Troy Plant Metal/Non-Metal

PETERBUILT TRUCK TURNED OVER ON IT'S SIDE WHEN TURNING A CORNER. RAIN AND LIGHTENING CONTRIBUTED. THE DRIVER HIT HER HEAD AND LEG. SHE WAS ON RESTRICTED DUTY.

7HE WAS WORKING ON THE SCREEN AND HIT HIS HEAD ON A CROWN BAR ON THE SCREEN, RESULTING IN A LACERATION TO HIS HEAD WHICH REQUIRED SEVERAL SUTURES TO CLOSE.

I WAS CLIMBING DOWN INTO THE POSSUMBELLY OF THE TYROCK SCREEN. I SLIPPED AND SLID DOWN ABOUT 3'. WHEN MY RIGHT FOOT HIT THE CONVEYOR BELT, I DISLOCATED MY RIGHT ANKLE.

EMPLOYEE STEPPED OFF STAIRS ONTO ROCK, STUMBLED AND FELLS, STRIKING HIS LEFT KNEE ON A ROCK.

EE COULD NOT START THE SHACKER SO HE WENT TO THE ELECTRICAL BUILDING TO CHECK THE HEATERS AND FUSES. EE HAD BEEN WORKING ON THE PLANT AND WAS HOT AND SWEATY. HE FOUND TWO BLOWN FUSES AND BEGAN REPLACING THEM WITH DISCONNECT STILL ON. WHEN HE TRIED TO INSET THE SECOND FUSE HE RECEIVED AN ELECTRICAL SHOCK.

PULLED MUSCLE IN BACK WHILE HANGING SHEET METAL INTO PLACE ON A 992C CATERPILLAR WHEEL LOADER.

EE WAS SQUATTING STRADDLE OF THE HEAD PULLEY USING HIS LEGS TO SLIDE THE HEAD PULLEY ONTO A SHAFT. HE HAD MOVED THE PULLEY SEVERAL TIMES THIS WAY HURTING HIS RIGHT KNEE.

EMPLOYEE PUSHED ON GLASS TO OPEN DOOR - GLASS BROKE.

HE WAS WALKING ALONG THE RAILROAD TRACKS TO THROW A SWITCH. A ROCK ROLLED UNDER HIS FOOT CAUSING HIM TO TWIST HIS RIGHT ANKLE.

EMPLOYEE SLIPPED AND FELL IN A PUDDLE OF OIL IN THE FUEL BAY.

EE WAS JUMPING THE STARTER TERMINAL WITH A SCREWDRIVER, AND SLIPPED. HIS LEFT INDEX FINGER WAS CRUSHED BETWEEN THE RING GEAR AND THE STARTER DRIVE.

FELL OF 5 1/2" CONE. HIT RIGHT ANKLE ON TRUCK BED.

PUNCTURED THUMB WHILE TIGHTENING HOSE CLAMP WITHA SCREWDRIVER.

SLIPPED AND FELL ON HIS BACK.

EE WAS UNHOOKING ELECTRIC SERVICE FROM WELDING MACHINE AND WAS SHOCKED.

EMPLOYEE WAS ADJUSTING V-BELTS WHEN IT SLIPPED AND SMASHED HIS FINGER.

BUMPED HIS HEAD WHEN HIS KNEE CAME OUT OF JOINT, IT HAPPENED WHEN HE WAS WALKING UP THE STEPS.

THE EE WAS KNEELING AND TRIED TO STAND HIS RIGHT KNEE LOCKED UP.

TIGHTENING COME-A-LONG TO SPLICE BELT COME-A-LONG SLIPPED. HE FELL OFF 2 TON TRACK AND LANDED ON HIS BACK AND NECK.

EE BEGAN MOVING CARS WITH HIS HEAD OUT THE WINDOW WATCHING THE TRACKS. HE HIT LOADED CARS AT A SPEED OF 3-5 MPH. THIS KNOCKED HIS SHOULDER INTO THE WINDOW FRAME.

HE COMPLETED WORK ON WATER PIPE, STEPPED UP (26") TO GROUND AND SLIPPED ON WET MATERIAL.

DRIVER LOST CONTROL OF TRUCK ON RAIN SLICK MUD OF ROAD SURFACE, TRUCK & TRAILER OVERTURNED.

EE STEPPED OFF RAILCAR AND HURT RT KNEE.

EE WAS REMOVING CENTER PINS ON 992-C LOADER. THE JACK HE WAS USING FELL ON HIS HAND WHILE REMOVING IT.

EE STEPPED ON A WELDING ROD WALKING TO SHOP. EE WAS GIVEN A TETANUS SHOT AT HOSPITAL.

EMPLOYEE WAS PULLING A BUCKET PIN. WHEN THE PIN CLEARED LOCATION, THE WEIGHT CAUSED HIM TO PULL A MUSCLE IN HIS RIGHT SHOULDER.

EMPL DISMOUNTING EUCLID HAUL UNIT,SLIPPED AND FELL.

EE WAS SITTING ON LOADER BUCKET MAKING A REPAIR TO CONVEYOR JOB FINISHED OPERATOR LOWERED BUCKET TO GROUND. BUCKET APPARENTLY JARRED EE AND AS HE WAS SITTING ON HIS FOOT A SMALL BONE WAS CHIPP ED.,

EMPLOYEE SAID HE LIFTED A TRAILER WELDER TONGUE & HURT HIMSELF WORKED UNTIL 08-04-91

OPERATOR LOST CONTROL OF LOADER-LOADER RAN INTO SMALL DITCH-OPERATOR HIT HEAD ON WINDSHIELD.

EMPLOYEE WAS CLEANING UNDER PLANT. WEDGE FELL OUT OF CRUSHER ABOVE HIM FELL AND HIT HIS HEAD.

EMPLOYEE WAS CLIMBING UP ON A CONVEYOR TO REPAIR A TORN BELT. HE PULLED AGAINST A GUARD, LOST HIS BALANCE AND FELL, INJURING HIS HEAD.

WASCLEANING SURGE TUNNEL, PICKED UP A ROCK AND INJURED BACK.

EE CLIMBED UP ON R-35 BUMPER TO CHECK HIS ENGINE SLIPPED AND FELL.

EMPL HAD CLIMBED UP ON ROLL CRUSHER TO CHECK TAKEUP PULLEY AS HE CLIMBED DOWN HE LOST BALANCE & APPARENTLY JUMPED ABOUT 12'.

EMPLOYEE REPORTED ON 8-18-89 THAT HE HAD PULLED A MUSCLE SHOVELING AROUND 8-13-89, WORKED THROUGH 8-21-89, TOOK OFF.

EMPLOYEE WAS PLACING A CABLE AROUND SOME PUMP PARTS WHEN THEY FELL & STRUCK HAND & WRIST BLOCKS TOOK IMPACT OF FALLING MATERIALS

WORKING ON WATER PUMP BENT OVER BUMPED FACE ON IRON BAR.

EMPL WELDING -PIECE OF HOT SLAG FELL INTO EAR.

HE WAS IN THE TUNNEL CHIPPING A ROCK OUT OF THE CHUTE USING A PIECE OF REBAR AS A CHIPPING TOOL, WHEN THE THE REBAR SPLIT AND CUT HIS HAND.

EMPL USING GRINDER PIECE OF METAL ENTERED EYE BEHIND SAFETY GLASSES.

CHANGING BEARING ON HEAD PULLEY,SLIPPED ON WET BELT.

CHECKING WEAR ON ROTAR OF IMPACT CRUSHER-MASHED HAND.

WHILE DIGGING O6T MATERIAL IN CRUSHER HE PULLED MUSCLE IN HIS SHOULDER.

UNKNOWN-EMPLOYE9 GOT UPSET AND WALKED OFF THE JOB FRIDAY, APRIL 17TH WITHOUT SAYING ANYTHING TO ANYBODY. MONDAY HE CALLED AND SAID HE HAD BEEN HURT

EMP SLIPPED GET7ING OFF SCRAPER AND FELL INTO FIRE EXTINGUISHER

EMPLOYEE STEPPE8 OFF BACKHOE AND TWISTED HIS K NEE.