Elevator was down due to water in the elevator pit.
Perry County Coal, LLC.Mining Incidents in 2012
All MSHA-reportable accidents at Perry County Coal, LLC. operations in 2012. Fatalities appear first.
- Fatalities in 2012
- 0
- Total incidents
- 63
- Year
- 2012
Top incident classifications
- 01HANDLING OF MATERIALS13 incidents
- 02HOISTING12 incidents
- 03SLIP OR FALL OF PERSON10 incidents
- 04HANDTOOLS (NONPOWERED)8 incidents
- 05FALL OF ROOF OR BACK7 incidents
All incidents in 2012
Rock fall was discovered at 1 West Mains spad number 1730 in the belt line entry for old intake. Fall measured approximately 20' wide x 120' long x 8' high.
Hoist car was down due to an electrical problem.
Elevator was down due to an electrical problem.
Rock fall occurred on 1 North East Mains Brk #12 on the belt line. Fall measured approximately 40' long X 15' wide X 3' thick.
Brake car/hoist was down due to an electrical problem.
Slope hoist car was down due to dead batteries.
Tracking system was down due to electrical problems.
Rock fall was discovered at break 8 on 1 Southeast Mains #6 entry. Fall measured approximately 20' wide x 60' long x 6'-8' thick.
Slope hoist car was down due to an electrical problem (contactor).
Preshift examiner found a large amount of water on the 002 section that was coming from #3 entry and the #4 entry of the pillar line.
Tracking system was down due to grounded highline. System was down over 12 hours.
Hoist was down due to hydraulic pump down on it.
Hoist was down due to an schedule maintenance. Changed hydraulic pump.
Rock fall occurred on the 1 West Mains 1 1/2 crosscut inby spad 2497 # 1 entry. Fall measured approximately 20' long X 20' wide X 5' thick.
Employee was coming around the roof bolter to take the cable down when he stepped in a pile of rocks causing him to twist his ankle.
Employee got off Lo-Trac and stepped on un-even bottom.
Employee was laying out structure for a belt set-up when he strained the back of his neck. Employee started missing 12-13-12.
Bolt bin in the shop fell, employee jumped out of the way slipped and fell.
Employee was shoveling belt when he felt pain in his back.
Employee inadvertently activated the rotation causing the roof bolt to spin and strike his wrist.
Employee and two other people were loading a sheet of metal in a scoop bucket, employee felt pain in right bicep. Employee started missing 10-25-12.
Employee was coming back from his tool box when he stepped in a hole in the bottom causing his knee to twist. Employee started missing 10-08-12.
Employee was replacing pipe when a hand rail broke causing him to fall.
Employee overexerted prying with a slate bar.
Employee was scattering belt structure when he experienced low back pain. Employee stated that this may be a reoccurrence of an old Army injury.
Employee was changing oil in raw coal viberator when he inadvertently stepped back off discharge end.
Employee was walking when he struck his head against a bent roof bolt.
Employee was riding in scoop when it hit a rock in the roadway.
Employee was attempting to put a roller back in when he strained his shoulder. Employee started missing 09-06-12.
Employee reported his injury two days after the occurrence to the personnel department. He stated that he was helping to install a pump when he hurt his back.
Employee was installing a spot bolt when a rock fell, struck the drill pot then bounced striking the employee in the mouth.
Employee was preshifting when he found a curtain down. Employee strained his back while pulling the curtain. Employee started missing 07-02-12.
Employee was taking water line loose when water gushed out causing him to fall. Employee started missing 08/08/12.
Employee was stepping down from servicing the radiator of the dozer. He possibly slipped and the nozzle for the windshield washer penetrated his skin resulting in a laceration on his left arm.
Employee was lifting/throwing supplies when he felt pain in his back. Employee started missing 04-19-12.
Employee was throwing roof bolts when he twisted his back. Employee started missing 04-16-12.
Under investigation. Employee started missing 04-02-12.
Employee was packing an eight foot timber when he felt a sharp pain in his lower back. Employee started missing 02-06-12.
Employee slipped off ladder while working on a loader. Employee started missing 02-06-12.
Employee was unloading a wheel unit from a buggy when it fell on his right hand.
Employee was using a bolt wrench, swung and hit his index finger against canopy with wrench.
Employee was pulling draw rock with a slate bar a piece of rock slid down slate bar and hit his thumb on left hand
Employee was helping to build cribs when another employee threw a crib block and hit his hand. Employee required surgery 11-08-12.
Employee was trimming a belt when he stumbled and cut his leg with his belt knife.
Employee was setting timbers when slate bar flipped up and hit him on his right leg. Injury required stitches.
Employee was packing tools through mandoor when he slipped and tried to catch himself from falling. Injury required stitches.
Employee was removing an old tracking tag from his hard hat when he inadvertently cut his left thumb.
Employee was pushing against rail motor with lifting jack when jack came out catching his right hand against the rib. Resulting in a fracture.
Employee was repositioning a piece of metal to get punch back out when he got the end of his thumb caught on the guard on the iron worker.
Employee was attempting to splice belt when he inadvertently cut his right leg. Injury required stitches.
Employee was building a crib back, when a piece of draw rock struck him on the back of his right hand. Injury required stitches.
Employee was taking bolts out of legs on belt structure. When he moved the structure over his finger rubbed over a piece of rock cutting his finger. Injury required 3 stitches.
Employee was bolting a brow up when a piece of rock came down the drill steel, broke off and struck him on the left jaw.
Employee was struck by rub rail handle that broke as a result of being caught on tailpiece. Injury required stitches.
Employee was attempting to make a D-belt when he inadvertently cut the palm of his right hand. Injury required 4 stitches.
Employee was packing a roll of cable, slipped and fell hitting his right eye on the spool of cable.
Pneumoconiosis