Buscar en el registro

While working the lime stockpile, a large portion of lime broke loose and hit the loader directly behind and to the left of the lift arms. The bent the bracket holding the outside mirror bring it through the door window. This caused the operator to sustain several superficial lacerations on his left arm.

Carter bin was connected to a D-8 dozer. Pin was pulled to release the dozer and the bin began to roll back. Employee attempted to stop the bin causing injury to right leg.

Employee was assisting in removing curtains. While pulling the curtains out of the way, he twisted and pulled his knee. He felt a slight pain and continued to work. Later that same day, while walking across the yard going to the break room, he felt something tear or stretch and had instant pain. Employee still felt it was nothing and continued to work through the week.

While assisting in the performance of maintenance on a Cat 330 excavator, employee struck in the right jaw area of his face with a glancing blow of a 16 pound sledge hammer. He was holding a metal bar, "with the use of a tie line"; the hammer glanced off the bar and still managed to strike him in the right jaw area of his face.

While trouble shooting a stack conveyor, where the belt was not moving, employee disconnected the power source. When he pulled the lever down, it failed, causing a flash fire.

While repairing a gate post, three employees, using a service truck and a Cat 950B loader, "to reshape the post". While the loader was moving into position its brakes failed and overran his intended point and an employee.

Employee was assisting in replacing flashing on a conveyor under the primary crusher. He was cutting the flashing with a utility knife when the knife slipped out of the flashing cutting himself across the stomach area.

Employee was positioning his mobile equipment for refueling. While climbing out and as he stepped onto the ground, he twisted his right ankle and went down. Equipment was parked on a level area and the surface area was flat and free of tripping hazards. He stated that he isn't sure just what happened.

EE WAS LOADING A "POWDER POT" WITH 50 POUND BAGS OF ANFO. THE ANFO WAS STACKED ON THE BED OF A STINGER TRUCK ALONG WITH THE POWDER POT. WHILE MOVING THE ANFO FROM THE STACK TO THE POT, EE WRINCHED BACK

WHILE TAKING A LOAD OF FINES TO THE STOCK PILE, EMPLOYEE WAS RETURNING TO THE PIT AREA (WITH A LOADED TRUCK). WHILE ROUNDING A CURVE IN THE HAUL ROAD, EMPLOYEE WENT THROUGH A BERM CAUSING THE TRUCK TO ROLL. EMPLOYEE WAS CRUSHED BY THE TRUCK HE WAS DRIVING.

BRIGHT/SUNNY AFTERNOON, TEMP. 82 DEG. EE WAS ATTEMPTING TO GREASE MOTOR ON A 60"-WIDE CONVEYOR. EE PULLED HIMSELF UP APPROX. 2 FEET AND RAMMED HIS HEAD INTO THE MOTOR HOUSING, CAUSING HIM TO LOSE HIS GRIP AND FALL BACK. EE LANDED WITH FULL WEIGHT ON HIS RIGHT LEG, CAUSING SEVERE PAIN AND DISCOMFORT.

WEATHER WAS COOL & SUNNY. SETTING UP PLANT FOR PRODUCTION WHILE BACKING IN A DOLEY. AFTER MISSING THE KING PIN, EMPLOYEE REACHED IN TO RESET THE LATCH ON THE HEAD PLATE. BEFORE THE LATCH WAS S ET, THE PLANT SLIPPED & PINCHED EMPLOYEE'S RIGHT THUMB BETWEEN PLANT & HEAD PLATE.

NOTHING OUT OF THE ORDINARY. BRIGHT SUNNY DAY. NOTHING TO TRIP ON/OVER. EMPLOYEE ENTERED THE CAP HOUSE, BENT OVER TO PICK UP A BOX OF CAPS (APPROX. 15 LBS). HE FELT A SHARP PAIN AND WENT DOWN TO HIS KNEES AND COULDN'T GET UP.

ON THE 20TH OF JANUARY 2003 AT APPROXIMATELY 3:20 PM EE A LOADER OPERATOR FOR DOUDS STONE, INC WAS ATTEMPTING TO MOVE A 4" WATER LINE THAT WAS USED TO PUMP WATER FROM THE PIT TO A SETTLING POND, WEATHER CONDITIONS AT THE TIME OF THE INCIDENT WAS CLEAR AND COLD, +OR- 17 DEGREES AND THEWATER LINE WAS FROZEN IN THE MUD. WHILE PULLING ON THE WATER LINE HE FELT A TWINGE AND BURNING

EE WAS TROUBLESHOOTING A PROBLEM WITH A MOTOR THAT PULLED A CONVEYOR. WHILE TROUBLESHOOTING, THE PANEL WAS REMOVED FROM THE CIRCUIT BREAKER CONTROLLING THE CONVEYOR. THIS WAS CHECKED WITH THE POWER OFF THEN WITH THE POWER ON. HE INSERTED PRPROBES CAUSING AN ARC, RESULTING IN A FLASH OF HEAT & FLAME RESULTING IN SEVERE BURNS TO EE.

EMPLOYEE WASLINING UP BACK PLATE FOR PRIMARY CRUSHER WHEN THE PLATE SHIFTED. THE EDGE OF THE PLATE KNOCKED OFF HIS HARD HAT AND CAUSED A LACERATION TO THE LEFT EAR AND A SMALL LACERATION TO HI S FOREHEAD.

HIS TAILGATE WOULD NOT CLOSE. A MINE EMPLOYEE OF OURS BROUGHT A LOADER TO HELP CLOSE THE TAILGATE. INJURED HELD A BOARD ON THE TAILGATE SO IT WOULDN'T GET SCRATCHED. WHEN THE LOADER MADE CO NTACT W/TAILGATE, INJURED'S FINGER WAS PINCHED. HE HAD A CUT THAT REQUIRED THREE STITCHES.

DUST PARTICLE IN LEFT EYE, EE WAS CHECKING LEFT FRONT TIRE & WHEEL WHEN GUST OF WIND BLEW SPECK OF DIRT IN HIS EYE. SAFETY GLASSES WERE BEING WORN AT THE TIME OF ACCIDENT.

EE WAS HOLDING A PIECE OF METAL HE WAS DRILLING, WHEN THE DRILL BIT WENT THROUGH THE METAL & INTO THE INDEX FINGER ON HIS LEFT HAND. STITCHES WERE REQUIRED TO CLOSE THE WOUND.

CUSTOMER TRUCK DRIVER SUFFERED AN APPARENT HEART ATTACK WHICH REQUIRED CPR FROM ON SITE OFFICE MANAGER AND NOTIFICATION OF EMERGENCY PERSONNEL. THE DRIVER DIED AT APPROX.10:30AM AT HOSPITAL.

EE OPERATING DOZER. HYDRAULIC LINE RUPTURED. FIR RESULTED CAUSING 10% 2ND DEGREE & 90% 1ST DEGREE BURN TO THE FACE, NECK AND HANDS. EE JUMPED FROM DOZER AND DISLOCATED THE RIGHT SHOULDER.

EE CLIMBED FROM CRANE TRACK TO HOUSE CATWALK TO RELEASE CABLE DRUM BRAKE TO REPAIR CABLE. HIS LEFT FOOT SLIPPED OFF THE TRACK AND HIS RIGHT SHIN HIT THE CATWALK CAUSING A PUNCTURE WOUND REQUIR ING 3 STITCHES.

STEEL CHANGER ON ROCK DRILL WAS NOT WORKING PROPERLY. MAINT. PERSON & EMPLOYEE WERE WORKING ON PROBLEM WHEN STEEL RELEASED DROPPING ON EMPLOYEE'S RIGHT FOOT. EMPLOYEE HAD LACERATION AND FRACTU RE OF RIGHT FOOT.

EE WAS LOADING A BRACE FROM PRIMARY CRUSHER ON TO LOW BOY CATCHING FINGER BETWEEN THE BRACE AND EDGE OF LOW BOY TRAILER.

FORKLIFT IN REVERSE, EMPLOYEE STEPPED BACK AND THE TIRE HIT HIS LEFT HEEL.

EMPLOYEE WAS BUILDING UP BARS ON CRUSHER. HE RECEIVED A BURNING SENSATION TO HIS EYES FROM THE FLASH OF THE WELDER.

EMPLOYEE WAS STANDING ON TRUCK, LOST HIS BALANCE & FELL 5 TO 6 FEET TO THE GROUND. HE TORE TENDONS IN HIS UPPER RIGHT ANKLE.

EMPLOYEE WAS GRINDING PIECE OT PREPARE TO WELD. A METAL SLIVER WENT IN FROM SIDE EMBEDDING IN RIGHT EYE.

WENT OBER EMBANKMENT FOREHEAD CUT ON WINDOW

REC EYE WELD BURN ON EYELIDS AND BLURRED VISION

EE WAS HELPING REPLACE RUBBER SCREENS ON SCREENING PLANT. HE USED HIS FOOT TO POUND THE SCREENS INTO PLACE. SEVERAL DAYS LATER COMPLAINED OF SWOLLEN AND PAINFUL FOOT. UNABLE TO CONTACT DR. HE SAW TO SEE IF GOUT IN FOOT COULD HAVE BEEN CAUSE POUNDING ON SCREEN. HE MISSED 2 1/2 DAYS THE FOLLOWING WEEKS .

REPLACING BARS IN PRIMARY IMPACT CUSHER, WAS CHECKING ROLLERS FOR PROPER BALANCING WHEN HE SLIPPED AND FOOT CAUGHT AND INJURY RESULTED.

THE MAN WAS TIGHTENING SOME 1 INCH BOLTS ONA FEEDER WITH A WRENCH AND OVEREXERTED HIMSELF CAUSING A STRAGILATED HERNIA

EMPLOYEE WAS CLEANING OUT LIME BIN WHEN HE FINISHED HE HAD A PAIN IN THE MIDDLE OF HIS BACK

EMPLOYEE REACHED UP TO PUSH PINM DOWN ON BED OF TRUCK PIN WAS HOT FROM BEING WELDED EMPLOYEE BURNED TIPS OF INDEX MIDDLE & RING FINGERS ON LEFT HAND

CHUNK OF LIME FELL ON LEFT HAND CAUSING MASHED AREA ABOVE THUMB & SEVERE WRIST SPRAIN

EMPLOYEE DRAGGI3G SHOT CORD BACK TO BLASTING AREA WHILE DRIVING COMPANY PICKUP. WHILE HOLDING CORDING IN LEFT HAND CORD SNAGGED ON ROCK JERKING EMPLOYEE LEFT ARM BACK AGAINST THE FRAME OF THE WINDOW. INJUR2 RESULTED IN BROKEN UPPER LEFT ARM.

HOISTING OUT OL8 LINER IN IMPACT CRUSHER.EMPLOYEE WAS USING A PRY BAR TO KEEP LINER AWAY FROM SIDES.BAR SLIPPED HITTING EMPLOYEE ON LEFT UPPER LIP.EMPLOYEE NEEDED 5 STITCHES AND CHIPPED ONE TO OTH. 3