San Antone Pit Metal/Non-Metal

Was trying to reset a circuit box that had a broken handle - used a metal bar.

Conveyor stopped running. Employee replaced fuses and turned it back on. Conveyor didn't start. He pulled disconnect box off. Electricity arched on switch blades causing the box to blow up.

Rock stuck in conveyor. Employee was prying on it with a bar. Bar slipped catching his finger between bar and crusher frame.

EMPLOYEE WAS PUTTING THE BACK STOP ON A GEAR BOX. HE TUGGED ON THE CONVEYER BELT AND IT JUMPED FORWARD ABOUT 2" CATCHING HIS FINGER BETWEEN THE BELT AND SHIVE. CONVEYER WAS NOT HOOKED TO POWER . EE'S FINGER WAS X-RAYED AND WAS NOT BROKEN, JUST SORE. HE IS O.K. AS OF TODAY. NO LOST TIME.

CLIMBED DOWN TOWER LADDER VERY HIGH WINDS BLEW ASMALL WINDOW PANE OUT OF WINDOW. EE HEARD SOMETHING & LOOKED UP AND SAW GLASS COMING. HE THEN DUCKED & GLASS HIT HIM IN THE BACK OF THE HEAD BEL OW THE HARD HAT CUT HIS HEAD. HE GOT 5 STAPLES IN HIS HEAD

EE WAS ATTEMPTING TO REMOVE A ROCK WHEN ROCK WENT BACK INTO PLACE. HIS FINGER WAS CAUGHT BETWEEN THE TWO ROCKS, CUTTING HIS SFINGER. HAD CUT ABOUT 1/4". NEEDED MEDICAL ATTENTION. BROKE FINGER. HAD 4 STITCHES.

LINING UP BOLT HOLES ON A CHUTE INSTALLATION WITH A PRYBAR. BAR SLIPPED CUASING EE TO LOSE HIS BALANCE AND SCRAPE HIS SHIN.

EMPLOYEE WAS SLIDING A GEAR BOX FORM THE BUCKE TOF A BOBCAT LOADER ONTO ANOTHER PIECE OF EQUIPMENT. HE SLIPPED ON THE LIGHT DUSTIN GOF SNOW AND DIRT AND FELL. THE GEAR BOX FELL ON HIS RIGHT LEG AND HE PULLED MUSCLES IN HIS BACK.

EE WAS HELPING JUMP START HIS LOADER. HE WAS HOOKING UP JUMPER CABLES TO HIS BATTERIES, LOST HIS BALANCE AND FELL APPROX. 4' TO THE GROUND. HE BRUISED HIS RIGHT LEG AND LOWER BACK.

EMPLOYEE WAS ATTEMPTING TO PULL A HEAVY 2" SCREEN OUT OF A LOADER BUCKET. THE SCREEN CAUGHT IN THE BUCKET AND EMPLOYEE HURT HIS BACK.

EE WAS REMOVING ROCKS FROM PRIMARY FEEDER WHEN A STUCK ROCK ABOUT 2' X 4' SLIPPED, PINNING HIS FOOT AGAINST THE FEEDER WALL, SQUEEZING THE BOOT BETWEEN THE FEEDER WALL & SLAB. THE EE HAD HARD TOED BOOTS THE BOOT WAS NOT CUT OR DAMAGED.

WORKING ON A LADDER IN A HOPPER. BASE OF LADDER SLIPPED AND WENT OUT THE OPEN END OF HOPPER. EMPL LOST BALANCE AND LEG WENT THRU LADDER CATCHING IT BETWEEN HOPPER AND LADDER.

CREW WAS PICKING UP A R35 TIRE WITH A BOBCAT TIRE SLIPPED IN THE BUCKET CATCHING EMPLOYEE FINGER BETWEEN THE BOBCAT BUCKET K& TIRE RIMS

EMPLOYEE WAS CLEANING GRIZZLEY RAILS IN FEEDER. HE RAISED HIS LEG TO PUT IT OVER THE SIDE OF THE FEED HOPPER. BUMPING HIS LEFT KNEE ON A SQUARE TUBE. THE NEXT DAY HIS KNEE SWELLED UP.

EE WAS STANDING ON TIRE AT FRONT OF IMPACT, PUSHING BELT LAGGING BACK ONTO CONVEYER BELT. EE FELL BACKWARD OFF OF TIRE, FALLING APPROX. 2 FT TO THE GROUND FRACTURED RIGHT WRIST ON ROCK.