Buscar en el registro

Reaching between the seat for a dash board knob. Right index finger slid along sheet metal.

Emp was moving a concrete block onto flat bed of boom truck. Emp placed concrete on angle iron. When cable was released, concrete rocked back onto foot. Fracture to right foot.

Rock from working face rolled onto bucket while mucking pile causing loader to jolt. Employee complained of pain in back. Dr put him off work as of 3/11/10.

EE was stepping down from loader & missed. Step & fell on right shoulder - 3.0' fall.

Emp. using impact wrench to draw up bolt on track. Bolt snapped & tool fell on right hand - caught between tool & machine.

Emp. walking from loader to shop and slipped on ice - aggravated pre-existing condition.

EE was removing bolts from cutting edge of cat loader horn bolt head spun while removing and cut through 2 pairs of gloves cutting left index finger.

Emp. states that he was walking from his haul truck to the lunch room. Passed by conveyor & stepped on a rock twisting his rt knee. Orig report as a notice only.

Employee was standing just below screen deck. A rock roller off of deck and struck employee over left eye. Laceration over left eyebrow.

Emp. using a pipe wrench to open a coupling. Wrench slipped of nut and hand caught between pipe stem & wrench.

After loading 20 holes in an 80 hole shot back began to get sore and tighten up. Continued & finished loading shot. Did not seek medical attention for 3 weeks after date of injury.

Co-worker was removing the cutting edge on the Komatsu 500. Stl fell & slid across floor & struck injured worker on side of rt. foot.

Employee picked up box of boosters and felt pull in back, it hurt and became tight.

Employee was removing & replacing cover guard (wt. approx 5 lbs) on hydraulic control @ the primary breaker - twisted & aggravated pre-existing injury to lower back.

EE was installing "teeth" on loader bucket using sledge hammer - piece of steel broke off and struck left forearm.

Caught left forefinger between pin & loader bucket while installing.

EE WAS ADJUSTING THROTTLE ON SKID - STEER. WRENCH SLIPPED AND LT. HAND STRUCK MOVING PART.

EMPLOYEE CLAIMS HE WAS REMOVING A "PIVOT SUPPORT" FOR R-50 EUCLID TRUCK AND FELT PAIN IN HIS LEFT SHOULDER (REPORTED 10-6-03).

EE WAS INSTALLING A NEW FRONT HUB ON TRACTOR BKHOE. EE TURNED HUB & LT INDEX FINGER (TOP OF KNUCKLE) WAS LACERATED BY SHARP EDGE (5 STITCHES).

EE WAS LIFTING BAGS OF SALT INTO SPREADER & FELTPAIN IN BACK

EMP WAS REMOVING WORN BOLTS FROM CUTTING EDGE OF FRONT END LOADER. BOLT SLIPPED OFF HAMMER HEAD BEING USED TO APPLY PRESSURE & EDGE OF BOLT HEAD LACERATED FINGER.

EE WAS REPLACING A PART ON A "WINDOW REGULATOR." HE REMOVED THE HANDLE GEAR RELEASING TENSION ON THE SPRING. PLATE ATTACHED TO SPRING SWUNG AROUND & STRIKING PALM OF RT. HAND.

HYDROLIC CRANE WAS LOWERING "ROPS" ONTO DOZER. EE ROTATED LOAD & CAUGHT RIGHT FOOT BETWEEN LOAD& DOZER.

EE WAS LIFTING A SECTION OF CUTTING EDGE INTO TRUCK & AGGRAVATED A PRE EXISTING INJURY TO HIS LOWER BACK