Stacks Run Coal

EE CUTTING PLASTIC 5 GAL BUCKET RAZOR KNIFE BROKE CAUSING EE TO LOSE CONTROL OF KNIFE. KNIFE STRUCK FOREAM LACERATING SAME

WHILE OPERATING A SWITCHING LOCOMOTIVE AT THE PREP PLANT A FOREIGN OBJECT (DUST) CAME THROUGH A OPEN WINDOW AND LODGED IN EMPLOYEE'S LEFT EYE. EMPLOYEE CONTINUED TO WORK AND REPORTED EACH DAY UNTIL A PAIN IN THE EYE FORCED HIM TO STOP WORKING AT 8AM ON 6/15/94.

WHILE EXITING THE PREP PLANT BY THE FEED BELT WALKWAY EE STRUCK HIS RIGHT FOREARM ON THE HANDRAIL INFECTION A CUT REQUIRING 7 STITCHES MINOR ACCIDENT.

I WAS OPENING DOOR TO ENGINE COMPARTMENT ON 988 LOADER STANDING ON BATTERY BOX UPON OPENING DOOR IT CAME OFF HINGES CAUSIGN MEN TO LOOSE HIS BALANCE AND FALL OFF THE LOADER, LANDINGON HIS RIGH T HAND.

WHILE DISMOUNTING A RAILROAD CAR EE S FEET SLIPPED ON RR CAR LADDER. CAUSING HIM TO FALL LANDING ON A ROD THAT SWITCHING THE RAILS INJUY HIS RIGHT FOOT.

WHILE LIFTING A PIECE OF METAL UP AND OVER THE TOP OF THE CLEAN COAL BELT ON 56 CHUTE. PULLED AND RUPTURED LEFT SIDE. THIS SIDE HAND BEEN PREVIOUSLY RUPTURED. DID NOT GO TO DR. UNTIL 9-27-9 1 WORKED UNTIL THEN.

WHILE REMOVING A JACK FROM THE LOADOUT BELT THAT IS USED TO PREVENT WATER BUILDUP ON THE BELT, THE JACK RELEASE MEC. SLIPPED CATCHING THE LEFT THUMB BETWEEN THE JACK HANDLE AND THE JACK FRAME.

WHILE TIGHTING THE HAND WHEEL BRAKE ON A 100 TON R.R. CAR THE EE STRAINED HIS LOWER BACK.

WAS WORKING ON ENGINE OF 275 LOADER WHILE STEPPING OFF OF WORK STEP TWISTED HSI ANKLE.

EMPL STEPPED OUT OF CAB OF DOZER TO TALK TO TRUCK DRIVER. THEN HE TURNED TO REENTER DOZER CAB LOST FOOTING SLIPPED ;& FELL TO GROUND STRIKING LEFT KNEE & RIGHT HAND ON GROUND.

WHILE HOLDING 4' STEEL BAR WHILE DRIVING STEEL PIN OUT OF REAR WHEEL ON AR50 EUC. ROCK TRUCK WHEN PIN CAME OUT BAR SLIPPED & CAME BETWEEN FINGERS & TRUCK FRAME.

WENT TO MOVE AIRTRACK DRILL SLIPPED & FELL LOSING CONTROL OF MACHINE. ARM WAS DAMAGED WHEN CAUGHT BETWEEN DRILL & COMPRESSOR.

WHILE KNEELING WORKING ON A 355 KOMOTSU DOZER NO. B-9 FOOT SLIPPED AND BUMPED RIGHT KNEE.

WHILE DISMOUNTING FROM ROCK TRUCK SLIPPED AND FELL.

WHILE STARTING 7O BACK UP TO A COAL DUMPING AREA THE OPERATOR MISSED A 25' RAMP OF COAL AND UPSET THE TRUCK ON ITS SIDE

EMPLOYEE WAS PERFORMING ROUTINE MAINTENANCE ON A DRILL AND BUMPED HIS LEG RESULTING IN A BRUISE

EMPLOYEE WAS REMOVING HYDRAULIC LINE, WHICH HAD PRESSURE TRAPPED IN A VALVE AND OIL BLEW OUT HITTING EMPLOYEE IN EYES AND CHEST. EYES WERE FLUSHED AND EMPLOYEE WAS TAKEN TO EMERGENCY ROOM FOR FURTHER FIRST AID TREATMENT.

EMP WAS DRIVING STEEL PIN FROM CLEVISE ON THE LOAD OUT HOIST THE HAMMER CHIPPED AND A PICE OF STEEL LODGED IN EMPLOYEES RT HAND

EES WERE PUTTING PIPE INTO PLACE TO BE HOISTED IT SLIPPED HITTING AN EE ON T HE FOOT BREAKING HIS TOE.

EMPLOYEE WAS PULLING AN INCLINE AND ENGINE STALLED, EMPLOYEE LOST CONTROL OF TRUCK BACKING IT INTO SQUIRES CREEK.

DRIVER WAS ON TOP OF TRUCK LOAD OF COAL TARPING - LOST HIS FOOTING AND FELL OVER THE SIDE OF THE TRUCK

THE TWO MEN WERE REPLACING TEETH ON THE SHOVEL BUCKET RINKER WAS HOLDING A HAMMER IN A KEEPER PIN AND HERSHMAN WAS HITTING THE HAMMER WITH A SLEDGE A SMALL METAL SPUR CAME OFF OF THE HAMMER AN D IMBEDDED INTO RINKERS INDEX FINGER

THE EMPLOYEE WAS USING A PRY BAR TO REMOVE THE STUB SHAFT HOUSING ON THE BACK OF THE ENGINE OF AN R-50. THE HOUSING CAME OFF FALLING DOWN ON THE PRY BAR PINNING THE RIGHT HAND BETWEEN THE PR Y BAR AND THE TIE ROD.

STEPPED OFF STEP ON FUEL TRUCK AND TWISTED LEFT ANKLE.

ERNEST WAS FUELING OUR CLARK GRADER WHEN HE FELL OFF THE BACK OF MACHINE.

MAN WAS GETTING OFF A STRUCTURAL BENT THE LADDER DID NOT REACH THE GROUND DUE TO EXCAVATION FOR THE CONVRETE STEP. EMPLOYEE DECIDED TO JUMP TO GROUND. MAN LANDED WRONG AND TWISTED HIS KNEE.

EMPLOYEE WAS LEAVING A STRUCTURAL TOWER. WHEN REACHING THE LAST STEP ON THE LADDER, HE JUMPED TO THE GROUND. DUE TO WINTER FREEZE CONDITIONS, THE GROUND WAS SOFT AND SLIPPERY. EMPLOYEE\S FEET SLIDE WHEN HITTING GROUND. CAUSING A GROIN MUSCLE PULL FROM THE SPLIT.

EMPLOYEE WAS PLACING STEEL SHIMS UNDER A CONVEYOR SUPPORT BY DRIVING THEM WITH A SLEDGE HAMMER. THIS IS THE PROPER METHOD TO LEVEL STEEL. EMPLOYEE STUCK HIS FINGER UNDER HAMMER. EMPLOYEE WAS E XPERIENCING SEVERAL MAJOR PERSONAL PROBLEMS DURING AT THIS TIME, WHICH IS BELIEVED TO BE THE RESSON FOR THIS ACCIDENT.

TWO MEN WERE WORKING ON ELECTRICAL PANELS WHEN A TOOL CAME INTO CONTACT WITH AN ELECTRIC BOX RESULTING IN FLASH CAUSING BURNS TO FACE AND HANDS OF THE TWO MEN MEN WERE TRANSFERRED TO H OSP HOSPITAL WHERE THEY WERE TREATED AND RELEASED

TWO MEN WERE WORKING ON ELECTRICAL PANELS WHEN A TOOL CAME INTO CONTACT WITH AN ELECTRIC BOX RESULTING IN A FLASH CAUSING BURNS TO THE FACE AND HANDS OF THE TWO MEN MEN WERE TRANSFERRED TO H HOSPITAL WHERE THEY WERE TREATED AND RELEASED

EMPLOYEE WAS WORKING AS HOOK-UP MAN FOR CRANE LIFTING CONVEYOR TRUSS SECTIONS. AFTER MAKING THECONNECTION, HE STEPPED CLEAR FOR CRANE LEFT. AS THE LOAD WAS BEING SWUNG INTO PLACE, IT BUMPED A SECTION ALREADY IN PLACE. THIS BUMP JARRED LOOSE A PIECE OF ANGLE LEFT ON COMPLETED SECTION DUE TO POOR HOUSEKEEPING PROCEDURES. THIS ANGLE FELL AND HIT MAN ON THE HEAD (APPROX. 4 FEET).

EMPLOYEE WAS STEPPING FORM CARGO TRAILER ONTO GROUND. GRAVEL HAD BEEN PLACED AT BOTTOM OF STEPS TO FILL HOLE FORMED BY HIGH TRACFFIC AREA. EMPLOYEE STEPPED ON LARGE GRAVEL WHICH ROLLED THROWIN G HIS WEIGHT ON ANKLE. MAN COULD C NOT WALK FOR TWO DAYS.