Buscar en el registro

The employee was cutting belting with a utility knife and cut leg. The knife slipped and cut leg.

The employee was injured when an implement tool dropped onto his Right foot. There were several employees in the process of changing the implement tool when this happened.

Walking up steps to access fuel pump, missed footing on step and sprained left knee. Started physical therapy on 04/04/2011.

Operating loader, seat suspension failed causing seat to tilt and bottom out. Operator strained back and neck.

The employee was replacing screens on a crusher plant. As he tightened a bolt with an impact wrench he got his finger on the end of the bolt. As ee spun the bolt with the impact wrench, the head caused a laceration to the end of his finger.

Supervisor of crusher crew suffered a laceration to his left hand while unloading a conveyor belt from the back of a pick up truck. The laceration required 30 stitches to his hand.

A piece of electrical switch gear broke off and arced between B & C phases inside switch gear. This caused an arc flash which resulted in a first degree burn to the operators face and neck on the right side.

A rock was stuck between a conveyor pulley and the frame of the conveyor, as the employee removed the rock, the rock slipped and smashed left fifth finger.

while replacing cutting edge on a 988 cat loader operator pushed bolt into place with his hand rattle gun spun the bolt cutting through glove and lacerating his hand.

IMPROPER USE OF COME-A-LONG. EMPLOYEE WAS TRYING TO PULL A BAR DOWN ON A GRIZZLEY. THE HOOK ON THE COME-A-LONG WAS NOT PROPERLY SECURED AND THE HOOK SLIPPED OFF THE BAR STRIKING THE EMPLOYEE 'S HAND.

EE WAS OPENING THE ROLLUP DOOR ON A PARTS VAN. THE DOOR JAMMED AND HE HURT HIS RT SHOULDER.

EMPLOYEE WAS DRIVING A 777 TRUCK DOWN THE HAUL ROAD WHEN A SPIDER BIT HIM ON HIS LEFT ELBOW. HE SLAPPED IT OFF HIS ELBOW AND THEN THREW IT. HIS ARM STARTED TO SWELL, SO HE WAS TAKEN TO THE HOS PITAL EMERGENCY ROOM. HE SAID HE WAS THERE WITHIN 1 1/2 TO 2 HOURS AFTER BEING BITTEN BY THE SPIDER.

EMPLOYEE WAS REMOVING WORN OUT BUCKET TEETH ON 992 LOADER. HE STRUCK A TOOTH WITH A HAMMER AND A PIECE OF THE TOOTH BROKE OFF AND EMBEDDED IN HIS LEG.

EE WAS WASHING A D.M. 45 DRIL AND PASSED TH EWAND OF THE PRESSRE WASHER ACROSS THE TOP OF HIS NEW STEEL TOED RUBBER BOOTS. THE HIGH PRESSURE HOT WATER CUT THROUGH HIS BOOT AND BURNED HIS RIGH T FOOT.

EE WAS WASHING A 77-B HAUL TRUCK, WHEN HE WENT TO RAISE THE TRUCK BED, THE WAND OF THE PRESSURE WASHER ACCIDENTLY PASSED ACROSS THE TOP OF HIS LEFT FOOT HEATING THE LEATHER OF HIS BOOT CAUSING A BURN TO THE TOP OF HIS FOOT.

DISMOUNTING CAT 777B TRUCK, MISSED LAST STEP AND FELL TO THE GROUND.

EE WAS POSITIONED TOO CLOSELY TO THE 773 HAUL TRUCKS HE WAS SPOTTING FOR IN THE FILL DUMP AREA. A ROCK FELL OFF THE LOADED MATERIAL IN A HAUL TRUCK WHEN THIS MATERIAL SHIFTED ONCE THE HAUL TRU CK DRIVER APPLIED THE BRAKES. THE ROCK HIT THE INJURED EE ON THE HEAD AND RIGHT SHOULDER.

HE WASN'T SURE HOW THIS HAPPENED BUT HIS FINGER GOT BETWEEN A ROCK AND THE GRIZZLE.

EMPLOYEE WAS WELDING ON THE BED OF A HAUL TRUCK ALONE. HE WAS CHIPPING SLAG FROM THE WELD WHEN HE BUMPED THE STINGER WHICH HAD A NEW WELDING RODIN IT. HE SAID IT MADE CONTACT WITH THE BED AND ARCED WHILE HIS HOOD WAS UP. LATER THAT DAY HE WAS WELDING ALONG SIDE ANOTHER WELDER AND GOT FLASHED. THIS IS AGAINST COMPANY POLICY WITHOUT SEPERATION SHIELD.

EE WAS CUTTING A USED CONVEYOR BELT FOR SKIRTINGMATERIAL WITH A UTILITY KNIFE. WHEN THE UTILITY KNIFE GOT STUCK IN THE BELT, EE PULLED HARD ON THE KNIFE FREEING IT FORM THE BELT AND PUNCTURING HIS RIGHT LEG JUST ABOVE THE KNEE. EE WAS KNEELING ON THE BELT DIRECTLY IN LINE WITH THE CUT.

DUMPING ROCKS IN A GRIZZLE, GOT OUT OF TRUCK AND SLIPPED ON A ROCK. HE TRIED TO CATCH HIMSELF AND TORE HIS TENDON IN THE RIGHT ARM.

EE WAS USING A HYDRAULIC JACK TO INSTALL A STEELBUSHING IN AN ARM ASSEMBLY OF A CATERPILLER 992 LOADER. EE HIT THE BUSHING WITH A HAMMER. THE JACK SHIFTED TO THE SIDE CAUSING A METAL SPACER TO FLY OUT OF POSITION STRIKING EE ON THE FOREHEAD AND RIGHT EAR.

WHILE ATTEMPTING TO DISLODGE A SHOVEL FROM STACKER CONVEYOR, EE'S LEFT HAND MAD COMTACT WITH BELT & ROLLER ASSEMBLY CAUSING MODERATE SOFT TISSUE DAMAGE TO THREE FINGERS.

EE WAS HELPING THE DRILLER DO REDRILLS. T HE DRILLER RAISED THE DRILL STEEL AND HAMMER ABOVE THE DECK TO CHECK THE DEPTH OF THE HOLE. EE PUSHED ON THE STEEL SO THE DRILLER COULD SET THE HAMME R ON THE DECK. EE HAD HIS HAND BETWEEN THE HAMMER AND BIT PINCHING HIS RIGHT INDEX FINGER.

EE WAS OPERATING A 992 LOADER, HE PARKED THE LOADER, GOT OUT OF THE CAB, WALKED AROUND THE CAB TO THE RT SIDE OF THE CAB. HE FELT DIZZY AND BLACKED OUT FALLING OFF OF THE CATWALK TO THE GROUND . MEDICAL TEST SHOWED REASON FOR BLACKING OUT WAS LOW BLOOD PRESSURE. INVESTIGATION FOUND NO TRIPPING OR SLIPPING HAZARDS . ALL HAND RAILS IN PALCE.

AGGRAVATION OF EXISTING CONDITION. REPORTED SLIGHT BACK PAIN 1-2-96. WENT TO DOCTOR 1-29-96. MRI SHOWED BULGING DISC IN LOWER BACK.

COMPRESSED HIS FINGER BETWEEN DRILL STEEL & STEEL GUIDE.

NO DESCRIPTION

EE WAS INSTALLING A TOOTH ON THE BUCKET OF A LOADER. HE HIT THE TOOTH WITH A HAMMER TO LINE UP THE PIN HOLES. A PIECE OF METAL CAME OFF OF THE BUCKET TOOTH AND EMBEDDED IN HIS LEFT FOREARM.

INJURED WAS CUTTING WITH AN OXYGEN ACETYLENE TORCH. HIS PANTS AND COVERALLS CAUGHT ON FIRE. CAUSING 1ST AND 2ND DEGREE BURNS ON HIS LEFT BETWEEN THE ANKLE & KNEE.

FELL FROM LADDER. LEFT HAND SLIPPED OFF OF HAND RAILING. LITTLE FINGER ON RT HAND GOT WEDGED BETWEEN RAILING AND WALKWAY.

THE EMPLOYEE WAS TRYING TO PLACE AN UPPER SUPPORT BEAM ON A WING WALL OF THE JAW CRUSHER.THEY USED THE BOBCAT BUCKET TO BALANCE AND WORK OUT OF.ONE FOOT ON LOWER BEAM AND ONE IN THE BUCKET.THE BOBCAT OPERATOR LIFTED THE BUCKET PUSHING THE LEG INTO THE UPPER BEAM.THIS AFFECT PUT GREAT PRESSURE ON THE LEG AND RESULTED IN A BROKEN ANKLE.

AGGRAVATION TO AN EXISTING INJURY. HE WAS MOVING A PORTABLE LIGHT. WHEN HOOKING LIGHT PLANT TO BALL OF PICKUP HE LIFT TOUNGE OF LIGHT PLANT FELT A PAIN IN LOWER BACK.

ON 9-23-94 EE PARKED HIS MACH WATER TRUCK. WHEN GETTIN GOUT OF THE CAB OF TRUCK HE HIT HIS RIGHT ELBOW ON THE DOOR POST LATCH ON THE CAB OF TRUCK. HE WENT IN AND HAT IT X-RAYED. TI NEVER BO THERED HIM AGAIN UNTIL 11-8-94 HE WEN TBACK TO THE DR WE GOT THE INITIAL DIAGNOSIS ON 11-15-94.

WENT TO DR WITH SORE NECK AFTER DRIVING A773 HAUL TRUCK FOR 1 YEAR AND 16 WEEKS AT THE FLAMBEAU MINE HIS ONLY JOB WAS DRIVING TRUCK.

EE WAS PLACING BLOCKING UNDER PRELL TRUCK IN THEKNEELING POSITION. HE LOST HIS BALANCE & FELL TOHIS RIGHT SIDE SMASHING HIS MIDDLE FINGER ON RIGHT HAND BETWEEN A 8" X 8" X 3' WOOD BLOCK & A RO CK.

EE WAS ROLLING UP BLASTING WIRE TRIPPED ON ROCK CAUSING HIM TO FALL ON LEFT ARM.

HIGH TEMP. THE DAY BEFORE WAS IN THE 40'S, DROPPING TO AROUND 20 AT NIGHT. CAUSED ICY SURFACE ON PARKING LOT. EMPLOYEE WAS REPORTING FOR WORK AND ALLEGEDLY SLIPPED ON THE ICE.

EMPLOYEE CLIMBED DOWN THE HILLSIDE TOT HE CRUSHER TRAP TO REMOVE A LARGE ROCK. WHILE CLIMBING BACK UP THE HILL A LOOSE ROCK ROLLED DOWN AND HIT HIM ON THE KNEE. HE RECEIVED A CONTUSIONTO THE RIGHT KNEE. DR PLACE DHIM ON LIGHT DUTY AND PRISCRIPBEDPHYSICAL TERAPY, FOR 1 WK.

EE JOB INCLUDES THE LIFTING OF SAMPLES WEIGHING 40-60-LBS IN THE PERFORMANCE OF HIS JOB ON 07-06-93 EE EXPERIENCED A POPPING SENSATION FROM THE GROIN AREA EE WAS TAKEN TO SEE A DOC & PLACED ON A LIFTING LIMITATION OF 10LBS FOR A PERIOD OF ONE WEEK SAMPLE WAS REDESIGNED TO THE BEST POSSIBLE ERGONOMIC DESIGN & REDUCED TO 15-30LBS IN WEIGHT