTED FURTHER BACK PINCHED FINGER BETWEEN TOP BAR LIFTING PIVOT A RM

THE EMPLOYEE HAD DRIVEN HIS MIXER TO THE JOB SITE AND WAS IN THE PROCESS OF UNLOADING HIS LOAD OF READY-MIX CEMENT. AS THE CEMENT WAS SLIDING DOWN THE CHUTE OF THE MIXER, THE CHUTE CAME UNLOC KED ALLOWING IT TO SWING. AS THE CHUTE SWUNG TO ONE SIDE, IT STRUCK THE EMPLOYEES LEFT LEG. IT WAS DETERMINED THAT A BLOOD CLOT HAD FORMED IN HIS LEG.

EE WAS OP TRUCK3WHEN IT STALLED WHILE ON A HILL. AS IT ROLLED FORWARD EE WAS UNABLE TO STEER IT & THE EUCLID WENT OVER AN EMBANKMENT OF APPROX 20' IN HEIGHT.

THE INJURED AND3ANOTHER TRUCKDRIVER HAD HAULED APPROX SEVEN LOADS EACH TO THE R AMP SITE BEFORE THE DOZER ARRIVED TO PUSH THE MATERIAL DOWN THE RAMP. AFTER THE DOZER ARRIVED AND STARTED TO PU SH THE MATERIAL3THE INJURED STARTED HAULING TO NO.4 PLANT ON THE TOP LEVEL. THE INJURED HAD HAULED 7 LOADS AND HE DUMPED ONE LOAD AT THE RAMP SITE AND WAS PREPARING TO DUMP A A SECOND LOAD WHE