Bennett's Lake Quarry Metal/Non-Metal

During the heavy rain down fall near the end of the shift on 2nd shift, a rock from the rock pile came sliding down the pile and struck the right-side window of loader, breaking out the side window and striking operator on left knee area causing a laceration to knee.

On a hot, humid day, an employee passed out due to heat exhaustion. Fell forward and cut a finger on the platform's deck requiring stitches.

Employee was attempting to straighten a lifting eye for one of the Grizzly Back Stops with a 5' pry bar. EE strained and felt a pop in EE's groin - diagnosed as an inguinal hernia.

After shoveling, felt discomfort in abdomen. Went to the doctor the following Monday (04/30/2018) and was diagnosed with a hernia.

At the start of a Monday shift, the Quarry Haul Truck driver bumped the berm while backing into the load out bench, causing a jostling to the driver's body. When dumping the load, the driver felt a twinge in lower back when the driver twisted. Doctor stated strain, and advised one week of no truck driving.

While EE was position the barge, he slipped and struck his wrist against the decking causing a suspected scaphoid fracture of his right wrist; soft cast and restricted duty prescribed.

Employee was stepping across barge. It was raining and was slippery. He slipped and hit his knee on the barge. He has a contusion to his knees

Employee was using a hook to pull a branch out of the water at a barge loading operation. Employee stated that he strained his back.

Employee was attempting to move a piece of plate steel that was setting on steel grating. He was using a pry bar to wedge in grating to move the plate. Instead of the plate moving, the grating shifted off the support beam, allowing the grating and employee to fall to the ground below. Sprain wrist and contusion.

Employee was assisting in moving a barge. He was preparing to attach the pull chain to the barge cleat. The cable sheave broke allowing the cable to fall. This jerked his arm causing a fracture to his left forearm.

THE EE WAS HELPING ANOTHER EMPLOYEE MOVE A PIECE OF METAL GRATING FROM A TABLE DOWN TO THE FLOOR. AS THE PAIR BENT DOWN TO PLACE THE GRATING DOWN TO THE FLOOR, ONE EMPLOYEE LET GO OF HIS END OF THE GRATING. THE INJURED EE CONTINUED TO HOLD ON TO HIS END. WHEN THE METAL HIT THE FLOOR THE GRATING CUT THE PALM OF THE EE'S HAND.

EE states he was moving barrels and cables on job site and cut the tip of his finger. Went in for a tetanus shot.

THE EE WAS CLIMBING DOWN A VERTICAL LADDER AND FELT A PULL IN HIS CALF MUSCLE.

EE WAS DISCONNECTING A HOT WATER HEATER COUPLING WHEN HE SLIPPED AND HIT HIS HEAD ON A GAS PUMP IN THE FLOOR. HE RECEIVED A SMALL CUT ON HIS FOREHEAD THAT REQUIRED FOUR STITCHES.

EMPLOYEE WAS TRYING TO REMOVE A PIN FROM THE PNEUMATIC HAMMER ATTACHMENT ON A TRACK HOE. THE EMPLOYEE STRUCK THE PIN WITH A PIN HE WAS HOLDING. THE FORCE CAUSED A STRAIN ON HIS SHOULDER RESULT ING IN A PARTIAL TEAR OF THE SUBSCAPULARIS TENDON. EMPLOYEE DID NOT START MISSING TIME UNTIL 08/01/01.

EMPLOYEE HURT KNEE WHILE OPERATING THE DOZER WHEN HE PUSHED AWKWARDLY ON THE BRAKE PEDAL. EMPLOYEE DID NOT START MISSING TIME UNTIL 7/30/01.

EE STEPPING UP ON AN ELEVATED PLATFORM TO CLEAR AWAY SOME ROCKS THAT HAD THE HAMMER MILL PLUGGED WHEN HE FELT A PAIN IN HIS GROIN AREA. EE DID NOT START MISSING WORK UNTIL JANUARY 23, 2001.

EMPLOYEE WAS KNEELING ON ONE KNEE, TURNED TO PICK UP BOLT AND FELT PULL IN LOWER BACK.

THE UNLOADING CREW SET THE FORKLIFT AT THE CENTER OF HORIZONAL BRACE TO BE UNLOADED FROM THE TRUCK. METAL BANDS HAD TO BE CUT AS TO ALLOW THIS ONE PIECE TO BE UNLOADED SEPARATELY. UPON SHEARIN G OF THE BANDS, THE BRACE TOPPLED OVER TO ONE END HITTING THE EE. THE REASON THE BRACE TOPPLED OVER TO ONE EVEN THOUGH THE CENTER WAS CORRECT, WAS DUE TO WATER INSIDE THAT COULDN'T BE SEEN OR

EMPLOYEE WAS ATTEMPTING TO LIFT A PUMP OFF OF ITS FRAME BY HIMSELF. EMPLOYEE FELT PAIN IN IS GROIN AREA.

EE WAS DIGGING OUT CHUTE ON #1 FEEDER. EE HIT HIS RIGHT WRIST ON A PART OF THE FEEDER RESULTING IN A CUT TO BACK OF HIS WRIST. APPROX 6 STITCHES WERE REQUIRED.

ROCK FELL & HIT DOZER HURTING RIGHT ELBOW

EE WAS GETTING DOWN FROM #2 HAMMER MILL & HIS LEFT KNEE POPPED.

EE WAS TURNING HOOK ON OVERHEAD CRANE. HOOK TURNED AND PUSHED FINGER INTO TOP PART OF HOOK HOUSING. THIS CUT THE EE S INDEX FINGER ON HIS LEFT HAND.

EE WAS PULLING ON BAR TO PULL PIN OUT OF HAMMERS. THE BAR SLIPPED & CAUSED PAIN IN HIS RIGHT SHOULDER & DOWN HIS ARM. EE STARTES LOSING TIME 11/3/97.

EMPLOYEE WAS WELDIGN ON A BEAM NEXT TO THE ELEVATOR AND A CABLE BROKE ON A CRANE WE HAD RENTED FROM WILSON CRANE. WHEN THE CABLE BROKE THE GUARD IT WAS LIFTING FELL AND THE SNATCH BLOCK FELL AND HIT THE EMPLOYEE ON THE RIGHT ARM. RIGHT ARM WAS BROKE AND HAD CUTS ALSO.

EMPLOYEE WAS WORKING ON PULL CABLE. A PIECE OF METAL CAM EOFF THE PULL CABLE INTO LEFT EYE.

EMPLOYEE HOOKED A CHAIN ON A GRATE BAR. THE CHAIN TURNED ON THE GRATE BAR AND MASHED HIS MIDDLE FINGER ON RIGHT HAND.

EMPLOYEE WAS LIFTING GRATE BAR WHEN HE FELT PAIN IN RIGHT SIDE.

EE WAS WORKING ON ELEVATOR AT QUARRY HE LIFTED A WHEEL AND FELT PAIN IN HIS BACK.

EMPLOYEE WAS P.M. ON TOP OF THE TANKS. EMPLOYEE SLIPPED ON TOP OF TANKS COMING DOWN FROM #11 TANK, ON RAMP. HE SAID, HE HAD OIL ON HIS FEET. EMPLOYEE HURT LEFT SIDE OF BACK AND RIBS WHEN H E FELL ON TOP OF TANK. EMPLOYEE IS BACK TO WORK.

EMPLOYEE WAS MOVING HAMMERMILL HAMMERS AND CAUGHT FINGER BETWEEN TWO OF THESE.

EMPLOYEE HAD MYLOGRAM ON 07-20-92 START LOST TIME 07-20-92 RETURN UNKNOWN.

DOZER BLADE HUNG UNDER ROCK AND SLIPPED OUT CAUSING DOZER TO SUDDENLY RISE AND THEN FALL WITH TREMENDOUS FORCE.EMPLOYEE WAS THROWN SIDEWAYS CAUSING PAIN TO LOWER BACK.EMPLOYEE WAS NOT TREATED BY DOCTOR UNTIL 07-24-91.REOCCURENCE OF INJURY.WILL BE LOST TIME AS OF 03-09-92.

EMPLOYEE WAS CUTTING BOLTS OUT OF WEARING PLATE ON LOADER BUCKET. PLATE SLIPPED OVER THE HEAD OF BOLT HITTING EMPLOYEE BEHIND STEEL CAP ON BOOT ACROSS BIG TOE.

EMPL SETTING SPRING ON SPRING JACK ASSEMBLY.STTOOD IN AWKWARD POSITION AS HE LIFTED THE SPRING.WENT TO DR 3-5-90.

EMPLOYEE WAS HELPING CHANGE FEEDER IN TUNNEL.MOVEMENT OF OLD DOOR THAT WAS BEING TAKEN DOWN CAUSED DUST AND RUSTY MATERIAL TO FALL IN HIS RIGHT EYE.

EMPL SETTING GAS CAN DOWN ON BARGES HIT ELBOW ON BARGE BRACE.EMPL WENT TO DR 10-2-89.

EMPLOYEE WAS MEASURING BARGES,WHEN BARGE CAME LOOSE,CAUSING SORENESS TO RIBS AND BACK.

THE DOZER BOUNCED ON LARGE ROCK OR TREE TRUCK CAUSING EMPLOYEE TO HIT TAIL BONE HARD IN SEAT.

EMPLOYEE WAS DESCENDING FROM EMPTY BARGE TO LOADED BARGE. THERE WAS GRAVEL ON THE SIDE OF LOADED BARGE AND HE SLIPPED AND FELL WHEN HIS FOOT HIT THE GRAVEL WITH A POSSIBLE CONCUSSION.