LYMAN QUARRY Metal/Non-Metal

EE claims they injured their left shoulder while climbing out of a chute. This incident did not become reportable until 12/5/2023 due to the employee going to the doctor on 12/4/2023.

Employee was attempting to shovel material underneath a conveyor when EE felt a pop in their left shoulder.

Driver was attempting to cut the end of a hose when the safety knife slipped, and EE cut self on the top of EE's right thigh a few inches above EE's knee. EE required 3-4 stitches.

Employee was dismounting from the Cat 988F loader located inside the plant shop. There were some loose rocks on the bottom step, employee's foot slipped on loose rock and he lost his balance, he tried to catch himself with his left hand and fractured the small bone between his thumb and wrist.

2 employees were performing routine maintenance on the Komatsu PC300 Rock hammer. They were replacing a section of the hydraulic hose from the boom to the hammer. Injured was loosening the nut on the hammer end & co-worker was using his pocket knife to cut tie straps which were holding a smaller hose to the one they were replacing. He cut a strap & knife hit EE in lower right leg.

DEATH FROM NATURAL CAUSE - HEART ATTACK.

EE WAS LOADING A FULL OXYGEN BOTTLE ONTO THE WELDING TRUCK. HE LIFTED THE BOTTLE BUT WAS NOT ELEVATED ENOUGHT TO PLACE IT ONTO THE STAND. HE GOTON HIS TOES AND ARCHED HIS BACK TO GAIN HEIGHT. HE FELT A PAIN IN HIS LEFT SHOULDER BLADE.

EE WAS INSIDE OF A SCREEN. HE WAS LAYING ON HIS BACK USING HIS FEET TO PUSH A PIPE WRENCH TO TIGHTEN SCREEN BOLTS

EE WAS LEVELING THE FLOOR IN THE PIT. AS THE EE WAS DRIVING FORWARD, THE LOADER BUCKET CONTACTEDA TOE STOPPING THE LOADER IMMEDIATELY THE EE'S KNEE CONTACTED THE DASSH

EE WAS INSTALLING WEAR PLATES IN WASH BIN EE LOST HIS FOOTING WHILE PULLING PLATE INTO POSITION EE FELL APPROX 1-2 FT BEFORE HIS FALL PROTECTIONHARNESS CAUGHT HIM Y