Buscar en el registro

This is not an employee - A customer delivery truck driver was exiting EE's truck from the drivers side and mis-stepped, falling approximately three feet to the ground

STS found during Annual hearing testing in the right ear

STS found during Annual Hearing testing in the Rt. Ear

While employee went for EE's annual audio-gram it was found EE had a Standard Threshold Shift.

During our Annual Hearing Testing employee was found to have a Standard Threshold Shift.

During our annual hearing test EE was found to have a Standard Threshold Shift.

three miners were found to have hearing threshold shifts

Three miners were found to have hearing threshold shifts

three miners were found to have hearing threshold shifts

Employee was found to have STS during annual hearing test

Employee claims he has Carpal Tunnel from working front end loader controls there is no known specific date or time of accident

Employee slipped on ice while walking to car at end of shift injuring his left shoulder

Employee was using a pry bar, the pry bar slipped, causing him to feel pain in his right shoulder.

Ee was cleaning conveyor belt from the jaw crusher with a hose, an 8" stone shot out of the crusher striking ee in the hand splitting his finger causing 5 stitches.

While stepping off front end loader employee fell backward onto fuel tank of truck.

The employee was jacking up the body of a truck. The handle slipped out of jack and struck employee on chin.

While tightening bolts to adjust belts on the slurry pump employee states he felt a pull in his lower back.

There was a Standard Threshhold Shift discovered during yearly hearing exam.

Employee states he was trying to start the Ingersol-Rand's T30 compressor located on the back of the Red Wing mechanic's truck at Billings. He was priming the carburetor by pouring gasoline over it; some of the gas had dribbled on his hand. As he was turning the on-off switch, the unit backfired; and his hand caught fire.

EE STATES HE WAS IN THE WORKSHOP INSIDE THE COARSE MATERIAL WASHER. HE WAS ASIDE THE SHAFT TRYING TO REMOVE AN OLD BOLT USING A HAMMER AND PUNCH(CHISEL). HE STRUCK DOWNWARD WITH THE HAMMER, IT DEFLECTED AND HIT HIS HAND BETWEEN THUMB AND FOREFINGER.

EE STATES HE WAS UNTANGLING THE RUBBER MINE CABLE FROM THE WIRE ROPE TAILCABLE ON THE DREDGE. HE HELD THE WIRE ROPE CABLE IN HIS RIGHT HAND AND AS HE FLIPPED ONE OF THE FLATS SUPPORTING THE MI NE CABLE WITH HIS LEFT HAND, HIS RIGHT INDEX FINGER GOT PINCHED BETWEEN THE TWO CABLES.

EE STATES HE WAS A TOP A DELIVERY TRAILER HELPING PREPARE A COME ALONG AROUND SOME PIECES OF PIPE TO REMOVE THELOAD. AS HE SHIFTED THE PIPE, IT CAUSED AN I BEAM TO DROP FROM THE EDGE OF THE TR UCK. AS ONE END OF THE I BEAM HIT THE GROUND, THE OTHER END STRUCK HIS LEFT SHIN AND RIGHT KNEE.

EE STATES HE WAS IN THE PROCESS OF ALIGNING 2 PIECES OF PIPE TO BE FUSED TOGETHER. THE 2' PIECES BACKHOE AND EE WAS GUIDING THE OTHER END THROUGH THE MACHINES SADDLES. EE PULLED ON PIPE BECAUS E IT GOT JAMMED OR HUNG UP ON SADDLE. MOMENTUM OF PIPE SWUNG ON INTO ANOTHER AND EE S FINGERS WERE CAUGHT IN BETWEEN.

EMPLOYEE STATES HE WAS CUTTING RUBBER HOSE 1 1/2" THICK USING A UTILITY KNIFE, HE WAS IN A KNEELING POSITION CUTTING TOWARD HIMSELF.

ASSITIG THE MECHANIC IN REMOVING LOADER DRIVE SHAFT, EE WAS SITUATED IN THE PIVOT AREA OF THE LOADER LOOSENING UP THE BOLTS. IT WAS NECESSARY TO BEND OVER IN ORDER TO ACCESS THE BOLTS. EE NOTI CED HIS BACK WAS HURTING. INJURED HAS BEEN SEEING A CHIROPRACTOR FOR MORE THAN TWO YEARS.

THERE WERE NO ADVERSE CONDITIONS, WEATHER WAS DRY AND EE HAD GOOD FOOTING/POSITIONING. HE WAS NOT WEARING GLOVES. CHAINSAW KICKED AND CAME DOWN ON THE TOP OF EE'S LEFT HAND, TENDONS WERE DAM GED AND REQUIRED SURGERY.

A FIRE COMPLETELY DESTROYED CONTENTS OF BARN/MAINTENANCE SHOP WHERE PARTS AND SPARE EQUIPMENT WERE STORED AS WELL AS WHERE REPAIRS WERE DONE. THE 210C BACKHOE AND P-6000 DATSUN FORKLIFT WERE P ARKED INSIDE THE BARN. THE GRAY 1985 GMC TRUCK WAS PARKED NEXT TO BARN AND IT WAS ALSO DESTROYED

EE WAS POSITONED ON HIS STOMACH IN BETWEEN THE NARROW SPACE OF 2 DECKS OF THE GRAVEL TOWER SCREEN. HE WAS CUTTING OFF BOLTS WITH A TORCH IN ORDER TO REMOVE ONE OF THE DECKS FOR REPLACEMENT. TH ERE IS AN APPROX. 20 DEGREE ANGLE OF THE SCREEN AND HE BEGAN TO SLIDE. AS HE MOVED BOTH ARMS TO GRAB HOLD, THE TORCH HELD IN HIS RIGHT HAND PASSED OVER FINGERS OF LEFT HAND.

A RPOPANE TORCH AND A HEATER WERE SET UP TO THAW FROZEN MATERIAL FROM INSDIE THE BIN SO THAT WELDING REPAIRS COULD BE PERFORMED. AS HE FINISHED WELDING ONE PATCH, HE LIFTED THE HELMET TO SEE & MOVE ON TO THE NEXT HOLE TO BE PATCHED. AT THISMOMENT SOME FROZEN SAND "POPPED" AND APRAYED PARTICLES. ONE OF THE PARTICLES HIT EE IN CORNER OF HIS EYE.

EE WAS IN THE PROCESS OF FREEING THE CLAMSHELL DREDGE FEEDER DOOR WHICH WAS CLOGGED WITH MATERIAL. AS HE STEPPED DOWN A CHUNK OF CLAY BROKE OFF FROM THE TOP OF THE GRIZZLY BARS AND STURCK EE O N THE TOP OF HIS RIGHT SHOULDER. HE CONTINUED OPERATING THE DREDGE, BUT IT STARTED TO BOTHER HIM; SO HE WENT TO MEDICUS.

EMPLOYEE HAD LOADED A SKID OF BAGGED MATERIAL WITH THE FORKLIFT ONTO A CUSTOMER'S TRUCK. CUSTOMER BEGAN PICKING UP AN ADDITIONAL 5 BAGS OF ROCK SALT. HE WAS CONCERNED THAT THE CUSTOMER WOULD G ET HURT SO HE OFFERED TO HELP LIFT THE BAGS WITH HIM. AS THEY WERE LIFTING ONE OF THE 80# ROCK SALT BAGS TOGETHER, HE FELT A "TWINGE" ON HIS LEFT SIDE. LATER IT BEGAN TO ACHE.

3 EMPLOYEES WERE IN A MOTOR BOAT USING A CLEVIS TO REPOSITION THE LUFTING DREDGE. INJURED AND ANOTHER EMPLOYEE WERE PULLING CABLE. SPLICE/CLAMPS JAMMED WITH CLEVIS CAUSING BOAT TO STOP SUDDENL Y AND PROPEL EMPLOYEES BACKWARD. INJURED SPUN AROUND TO GRAB FOR SIDE OF BOAT AND PULLED A MUSCLE IN THE RIGHT LOWER BACK AREA.

EMPLOYEE WAS REMOVING A 50# ROCK STUCK IN THE DREDGE PUMP PIPE. AFTER DISLODGING THE ROCK W/ A PRY BAR, HE REACHED HIS RIGHT ARM IN THE ROCK BOX OPENING (WHICH IS CHEST HEIGHT) TO POSITION THE ROCK AT THE OPENING. HE THEN WENT TO SCOOP/LIFT THE ROCK UP/OUT WHEN HE FELT A SHARP PAIN IN HIS LEFT SIDE. HE DROPPED THE ROCK, WAITED A MOMENT & THEN LIFTED THE ROCK UP & OUT OF THE PIPE.

BELT THAT BAGGED MATERIAL ROLLS ON BECAME MISALIGNED. INJURED EMPLOYEE & SUPERVISOR TRIED TO REALIGN BELT. AS INJURED EMPLOYEE PUSHED BELT AWAY FROM HIM, HE TRIPPED THE AUTOMATIC EYE FOR THE KICKER. THE KICKER RELEASED & CAME DOWN ON HISHANDS.

ATTEMPTING TO REMOVE SPEED REDUCER SEIZED TO SHAFT OF MAIN FEED CONVEYOR, EMPLOYEE TOOK PRY BAR TO TRY TO "FREE UP" REDUCER. PRY BAR SLIPPED AND PINCHED EMPLOYEE'S FINGER BETWEEN BAR AND FRAME OF REDUCER. EMPLOYEE MAY HAVE BEEN RUSHING TO FINISH JOB; SHIFT ENDED AT 3:30 PM.

54736YEE WAS GREASING A CONVEYOR BELT MOTOR BEARING IN A KNEELING POSITION.A LOADER OPERATOR LOOKED AT BELT TWICE BUT COULD NOT SEE VICTIM.OPERATOR GAVE OK TO START CONVEYOR.INJURED EMPLOYEE W 12038ROWN BACKWARD ONTO GRIZZLY BARS.

EMPLOYEE WAS LEANING DOWN (IN A "HEAD-UNDER-HEALS" POSITION) INTO THE AREA WHERE CENTER PIN IS LOCATED. THIS IS UNDER THE LOADER SEAT; SEAT WAS REMOVED TO ACCESS THE CENTER PIN. EMPLOYEE WAS P OSITION IN AN "AWKWARD" MANNER WHICH PUT STRAIN ON HIS NECK.

INJURED WAS SHOVELING OUT #3 CONVEYOR CLEARING CLOG. WHEN FINISHED EMPL WAITED & WATCHED AS SYSTM WAS RESTARTED. EMPL WAS STANDING NEXT TO #3 CONVEYOR BELT WHICH WAS MOVING HE WAS WATCHING TO SEE IF #2 CONVEYOR WOULD START. LARGE ROCK APPROX 6-8" ROLLED OFF #3 BELT & STRUCK EMPLS RIGHT INNER LEG KNEE AREA BRUISING IT.

ENTHUSIASTIC EE JUMPED OFF FORKLIFT TO SHUT DOWN HAMMER MILL THE IMPACT AS HE LANDED ON FLOOR ESULTED IN SPRAINED LEFT FOOT AS WELL AS TORN CARTILAGE OF LEFT KNEE.

EMPLOYEE WAS WORKING ON LINE BAGGER; PLACING BAGS ON SPOUT. EMPLOYEE HAD LEFT HAND IN THE WAY WHEN BAG WAS KICKING OFF FROM SPOUT. HIS LEFT WRIST WAS HIT BY THE KICKER.

INJURED WAS PERFORMING MAINTENANCE ON 980 LOADER HE BROUGHT WITH HIM A 5 GALLON CONTAINER OF ANTI FREEZE. THE CONTAINER WAS PLACED UP ON MACHINE HANGING OVER THE EDGE AS HE CLIMBED HIGHER EE W ITH HANDS ABOVE HEAD AT THE CONTAINER SO IT WOULDNT BE HANGING OVER THE EDGE IN SO DOING HE PULLED SOMETHING IN HIS BACK.

EMPLOYEE WAS WORKING ON PALLETIZER/BAGGING LINE WITH THE POWER ON EMPLOYEE WENT DOWN TO STRAIGHTEN OUT BAGS ON PALLET HE MOVED IN FRONT OF THE ELECTRIC EYE WHICH TRIGGERED THE FORKS OF PALLETI ZER TO COME DOWN EMPLOYEES LEFT FOOT WAS CAUGHT UNDER THE PALLETIZER FORKS HAD TO PLY FORKS UP TO RELEASE FOOT

EMPLOYEE WAS IN THE PROCESS OF CLEANING ROLLERS HE WAS STANDING ON A LARGE CONCRETE FOOTING (WHICH WAS BROKEN IN HALF) EMPLOYEE STEPPED BACKWARD & HIS FOOT WENT INTO A 5IN WIDE CRACK

EMPL WAS WORKING IN CRUSHER HOPPER REMOVING ROCK THAT GOT STUCK IN THE CRUSHER WHEN HE CLIMBED OUT OF THE HOPPER HE PULLED SOMETHING IN HIS R SHOULDER THE PULL RESULTED IN A TORN MUSCLE

EMPLOYEE WAS LEARNING HOW TO WELD. AS HE WAS PUTTING HIS MASK DOWN, HE LOOKED INTO THE ARC. HE RECEIVED FLASHBURN AS A RESULT.

EMPL WAS USING SLEDGE HAMMER FELT SHOULDER PULL IGNORED IT THOUGH BECAUSE HE SAYS IT HAPPENS FREQUENTLY. HE LATER WENT TO CLIMB ONTO LOADER & PULLED SHOULDER & BACK.

WHILE WORKING ON CASE BACK HOE FRONT BUCKET, SMOE DIRT OR RUST CAME LOOSE WHILE STRAIGHTENING, THE SIDES OF THE BUCKET. A SMALL PARTICLE FELL INTO EMPLOYEE'S EYES.

EMPLOYEE WA WORKING ON PLATFORM OF #2 HAMMER MILL IN DRY PLANT. SOMEONE YELLED TO HIM AND HE TURNED TO SEE WHO IT WAS. HE SLIPPED AND THOUGHT HE WAS GOING TO FALL HE GRABBED ONTO SOMETHING AN D WITH THIS MOVEMENT HE PULLED SOMETHING IN HIS BACK.

THE OFFICE TRAILER AT THE BILLINGS LOCATION WAS MOSTLY DESTORYED BY A FIRE WHICH STARTED IN THE BASEMENT AREA. IT WAS POSSIBLY DUE TO AN ELECTRICAL PROBLEM.

CUTTING AND GOT PIECE OF RUST LODGED IN EYE.WENT TO DR TO HAVE IT REMOVED.