Buscar en el registro

An employee was in the Raw Mill attempting to remove reject stone, when a raccoon ran under the skid steer they were operating. The employee stopped the skid steer and the raccoon ran into the corner and got trapped under a beam. The employee attempted to rescue the raccoon, but was bit in their right index finger. Rabies exposure protocol was followed at the emergency room.

Employee was inspecting a bin hole that was about to be patched when material from above fell onto to employee and in between their safety glasses and face. The employee reported irritation in their eye and sought medical treatment. They were diagnosed with a scratched cornea and placed on restricted duties.

Employee was operating an open cab forklift outside when the wind speed increased. The employee got dust underneath their safety glasses and into their eye. They flushed their eye and the following morning had irritation. They sought medical treatment and were given a prescription.

Employee was an air impact with reducer and socket. They went to the place the tool in place to tighten a bolt and felt a pop in their elbow. They were given self care treatment, but on 3/16/2026 they sought medical treatment and were given medication for treatment.

A dust collector bin was being emptied. Material flowed over the toe board and fell below and became airborne. The employee was covered in a layer of fine dust. The employee sought medical evaluation the following date and released to full duty. 2.5 months later the employee was placed on restricted duty with respiratory inflammation.

Supervisor was reporting to work and was experiencing chest pains and shortness of breath when they arrived for their shift. Emergency services were called and employee was taken to the emergency room. Determined as a non-work related illness.

A quarry operator exited the CAT D9 Dozer to end their shift. As they were getting off the equipment, they stepped on the tracks of the dozer. Their right foot slipped and went out from underneath them. They fell onto the blade pusharm grab handle. The following day, they sought medical treatment, were referred to an orthopedic specialist, and were placed on restricted work duty.

Employee slipped on ice and fell

Miner was struck on left side of face by an extension for manual jack.

Employee was walking up stairs in Raw Mill Building and felt a pop in their knee. The following shift (9/27/25) the employee sought medical treatment and was placed on restricted duties. This is a potential aggravation of a previously reported self care injury on 5/28/25.

Employee was removing rocks from between the intermediate conveyor belt and felt pain in their shoulder while using a prybar. They sought medical treatment and were placed on restricted duties.

Employee was cutting a pallet that was stuck between a feed conveyor and palletizer table. When the pallet was cut loose, the palletizer table the employee was kneeling on dropped 6-8" and the employee's knee struck the table. The employee sought medical treatment and was placed on restricted work duties.

Employee was stepping off a loader and stepped on a mud ball. They ankle gave out. The employee sought medical treatment the following day and was placed on restricted duties.

Employee was pulling an air lance out of a bin filled with sand and they reported a sharp pain in the hand through their elbow. 13 days later the employee sought medical treatment and was given a brace for their wrist.

Employee was attempting to blow off a turntable in the packhouse between the grate using an air lance. As the employee was pulling the air lance from the grate they felt a sharp pain in the right shoulder. The employee received medical attention, and been place on restricted duties.

Employee was pulling back a piece of flex pipe when they felt a pop in their elbow. The employee sought medical treatment and was given an immobilization sling to use as needed.

Contractor employee was moving a ramp into the preheat tower elevator, when it fell in a small gap between the elevator car and floor they were on. When the plate hit the basement of the elevator shaft, the allowing governor cable to become free, stopping the car. The employee using the elevator became stuck between the 1st and 2nd floors at the tower and was retrieved in an hour.

Employee was stepping out of pick-up truck when they felt their left foot slip and they fell, landing on their left knee and braced themselves with their left arm and their face struck the ground. The employee broke their kneecap, fractured their wrist, and received superficial cuts to their face.

Employee was repairing a handrail, when the opposite end they were adjusting slipped out of the joint and their ring finger was smashed between the handrail and I-beam. The employee sustained a finger fracture under their nail bed. Employee sought medical treatment the following day.

Employee went to use the Homo Silo personnel elevator, when the elevator car became stuck. The employee was able to leave the elevator for 35 minutes. Employee was uninjured.

Employee was walking up a staircase and felt a pop in their knee. 2 days later the employee sought medical treatment and was placed on restricted duties for a knee strain.

Employee was going to reset the packer, when a bag below the area EE was working broke open and dust became airborne. The employee got dust under their safety glasses and in their eye. The employee notified their supervisor the next day and sought medical treatment. Employee was diagnosed with a corneal abrasion.

Employee stepped off a railcar ladder next to the rail switch. The employee stepped onto the rail switch linkage and twisted their right ankle. The following day, the employee sought medical treatment and was placed on restricted duties.

An employee was shimming the secondary crusher and trying to remove a metal wedge. As the employee used a hammer to knock the wedge out a piece of metal from the top of the wedge flew back into the employee's mouth. The employee sustained a cracked tooth.

An employee was moving a FK pump on a dolly with assistance from coworkers. After completing the work, the employee had pain in their back. On 4/5/2024, the employee sought medical treatment for continued pain and was diagnosed with a back strain. They were placed on restricted duties.

An employee was trying to clear a lump of hardened material from above the silo rotary feeder. They used an air lance through a port to get the material to start flowing. The silo became pressurized with the use of the air lance and cement came out of the port and blew into the employee's eye. The employee received a chemical burn to their eye.

While cleaning the preheat tower on the riser level, an employee bent over. When they bent over there was a build up of dust on the brim of their hard hat fell underneath the employee's safety glasses and into their right eye. They received a scratch the eye.

A Hotwork (Contractor ID D843) employee was plugging an extension cord with a 3 prong-locking connection type into a metal gas train control box. When they plugged the cord in, they experienced a 120V shock. The employee was observed at the ER and released back to work. The control box lid did close on the employee's hand during the incident and EE received a bruise.

Employee was setting spring tension on the door of a coal mill with a 36" pipe wrench. While applying pressure to the wrench, the wrench slipped from its purchase, causing the employee to lose their balance and fall to the grated surface EE was standing on. During the fall, the employee fell onto their left ankle with all of their weight, breaking EE's ankle.

An employee was carrying a box of dust collector bags into an entryway. When the employee entered they stepped over the entrance threshold and went to step down. Their foot landed halfway on plate at the entrance and then halfway off the plate. The employee twisted their ankle. Employee was placed on restricted duties.

An employee was using an air hammer to clean bolts at the secondary sizer. They were sitting on a 10 inch lip of the sizer bending over. The employee reported back pain and sought medical treatment the next day. They were placed on restricted work duties.

An employee was operating a water truck, watering down a ramp. The truck started to slide in slick material. Towards the base of the ramp, the equipment tipped over and came to a stop on the roof of the equipment. The employee was able to get out of the cab without assistance and reported pain in their side. They were assessed at a local clinic and diagnosed with broken ribs.

Employee was getting off a railcar. Their right foot caught a wooden rail tie and they fell forward. The employee fell into the railcar switch control pole. They reported bruising and chest pain in their left pectoral area. They were taken for medical treatment.

Employee was exiting the preheat tower elevator on the second floor. When they exited dust became airborne and blew underneath the employee's safety glasses. The employee sought medical treatment and was diagnosed with a corneal abrasion.

An employee was trouble shooting an air slide that wasn't feeding properly and opened an inspection port to inspect. The material started flowing out slowly and then rapidly, becoming airborne. The employee tried to close the port and was exposed to cement dust. Medical treatment was provided and the employee sustained a scratch to the eye.

An employee was sweeping build up in a roadway and later in the shift moved a gas cylinder. The next day the employee reported pain. 2 days after the date of incident, the employee sought medical treatment and was placed on restricted work duties.

Employee reported rapid heart rate, nausea, and headache. Emergency responders were called as a precaution. The employee was diagnosed with non-work related illness.

Employee was in the Raw Mill assisting in clearing a chute. The employee was experiencing cold hands and went into the office to warm up. While warming up they experienced dizziness, blurred vision, and nausea. Emergency Responders were called and the employee was taken to the local hospital.

Employee was helping mill tender change two FK line valves. While pulling down on the wrench to tighten the valve, the employee heard and felt a pop. The employee sought medical treatment two days later and was diagnosed with a broken rib. The employee was placed on restricted work duty.

Employee was standing underneath the ball mill when they experienced a seizure. Emergency response was called and the employee was taken to the local hospital for evaluation.

Employee was removing a metal punch. When they struck it, it struck the employee in the tooth and broke the tooth.

On 10/10/22 an employee was walking along the rail when they stepped on uneven ground and their ankle twisted. On 10/31/22 the employee sought medical treatment and was placed on restricted duties.

Employee was changing a hammer valve in the raw mill when it became stuck. The employee felt pain in their shoulder. EE sought medical treatment 2 days later, was instructed to ice injury, referred to specialist. On 4/15/24 EE went out of work for shoulder surgery, which was determined non-work related. On7/16/24, safety manager was notified the injury was determined work related.

Employee was air lancing a chute and leaning against a railing. The employee leaned into the railing to back the air lance and banged their ribs on the railing. Employee was placed on restricted duties.

Employee was walking when when they experienced a shock from their implanted defibrillator. Employee was taken to ER as a precaution.

An employee reported pain in their shoulder. The pain is potentially from a previous reportable injury. The employee sought medical treatment and was placed on restricted duties until a diagnosis is made.

An employee was walking around a pick up truck when they slipped on loose ground. They fell on their shoulder and reported pain. The employee was placed on restricted duties the following day.

An employee was exiting a skidsteer, with their hand on the bar (meant for grabbing for three-points contact), stepped on the bucket, and slipped. The employee reported pain in the shoulder. The employee sought medical treatment 19 days later and was placed on restricted work duties.

An employee was turning around and walking down a catwalk on the Bedford Crane, when they tripped over one of the structural midrail supports. The employee sustained a knee contusion and abrasion. Medical treatment was sought.

Employee was found experiencing a stroke. Emergency responders were called to scene and employee was taken for further medical care.