Little Mountain Metal/Non-Metal

Victim climbed approx. 3 feet up crusher cribbing and fell to the concrete head first Witness to the accident says he went limp before he fell. He had a small cut at the hair line and a bloody nose. Eyes were not dilated. He said his only pain was a headache.

A ROCK WAS WEDGED BETWEEN THE TAILGATE OF THE TRUCK AND EE TRIED TO REMOVE IT BY LIFTING THE GATE BY HAND INSTEAD OF RAISING THE BED. THE GATE CLOSED ON THE TIPS OF HIS LEFT FINGERS AND CRUSHED THEM BETWEEN THE GATE & SEALING EDGE WHICH CUT OF 2 FINGER TIPS

The operator was exiting a front end loader. When he turned to climb down ladder, his foot caught on step. He fell backwards to ground.

OPERATOR WAS DISCONNECTING MOTOR FROM GEAR BOX ON CONVEYOR APPROX. 5 FT OFF GROUND. HE UNHOOKED SAFETY LANIARD AND STARTED TO CLIMB DOWN. HE SLIPPED AND FELL ON HIS ARM AND BACK SIDE. IT WAS D ETERMINED WITH A DR VISIT THAT HIS LEFT WRIST WAS BROKEN, AND POSSIBLE BACK INJURY.

EES WERE REPLACING GEAR BOX ON MAIN FEED CONVEYOR. THE LIFTING EYE BROKE, LETTING THE BOX ROLL SIDEWAYS. WHEN THE BOX ROLLED, IT PINNED EE'S FINGER BETWEEN PIPE & BOX. EE'S FINGER WAS SCRAPED RESULTING IN TWO STITCHES.

CRANE EXTENDED BOOM COMING IN CONTACT WITH OVERHEAD POWER LINES. WHEN THIS HAPPENED, EE WAS ELECTROCUTED WHILE STANDING IN THE TRAILER. DAMAGE TO BOTH ARMS, TORSO, HEAD, LEG. EXTENT AS YET UNK NOWN.

LOWERING BONNET ON TOP OF CRUSHER WITH CRANE WHEN BONNETT CAME APART. LOWER PART OF BONNET (1/2 STEEL PLATE) FELL 18" AND LANDED ON RIGHT BIG TOE

EE WAS SPLICING A CONVEYOR. WHENHE WAS POUNDING THE BELT PUNCH THROUGH THE CONVEYOR BELT, THE PUNCH BROKE OFF. ONE END FLIPPED UP & HIT HIS FACE ON THE CORNER OF HIS EYE. HE RECEIVED A SMALL S UPERFICIAL CUT ON FACE.

EE WAS CLEANIGN OUT UNDER CONVEYOR. HE KNOCKED DIRED FROM A RETURN ROLLER WITH A SHOVEL. THE SHOVEL ROLLED OVER THE ROLLER FLIPPING THE END OF THE HANDLE AGAINST HIS FACE. HE RECEIVED A SMA LL CUT OVE HIS LIP ON THE LEFT SIDE OF HIS FACE.

JUMPED FROM TOP OF CRUSHER ONTO THE SCREEN WALKWAY, BUT THE WALKWAY WAS MISSING A SECTION OF EXPANDED METAL THEREFORE I FELL TO THE GROUND ON MY BACK AND NOTICED THE EXPANDED METAL HAD RIPPED MY ARM.

EE WAS UNLOADING I BEAMS FROM A TRAILER. THE CHAIN WAS NOT HOOKED PROPERLY TO SECURE LOAD. WHEN THE CRANE LIFTED THE BEAM, THE CHAIN CAME OFF LETTING THE BEAM SLIDE AGAINST HIS RIGHT LEG. THE BEAM SCRAPED SOME SKIN FROM HIS RIGHT SHIN.

TWO MECHANICS WERE TIGHTENING FRAME BOLTS ON A CEMENT TRUCK ONE WAS HOLDING A WRENCH THE OTHER AN IMPACT GUN WHEN EE S TURNED ON THE GUN IT PULLED THE END WRENCH FROM THE OTHER MECH. HANDS THE WRENCH HIT EE ABOVE THE LEFT EYE, CAUSING A SMALL CUT, REGUIRING 4 STITCHES.

HE WAS HURRYING DOWN A STAIRCASE AND TRIPPED, LANDING FACE FIRST ON THE METAL STAIRS. HE WAS CUT ABOVE THE NOSE AND UNDERTHE NOSE AND BROKE 2 FRONT TEETH.

HE WAS FUELING LOADER. WHEN HE FINISHED HE WAS CLIMBING DOWN LADDER ON MACHINE. HIS FOOT SLIPPED ON BOTTOM STEP AND HE DROPPED 2 FEET TO GROUND, LANDING OFF BALANCE ON LEFT FOOT, STRAINING LIG AMENTS IN HIS KNEE.

HE WAS PUTTING 5 TARP RUBBER AROUND THE DOOR ON THE LOADER SO IT WOULD STAY OPEN THE T ARP RUBBER BROKE & HE FELL OFF THE FENDER LANDING ON HIS TAIL BONE

100 FOOT ROLL O0 BELT FELL DOWN FROM SUPPORT CABLE.IT HIT THE INJURED AND KNOCKED HIM OFF THE CONVEYOR.HIS LEG GOT CAUGHT AND HELD HIM FROM FALLING TO THE GROUND.

EMPLOYEE CLIMBE8 UP ON LOADER WHEEL TO CHECK THE OIL AND SLIPPED OFF AS THE EMPLOYEE FELL HE HIT A TELEPHONE POLE THAT WAS LAYING ON THE GROUND POSSIBLE BROKEN HIP