Buscar en el registro

EMPLOYEE WAS IMPROPERLY REMOVING A DRILL BIT ON A FACE HOLE. THE BIT WAS SITTIG ON THE GROUND AND HE REACHED UNDER THE TABLE TO LINE THE BIT UP WITH THE HAMMER AS IT CAME DOWN. HIS THUMB WAS T OP OF THE BIT WHEN THE HAMMER CAME DOWN, AMPUTATING HIS LEFT THUMB. GLOVES WERE ON.

EE WAS USING A PRY BAR TO REMOVE A ROCK FROM A CHUTE. THE BAR SLIPPED & HE HIT HIS FINGER ON THE EDGE OF THE CHUTE

TIGHTENING TAIL PULLEY ADJUSTER NUT WITH 3/4" DRIVE RATCHET. RATCHET SLIPPED OFF OF NUT, CAUSING EMPLOYEE TO CUT PINKY FINGER ON RIGHT HAND BETWEEN RATCHET HANDLE AND ROCK ON THE GROUND.

EMPLOYEE WAS PRYING A ROCK LOOSE IN FEED HOPPER. IT ROLLED WHEN FREED AND STRUCK HIM IN LEFT KNEE.

THE EE WAS CHANGING A TOOTH ON HIS LOADER. HE USED A HAMMER TO HIT THE TOOTH AND LOSING IT UP. WHEN HE HIT THE TOOTH ON THE POINT END A CHIP CAME OFF AND HIT HIM IN HIS LEFT UPPER ARM BICEP.

EE ATTEMPTING TO CUT RUBBER BELT INTO WHEN BOX KNIFE SLIPPED AND CUT LEFT THUMB REQUIRING 5 STITCHES.

WHILE CUTTING INSULATION TO INSTALL A CONDUIT BOX, THE KNIFE THAT EMPLOYEE WAS USING SLIPPED, CUTTING EMPLOYEE'S LEFT THUMB. SIX STITCHES WERE REQUIRED TO CLOSE WOUND.

THE EMPLOYEE WAS FIXING A RUBBER WAER LLINE WHEN HE CUT THROUGH THE LINE WITH A KNIFE AND CUT HIS INDEX FINGER.

EE WAS USING A PRY BAR WHEN IT SLIPPED COMING UP AND STRIKING HIM IN THE EYE.

EMPLOYEE WAS REMOVING RUST FROM A BEAM WITH A CHIPPING HAMMER. ONE OF THE PIECES WENT NDER EMPLOYEES SAFETY GLASSES & BECAME EMBEDDED INTO RIGHT EYE. THE RUST WAS REMOVED & EMPLOYEE WAS GIVE N DROPS OVER THE WEEKEND.

INJURED AND OTHER WERE LOOSENING LARGE NUTS ON CONE CRUSHER PRIOR TO REPLACING STEEL THEY WERE SWINGING A TWO MAN PENDULUM HAMMER TO STRIKE A HAMMER WRENCH W STRIKING PAD DURING ONE OF THE SWI NGS EITHER THE HAMER FRONT WHICH THE INJURED WASDIRECTING DEFLECTED SLIGHTLY OR THE WRNECH WAS COCKED UPWARDS SLIGHTLY WHICH CAUSED THE HAMMER TO SLIDE UNDER THE STRIKE PAD AND CATCH THE INJU

45381NIC WAS INSTALLING TRAVEL CHAIN ON AN 80D.HE HAD A PUNCH IN ONE SIDE OF CHAIN,TRYING TO LINE IT UP.HE STUCK HIS FINGER IN HOLE WHERE PIN GOES JUST TO SEE HOW MUCH FURTHER THE PUNCH NEEDED 03603OME.AS HIS FINGER WAS IN THE PIN HOLE,THE PUNCH SLIPPED OUT,AND TRAVEL CHAIN FLEW APART WHILE FINGER WAS IN IT.

EMPL USING SLEDGE HAMMER AND SLUG WRENCH TO TIGHTEN CAP NUTS ON TOGGLE BOLTS IN TIGHT WORK AREA ON JAW CRUSHER.DURING A SWING,HIT OVERHEAD PLATFORM WITH THE SLEDGE WHICH CAUSED THE HAMMER TO S LEW AS HE SWUNG.THIS CAUSED RIGHT HAND TO STRIKE THE CAP NUT WHICH RESULTED IN A DEEP BRUISE ON THUMB AT THE NAIL WHICH BECAME INFECTED. TREATMENT DONE BY CO DR INCLUDED THE REMOVAL OF THUMBN

EE WAS TIGHTENING BOLT ON THE BOTTOM OF A BEARING ANOTHER EE WAS TRYING TO HELP BY MOVING THE FLYWHEEL BACK AND FORTH. THE FLYWHEEL ACCIDENTLY HIT THE WRNECH AND THE WRENCH STRUCK VICTIMS ARM AND WRIST AREA.

EMPLOYEE AND HELPERS WERE PULLING 75-LB SCREENS ONE AT A TIME TO THE GAB TOWER SCEEEN DECK BY MANUALLY HAULING ON A ROPE 45' VERTICALLY.AFTER TASK WAS DOME EMPLOYEE REPORTED PAIN AND SOME NAUS EA.EXAM BY PANEL PHYSICIANS DIAGNOSED INJURY AS BACK SPRAIN.EMPLOYEE AT THIS TIME REFERRED TO A LIFTING INCIDENT ON 11/8 AND REPORTED BEING INJURED THEN ALSO.DR'S RECOMMENDED PHYSICAL THERAPY

INJURED AND PLANT FOREMAN WERE INSTALLING NEW CHUTE IN GAB TOWER USING COME-A-LONGS AND PRYBARS TO LIFT AND POSITION CHUTE. AFTER A SERIES OF LIFTING AND PRYING, INJURED REACHED DOWNWARDS TO PICK UP A CUTTING TORCH TO TRIM SOME PLATFORM DECKING AWAY, AT THIS MOMENT THE HANDLE ON THE COME-A-LONG FLIPPED UP AND STRUCK HIM ON THE NOSE. DOCTOR LATER DIAGNOSED INJURY AS CONTUSION OF T

EMPLOYEE DETERMINED THAT SWING LOCK NEEDED REPAIR.HE GOT TOOLS AND THEN LAID ON HIS LEFT SIDE AND REACHED THROUGH SWINF MECHANISM TO REACH LOCK HOUSING BOLT.EMPLOYEE STRAINED OR JERKED ON RATC HET HARD FROM THIS POSITION AND STRAINED MUSCLES IN THE LEFT NECK AND SHOULDER.DOCTOR EXAMINED AND TREATED WITH RECOMMENDATION FOR ABSENCE AND RE-EXAM AFTER ONE WEEK.

INJURED AND OTHER WERE KNOCKING AWEDGE OUT OF A MAIN HOIST LINE. WEDGE WAS BEGIN USED AS A RETAINER. A CHIPPING HAMMER WAS USED BY INJURED AS A PUNCH. WHEN HELPER STRUCK HAMEMR WITH A 16 LB. SLEDGE HAMMER, A FLECK CAME OFF THE WEDGE AND STRUCK EMPLOYEE'S HAND. EMPLOYEE REPORTED ACCIDNET BUT DID NOT THINK SERIOUS ENOUGH TO REQUIRE MED. ATTENTION AT THE TIME. ON 5-24-91 AFTEREMPL

EE WAS TRYING TO PUNCH A BOLT HOLE THRU 1/2" RUBBER BELTING WITH A 5/8" BELT PUNCH USING A 6LB SLEDGE HAMMER FROM A CROUCHING POSITION. PUNCH WAS NOT BEING STEADIED WHEN HAMMER HIT IT. THE PUN CH COME OUT FROM THE BELTING AND STRUCK EE IN THE RIGHT SHIN CAUSING A CUT. THE CUT DEVELOPED REDNESS AND WAS SORE OVER THE FOLLOWING 6 DAYS. EE WAS SENT TO CO DR WHO DIAGNOSED INFECTION AND

EMPLOYEE WAS CORRECTING TIME CARDS & HAD FACE IN CLOSE PROXIMITY TO TIME CARD SO SHE SHOULD SEE THE NUMBERS BETTER WHEN SHE RAISED UP FROM THE TIMECARD THE PEN END CAUGHTIN HER COAT FABRIC CAU SING THE PEN TIP TO ROTATE UP & STRIKE HER RT EYEYE BALL WAS SCRATCHED ABOVE THE IRIS EMERGENCY ROOM DOCTOR APPLIED DROPS & OINTMENT & ISSUED PRESCRIPTION FOR OINTMENT & PAIN -KILLER CO DOC C

EMPLOYEE HELPING OTHERS CHANGE SCREWS IN PLANT WAS LOOSENING BOLTS THAT WERE OVER HIS HEAD. EMPLOYEE PULLED DOWN WARDS ON WRENCH AND FELT TEARING SENSATION IN ABDOMEN. EMPLOYEE TTAKEN TO COP A ANY DOCOTR HERNIA WAS DIAGNOSED, BUT WAS LEFT UNREPAIRED. EMPLOYEE RETURNED TO WORK. IN 12-89 EMPLOYEES DOTOR RECOMMENDED SURGERY TO REPAIR THE HERNIA WHICH HAD WORENED OVER THE YEAR ABENS

INJURED AND 3 OTHER WERE LINING UP 87"X6" I BEAM IN PREPARATION OF WELDING IT IN PLACE. END OPPOSITE TO INJURED KICKED OUT AND FELL OFF OF PRYBAR CAUSING INJURED'S END TO JUMP AND CATCH HIM T HUMB AGAINST SCREEN SIDE. LACERATION TO THE THUMB. INJURED WAS HELPED OFF OF SCREEN TOWER AND TAKEN TO LOCAL EMERGENCY ROOM. INJURY WAS EXAMINED. TREATED AND STICHED. PRES. FOR ANTIBIOTICS

INJURED AND OTHERS WERE REMOVING BEARING HOUSING ON SCREEN USING A POWER PULL. THE POWER PULL WAS OFFSET TO ONE SIDE WHICH CAUSED THE HOUSING TO SWING AS IT CAME LOOSE. INJURED'S HAND WAS ON THE HOUSING WHICH GOT CAUGHT BETWEEN THE HOUSING AND SCREEN SIDE. INJURED WAS GIVEN 1ST AID FOR A SMALL CUT CAUSED BY THE HOUSING. HE THEN WORKED THE REST OF THE DAY. THE NEXT DAY HE WAS S

EMPL MOVING STAND INTO POSITION TO SUPPORT LOADER BUCKET DECIDED STAND NEEDED TO BE RAISED WHILE REMOVING LOCKING PIN STAND FELL CATHCING FINGERTIPS AGAINST STAND BODY EDGE FORCE AND WEIGHT OF STAND PLATE FRACTURED 3RD AND 4TH FINGER TIPS EMPL TAKEN TO COMPANY DR WHERE XRAYS SHOWED FRACTURE BLOOD ALSO HAD TO BE EVACUATED FROM UNDER FINGERNAILS FINGER WERE SPLINTED AND EMPL SENT HOM

EMPLOYEE WAS TIGHTENING NUTS ON BELT SKIRT BRACING USEING 15/16 OPEN END WRENCH. EMPLOYEE DID NOT HAVE WRENCH PROPERLY ON NUT, WHEN PULLED TO TIGHTEN, WRENCH SLIPPED OFF CAUSING OTHER END TO STRIKE EMPLOYEE IN THE LEFT SIDE OF MOUTH BREAKING 3RD. TOOTH FROM MIDLINE OFF EVEN WTH GUM. TOOTH WAS PULLED AND MORE DENTAL WORK IS REQUIRED. SAFETY MEETING HELD ON CORRECT USE OF HAND TOO

EMPLOYEE WAS HELPING OTHER EMPLOYEE TIGHTEN BOLTS ON JAW DRIVE COUPLING USING BOX/OPEN END COMBINATION WRENCH & PIPE INJURED WAS USING HAND TO STEADY WRENCH ON BOLT HEAD WHEN OTHER EMPLOYEES TIGHTENED UP ON BOLT INJUREDS FINGER GOT CAUGHT BETWEEN WRENCH & COUPLING RIM INJURED SUFFERED AVUISION OF FINGER NAIL & WAS TAKEN TO EMERGENCY ROOM PRESCRIPTION ISSUED & RETURNED TO WORK

EMPLOYEE WAS HELPING TO INFLATE A TUBELESS TIRE THAT HAD GONE FLAT. THE TIRES BEAD HAD SEPARATED FROM THE WHEEL RIM. THE INJURED APPLIED A 4" RATCHET TYPE TIE-DOWN STRAP AROUND THE TIRE TO HOL D IT TO THE RIM SO IT COULD TAKE AIR. ONCE INFLATED THE INJURED TRIED TO REMOVE THE STRAP. ON A SECOND ATTEMPT THE STRAP COME LOOSE AND STRUCK THE EMPLOYEE ON THE HAND. EMPLOYEE WAS TAKEN TO

EMPL UNCROSSING CABLES ON IDLER DRUM OF SHOVEL USING 3' PRY BAR.EMPL SLIPPED DUE TO GREASE ,CAUSGHT SELF WITH LEFT ARM.EMPL ALSO HELPED STRAIGHTEN CABLE ON GROUND AND APPLIED TENSION TO CABLE BY PULLING ON CABLE WHILE IT WAS TAKEN UP ONTO DRUM.EMPL WORKED REST OF DAY BUT WENT TO DR THAT PM -PAIN IN SHOULDER.ISSUED RX FOR PAIN AND RELEASED.RECOMMENDED REST AT HOME 2-3 DAYS.