Buscar en el registro

EMPLOYEE WAS REACHING UP TO GET A LIGHTED ACETYLENE TORCH WHICH WAS BEING PASSED TO HIM BY ANOTHER EMPLOYEE. THE HOSE WAS KINKED AND WHEN IT UNTWISTED THE TORCH SPUN AROUND BURNING EMPLOYEE.

EMPLOYEE HAD REMOVED DIRTY DUST COLLECTOR BAGS FROM DUST COLLECTOR AND WAS WALKING WITH THEM WHEN A GUST OF WIND BLEW DUST INTO THE EMPLOYEE'S EYE.

EMPLOYEE EMPTYED OUT PREPARED CLINKER SAMPLE FROM CONTAINER INTO PULVERIZER,A PORTION OF THE CLINKER SAMPLE LANDED ON FLOOR,EMPLOYEE STEPPED ON SPILLED CLINKER,CAUSING EMPLOYEE TO LOSE HIS BAL ANCE,STRAINING KNEE.EMPLOYEE WAS RELEASED TO REGULAR DUTY,AND ON 09-14-90 WAS ADMITTED FOR OUT PATIENT SURGERY ON INJURED KNEE.STARTED LOSING TIME 09-14-90.

EE REACHED DOWN TO RETRIEVE A BOOK FROM THE PASSENGER SIDE OF CAR FELT PAIN IN LOWER BACK.

EMPL DOING MAINT WORK INSIDE COAL MILL,TIGHTENING BOLTS WITH AIR WRENCH.AFTER COMPLETING WORK WHILE WALKING OUTSIDE COAL MILL,EMPL FELT SOMETHING IN EYE.

WHILE WALKING TO WORK SITE ON TOP OF A CEMENT SILO, EE STATED THAT WHEN HE STEPPED ONTO METAL FLOOR THE FLOOR SPRANG UP SLIGHTLY CAUSING SLIGHT PAIN TO THE LEFT KNEE.

EMPLOYEE WAS REMOVING MILL LINERS INSIDE D2 MILL. EMPLOYEE WAS CUTTING A LINER BOLT WITH ACETYLENE TORCH, WHEN THE BOLT WAS CUT THE LINER CAME LOOSE STRIKING EMPLOYEE'S FOOT.

EMPL WAS ATTEMPTING TO OPEN SLIDE GATE BY PULLING ON GATE VALVE HANDLE. GATE VALVE HANDLE SLIPPED OUT OF BRACKET CASUING EMPL TO TWIT TO REGAIN BALANCE.

EMPLOYEE WAS ATTEMPTING TO INSERT PIPETTE INTO A PIPETTE DISPENSER. EMPLOYEE WAS APPLYING PRESSURE ON PIPETTE WITH ONE HAND AND HOLDING THE PIPETTE DISPENSER WITH THE OTHER HAND. PIPETTE BROKE WHEN PRESSURE WAS APPLIED.

EMPLOYEE WAS ATTEMPTING TO DRIVE IN A BIN SLIDE BY STRIKING IT WITH AN 8# SLEDGE HAMMER. WHEN EMPLOYEE SWUNG HAMMER HE FELT PAIN IN LOWER BACK.

EMPLOYEE ATTEMPTED TO LIFT CORNER OF A TRANSFORMER TANK TO MAKE THE OIL DRAIN COMPLETLY, FELT SLIGHT PAIN IN LOWER BACK.

EMPL WAS WELDING OVERHEAD LIFTED WELDING HOOD TO INSPECT WORK AT WHICH T8IME DUST PARTICLES ENTERED INTO RIGHT EYE.

EMPLOYEE WAS STANDING PUSHING DOWN WITH A3/4" CONDUIT(APPROX 12' LONG).EMPLOYEE PUSHED DOWN ON CONDUIT AND FELT PAIN IN LEFT KNEE.

EMPL ALLEGES HEARING LOSS IN BOTH EARS. EMPL HAS BEEN LAY OFF STATUS SINCE 7/26/89.

EMPL WAS MEASURING VOLTAGE AT OUTPUT TERMINALS OF DRIVE USING DIGITAL VOLT OHM METER. HE HAD TEST LEAD IN EACH HAND & WAS MEASURING ACROSS TERMINALS TO OBTAIN PHASE TO PHASE VOLTAGE. AFTER OBT AINING PHASE 1-2 & 1-3 VOLTAGES & DURING PHASE 2-3 CHECK HE CAME IN CONTRAT WITH 480V HOT TERMINALS. THERE WAS NO FLASH OR EQUIP DAMAGE. EMPL DID NOT RECEIVE ANY BURNS BUT EXPERIENCED SEVERE

EMPLOYEE WAS ATTEMPTING TO MOVE AN ACETYLENE CART TO CONNECT IT TO TRUCK; EMLOYEE PULLED ON CART AND FELT PAIN IN LEFT SHOULDER.

EMPLOYEE WORKED REMOVING OLD TROUGHING IDLERS BY MANUALLY REMOVING THEM FROM UNDER A BELT CONVEYOR. EMPLOYEE STATED THAT HIS SHOULDER FELT "SORE" AFTER HAVING PERFORMED THIS WORK. EMPLOYEE SOU GHT MEDICAL TREATMENT ON 9/01/89.

WHILE ATTEMPTING TO SIT ON FOLDING CHAIR, EMPLOYEE'S HAND WAS CAUGHT BETWEEN CHAIR HINGE AND FOLDING STRUCTURE OF CHAIR.

EMPLOYEE WAS ASKED TO ROD THE TOWER ANALYSER PROBE. HE TOOK OFF THE ANALYSLER CAP, AT WHICH TIME HIT MATERIAL SURGED OUT OF THE ANALYSER PROBE PORT HOLE.

EMPL FELT PAIN IN ELBOW AFTER HAVING AIRLANCED TOWER VESSEL. JOB REQUIRES THAT EMPL PUSH IN & PULL OUT AIRLANCE FROM VESSEL.

EMPL WA SPULLING ON BOX WRENCH TO TIGHTEN BOLT FELT PAIN IN RIGHT SHOULDER.

EMPL STATED THAT AFTER WORKING WITH GUZZLER HOSE SHE FELT NUUMBNESS & PAIN IN FINGERS. WORK PROCEDURE WHEN WORKING WITH GUZZLER HOSE INVOLVES GRASPING 6" HOSE WITH BOTH HANDS & MOVING HOSE TO AND FRO AS IT VACUUMS MATERIAL. EMPL REFERRED TO DR 11/15/88 WHO DIAGNOSED AS NEURITIS. LATER EXAMINATION REVEALED POSSIBLE CARPAL TUNNEL SYNDROME.

IN THE PROCESS OF PRODUCING A SAFETY FILM WHILE ATTEMPTING TO SIMULATE AN ACCIDENT, EMPLOYEE'S RIGHT FOOT WAS ACCIDENTLY PINCHED BY FORKLIFT TIRE. THIS ACCIDENT WAS REPORTED TO MSHA, FORM 7000 -1 ON 8/01/85 WHEN EMPLOYEE REQUESTED MEDICAL EVALUATION. EMPLOYEE WAS UNDER DOCTOR'S CARE UNTIL HE COMMENCED LOSING TIME ON 11/15/88.

EMPLOYEE STRUCK DRIFT PUNCH WITH HAMMER, DRIFT PUNCH MOVED CATCHING EMPLOYEE'S THUMB BETWEEN DRIFT PUNCH AND GEAR PULLER.

EMPL STEPPED OVER PINION SHAFT BEARING LOST BALANCE AND FELL FORWARD SAME LEVEL.EMPL TRIED TO CUSHION FALL WITH ARMS -SUFFERING FX.

THE EMPLOYEE WAS PULLING DOWN ON A TARPAULIN WITH BOTH HANDS, NOTICED A DEFORMITY OF THE RIGHT HAND RING FINGER.

AS EMPLOYEE ATTEMPTED TO TIGHTEN CHUCK BY TURNING ON CHUCK WRENCH,FELT SHOULDER POP.EMPLOYEE WAS STANDING,TURNING CHUCK WRENCH WITH BOTH HANDS.

THE JINJ. WA> ASSISTING ANOTHER EMP. IN LIFTING UP A SECTION OF DRAGCHAIN WITH A COM A LONG, THE RIGGING HOOK APPARANTLY FAILE DROPPING THE LOAD PINCHING THE VICTIMS FINGER AGAINST A METAL FLANGE. THE INJ. WAS GUIDING THE LOAD WHEN THE ACCIDENT OCCURED.

EMPL WAS ATTEMPTING TO CLEAN OUT DENVER SAMPLER BY APPLYING AIR WITH AIRHOSE. EMPL HAD REMOVED COVER TO FACILITATE BLOWING OFF SPLITTER BLADES WHICH ARE SET ON SIX SECOND TIMING CYCLE, EMPL L OOKED AWAY FROM SAMPLER TO LOOK AT TIMER WHEN SLPLITTER BLADES CYCLED CATCHING HIS FINGER BETWEEN BLADE & SAMPLER HOUSING.

EMPLOYEE SLIPPED ON LOOSE MATERIAL AND TWISTED KNEE. EMPLOYEE SOUGHT MEDICAL TREATMENT, ANTHROSCOPIC SURGERY WAS PERFORMED 8/3088.

EMPLOYEE ATTEMPTED TO MANUALLY ROTATE SAMPLER SPLITTER PINCHED FINGER BETWEEN SPLITTER BLADE & SAMPLER HOUSING

EMPLOYEE WAS IN THE PROCESS OF DISMOUNTING FROM CATERPILLAR, STEPPED ONTO LOOSE ROCK, RIGHT ANKLE TWISTED RESULTING IN A SPRAIN.

EMPLOYEE WAS PUSHING UP ON BLASTGATE CYLINDER, FELT PAIN TO LOWER BACK.

INJ. WA> SHOVELING AT THE FEED END OF CM-3 MILL, WHEN HE FELT PAIN IN LOWER BACK. NOTE: EMP. HAS PETITIONED TO REOPEN PRIOR CLAIM, STATED THAT HE COULD NOT RELATE TO A SPECIFIC INCIDENT W HICH AGGRAVATED CONDITION, BUT THAT HE HAS HAD PROBLEMS SINCE DATE OF ABOVE INCIDENT.

EMPLOYEE WAS IN3THE PROCESS OF CLIMBING OUT OF CHERRY PICKER CAB MOVED LEG SIDEWAYS AND FELT KNEE POP-EMPLOYEE SOUGHT MEDICAL TREATMENT ON 10/20/87 AND STARTED LOSING TIME 11/17/87.

EMPLOYEE ASSSIT9D BY TWO OTHER EMPLOYEES, WAS ATTEMPTING TO LIFT A 12'X15' SCREW CONVEYOR COVER. EMPLOYEE LOST HIS GRIP, TWISTED SUFFERING STRAIN.

EE WAS CUTTING 5 PIECE OF H OSE WHEN HIS KNIFE SLIPPED LACERATING LEFT INDEX FINGER.

THE INJURED WAS3CLEANING OUT RECOUP DUCT OF CEMENT BUILD-UP.

EMPLOYEE FELL S5ME LEVEL WHEN A WOODEN BENCH HE HAD STEPPED ON COLLAPSED.

EMPLOYEE WAS A7TEMPTING TO MOVE A 250# MILL LINER PLATGE EMPLOYEE WAS AWARE OF PROPER MATERIAL HANDING PROCEDURES BUT IGNORED HAZARD

EMPLOYEE STATED THAT HE HAD FELT PAIN WHEN LIFTING A BOX ON 5/5/87 WHICH WAS REPORTED TO HIS SUPERVISOR AT THAT TIME. THAT SOON AFTER THE INJURY HE HAD SEEN A DOCTOR WHO DIAGNOSED AN INGUINAL HERNIA AND HAD RECOMMENDED SURGERY. EMPLOYEE STATED THAT HE HAD REFUSED THE SURGERY AND THAT HE AS HAD PAIN EVER SINCE.

EMPLOYEE WAS LO4ERING 6 INCH GUZZLER HOSE, WEIGHT OF HOSE CAUSED THE HOSES TO DESCEND RAPIDLY CATCHING EMPLOYEE S HAND BETWEEN HOSE AND A METAL DOOR PLATE.

EMPLOYEE WAS MO5ING SEVERAL CRANE BEARING COLLARS BY PUSHING THEM WHEN HE FELT PAIN IN LOWER BACK.

I NAME WAS LAYI3G BRICK, CLEANING AROUND STEEL PLATE AND HIT HAND WITH BRICK HAMMER.

EMPLOYEE WAS WA5KING TOWARDS JOBSITE FELT SOMETHING ENTER HIS RIGHT EYE.EMPLOYEE WEARS ANSI APPROVED EYE PROTECTION WHILE CONDUCTING WORK ON COMPANY PREMISES.

CRAWLED OUT OF 3MANWAY OPENING AND SAFETY BELT HUNG UP ON SOMETHING INSIDE, PULLED ON ROPE TIGHTLY AND THE HOOK RELEASED AND FEEW UP AND HIT HIM ON HEAD.EMP WENT TO ST MARYS HOSPITAL AND WAS RELEASED TO GO 6ACK TO WORK

EMP WAS BENT OV9R ATTEMPTING TO LIFT UP ON A PLATFORM WEIGHTING APPROX 50# UPON LIFITNG THE PLATFORM HUNG UP ON A DOOR JAM, CAUSING EMPLOYEES BODY TO JAR

EMPLOYEE WAS IN3THE PROCESS OF CHECKING SUCTION ON 6" GUZZLER HOSE BY PASSING HAND IN HOSE OPENING. HOSE SUCTION FORCED ARM TO GO INTO HOSE.

EE HWILE STANDI3G PERFORMING ON OVER HEAD WLEDING TASK TWISTED BODY FOR BETTER POSITIONING, FELT PAIN IN BACK. EE HAS A HISTORY OF BACK PROBLEMS & HAS BEEN ON MEDICATION FOR PREVIOUS BACK IN JURIES. 3

EMPLOYEE WAS HO5DING PUNCH WHEN IT WAS STRUCK BY ANOTHER EMPLOYEE WITH SLEDGE HAMMER A STEEL CHIP BROKE OFF OF PUNCH AND STRUCK EMPLOYEE