Buscar en el registro

Employee overheated while lacing conveyor belt, claimed they got dizzy and sat down beside the conveyor road, did not communicate to anyone and called 911 themselves! Employee ate and drank throughout the day. With a group of co-workers all day including the supervisor to allow breaks (water, shade, cooling) due to the extreme heat.

MSHA inspector issued citation forcing us to file even though we don't believe this is a recordable. Employee stated they had soreness in shoulder on Thursday, May 1. There was no lifting, pushing, pulling or striking incident that caused this shoulder soreness. States "I drove over a bump in my path and it jarred me".

Employee was walking backwards from front of pickup truck along conveyor. Stepped onto the grated ground berm, twisted ankle underneath self landing with all EE's body weight. Believed ankle was just sprained and went home. Two days later (6/14/24) found out it was a nondisplaced fracture of lateral right fibula.

Laceration to left leg requiring stitches. While attempting to disconnect bucket from skid steer, the bucket slipped off the bucket moment and contacted left leg resulting in a laceration.

Climbing on the sandbox, above the conveyor cat walk, and standing on the conveyor. No LOTO procedures followed. Miscommunication and the conveyor was turned on while employees was climbing down. EE fell onto the catwalk below, about 2-3 feet.

While checking rotation of the piggy backs in the pit, the pig was rotating backwards. Employees switched the electrical wires inside the junction box. When turning the power back on it caused an electrical short which made the employees run into one another. Our employees fell to the ground injuring their right shoulder. The employees were located 200 feet away.

Employee had been doing maintenance on the shakers at Perry Wash Plant. EE was walking down the stairs and when EE got to the end EE stepped on a piece of gravel. This caused EE to lose balance and fall on the same level surface. EE was diagnosed with a right twisted ankle.

Injured party was in line to sign up in for a huddle up meeting. The other party broke in line and mouthed off with profanities at the injured party. The injured party rushed towards the party who started this altercation and then shoved the injured party, who then fell backwards and landed on a truck trailer hitch/ball with EE's buttocks, thus the injury. T

Injured employee assisted in maintenance of log washer. Employee was standing on walkway holding journal of log washer. As EE was doing this another employee was in the tub of the log washer removing the bolt. As the bolt was removed the journal became unstable, pinching three fingers of the employees left hand.

Employee was changing a roller on a field conveyor. Employee was holding one side when it suddenly fell pinching the middle finger of right hand between the roller and conveyor frame. This resulted in a contusion to right hand and also injured the fingernail of the middle finger of the right hand .

EE was pulling off a Roller from the conveyor to replace, as EE grabbed it to remove as EE and helper pulled it EE's finger was caught in roller, it crushed and cut middle right finger

Employee was assisting another employee to remove a nut and bolt from a conveyor roller frame. The injured employee was using a wrench to hold the bolt as the other employee was turning the nut. The injured employees wrench slipped resulting in the ring finger of EE's left hand being struck against some angle iron or conveyor frame.

Employee was climbing into the classfier to clean a screen. They stepped onto a brace, their feet slipped, and they fell against another brace. Employee has a contusion of the left shoulder and thorax.

Employee was standing next to an electrical panel as another employee removed a ground cable using a wrench. The wrench suddenly slipped striking a positive connection which resulted in a electrical flash burning the supervisors that was standing next to the panels right forearm.

Employee states EE and another employee were carrying a pipe. Each employee was positioned on an end of the pipe. one employee suddenly dropped EE's end resulting in EE's right shoulder being strained.

Employee was performing conveyor maintenance. Employee attempted to climb on conveyor and slipped and fell. EE's left wrist was impaled by bolt attached to the conveyor as EE attempted to grab the conveyor when EE was falling.

I had changed the cables on a crane from a single to a double. The crane operator boomed up as my hand was on one of the cables causing might pinky on my right hand to be pinched between the pulley and cable.

Employee was installing paddles on the log washer and felt back pain. EE previously reported that on 10/13/16 EE had felt similar pain when EE was washing the shaker platform while pulling on a 2 1/2 inch water hose. EE requested to seek medical treatment on 10/31/16.

This was not a Memphis Stone employee and there was no incident. A crusher operator discovered a customer(truck driver) in the cab of truck unresponsive and notified the foreman in which emergency medical help was summoned through the use of 911. Paramedics arrived and transported to the hospital where passed away. There was no event that occurred which caused this.

Employee was putting a battery on a John Deere excavator when the battery suddenly blew up. The employee received initial evaluation on the day of occurence for ringing in ears and given no diagnosis. Employee was referred to an audiologist for evaluation.

Employee states he was removing a cutting edge from a bucket. He was using an impact wrench to remove a bolt that secured the cutting edge on the bucket. As he was removing this, the nut began to spin, and he grabbed it to secure it from moving. When he did this it caused a laceration of the index finger of the right hand.

Employee was training employees on how to train a conveyor. He states he was using a hammer to tap the rollers for adjustment. He completed this and walked to his truck and as he began to open his truck door he felt back pain.

The employee was using a utility knife to cut a piece of conveyor. The knife slipped and lacerated the employee's right leg.

Employee states he was prying on a wear plate that was to be removed from a front end loader bucket. The pry bar broke resulting in it striking him above the lip.

Employee was involved in moving a 55 gallon drum from a Bobcat onto a pallet. As he was standing the 55 gallon drum up his middle finger on his left hand was caught between that drum and another drum that was on the pallet.

Employee states he was pulling on a suction hose of a water pump that was stuck in the mud and injured his lower back.

Employee states he was installing flashing on a conveyor belt to prevent spillage. As he was pulling on the flashing to properly place it his right hand went across a piece of jagged metal resulting in a laceration to his index finger on his right hand.

Employee states he was operating a water wagon to wet the roadways. In the evening the employees back began to bother him.

Employee was giving hand signals to a front end loader operator as they were splicing a belt. The nylon choker broke and struck employee in the chest.

Employee was helping to push a 6 inch pipe on to the bed of a truck when he slipped resulting in his hand being smashed between the bed and the pipe.

Employee states he was shoveling and felt pain in his shoulder.

Employee states he was cleaning built up material out of a catch hopper on a conveyor line with a shovel when a rock hit his hand.

EMPLOYEE WAS AT THE REAR SECTION OF AN 8" PIPE THAT WAS BEING PULLED FROM A TRENCH BY A 824 JOHN DEERE LOADER. THE REAR OF THE PIPE SUDDENLY CAME UP OUT OF THE TRENCH AND STRUCK HIM IN THE CHEST.

Employee states he was washing out the inside of the log washer. He slipped and fell onto the paddles which resulted in bruising his ribs.

Employee states he was removing a turbo from a Caterpillar generator. He states he had a wrench in his left hand and reached around the exhaust with his right hand. He was trying to put the wrench in his right hand and as he was doing this a metal gasket that joins the exhaust to manifold cut his right forearm.

Employee states he was tightening a bolt on the shaker screen and the bolt broke causing the wrench to strike him in the nose.

Employee states he was securing crane to lowboy trailer. As he was throwing chain through the hook of the crane to secure felt a pain in his right shoulder.

Employee was removing a lid off of 120lb can of grease with a screw driver. As he was removing the lid the screwdriver slipped lacerating his middle finger on his right hand.

Employee was striking a U joint with a hammer on a Terex Scraper when a piece of metal came off of the U joint entering his right index finger.

Employee states he had positioned a 6X10 sheet of metal in a vertical position in a hopper to weld. He had placed (3) 2x2's in a horizontal position with one end against the sheet of metal and the other against the wall. As he was climbing out of the hopper on a ladder sheet of metal came unsecured and pinned him against the ladder.

Employee states he was driving a hinge pin into an ejector pan with a sledge hammmer.

Employee states he was walking down stairs of control tower when he stepped on a wrench and twisted his ankle.

Employee states he was driving a groung rod with a hand held tool designed for this task, when he hit himself in the head.

Employee had been welding and helping another welder weld on a drainage pipe throughout the shift. Employee was diagnosed with flash burn.

Employee states he was climbing down the steps of the trackhoe and felt his left shoulder pop.

Employee states he was setting up 100ft piggy back conveyor in pit. He was lifting cross ties and pulling SO cable.

Employee was replacing flooring at the primary plant. The employee was using a pry bar to move a steel plate when he felt pain in his back.

Employee states he was removing hydraulic pump and it slipped and caught his finger between metal lines and cut left middle finger.

Employee was knocking the pin out of the bucket from the stick of the backhoe. The stick moved causing the pry bar to pinch between the stick and bucket. The pry bar then hit employee in his right collar bone.

Employee states he was taking compressor off of engine , had it unbolted, reached for a hammer, when the compressor fell off of mounting studs. He grabbed the compressor to keep it from falling.