¿Quieres dar seguimiento? Suscríbete al feed RSS de víctimas mortales de Tennessee — cada nueva víctima mortal ante la MSHA, en tu lector en cuanto se registra.
Operator was conducting remoting activities in an area known as the 2025 area when a large rock contacted the cab. Operator was found in the cab out past the designated no-go line and sustained fatal injuries.
Employee found face down on ground next to loader EE was operating. Responding authorities pronounced employee deceased. Incident is still under investigation.
The victim was mounting a haul truck tire on a rim when a rim locking ring dislodged and struck employee, causing fatal injuries.
Employee was assisting repair/replace toggle plate and toggle plate bearings on the jaw crusher when they suffered a pinning type injury.
Employee was operating front end loader in the coal shed. For unknown reasons employee left the loader and was engulfed in the coal pile near the grizzly bars for the feeding system.
Employee was conducting ground control measures when a rock fell striking the employee while high scaling.
A group solely comprised of RWS contractors [MSHA Contractor ID B5045] was working in the mine. A pump sitting on a trailer was moved by RWS contractors by a telehandler, without notification to Nyrstar. RWS hitched the trailer to their telehandler. RWS pulled the trailer up a ramp. The trailer hitch broke. An individual RWS EE traveling on foot behind the trailer was struck
A rail haulage offsider was riding back to the chute to get another load when the locomotive over traveled into the chute causing fatal injuries to the offsider rail employee.
Plant Manager aggravated a pre-existing injury to the right heel tearing a blood blister while walking over a level drill bench. On July 20th, EE died after complications following surgery after an x-ray revealed a broken right heel bone and torn achilles tendon.
Pending Investigation - Victim was leveling material in a trench made for laying electrical conduit, manager was operating front-end loader above. The front-end loader was being used to back fill the trench when the bank collapsed causing the front-end loader to slide into the trench. The victim was fatally injured when victim was pinned between loader and jersey block.
The injured employee was working in the North East corner of the pit loading shot rock. While waiting for the haul truck to return to the muck pile, the excavator was struck by several large rocks. No one witnessed the accident. The haul truck driver discovered the accident scene and rescue/recovery efforts begun. The excavator operator was fatally injured.
Operator working at site pushing material and apparently went over earthen wall into water.
Victim was inby last row of support when a rock fell on him causing death.
EE was cutting drill head from drill steel. Cutting operation resulted in fragmentation of drill steel. EE was struck by drill steel fragment resulting in his death.
Truck traveling from mine site. The victim had truck in high gear, truck was out of control, he put truck in ditch and jumped out. Victim received fatal injury to head.
Employee was pinned between concrete structure and wall of hole.
Employee was working approximately 550' down in elevator shaft, working off top of elevator. Beam came loose that was thought to be secured. Employee fell from top of elevator to bottom of shaft, resulting in his death.
Utility operator was preparing to wash out the rail scale. The loader operator was weighing the loader on the scale. The loader operator announced on the radio that he was moving the loader off the scale. He slowly moved forward when he observed the utility operator on the ground. The utility operator apparently fell and was crushed by the front left tire of the loader.
The employee suffered a fatal electrocution injury while engaged in positioning the electrical MCC building. The boom truck became energized when contacting overhead power lines.
Disassembling a crushing plant. two employees were attempting to remove the motor that drove the hazmac crusher by using a boom truck. The motor became stuck on the motor mount bolts that had been cut off using a torch. The employees then tried to pry it from its stuck position when it freed and came forward.