Mount Airy Plant: 176 citaciones de la MSHA Metal/Non-Metal

During the course of the day the associate was exposed indirectly to the mig welding arc of other associates

While performing morning routine housekeeping, employee went to exit the catwalk going down steps, EE slips on the first step. Employee was holding onto the handrail and hit knee on the steps.

Loader operator was traveling from the clean stone stockpile to the Class A stockpile, while traveling the loader bucket struck the ground stopping the loader.

While climbing a ground ladder, employee lost balance fell to the ground injuring right foot(heel)

Employee was entering a Bobcat skid steer and closed door on left thumb. The employee received medical attention at a local doctor's office which consisted of 5 sutures.

An employee fell approximately 8'6" off of a concrete landing, striking the ground. The employee was transported by EMS to the hospital. EE injuries include a left wrist fracture and a fractured pelvis. Notification was made to the call center when the accident occurred.

Employee was placing metal I beams on a band saw table, metal slid into employees left ring finger.

Operator was operating the skid steer cleaning up around crushing plant, dug down to deep edge of bucket came in contact with a piece of metal in the ground. Operator was thrown forward in cab, lower chest was struck by safety restraint. At the time of accident operator was fine, 1 1/2 hours later he started feeling nauseous went to hospital for exam.

A cow was loose in the pit and several mine employees were trying to herd the animal out of the road. EE aproached the cow to move it and the cow ran at him. When EE ran out of the way he twisted his ankle.

The miner listed below was drilling a hole into a piece of sheetmetal on an excavtor with a 3/8" drive electric hand drill. As the bit broke through the other side, the bit "grabbed" and started jerking. The drill slipped out of his hands and spun around striking his right hand.

Miner was helping loosen an impaler with a pipe wrench, when he strained himself. Miner failed to let anyone know that he was hurt until Wed. of the next week. Company policy states that any injury MUST be reported when it occurs.

Miner was hooking a chain onto an autocrane. Mechanic thought chain was hooked and moved boom to the side. The chain hook was caught in miner's gloves and cut his hand.

ROCK STUCK IN TAILGATE ON BED OF DUMP TRUCK.

EE WAS CLEANING CAT WALK ONT HE SCREEN LOWER WHERE MATERIAL WAS FROZEN WITH A HAND PICK. HE WENT TO STRIKE THE PILE OF MATERIAL WITH THE PICK AND STRUCK THE HAND RAIL, CAUSING THE PICK TO STRI KE HIS LEFT FOOT.

EE WAS AT THE WASHING PLANT HELPING TO CHANGE SCREENS HE LIFTED SCREEN CARRIED UP THE STEPS & PULLED SOMETHING IN HIS GROIN

ONE EMPLOYEE WAS HAVING TROUBLE WITH THE TRACTOR OVERHEATING. EE STOPPED TO HELP. EE TOUCHED THE RADIATOR CAP AND THE CAP BLEW. HOT WATER SPEWED OUT ONTO EE.

SHOVELING AROUND CRUSHER HURT BACK.

BENT DOWN TO RELEASE POWER TAKE OFF LEVER ON TRACTOR AND INJURED BACK.

ON LADDER TO ADJUST CONTROLS ON DRILL LADDER SLIPPED EMPLOYEE FELL ON ROCKS.

MASHED FINGER IN DRILL STEEL.

EMPLOYEE WAS CLIMBING INSIDE BED OF TRUCK WHEN HE TURNED HIS ANKLE

EMPLOYEE WAS STEPPING OFF SIDEWALK & TURNED HIS ANKLE

DEBRIS FLEW INTO HIS EYE

EMPLOYEE WAS DOING MAINTENANCE ON CRUSHER WHEN HIS LEFT THUMB GOT CAUGHT BETWEEN ROLLER AND FRAME.

EE WAS HELPING CHANGE A SCRREN WHEN HE SPRAINED HIS BACK.

EE WAS TRYING TO LOOSEN A PIECE OF RILL STEEL WHEN HIS HAND GOT CAUGHT BETWEEN THE DRILL STEEL AND BOOM.

EMPLOYEE WAS MOVING MOTOR WHEN IT SLID DOWN A WALKWAY PINNING HIS LEG BETWEEN THE MOTOR & A PIECE OF WATER PIPE

EMPL BENDING DOWN,PICKED UP 50 LB BAG OF SAND ,STRAINED BACK.

EMPL WAS PICKING UP TRASH WHILE BENDING DOWN HE PULLED BACK REINJURING OLD INJURY.

EMPLOYEE WAS GETTING INTO HIS TRUCK WHEN HIS FOOT SLIPPED CAUSING HIM TO FALL ON HIS LEFT ARM.

I NAME & ANOTHER EMPLOYEE WERE HORSEPLAYING ON THE JOB WHEN I NAME FELL ON HIS LEFT LEG & FRACTURED BONE BOTH EMPLOYEES HAVE BEEN DISCHARGED FROMTHEIR JOBS

MOVING CUTTING EDGES MASHED FINGER BETWEEN TWO AND UT FINGER.

MEPL FOOT SLIPPED OFF TRUCK AND AS HE TRIED TO CATCH HIMSELF HE HIT HIS ELBOW

IN TRUCK LEAVING QUARRY SUN BLINDED HIM WAS TRUCK THAT WAS STOPPED IN FRONT HE RAN INT O THE DUMP TRUCK .

EMPLOYEE WAS GETTING LARGE PIECES OF ROCK OUT OF THE PUGMILL WHEN HE STRAINED HIS RT.SIDE & BACK

EMPLOYEE GOT HIS FINGER CAUGHT BETWEEN AN AIR WRENCH AND A PIECE OF METAL.

EMPLOYEE WAS UNLOADING BOXES OFF PICKUP WHEN HE SPRAINED HIS BACK.

EMPLOYEE WAS HOLDING SHAFT FOR ANOTHER EMPLOYEE TO HIT WITH HAMMER, HE PUT HIS HAND ON THE END OF THE SHAFT JUST BEFORE THE HAMMER GOT TO THE SHAFT, THE OTHER EMPLOYEE COULD NOT STOP HIS SWING AND HIT HIS HAND WITH THE HAMMER.

PUTTING POCETKNIFE INTO POCKET WHEN KNIFE CLOSED UP AND CUT FINGER.

EMPLOYEE WAS BENDING DOWN TO PICK UP A ROCK OUT OF THE ROCK BOX AT THE CRUSHER WHEN HE SPRAIN HIS BACK.

EMPLOYEE WAS USING AHMMER AND HE ACCIDENTALLY HIT HIS AHND WITH IT.

EMPLOYEE WAS ST5NDING ON HOOD OF TRUCK WATCHING A LOAD OF ROCK BEING LOADED WHEN A ROCK BOUNDED TOWARD HIM, HE JUMPED BACK AND GOT OFF BALANCE AND FELL TO THE GROUND. FALLING ABOUT 8 FEET.

EMPLOYEE WAS ST1EPPING UP ON THE STEP OF THE LOADER WHEN HIS FOOT SLIPPED CAUSING HIM TO FALL ON THE STEP & BREAKING HIS RIBS

EMPLOYEE WAS MO5ING ROCK OUT OF ROCK BOX WHEN A ROCK SLID DOWN AND HIT HIS LEG.

EMPLOYEE WAS HE5PING TO PICK UP A PIECE OF SCREEN TO PUT IN SCREENING PLANT WHEN HE HURT HIS BACK.

EMPLOYEE WAS ST5NDING BY THE BUCKET TRUCK WHILE OPERATOR WAS LOWERING THE OUTRIGGERS.EMPLOYEE WAS STANDING THERE AND WATCHING BUT FAIL TO MOVE OUT OF THE WAY AND THE OUTRIGGERS WENT DOWN ON HI S TOE. 3

EMPLOYEE WAS CH5NGING BARREL OF GREASE,AS HE WAS MOVING IT HE STRAINED HIS BACK.

OPERATOR WAS SE7TING DRILL UP GUIDING STEEL WITH HIS HAND THROUGH THE GUIDE & THE LARGE BUSHING SLIPPED DOWN THE STEEL SEVERING HIS FINGER

EMP WAS CHANGIN1 SCREEN AT SCREEN PLANT WHEN HE MASHED HIS FINGERS IF HE HAD USED CAUTION WHEN CHANGING SCREENS HE WOULD HAVE PREVENTED THE INJURY

EE WAS CHANGING3STEEL ON DRILL THE COUPLING WAS LOOSE & WHEN HE STARTED TO SCREW ON THE NEXT PIECE OF STEEL THE COUPLING WAS NOT STRAIGHT & C AUSED THE PIECE OF STEEL TO WOBBLE, CATCHIN G HIS FINGER BE7WEEN THE STEEL & BOOM.

EMPL CALLED IN 3-6-86 AND SAID HE HAD HURT HIS BACK THE DAY BEFORE WHILE TURNING ELECTRIC MOTOR WITH WRENCH.

EMP STUMBLED AN8 FELL HITTING KNEE ON CATWALK IN PUGMILL TUNNELL

EE SAID HE WAS CARRYING 5 GALLON BUCKET OF OIL WEIGHING APPROX 40# UP STEPS WHEN HE STRAINE HIS B ACK.

EE WAS GETTING OUT OF WATER TRUCK WHEN HE LOST HIS BALANCE & FELL INJURING HIS BACK.

EMPLOYEE WAS INJURED WHEN MOVING A PIECE OF ROCK APPROX 40 LBS. WHEN HE CAUGHT HIS LITTLE FINGER ON HIS RIGHT HAND BETWEEN THE ROCK AND A METAL HOPPER

EMP WAS WORKING ON CONVEYOR IN BUCKET TRUCK WHEN CONVEYOR GAVE WAY HITTING HIM IN THE HEAD CAUSING A CUT ON HIS HEAD AND BRUISING 4TH VERTEBVRAE

WAS UNLOADING TRUCK TIRE THAT HAD BEEN REPAIRED BY PARRISH TIRE CO OF MT AIRY WHEN RIM BROKE APART AND EXPLODED HALF OF THE RIM HIT HIM IN THE UPPER LEG AND BROKE IT