Buscar en el registro

Employee was cleaning a catwalk with a crowbar, missed their spot and hit themselves in the cheek.

Employee was using a utility knife to cut a piece of 6" rubber skirt board.

Employee removed the guard on the 30" stockpile conveyor snub roller. While it was running, EE put a crowbar in it to clean.

Employee was using a crowbar to open hatch in the tunnel when the bar slipped and employee hit elbow.

Employee was loosening bolts on the mill when they lost their grip and hit their arm on a piece of metal.

Employee was hitting a coal hopper with a 3lbs lump hammer and hit/jammed their finger.

Employee was hitting slug wrench with hammer when the nut came loose the wrench hit EE's finger.

Swinging hammer to tighten the wedges on crusher.

When turning down head nut with pinch bar in shop, strained left shoulder.

Employee was adjusting a 425 Symonds crusher using a come-along adjusting bolts, was not loose. Employee "side loaded" come-along breaking connection to hook, causing chain to hit EE in EE's side/back.

Employee was cleaning a chute with a bar and pulled muscle in shoulder.

Hitting bucket tooth adaptor with 20lb sledge hammer piece broke off struck employee and entered inside right leg exiting 4 inches below entry point

Putting a conveyor belt splice in the 3/4 conveyor @ the finish plant.

Working on rebuilding hydraulic cylinder. When tightening nut, wrench slipped off nut pinching right pinky finger on floor.

Employee was cutting belt with utility knife when he cut his left forearm.

EE was working on adjusting auto brake control when the wrench slipped off the nut hitting his elbow. No lost time from work.

Employee was prying rock with pry bar and bar slipped off striking employee in head. Employee was wearing hardhat....

Cleaning rollers on conveyor belt, caught hand betwen sledgehammer and metal conveyor support.

Shoveling under tunnel conveyor belt, hit left thumb on frame

EE was cleaning mud from the 30" stockpile chute at the raw plant when he said he pulled a muscle in his lower back.

EE was digging a large rock out of the raw crusher the rock fell jarring the bar the EE was using. The bar struck the EE's left forearm.

EE WAS REPAIRING A 1" WATER HOSE - CUTTING END OF HOSE WITH KNIFE, KNIFE SLIPPED CUTTING LEFT THUMB - NEEDED 8 SUTURES.

EE ASSISTING MAINT REPLACE CONVEYOR BELT, WHILE CUTTING OFF SECTION OF OLD BELT UTILITY KNIFE SLIPPED AND CUT EE IN RIGHT THIGH - REQUIRED 2 SUTURES.

OPERATING HAND CRANKED RATCHET, HAND SLIPPED & SKINNED KNUCKLE ON RIGHT LITTLE FINGER. RECIEVED5 SUTURES TO CLOSE AVULSION.

EE USING SLEDGE & SLEDGE WRENCH TO LOOSEN/ADJUST LARGE NUT. EE MIS-HIT SLEDGE & HIT RIGHT HAND ON WRENCH & SLEDGE HANDLE.

EE CUTTING PIECE OF SKIRT RUBBER WITH LITTELITY KNIFE-KNIFE SLIPPED CUTTING EE IN LEFT THIGH REQUIRING 4 SUTURES.

WHILE CLEANING A CHUTE, BLOCKED WITH STONE A ROCK FELL FROM THE CHUTE AND STRUCK HIS SHOULDERCAUSING CONTUSION TO LT. SHOULDER AND SHOULDER STRAIN.

EE SHOVELING BELT SPILLAGE FROM UNDER STOPPED BELT, GOT RIGHT HAND TOO CLOSE TO ANGLE BRACING & GOUGED A 1/2" X 1/2" X 3/16" PIECE OUT OF HIS MIDDLE FINGER, WAS NOT WEARING GLOVES. RECEIVED 5 SUTURES AT CLINIC.

REPAIRING TRACK HOE AND CAUGHT FINGER BETWEEN HAMMER HANDLE AND RAIL.

EMPLOYEE WAS STRIKING PIN IN A CHAIN. A PIECE OF STEEL CHIPPED OFF PIN AND WENT IN INDEX FINGER OF RIGHT HAND.

EE HOLDING PUNCH TO KNOCK OUT RUSTED BOLTS OUT OF COAL MILL. ANOTHER WAS HITTING PUNCH WITH SLEDGE HAMMER HAMMER GLANCED OFF PUNCH HITTING OTHEREE ON LITTLE LEFT HAND FINGER.

EE WAS CLEANING THE WALL OF THE KILN WITH THE BAR. BAR SLIPPED CATCHING FINGER BETWEEN THE BAR& ANGLE IRON WHICH SUPPORTS KILN NOZZEL. CUT FINGER.

EMPLOYEE PULLED BACK MUSCLES WHILE BARRING THE KILN WHILE TRYING TO GET RING OUT OF UPPER PORTION OF #8 KILN.

DRIVING A TOOTH OFF A DRAG BUCKET A PIECE OF METAL WENT INTO LOW LEFT LEG.

THE INJURED EMPLOYEE WAS USING TWO CRESCENT WRENCHES TO BREAK THE BOLTS, LOOSE ON FLANGED PIPE CONNECTION. ONE OF THE WRENCHES SLIPPED OFFCAUSING TO LOOSE HIS BALANCE. HE FELL STRIKING HIS R ELBOW AGAINST THE STEEL PIPE. HE REPORTED IT THAT MORNING, BUT DECIDED TO GO TO THE DR. ONLY AFTER THE SWELLING GOT WORSE.

INJURED WAS USING APICK ON A RING IN #3 KILN. A PIECE OF THE RING FELL HITTING HIM IN THE SHOULDER AREA HE THEN TWISTED HIS KNEE. AND ANKLE ALSO HAD ABRASIONS TO RIGHT WRIST.

EMPLOYEE WAS REMOVING BEARING WITH HAMMER AND PUNCH. A PIECE OF METAL CAME OFF END OF PUNCH, FROM BEARING END, AND ENTERED LEFT THIGH. SMALL PUNCTURE WOUND WITH PIECE OF METAL IN IT.

EMPLOYEE WAS CUTTING A PLASTIC PAIL, WITH AUTILITY KNIFE, WHEN THE KNIFE SLIPPED, CUTTING HIS LEFT KNEE.

TOMMY WAS ATTEMPTING TO REMOVE A CONVEYOR IDLER FROM A CONVEYOR FRAME USING A 6 FOOT PRY BAR WHILE STANDING ON A I BEAM AND CONVEYOR FRAME. THE PRY BAR SLIPPED WHICH CAUSED TOMMY TO FALL 6 TO 7 FEET TO THE GROUND.

SUBJECT WAS USING A SOCKET WRENCH AND RATCHET SOCKET SLIPPED OFF NUT AND STRUCK INJURED RIGHT GHEEK BONE RESULTING IN A SMALL SHOALLOW CUT APPROX. 3/8 LONG.

68935 ATTEMPTING TO OPERATE A HYDRAULIC JACK, THE EMPLOYEE'S LEFT THUMB WAS BROKEN WHEN THE JACK SLIPPED ALLOWING THE STEEL PLATE BEING JACKED TO FALL AND STRIKE THE EMPLOYEE'S THUMB.

EMPL USING COME-ALONG TO SUPPORT A DIFFERENTIAL GEAR -100 LBS-WHILE TRYING TO PLACE GEAR IN HOUSING,THE COME-ALONG SLIPPED ,GEAR FELL 24" ON EMPL LEFT HAND.HAD A CONTUSION OF LEFT HAND.

EMPLOYEE WAS MOVING A PALLET OF FIRE BRICK USING A PALLET JACK HE PULLED ON JACK & HE FELT A PAIN IN HIS RT SHOULDER HE WAS TAKEN TO THE DOC & WAS DIAGNOSED AS HAVING A MUSCLE PULL IN HIS RT S HOULDER EMPLOYEE PLACED ON LIGHT DUTY 02-25-91

USING A PICK TO DIG OUT RING IN KILN. PIECE OF MATERIAL HIT HAND AND CUT IT.

DURING TRACK REPAIR ON OUR RH40 SHOVEL A TRACK PIN WAS BEING DONE IN THE TRACK LINK WHEN THE HAMMER HIT THE SIDE OF THE STRIKING BAR CAUSING IT TO JUMP TO THE SIDE HITTING THE HOLDER IN THE LE FT TEMPLE CAUSING A CUT THAT REQUIRED 4 STITCHES.

WORKING WITH WRENCH ON HEAVY EQUIP.FOR REPAIRS,WRENCH SLIPPED & SLAMMED FINGER SPLITTING IT OPEN

EMPLOYEE HOLDING HAMMER BEHIND BOULDER HAMMER JERKED ARM & SHOULDER WHEN WEIGHT SHIFTED RESULTED IN PULLED MUSCLE

BARRAING A KILN & HE MOVED HIS RIGHT FOREARM ONTO THE HOT BAR

PUNCHING ROCK OUT OF PIPE. ROCK BOUNCED OUT AND HIT LEFT EYE.

EMPLOYEE WAS USING A PRY BAR TO PUNCH OUT A CHUTE THAT WAS STOPPED UP.IT WAS RAINING AND HIS AHND SLIPPED OFF OF BAR.THE BAR STRUCK HIM ON THE LOWER PART OF HIS LEFT ARM JUST ABOVE WRIST.