Buscar en el registro

Oil gun was attempting to retract from the boiler, when it jammed against the igniter. EE lifted up on the igniter to free the oil gun and the gun shot back and pinched his right hand ring finger.

Two employees were moving the Sandpiper Portable Sump Pump out from between the Sump Pumps 1A & 1B. One was pushing the Pump forward while the other was lifting it up with the chain hoist. The Pump started to roll toward Sump Pump 1A; injured tried to hold it back, trapped his (R) hand smashing pinky finger between pumps.

Working on Coal ramp with loader, was bouncing in loader. Back started hurting around end of shift.

Employee was repairing tube leaks on reheat header. we were using the pneumatic grinder to clean tubes and dirt blew in his left eye.

EE WAS CLEANING OUT THE HOPPERS ON THE BAGHOUSE.EE OPENED THE DOOR AND THE MATERIAL WAS PACKED IN TIGHT. WHEN THE MATERIAL WAS BROKE IT STARTED FLOWING OUT, AND THE HOT MATERIAL WENT DOWN INDIDE HIS BOOTS.

EE WAS LEAVING BOILER THRU CHAIN CONVEYOR. HE STEPPED FROM TOP LEVEL ONTO BOTTOM SCAFFOLD BAORD. THE BOARD BROKE AND HE FELL 6 FEET INTO CHAIN CONVEYOR.

EE LOST HIS FOOTING WALKING ALONG RAILROAD TRESSELL GOING TO HIS CAR.

EE WAS SWEEPING, REMOVING DIRT FROM UNDER TABLE WITH A BROOM, WHEN HE FELT SOMETHING IN HIS EYE.

EE WAS PREPARING A BOILER TUBE TO REPAIR A CRACK IN THE TUBE. AIR FROM THE PNEUMATIC GRINDER BLEW DUST UP UNDER HIS WELDING HOOD.

EE WAS STEPPING OVER PIPE & CAUGHT HIS FOOT & FELL LANDING ON HIS RIGHT HAND. EE WAS DISTRACTED & WAS NOT PAYING ATTENTION TO HIS FOOTING.

EE WAS MOVING A 450# DRUM OF OIL ACROSS SHOP FLOOR WHEN HE CAME TO A NARROW OPEING BETWEEN THE 4160 ROOM, DRUM CART ROLLED OVER A SEAM ON THE FLOOR. DRUM CART HIT THE SEAM IN THE FLOOR & JARRE D THE CATCH LOOSE FROM THE DRUM, ALLOWING DRUM TO MOVE UP & FORWARD.

EE STEPPED ON A PIECE OF AROMA FLEX (BLOCK FROM INSULATION), THAT WAS PARTLY UNDER WATER AND HADMUD ON IT. EE SLIPPED AND FELL ON HIS RT. HIP, WHEN HE FELL HE HIT THE LOCKER ALONG THE POWER HOUSE AND WALL.

KNEELING ON CONCRETE, SCRAPING GASKET SURFACES. IMPROPER KNEELING & BENDING PROCEDURES.

EE WAS INSIDE CATIOR VESSEL ON PT #1 TAKING FINGERS OFF DISTRIBUTION READER FOR REPAIRS. AS HE WAS PUSHING HIS WAY OUT OF THE VESSEL, RE CUT HIS LEFT HAND ON THE STAINLESS STEEL DISTRICUTION H EADER.

HAND WAS IN PRONE POSITION WHEN PIN WAS PULLED HAND WAS PINCHED IN BETWEEN A PINCH POINT IN MOWER.

EMPLOYEES WERE CUTTING AND WELDING PATCHES ON SEWAGE TREATMENT PLANT.

WORKING ON GATHERING SCREW AT E-40 BAGHOUSE. CONTRIBUTING FACTOR WAS HEAT.

THE AREA WHERE EE FELL WAS SLIPPERY WITH ALGAE GROWING, BECAUSE OF A STOPPED UP DRAIN.

KNOCKER WRENCH FELL FROM LEDGE OF EXPADSHION JOINT AND DOWN ONTO TOP OF FOOT.

DO NOT KNOW EXACTLY EE FELT PAIN WHEN HE WAS WALKING DOWN FRON E-40 BAGHOUSE.

WORKING ON FLY ASH VALVE 141 HAD END COVER OFF AND WAS APPLYING AIR PRESSURE TO VALVE WHEN VALE PISTON FLEW OUT HITTING RIGHT HAND AND CUTTING RIGHT THUMB.

EMPLOYEE WAS STANDING ON THE FENDER OF THE LOADER WASHING THE WINDOW. HE WAS HOLDING ON TO SIDE MIRROR WITH ONE HAND. HE LOST HIS BALANCE AND FELL TO THE GROUND. HE WAS COMPLAINING OF A HURT B ACK AND SORE LEG.

DRILLING HOLE AT AN ANGLE WHEN DRILL LOCKED UP AND CAUGHT EE'S HAND BETWEEN STEEL.

CLIMBING DOWN BETWEEN BOILER AND CATWALK. EE PUT HIS KNEE ON A ROUND PIECE OF SKIM CAUSING TO GET HIS FOOTING BELOW WHEN HE FELT HIS KNEE POP.

LIFTING CHUTE OUT OF MILL WHEN RIGGING WAS BINDING. LET OFF RIGGING TO ADJUST STRAP CHUTE WAS WEDGED BUT WHEN ADJUSTING STRAP IT FELL ON HAND.

TRYING TO LINE UP SPRINGS IN PULVERIZER BY TURNING COUPLING. HE FELT SHARP PAIN IN CHEST. HE AT THAT TIME DID NOT REPORT ACCIDENT BECAUSE HE DID NOT THINK IT WAS THAT BAD.

TAKING CENTER POST FROM D COAL MILL & CENTER POST FELL FROM MILL LANDING ON UPPER CHEST

EMPLOYEE WAS ASSISTING ANOTHER EMPLOYEE WHO WAS MOVING A WELDING MACHINE. THE INJURED EMPLOYEE WAS CARRYING THE MAJORITY OF THE LOAD. THE INJURED EMPLOYEE FELT A PAIN IN HIS GROIN AREA.

EMPLOYEE WAS USING A PIPE WRENCH & STRAINED HIS BACK. EMPLOYEE DID NOT REPORT INCIDENT TO SUPERVISOR UNTIL 7/25/00 & DID NOT REQUEST TREATMENT UNTIL 7/28/00.

EE WAS COMING OUT OF A SPACE & THE PERSON ABOVE HIM DID NOT SEE HIM THERE. THE PERSON ABOVE OPENED THE BUILER DOOR AND HOT GLY ASH FELL ONTO THE INJURED EE'S NECK & SMALL SECTION OF HIS RIGHT ARM.

EE WENT TO GET THE ATTENTION OF A CONTRACTOR. THE CONTRACTOR TURNED AROUND WHILE UNHOOKING A GAINT GUN AND EE WAS SPRAYED WITH PAINT.

EE SLIPPED WHEN HE PLACED HIS FOT ON THE EDGE OF A HOPPER & BUMPED HIS SHIN. EE DID NOT REPORT INJURY UNTIL 4/29. DR.'S NOTE DID NOT INDICATE DIAGNOSIS. WE WERE UNABLE TO DETERMINE (THRU DR.) UNTIL 5/9/00.

EMPLOYEE WAS LAYING DOWN TO LOOK AT SOMETHING AND THE NEXT DAY HE SAID THAT HIS RIBS WERE SORE. IT WAS NOT REPORTED UNTIL 3-27-2000.

EE WAS WALKING OUT OF FIRST AID CLASS WHEN SOMEONE STUPPED IN FRONT OF HIM AND HE STEPPED WRONG, TWISING HIS KNEE.

EE WAS MOVING BATTERIES ALONG A SHELF. HE HAD DONE EVERYTHING HE COULD TO MAKE THE JOB EASIER, BUT AT SOME POINT HE STRAINED HIMSELF TOO HARD. THE INCIDENT WAS NOT REPORTED TO HIS SUPERVISOR U NTIL 3-10-2000& EE DID NOT WANT MEDICAL ATTENTION UNTIL 3-13-2000.

EE WAS USING A WRENCH WHEN IT SLIPPED AND HIS HAND HIT A PIECE OF SHEET METAL WHICH CUT HIS RIGHT INDEX FINGER.

WHILE HELPING ANTOHER EMPLOYEE MOVE SOMETHING HE FLT A SLIGHT BURINING SENSATION IN HIS GROIN AREA. IT WENT AWAY THE NEXT DAY, BUT CME BACK. EE DID NTO REQUEST MEDICAL TREATMENT UNTIL 3-16 U NTIL SEEN BY A DR, IT WAS BELIEVED TO BE A GROIN STRAIN.

EE STOOD UP AND HIT HIS HEAD ON A BEAM. HE WAS WORKING ON A TEMPORARY PLATFORM.

THE EE WAS TAKING MEASUREMENTS AND STEPPED IN A DRAIN HOLE.

EE WAS CLEANING HOPPER WITH A ROD WHEN THE MATERIAL SHIFTED AND HE HIT HIS RIBS ALONG THE HANDRAIL.

EMPLOYEE SLIPPED AND TWISTED HIS KNEE, LEFT.

EE STRAINED HIS BACK WHILE UNLOADING TRAILER. THIS WAS AN INCIDENT THAT THE EE DID NOT WANT MEDICAL TREATMENT UNTIL 6-28-99-WHEN SAFETY DEPT WAS NOTIFIED.

EE WAS SORTING CROSSTIES WHEN HE TWISTED THE WRONG WAY & HURT HIS BACK DID NOT NOTIFY MGMT UNTIL5/25/99 HE WAS ATTEMPTING TO MOVE LARGE AWKARD OBJECTS W/O HELP

EE WAS LIFTING OBJECTS TOO HEAVY FOR ONE PERSON. ANOTHER EE NOTICED AND WENT TO HELP HIM FROM THEN ON.

EE WAS IN A AREA WHERE THEY WERE REBUILDING TUBES AND WAS NOT WEARING PPE. HIS WRIST CAUGHT THE END OF A TUBE WHERE IT CUT IT.

EMPLOYEE WAS WALKING UP STAIRS THAT HAD MATERIALBUILD UP ON IT, WHEN HE TWISTED HIS RIGHT KNEE. INJURY WAS REPORTED TO HIS SUPERVISOR ON 03/30/99 AND TO THE SAFETY DEPARTMENT ON 04/02/99.

EE WAS HANDLING SCRAP METAL WITHOUT GLOVES AND CUT HIS RIGHT HAND.

EE WAS WORKING IN TIGHT SPOT. WHEN HE WAS GETTING OUT HE TWISTED WRONG & STRAINED HIS BACK

EE WAS BY THE BOILER WHEN SOME CLINKER FELL INSIDE THE BOILER RUPTURING A STEAM PIPE

WHLE REBRICKING THE KILN, EE HANDED A BRICK UP TO THE CONTRACTOR. THE CONTRACTOR LOST HOLD & IT FELL ON TO EE'S HAND WHILE IT WAS ON THE PALLET OF BRICKS.